• Journal of Power Electronics
• /
• v.16 no.1
• /
• pp.297-309
• /
• 2016

Grid-connected inverters (GCIs) with an LCL output filter have the ability of attenuating high-frequency (HF) switching ripples. However, by using only grid-current control, the system is prone to resonances if it is not properly damped, and the current distortion is amplified significantly under highly distorted grid conditions. This paper proposes a synchronous reference frame equivalent proportional-integral (SRF-EPI) controller in the αβ stationary frame using the parallel virtual resistance-based active damping (PVR-AD) strategy for grid-interfaced distributed generation (DG) systems to suppress LCL resonance. Although both a proportional-resonant (PR) controller in the αβ stationary frame and a PI controller in the dq synchronous frame achieve zero steady-state error, the amplitude- and phase-frequency characteristics differ greatly from each other except for the reference tracking at the fundamental frequency. Therefore, an accurate SRF-EPI controller in the αβ stationary frame is established to achieve precise tracking accuracy. Moreover, the robustness, the harmonic rejection capability, and the influence of the control delay are investigated by the Nyquist stability criterion when the PVR-based AD method is adopted. Furthermore, grid voltage feed-forward and multiple PR controllers are integrated into the current loop to mitigate the current distortion introduced by the grid background distortion. In addition, the parameters design guidelines are presented to show the effectiveness of the proposed strategy. Finally, simulation and experimental results are provided to validate the feasibility of the proposed control approach.

• Journal of IKEEE
• /
• v.19 no.3
• /
• pp.357-365
• /
• 2015

Recently, embedded systems such as aircraft and automobilie, are developed as modular architecture instead of federated architecture because of SWaP(Size, Weight and Power) issues. In addition, partition operating system that support multiple logical node based on partition concept were recently appeared. Distributed recovery block is fault tolerance design scheme that applicable to mission critical real-time system to support real-time take over via real-time synchronization between participated nodes. Because of real-time synchronization, single-core based computer is not suitable for partition based distributed recovery block design scheme. Multi-core and AMP(Asymmetric Multi-Processing) based partition architecture is required to apply distributed recovery block design scheme. In this paper, we proposed design scheme of distributed recovery block on the multi-core based supervised-AMP architecture partition operating system. This paper implements flight control simulator for avionics to check feasibility of our design scheme.

• Proceedings of the KIPE Conference
• /
• 2004.07a
• /
• pp.33-37
• /
• 2004

Slotless Permanent magnet Brushless DC Motor(PM BLDC) with the characteristics of high speed and high power density has been more widely used in industrial and automatic machine. Generally, PM BLDC meter is necessary that the three Hall-ICs evenly be distributed around the stator circumference in case of the 3 phase motor. The Hall-ICs are set up in this motor to detect the main flux from the rotor. therefore the output signal from Hall-ICs is used to drive a power transistor to control the stator winding current. However, instead of using three Hall-ICs, if only we used one Hall-IC, we estimate information of the others phase in sequence through a revolving rotor. This paper identified the characteristics and performance by using one Hall-IC for the 3 phase PM BLDC whose six stator and two rotor designed.

• Journal of KSNVE
• /
• v.5 no.2
• /
• pp.169-181
• /
• 1995

A theoretical model has been studied to describe the sound radiation analysis for structural vibration noise control of tire under the action of random moving line forces. When a tire is analyzed, it has been modeled as a curved beam with distributed springs and dash-pots which represent the radial, tangential stiffness and damping of tire, respectively. The reaction due to fluid loading on the vibratory response of the curved beam is taken into account. The curved beam is assumed to occupy the plane y = 0 and to be axially infinite. The material of curved beam and elastic foundation are assumed to be lossless, and governed by the law of Bernoulli-Euler beam theory. The expression for sound power is integrated numerically and its results examined as a function of Mach number(M), wavenumber ratio(.gamma.) and stiffness factor(.PSI.). The experimental investigation for structural vibration noise of tire under the action of random moving line forces has been made. Based on the STSF(Spatial Transformation of Sound Field) techniques, the sound power and sound radiation are measured. The experimental results show that operating condition, material properties and design factors of the tire have a great effect on the sound power and sound radiation characteristics.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.31 no.3B
• /
• pp.232-238
• /
• 2006

We propose a novel call admission control scheme which improves the handoff drop and the new call block probabilities of high priority services, minimizing the negative impact on low priority services, in multimedia service cellular networks. This paper proposes three schemes to solve this problem; the packing scheme in which available channels of a cell distributed to each frequency channel are concentrated on one frequency channel and a high transmission rate service is assigned to the frequency channel; the queuing scheme in which the queue is used for high transmission rate calls; and the power reallocation scheme in which the power assigned to calls under service is temporarily reduced and a high transmission rate service is allowed. The simulation results revealed that our scheme improved the drop and the block probabilities of the high priority services compared with the conventional scheme.

• Journal of the Korean Solar Energy Society
• /
• v.33 no.5
• /
• pp.34-40
• /
• 2013

Islanding phenomenon of photovoltaic system is undesirable because it leads to a safety hazard to utility service personnel and may cause damage to power generation and power supply facilities as a result of unsynchronized re-closure. Anti-islanding protection is an important technical requirement for grid-connected PV system. Until now, various anti-islanding methods for detecting and preventing islanding of photovoltaic and other distributed generations have been proposed. Most of them are focusing on the anti-islanding performance of single PV system according to the related international and domestic standard test procedures. There are few studies on the islanding phenomenon for multiple photovoltaic operation in parallel. This paper presents performance analysis of anti-islanding function for grid-connected PV inverter systems when several PV inverters are connected in parallel.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.19 no.5
• /
• pp.1063-1070
• /
• 2015

In this paper, we propose a distributed user scheduling with transmit power control based on the amount of generating interference to other base stations (BSs) in multi-cell multi-input multi-output (MIMO) networks. Assuming that the time-division duplexing (TDD) system is used, the interference channel from users to other cell BSs is obtained at each user. In the proposed scheduling, each user first generates a transmit beamforming vector by using singular value decompositon (SVD) over MIMO channels and reduces the transmit power if its generating interference to other BSs is larger than a predetermined threshold. Each BS selects the user with the largest effective channel gains among users, which reflects the adjusted power of users. Simulation results show that the proposed technique significantly outperforms the existing user scheduling algorithms.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.34 no.4A
• /
• pp.316-323
• /
• 2009

Power allocation of soft frequency reuse(SFR) to increase cell edge user throughput by reducing inter-cell interference is proposed for coordinated cellular systems. SFR is the effective technique to increase cell edge user throughput, however, it costs the degradation of total system throughput. The cost increases when SFR operated in distributed resource controlled systems fails to be fast adaptive in the change of user distribution. The proposed scheme enables coordinated cells to control transmit power adaptively depending on user distribution so that it minimizes the loss of system throughput introduced from SFR while it guarantees enhancement of cell edge user throughput. Through system level simulation considering neighboring two cells, evaluation result for adaptive power allocation is shown compared with static power allocation.

• Journal of Power Electronics
• /
• v.16 no.6
• /
• pp.2272-2283
• /
• 2016

This paper proposes a power conditioning system (PCS) for distributed photovoltaic (PV) applications using an asymmetric cascaded multilevel inverter with a single PV source. One of the main disadvantages of the cascaded multilevel inverters in PV systems is the requirement of multiple isolated DC sources. Using multiple PV strings leads to a compromise in either the voltage balance of individual H-bridge cells or the maximum power point tracking (MPPT) operation due to localized variations in atmospheric conditions. The proposed PCS uses a single PV source with a flyback DC-DC converter to facilitate a reduction of the required DC sources and to maintain the voltage balance during MPPT operation. The flyback converter is used to provide input for low-voltage H-bridge cells which processes only 20% of the total power. This helps to minimize the losses occurring in the proposed PCS. Furthermore, transient analyses and controller design for the proposed PCS in both the stand-alone mode and the grid-connection mode are presented. The feasibility of the proposed PCS and its control scheme have been tested using a 1kW hardware prototype and the obtained results are presented.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.20 no.6
• /
• pp.540-549
• /
• 2015

Unintentional islanding results in safety hazards, reliability, and many other issues. Therefore, the islanding detection of a power conditioning system of a distributed generation, such as a grid-connected photovoltaic inverter, is a key function for standard compliance. Currently, many anti-islanding schemes have been examined, but existing anti-islanding schemes have poor power quality and non-detection zone issues. Therefore, this study analyzes the non-detection zone in a more deliberate manner than the existing analysis of the non-detection zone and proposes a new anti-islanding scheme, which has negligible power quality degradation and no non-detection zone. Simulation and experimental results validate that the proposed scheme shows much better performance than other existing schemes.