• Transactions on Semiconductor Engineering
• /
• v.2 no.3
• /
• pp.13-18
• /
• 2024

This paper proposes a circuit utilizing auto zero technology to minimize offset and enhance accuracy in the reference generator and comparator. As evidence, a comparison between pre and post auto zero usage revealed a reduction of approximately 90% in standard deviation. The proposed circuit was implemented using a 55nm CMOS process, with an input frequency of 781.2 Hz. It achieves an Effective Number of Bits (ENOB) of 8.01 bits and a Signal-to-Noise Distortion Ratio (SNDR) of 49.98 dB.

• Journal of Broadcast Engineering
• /
• v.5 no.2
• /
• pp.260-272
• /
• 2000

In this paper, we propose a simple auto calibration method for a CCD camera with wide an91e lens that causes high degree of distortion. We formulate a cubic warping equation for the relationship between the cross points on the distorted calibration target and the corresponding points from the standard grid image, and calibrate distorted images using the computed parameters. The experiment has been performed with the distorted images resulted from wide angle CCD camera. The experimental results show that the proposed method, in terms of the average and maximum distorted error, has higher accuracy than the existing methods because of maintaining the calibration ratio more than 95 percent. The proposed method is applicable to wide variety of images regardless a type of lens or distortion.

• Journal of Biomedical Engineering Research
• /
• v.28 no.6
• /
• pp.798-802
• /
• 2007

The synthetic focusing in the ultrasonic imaging systems has been formed in the way that one element transmits a circular wave and receives an echo signal. The amplitude of the signal transmitted from one element is too small to propagate a long distance so that the SNR(Signal to Noise Ratio) is very low in an image obtained by the synthetic focusing. To solve this problem, a defocusing method which uses several elements has been proposed. In this method, the SNR is improved due to using several elements to transmit the circular wave. But if the number of transmitting elements increases, the phase distortion is severe in the defocusing method. In this paper, we propose a new method that can generate a circular wave using a lot of elements without phase distortion. At first, we generate limited plane waves with different propagation angles and then superpose them to make a circular wave. We show that the circular wave can be used to improve SNR in the real-time 3D ultrasonic imaging as well as the synthetic focusing through computer simulation and experiments.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.7 no.11
• /
• pp.2793-2803
• /
• 2013

In H.264, three different data partition types are used, which have unequal importance to the reconstructed video quality. To improve the performance of H.264 video streaming transmission over IEEE 802.11e Wireless Local Area Networks, a prioritization mechanism that categorizes different partition types to different priority classes according to the calculated distortion within one Group of Pictures. In the proposed scheme, video streams have been encoded based on the H.264 codec with its data partition enabled. The dynamic scheduling scheme based on Enhanced Distributed Channel Access has been configured to differentiate the data partitions according to their distortion impact and the queue utilization ratio. Simulation results show that the proposed scheme improves the received video quality by 1dB in PSNR compared with the existing Enhanced Distributed Channel Access static mapping scheme.

• Journal of Korea Multimedia Society
• /
• v.23 no.3
• /
• pp.395-401
• /
• 2020

In this paper, a motion-based ROI extraction algorithm from a high resolution fisheye image is proposed for multi-view monitoring systems. Lately fisheye cameras are widely used because of the wide angle-of-view and they basically provide a lens correction functionality as well as various viewing modes. However, since the distortion-free angle of conventional algorithms is quite narrow due to the severe distortion ratio, there are lots of unintentional dead areas and they require much computation time in finding undistorted coordinates. Thus, the proposed algorithm adopts an image decimation and a motion detection methods, that can extract the undistorted ROI image with a standard angle-of-view for the fast and intelligent surveillance system. In addition, a mesh-type ROI is presented to reduce the lens correction time, so that this independent ROI scheme can parallelize and maximize the processor's utilization.

• KSBB Journal
• /
• v.32 no.2
• /
• pp.103-107
• /
• 2017

The effect of the trehalose incorporation on the biological membranes was investigated with respect to the phase of the membranes using the fluorescence intensity change. Spherical phospholipid bilayers, vesicles, were prepared only with the variation in the phase of each layer via a double emulsion technique. In the aqueous inside of the vesicles, 8-Aminonaphthalene-1,3,6-trisulfonic acid disodium salt(ANTS) was encapsulated. As a quencher, p-Xylene-bis(N-pyridinium bromide)(DPX) was included in the buffer where the vesicles were dispersed. The fluorescence scale was calibrated with the fluorescence of ANTS vesicles in p-Xylene-bis(N-pyridinium bromide)(DPX)-included-buffer taken as 100% fluorescence and the mixture of ANTS and DPX in the buffer as 0% fluorescence. Trehalose injection into the vesicle solution led the distortion of the membrane. It was found that the distortion was related to the phase of each layer the vesicle up on the ratio of trehalose to lipid. In the identical measurements at glucose, the behavior of the distortion was completely different from that of trehalose. These results seem to depend on the stability of the vesicles, due to the osmotic and volumetric effects on the headgroup packing disruption.

• Journal of electromagnetic engineering and science
• /
• v.14 no.2
• /
• pp.68-73
• /
• 2014

A linear stacked field-effect transistor (FET) power amplifier (PA) is implemented using a $0.18-{\mu}m$ silicon-on-insulator CMOS process for W-CDMA handset applications. Phase distortion by the nonlinear gate-source capacitance ($C_{gs}$) of the common-source transistor, which is one of the major nonlinear sources for intermodulation distortion, is compensated by employing a PMOS linearizer with improved AM-PM. The linearizer is used at the gate of the driver-stage instead of main-stage transistor, thereby avoiding excessive capacitance loading while compensating the AM-PM distortions of both stages. The fabricated 836.5 MHz linear PA module shows an adjacent channel leakage ratio better than -40 dBc up to the rated linear output power of 27.1 dBm, and power-added efficiency of 45.6% at 27.1 dBm without digital pre-distortion.

• Electrical & Electronic Materials
• /
• v.7 no.5
• /
• pp.403-408
• /
• 1994

Dielectric and structural properties of $Ba_{1-x}$(Z $n_{1}$3/T $a_{2}$3/) $O_{3}$+1 mol% Mn $O_{2}$ (x=0, 0.01, 0.02, 0.03, 0.04) ceramics was investigated at microwave frequencies. With $Ba_{+2}$ shortage, the sinterability and the unloaded Q( $Q_{u}$) were much improved, and the ordering in B site and the lattice distortion was greatly enhanced and the structure approached the completely ordered structure. $Q_{u}$ was strongly correlated with these factors such as ordering ratio, lattice distortion and sinterability, and had the maximum value of 7500 at x=0.01. The dielectric constant was near 30 and the temperature coefficient of the resonant frequency was 2 ppm/.deg. C at x=0.01.1.1.1.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.18 no.8
• /
• pp.1847-1853
• /
• 2014

The PAPR of the input signal is increased due to OFDMA signal in a mobile communication system. High efficiency of a power amplifier, which accounts for power consumption, is a very important key technology. Digital Pre-Distortion techniques were used to improve the linearity of the power amplifier. The Asymmetric Doherty scheme was used to improve the efficiency of the power amplifier. In this paper, we propose a new structure of Asymmetric Doherty. Drive power amplifier part is separated as main path and peak path, and phase shifter is employed to improve power combine characteristics of the Doherty Amplifier. Also, envelope tracking technology for drive gate bais in drive peak amplifier is used to improve efficiency.

• Journal of the Semiconductor & Display Technology
• /
• v.9 no.2
• /
• pp.55-60
• /
• 2010

Ink transfer process from the printing roll to the moving web was investigated using a CFD technique for the application in R2R printed electronics. In line with the requirement that the web handling speed needs to be increased further for the cost competitiveness, the effects of web moving velocity with relatively complex roll patterns were analyzed. To make the present analysis more realistic, the numerical geometry and the ink properties were selected to match those of the real printing production system. Our numerical results showed that both web handling speed and complex printing-roll patterns influenced the shape of the transferred ink. As the web moving speed approaches towards 30mpm, a significant distortion of the shape of the transferred ink occurred. In the range of pattern width smaller than 100 microns, a phase distortion was also found to occur in all the printing-roll patterns considered in the present work but the ratio of the phase distortion to the line width gets smaller as the width becomes smaller. Thus, the web handling speed and the shape of printing-roll pattern will be important elements for the better printing quality under 100 micron line width range.