• Aerospace Engineering and Technology
• /
• v.2 no.2
• /
• pp.25-32
• /
• 2003

In the present paper, a computational study on the hydrodynamic behavior of the inducer are presented including the effect of the mass flow rate. The adopted inducer showed very low head rise with high volume flow rates, which may be caused by the small passage area near the trailing edge. The static pressure distributions at the shroud surface are compared with experimental results showing very good agreements. The overall performance of the inducer such as, efficiency, head rise is also compared with experiments. The computational results are generally in good agreements with experimental ones near the design point, but at the high flow rate, the two results shows discrepancy.

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.11 no.5
• /
• pp.846-855
• /
• 1987

The experimental study was carried out to investigate the performance characteristics of the aero-valved pulsating combustor designed to increase the practical applications of the system. The geometric effect on the stable condition and the dynamic behavior of the system is identified. The equivalence ratio, the inflammability limit, the operating frequency, and thrust were also measured when the system oscillated stably. It is found that while the operating condition is sensitive to the diameter of the inlet pipe and the length of the tailpipe, the maximum value of the turn down ratio was obtained up to 3.2. The measured air flow rate shows that the equivalence ratio increases monotonously with the increasing fuel flow rate and decreasing air inlet diameter and tailpipe length. The measured operating frequency can be approximated by the simple linear equation and the discrepancy is within five percent. The system produced the maximum total thrust of 14N and the minimum specific fuel consumption of 0.155 Nm$^{3}$/h.N when the total thrust was 13N.

• BMB Reports
• /
• v.46 no.6
• /
• pp.310-315
• /
• 2013

The gene order on the X chromosome of eutherians is generally highly conserved, although an increase in the rate of rearrangement has been reported in the rodent lineage. Conservation of the X chromosome is thought to be caused by selection related to maintenance of dosage compensation. However, we herein reveal that the cattle (Btau4.0) lineage has experienced a strong increase in the rate of X-chromosome rearrangement, much stronger than that previously reported for rodents. We also show that this increase is not matched by a similar increase on the autosomes and cannot be explained by assembly errors. Furthermore, we compared the difference in two cattle genome assemblies: Btau4.0 and Btau6.0 (Bos taurus UMD3.1). The results showed a discrepancy between Btau4.0 and Btau6.0 cattle assembly version data, and we believe that Btau6.0 cattle assembly version data are not more reliable than Btau4.0.

• Journal of Chest Surgery
• /
• v.26 no.1
• /
• pp.4-11
• /
• 1993

The Korean Thoracic and Cardiovascular Surgical Society was founded in 1968. After the first Board Certified Examination in 1972, the Society consists of 592 members including 392 specialists [certified board members] now in 1992. Many of the great advances in cardiothoracic surgery were made by pioneering efforts of these members. The annual increment rate of certified board members in KTCSS [KTCSS Boardmen] was 11.9% which was slight greater than that of doctors [6.6%] and overall specialists [9.9%] in Korea. Their working territories were mainly urban areas [91.9%]. Some states showed regional discrepancy in supply/demand of KTCSS Boardmen. 56.1% of all [73.5% of active members] was working at a larger institute than general hospital. There were 99 institutes [41university hospitals and 58 general hospitals] and 76 private clinics where KTCSS Boardmen were employed, and more than three quarters of those institutes have less than 3 in number of KTCSS Boardmen. The rate of practicing private clinics was declined from over than 50% of the beginning to less than 30% now. We propose this survey for a basic data for specialist supply/demand and resident training program.

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.12 no.1
• /
• pp.137-151
• /
• 1988

Thurbulent thermal convection between two plates, bottom plate is at higher temperature $T_{h}$ and the upper plate is at lower temperature $T_{i}$ is numerically investigated. Model equations are abridged Reynolds stress equations; full Reynolds stress equations are simplified to yield algebraic relations in case of mean square velocity fluctuations in vertical and horizontal directions. Boundary conditions for turbulent kinetic energy k and mean square temperature variance .thera.$^{2}$oner bar at the plate surfaces are set to be zero and those of dissipation rate of turbulent kinetic energy .epsilon. and dissipation rate of mean square temperature variance .epsilon.$_{\theta}$ are assumed at first grid point nearest to the boundary surfaces, whose values are approximated by inviscid estimates. Results show that temperature profiles are in good agreement with experimental data except transition region, in which temperature is over-predicted. Such discrepancy becomes larger as the Rayleigh number becomes smaller. Nusselt numbers, which are calculated from the temperature gradients at the boundary surfaces, are also in good agreement with experimental data.a.a.

• The korean journal of orthodontics
• /
• v.24 no.2
• /
• pp.367-394
• /
• 1994

The purpose of this study was to evaluate self perception of occlusal status and recognition for orthodontic treatment as well as the prevalence of orthodontic treatment need objectively and subjectively. 3979 (male 2107, female 1872) school students of age 7~18 were analyzed by questionnaire and clinical examination and the results were as follows, 1. Perception of occlusal status on one's own was more generous than that of orthodontist's and it was affected by the factors such as age, patterns of malocclusion. 2. Recogniuon of subjective need for orthodontic treatment was more generous than that of objective need for the treatment, and factors such as age and sex of patient, parents' age and rate of education, income, occupation, classification of malocclusion and regional discrepancy were influenced. 3. Negative aspect of orthodontic treatment was influenced by the environmental factors. 4. A survey of want for orthodontic treatment showed one's alteration in recognition of the occlusal status with age and esthetic component was much more emphasized than functional component. 5. The multivariate discriminanat analysis for orthodontic treatment group showed that mother's rate of education, classification of malocclusion, demographic characteristics were critical in the determination of treatment group. 6. Test of inter-examiner reliability showed moderate coincidence.

• Korean Institute of Interior Design Journal
• /
• no.32
• /
• pp.82-89
• /
• 2002

This study is focused on the chairs for students, especially, middle school students who grow rapidly compared with other group. We make a certain definite possibilities by the scientific and medical comparison of the approved chair with existing chair about the function of feet-height control & the application of the flexible back. The object of this test is middle & high school student (ratio of gender is the same) in Inchon. And the study types are two. One is to bring a matter and to suggest a design as alternative, the other is to verify propriety of the alternative. The major finding from the research are summarized as follows: 1) K·S standards for existing chairs are not proper to the growth rate of present juveniles, and they don't cope with proactive the discrepancy of growth pace. 2) Existing chairs have caused troubles by using only the fixed back of a chair. This troubles made bad influences on juveniles in a growth period. 3) Even existing chairs can adjust the back of a chair, they can be easily broken , and if they adjusted once, they can't be easily controled. Furthermore, it is Impossible to manage them because of the rust of control parts. 4) In the case of supplying the same sizes of them, juveniles who are different to growth rate respectively, can't accept the chairs. Even supplied adjustable chairs, they cant be ideal types of chairs in Open Classroom mode.

• Metals and materials international
• /
• v.24 no.6
• /
• pp.1412-1421
• /
• 2018

Cold-expanded austenitic high nitrogen steel (HNS) was subjected to investigate the effects of grain size on the stress-controlled high cycle fatigue (HCF) as well as the strain-controlled low cycle fatigue (LCF) properties. The austenitic HNSs with two different grain sizes (160 and $292{\mu}m$) were fabricated by the different hot forging strain. The fine-grained (FG) specimen exhibited longer LCF life and higher HCF limit than those of the coarse-grained (CG) specimen. Fatigue crack growth testing showed that crack propagation rate in the FG specimen was the same as that in the CG specimen, implying that crack propagation rate did not affect the discrepancy of LCF life and HCF limit between two cold-expanded HNSs. Therefore, it was estimated that superior LCF and HCF properties in the FG specimen resulted from the retardation of the fatigue crack initiation as compared with the CG specimen. Transmission electron microscopy showed that the effective grain size including twin boundaries are much finer in the FG specimen than that in the CG specimen, which can give favorable contributions to strengthening.

• Ocean and Polar Research
• /
• v.36 no.4
• /
• pp.395-405
• /
• 2014

A 570 cm-long sediment core was retrieved at $9^{\circ}57^{\prime}N$ and $131^{\circ}42^{\prime}W$ in 5,080 m water depth from the northeast equatorial Pacific and its stratigraphy was established with $^{10}Be/^9Be$ and paleomagnetic measurements. Successive AF demagnetization reveals eight geomagnetic field reversals. In the reference geologic time scale, the eight reversal events correspond to an age of about 4.5 Ma. However, $^{10}Be/^9Be$-based age yields 9.5 Ma at a depth of 372 cm. Such a large discrepancy in determined ages is attributed to an extremely low sedimentation rate, 0.4 mm/kyr on average, of the study core and resultant loss or smoothing of geomagnetic fields. The composite age model reveals a wide range in the sedimentation rate - varying from 0.1 to 2.4 mm/kyr. However, the sedimentation rate shows systematic variation depending on sedimentary facies (Unit II and III), which suggests that each lithologic unit has a unique provenance and transport mechanism. At depths of 110-80 cm with a sedimentation rate of about 0.1 mm/kyr, ancient geomagnetic field reversal events of at least a 1.8 Myr time span have not been recorded, which indicates the probable existence of a hiatus in the interval. Such a sedimentary hiatus is observed widely in the deep-sea sediments of the NE equatorial Pacific.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.40 no.7
• /
• pp.477-484
• /
• 2016

In a multi-effect solar distiller, a feeding rate of seawater to each effect should be decreased as the effect number is increased. In previous studies, the feed rate of seawater was not reduced evenly between the effects, which is unreasonable, since the thermal energy input of each effect decreases by the same amount. In this work, numerical analysis was carried out in order to elucidate this discrepancy. The results showed that the amount of distillates produced was almost the same for both evenly and unevenly reduced flow rates between the effects. Optimum feed rates of seawater with various energy inputs from exhaust gas heat exchanger were also obtained. The results showed that the optimum feed rate of the first effect increased linearly or reached a steady state depending on the heat flux.