• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.21 no.5
• /
• pp.906-912
• /
• 2017

In this paper, we studied a design method for a broadband 3-element quasi-Yagi antenna (QYA) for indoor digital television (DTV) reception. The proposed QYA employs a novel balun between a microstrip (MS) line and a coplanar strip (CPS) line feeding the driver dipole. The proposed balun is constructed by connecting the end of MS line to CPS line through a shorting pin, and the CPS and ground reflector are connected through a circular ring-type conductor. An antenna, as an design example for the proposed antenna, is designed for the operation in the frequency band of 470-806 MHz for terrestrial DTV. The antenna fabricated on an FR4 substrate with a size of $270mm{\times}150mm$ showed a good performance such as a frequency band of 470-820 MHz for a voltage standing wave ratio < 2, a gain > 4.0 dBi, and a front-to-back ratio > 8.4 dB over the DTV frequency band.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.5 no.4
• /
• pp.352-357
• /
• 2000

The vector control scheme is usually applied to the high performance induction motor drives. The PI controller is adopted traditionally to control the motor speed and currents in the vector control scheme. In this case, the dynamic performance of the induction motor is dependent on the PI gains and the gain optimization is necessary in order to get a good dynamic performance. But, it is very hard to optimize the PI gains uniquely within the speed control range because the equivalent model of the motor control system should be known exactly. In this paper, we propose the hybrid control scheme to remove the defects of PI controller. The hybrid control scheme includes the simplified fuzzy controller which operates in the transient state and the PI controller which operates in the steady state. The proposed scheme is applied to the vector control for induction motor, and the digital simulation and the experimental results are given to verify the proposed scheme.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.2A
• /
• pp.147-156
• /
• 2004

This paper presents an implementation and performance analysis of an access channel decoder which exploits a diversity gain due to the independent magnitude of received signals energy at each of antenna elements of a smart antenna BTS (Base-station Transceiver Subsystem) operating in CDMA2000 1X signal environment. Proposed access channel decoder consists of a searcher supporting 4 fingers, Walsh demodulator, and demodulator controller. They have been implemented with 5 of 1 million-gate FPGA's (Field Programmable Gate Array) Altera's APEX EP20K1000EBC652 and TMS320C6203 DSP (digital signal processing). The objective of the proposed access channel decoders is to enhance the data retrieval at co]1-site during the access period, for which the optimal weight vector of the smart antenna BTS is not available. Through experimental tests, we confirmed that the proposed access channel decoder exploitng the diversity technique outperforms the conventional one, which is based on a single antenna channel, in terms of detection probability of access probe, access channel failure probability, and $E_{b/}$ $N_{o}$ in Walsh demodulator.r.r.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.35 no.9C
• /
• pp.729-734
• /
• 2010

In the initial stage of the communications between a base station and a satellite transponder, the base station transmits the frequency-sweeping un-modulated up-link carrier within a certain frequency range to acquire the doppler frequency shift and signal power between the base station and the satellite in orbital flight. The satellite transponder acquires and tracks the carrier in order to initialize the communication. To control such initialization process, the satellite receiver should analyze the input carrier signal in various ways. This paper presents an SNR estimation algorithm to control the initialization process. The proposed algorithm converts the input signal into the baseband polar coordinate representation and estimates the SNR via the statistics of the angular signal components as well as the status parameters to control the receiver. The Monte-Carlo simulations shows the validity of the estimation proposed.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.34 no.4C
• /
• pp.403-413
• /
• 2009

We compare three predistortion methods to prevent signal distortion and spectral re-growth due to the high PAPR (peak-to-average ratio) of OFDM signal and the non-linearity of high-power amplifiers. The three predistortion methods are pth order inverse, indirect learning architecture and look up table. The pth order inverse and indirect learning architecture methods requires less memory and has a fast convergence because these methods use a polynomial model that has a small number of coefficients. Nevertheless the convergence is fast due to the small number of coefficients and the simple computation that excludes manipulation of complex numbers by separate compensation for the magnitude and phase. The look up table method is easy to implement due to simple computation but has the disadvantage that large memory is required. Computer simulation result reveals that indirect learning architecture shows the best performance though the gain is less than 1 dB at $BER\;=\;10^{-4}$ for 64-QAM. The three predistorters are adaptive to the amplifier aging and environmental changes, and can be selected to the requirements for implementation.

• Ocean and Polar Research
• /
• v.39 no.2
• /
• pp.159-168
• /
• 2017

To evaluate the accuracy of UAV photogrammetry for Hyangho coast, eastern coast of Korea, we conducted a field experiment wherein UAV photogrammetry test was repeated three times. Since the Haygho coast is located within a military reservation zone, it was necessary to obtain permission to gain access to the beach and to have sensitive aerial photographs showing military facilities inspected and cropped. The standard deviation of the UAV shooting position between the three tests was less than 1 m, but repeatability of footprint on the ground was low due to wind-driven variability of the UAV pose. Self-calibrating bundle adjustment(SCBA) of implementing non-metric camera calibration was failed in one test. In two tests, the vertical error was twice as large as the pixel size except for those areas that were subject to security inspection and cropping. Given the problems that can arise with regard to the repeatability of the shooting area as well as the possibility of failure with regard to SCBA, we strongly recommend that UAV photogrammetry in coastal areas needs to be repeated at least twice.

• Journal of the Korean Society for information Management
• /
• v.18 no.4
• /
• pp.57-79
• /
• 2001

The study designs and implements a metadata management system for archival and manuscripts control. It has two purposes. First purpose is to organize the collection that the Institution of Korean Church History holds by using the proposed metadata format. Second purpose is to suggest the model and framework for managing the collection. The proposed metadata is designed based on ISAD(G), USMARC AMC, EAD and Ebind, By using the proposed metadata, the collection management system, which allows an integrated retrieval, is implemented. In order to evaluate the efficiency of the proposed system as well as to gain the basic data for the improvement of the proposed system, a questionnaire survey through e-mail is conducted. The evaluation results will be utilized for improving and upgrading the proposed system, and the phrased implementation of applying the system to digital libraries is suggested.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.33 no.8
• /
• pp.65-74
• /
• 2005

It is required for getting the ring laser gyro output purely related to the input rotation to eliminate the output of the modulated angular vibration from the ring laser signal. In this paper we discuss the dither stripping methods of compensating the ring laser signal by converting the rate signal of dither detector from voltage to frequency for a dither type ring laser gyro. We discuss the differential methods for getting rid of the offset of the V-F signal. And we develope the methods of compensating the phase differences between the ring laser signals and the V-F differential signals by using analog integrator and digital time delays. And also, we develope the gain calculation method by comparing the standard deviations of the ring laser signals with V-F differential signals. We implemented these methods and analyzed the effectiveness of these methods by comparing the dither trapping methods.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.23 no.4
• /
• pp.1100-1112
• /
• 1998

In this paper, a novel method of minimizing the phase error is proposed. A DP-PLL system using this method is implemented and its performacnce is investigated, too. The DP-PLL system detects the phase error between reference clock and locally generated system clock. The phase difference is then reported as a PEV(Phase Error Variation), which is propoced from the delayted n-tap rising dege clock circuit with 5ns resolution in the phase detector. The algorithm is used to track the optimal DAC coefficients, which are adjusted from sample to sample in such a way as to minimize the PEV. The proposed method is found to have remarkable good potential for fast and accurate phase error tracking characteristic. The algorithm shows good performance to supress the low frequency jitter.-ending points, we design new basis functions based on the Legendre polynomial and then transform the error signals with them. When applied to synthetic images such as circles, ellipses and etc., the proposed method provides, in overall, outstanding results in respect to the transform coding gain compared with DCT and DST. And in the case when applied to natural images, the proposed method gives better image quality over DCT and comparable results with DST.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.40 no.7
• /
• pp.1347-1353
• /
• 2015

We implemented a 10 Gb/s 4-channel vertical cavity surface emission lasers (VCSEL) driver array in a $0.13{\mu}m$ CMOS process technology. To enhance high current resolution, power dissipation, and chip space area, digital APC/AMC with time division sensing technology is primarily adopted. The measured -3 dB frequency bandwidth is 9.2 GHz; the small signal gain is 10.5 dB; the current resolution is 0.01 mA/step, suitable for the wavelength operation up to 10 Gb/s over a wide temperature range. The proposed APC and AMC demonstrate 5 to 20 mA of bias current control and 5 to 20 mA of modulation current control. The whole chip consumes 371 mW of low power under the maximum modulation and bias currents. The active chip size is $3.71{\times}1.3mm^2$.