• Elastomers and Composites
• /
• v.38 no.3
• /
• pp.213-226
• /
• 2003

The cure and rheological behavior of diglycidyl ether of bisphenol F/nadic methyl anhydride resin system with the kinds of imidazole were studied using a differential scanning calorimeter (DSC) and a rotational rheometer. The isothermal traces were employed to analyze cure reaction. The DGEBF/ anhydride conversion profiles showed autocatalyzed reaction characterized by maximum conversion rate at $20{\sim}40 %$ of the reaction. The rate constants ($k_1,\;k_2$) showed temperature dependance, but reaction order did not. The reaction order (m+n) was calculated to be close to 3. There are two reaction mechanisms with the kinds oi catalyst. The gel time was determined by using G'-G" crossover method, and the activation energy was obtained from this results. From measurement of rheological properties it was found that the logarithmic 1:elation time of fused silica filled DBEBF epoxy compounds linearly increased with the content of filler and decreased with temperature. The highly filled epoxy compounds showed typical pseudoplastic behavior, and the viscosity of those decreased with increasing maximum packing ratio.

• Journal of the Korean Solar Energy Society
• /
• v.23 no.1
• /
• pp.29-38
• /
• 2003

To develope chemical heat pump using available energy sources, solar heat and other kinds of waste thermal energy, we have studied the material and heat transfer rate in the cylindrical bed reactor packed with Calcined Dolomite. Our results from the studies are as follows ; 1 The time needed to complete dehydration reaction at the wall side of the cylindrical reactor(r/rL=0.5) was shorter than that of the center(r/rL=0.0) as much as 12%. 2. Two dimensional (radial and circumferential) partial differential equations, concerning heat and mass transfer rate in the packed bed of calcined Dolomite, are solved numerically to describe the characteristics of the reaction in the cylindrical reactor. The solution reads rate of reaction in the packed bed reactor depends on the temperature and concentration of reactants. These results read the supplied heat transfers from the wall side of the cylinder to the center, dehydration reaction begins at the inner side of the wall of the cylindrical reactor and the dehydration reaction proceeds from the wall side to center of cylinder.

• Journal of Environmental Science International
• /
• v.6 no.4
• /
• pp.399-407
• /
• 1997

The pyrolysis reactions of atomic hydrogen with chloroform were studied In a 4 cm 1.6. tubular flow reactor with low flow velocity 1518 cm/sec and a 2.6 cm 1.4. tubular flow reactor with high flow velocity (1227 cm/sec). The hydrogen atom concentration was measured by chemiluminescence titration with nitrogen dioxide, and the chloroform concentrations were determined using a gas chromatography. The chloroform conversion efficiency depended on both the chloroform flow rate and linear flow velocity, but 416 not depend on the flow rate of hydrogen atom. A computer model was employed to estimate a rate constant for the initial reaction of atomic hydrogen with chloroform. The model consisted of a scheme for chloroform-hydrogen atom reaction, Runge-Kutta 4th-order method for Integration of first-order differential equations describing the time dependence of the concentrations of various chemical species, and Rosenbrock method for optimization to match model and experimental results. The scheme for chloroform-hydrogen atom reaction Included 22 elementary reactions. The rate constant estimated using the data obtained from the 2.6 cm 1.4. reactor was to be 8.1 $\times$ $10^{-14}$ $cm^3$/molecule-sec and 3.8 $\times$ $10^{-15}$ cms/molecule-sec, and the deviations of computer model from experimental results were 9% and 12% , for the each reaction time of 0.028 sec and 0.072 sec, respectively.

• Transactions of the Korean hydrogen and new energy society
• /
• v.29 no.5
• /
• pp.530-537
• /
• 2018

The effect of temperature and absorption capacity on heat of reaction, which is one of the characteristic studies of $CO_2$ absorption, were investigated in a differential reaction calorimeter (DRC) by using piperazine (PZ) and 2-methylpiperazine (2-MPZ). For all absorbents, $CO_2$ loading capacity decreased with increasing the temperature, while the heat of reaction increased, it figured out that these had a linear correlation between $CO_2$ loading capacity and/or heat of reaction and the temperature. The heat of reaction of all absorbents increased with increasing $CO_2$ loading capacity, especially 2-MPZ rapidly increased at $70^{\circ}C$. The reason for increase in the heat of reaction was occurred the regeneration of $CO_2$, which is a reverse-reaction, simultaneously with the absorption.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.21 no.6
• /
• pp.183-194
• /
• 2013

Liquid urea based SCR has been used in the market to reduce NOx in the exhaust emission of the diesel engine vehicle. This system has several problems at low temperature, which are freezing below $-12^{\circ}C$, solid deposit formation in the exhaust, and difficulties in dosing system at exhaust temperature below $200^{\circ}C$. Also, it is required complicated exhaust packaging equipment and mixer due to supply uniform ammonia concentration. In order to solve these issues, solid urea, ammonium carbonate, and ammonium carbamate are selected as ammonia sources for the application of solid SCR. In this paper, basic research on reaction rate of three ammonia-transporting materials was performed. TGA (Thermogravimetric Analysis) and DTA (Differential Thermal Analysis) tests for these materials are carried out for various heating conditions. From the results, chemical kinetic parameters such as activation energy and frequency factor are obtained from the Arrhenius plot. Additionally, from test results of DSC (Differential Scanning Calorimeter) for these materials, chemical kinetic parameters using the Kissinger method are calculated. Activation energies of solid SCR from this experiment are compared with proper data of literature study, then obtained data of this experiment are used for the design of reactor and dosing system for candidate vehicle.

• Journal of The Korean Dental Society of Anesthesiology
• /
• v.14 no.4
• /
• pp.243-250
• /
• 2014

Generalized anaphylaxis is a most dramatic and acutely life-threatening allergic reaction and may cause death within a few minutes. Differential diagnosis of anaphylaxis is made by clinical signs, such as, mental change, respiratory distress, hypotension, hypoglycemia, urticaria and angioedema. Especially, insulin reaction, myocardial infarction and vasovagal syncope are considered as differential diagnosis. In cases of fatal anaphylaxis, respiratory and cardiovascular disturbances predominate and are evident early in the reaction. This is a case report of the intensive care of anaphylactic shock after intravenous injection of the penicillin in a old medically compromised patient with the maxillary osteonecrosis. The anaphylactic shock symptoms, such as, unconsciousness, respiratory disorder, no pulsation on carotid artery and cardiopulmonary arrest are occurred in intravenous injection of augmentin 1.2 g after the skin test. In spite of immediate emergency cares, such as intravenous injection of epinephrine, endotracheal intubation, cardiopulmonary resuscitation, and continuous intensive care, the patient is expired in 58 hours after anaphylactic shock attack.

• Polymer(Korea)
• /
• v.24 no.6
• /
• pp.837-844
• /
• 2000

The cure behavior of commercial epoxy molding compounds (EMC) commonly used for IC package was studied at constant cure temperatures as well as at constant heating rates using differential scanning calorimetry (DSC), rheometer, and dielectric analyzer (DEA). The cure kinetics were obtained using autocatalytic reaction model according to the Ryan Dutta method after assuming m+n equal to 2. The prediction of reaction rates by the model equation corresponded well to experimental data at all temperatures except for 10$0^{\circ}C$. The phase transitions such as gelation and vitrification occurred during network formation. At each isothermal cure temperature, $T_{g}$ was measured in accordance with cure time, and the vitrification point was attained when $T_{g}$ was equal to $T_{cure}$. The temperature dependence of gel points and vitrification points showed good agreement with Arrhenius relation. DEA using parallel plate electrode was effective for the monitoring of EMC cure. we knew that if the resin systems are materials of comparable quality, $_{gel}$$T_{g}$ is constant regardless of accelerator concentration in TTT (Time-Temperature-Transformation) diagram.

• Composites Research
• /
• v.14 no.2
• /
• pp.1-7
• /
• 2001

The studies on the formulation and curing behaviors of Kevlar/Epoxy prepreg for NOSE CONE of aircraft were presented in this paper. Dielectrometer and differential scanning calorimeter were used in order to check the curing behaviors. This prepreg showed the lowest ionic viscosity around $120^{\circ}C$, and then the ionic viscosity was gradually increased up to $200^{\circ}C$. This indicated that the curing reaction of this prepreg started at $120^{\circ}C$ and the molecular weight was increased by the accelerated thermal cross-linking reaction. The loss factor and tan $\delta$ values were also measured and discussed. The loss factor behaviors of Kevlar/Epoxy prepreg, which is related to the fluidity of matrix, were fecund to be similar with that of ionic viscosity. The thermal reaction properties of this prepreg were also studied by differential scanning calorimeter.

• Bulletin of the Korean Chemical Society
• /
• v.31 no.10
• /
• pp.2841-2848
• /
• 2010

Quasiclassical trajectory (QCT) method has been used to investigate stereodynamics information of the reaction $O(^1D)+H_2{\rightarrow}\;OH$+H on the DK (Dobbyn and Knowles) potential energy surface (PES) at a collision energy of 23.06 kcal/mol, with the initial quantum state of reactant $H_2$ being set for v = 0 (vibration quantum number) and j = 0-5 (rotation quantum number). The PDDCSs (polarization dependent differential cross sections) and the distributions of P($\theta_r$), P($\phi_r$), P($\theta_r$, $\phi_r$) have been presented in this work. The results demonstrate that the products are both forward and backward scattered. As j increases, the backward scattering becomes weaker while the forward scattering becomes slightly stronger. The distribution of P($\theta_r$) indicates that the product rotational angular momentum j' tends to align along the direction perpendicular to the reagent relative velocity vector k, but this kind of product alignment is found to be rather insensitive to j. Furthermore, the distribution of P($\phi_r$) indicates that the rotational angular momentum vector of the OH product is preferentially oriented along the positive direction of y-axis, and such product orientation becomes stronger with increasing j.

• Journal of Veterinary Science
• /
• v.21 no.3
• /
• pp.45.1-45.15
• /
• 2020

Background: Feline mammary carcinoma is the third most common cancer that affects female cats. Objectives: The purpose of this study was to screen differential serum proteins in feline and clarify the relationship between them and the occurrence of feline mammary carcinoma. Methods: Chinese pastoral cats were used as experimental animals. Six serum samples from cats with mammary carcinoma (group T) and six serum samples from healthy cats (group C) were selected. Differential protein analysis was performed using a Label-free technique, while parallel reaction monitoring (PRM) was performed to verify the screened differential proteins. Results: A total of 82 differential proteins were detected between group T and group C, of which 55 proteins were down regulated and 27 proteins were up regulated. Apolipoprotein A-I, Apolipoprotein A-II (ApoA-II), Apolipoprotein B (ApoB), Apolipoprotein C-III (ApoC-III), coagulation factor V, coagulation factor X, C1q, albumen (ALB) were all associated with the occurrence of feline mammary carcinoma. Differential proteins were involved in a total of 40 signaling pathways, among which the metabolic pathways associated with feline mammary carcinoma were the complement and coagulation cascade and cholesterol metabolism. According to the Label-free results, ApoB, ApoC-III, ApoA-II, FN1, an uncharacterized protein, and ALB were selected for PRM target verification. The results were consistent with the trend of the label-free. Conclusions: This experimen is the first to confirm ApoA-II and ApoB maybe new feline mammary carcinoma biomarkers and to analyze their mechanisms in the development of such carcinoma in feline.