• Journal of the Korea Society for Simulation
• /
• v.25 no.3
• /
• pp.1-14
• /
• 2016

This paper proposes four general wireless gateway types, which are distinguished by their own processing ways to connect between a wireless sub-network of things and the mobile internet that links mobile network to internet step by step. In this paper, we also design general processing procedures of these four types using the state transition model. Gateways of each types were developed on the basis of the resulted state transition models and their performances were evaluated through several tests, analyzed, and compared each other. As the results of our evaluation, compared with the other types, the type, which combines both of a low-power Sleep-interrupt way and polling ways for receiving data or responses in all the waiting states of a gateway, shows the best performance in all of data transmission real-timeliness, data loss and energy consumption.

• The Journal of the Acoustical Society of Korea
• /
• v.40 no.5
• /
• pp.428-438
• /
• 2021

For long-range communication in deep water, low carrier frequency is efficient due to a decrease in transmission loss. However, there is a limitation in that the data rate decreases due to a narrow bandwith. In order to increase the data rate in an environment with a limited bandwidth, it is necessary to design a higher-order modulation scheme. This paper analyzes the long-range communication data modulated by higher-order modulation schemes. The long-range communication experiment (23 km ~) was conducted in East Sea in October 2020. During the experiment, a vertical line array was utilized and communication sequences were modulated by Phase Shift Keying (PSK) and Quadrature Amplitude Modulation (QAM) schemes and transmitted by a towed source. In more detail, PSK modulation consists of quadrature PSK and 8PSK, QAM modulation consists of 8QAM and 16QAM. Time reversal processing is applied to mitigate inter-symbol interference by utilizing the correlation between received signals and channel impulse responses. All modulation schemes show successful results at 23 km range, demonstrating the feasibility of higher-order modulation in long-range communication.

• Journal of the Korea Society of Computer and Information
• /
• v.27 no.12
• /
• pp.231-238
• /
• 2022

In this paper, among short-range wireless communication technologies such as Beacon, Bluetooth, UWB (Ultra-wideband), ZigBee, NFC (Near Field Communication), Z-Wave, 6LoWPAN (IPv6 over Low power WPAN), D2D (Device to Device), etc., proposed an IoT service platform based on a beacon that can provide indoor positioning. And, a beacon-linked web server was designed by blocking indiscriminate beacon spam signals and applying REST web service technology with flexibility and scalability. Data accessibility between different devices was verified by testing the success rate of data transmission, the success rate of blocking beacon push, the success rate of IoT interlocking processing, the accuracy of location positioning, and the success rate of REST web service-based data processing. Through the designed IoT service platform, various proposals and research on short-distance-based business models and service platforms will be conducted in the future.

• Proceedings of the Korea Information Processing Society Conference
• /
• 2011.04a
• /
• pp.576-579
• /
• 2011

Wireless sensor network are widely all over different fields. Because of its distinguished characteristics, we must take account of the factor of energy consumed when designing routing protocol. Wireless sensor networks consist of small battery powered devices with limited energy resources. Once deployed, the small sensor nodes are usually inaccessible to the user, and thus replacement of the energy source is not feasible. Hence, energy efficiency is a key design issue that needs to be enhanced in order to improve the life span of the network. In BCDCP, all sensors sends data from the CH (Cluster Head) and then to the BS (Base Station). BCDCP works well in a smallscale network however is not preferred in a large scale network since it uses much energy for long distance wireless communication. TBRP can be used for large scale network, but it weakness lies on the fact that the nodedry out of energy easily since it uses multi-hops transmission data to the Base Station. Here, we proposed a routing protocol. A Cluster Based Energy Efficient Tree Routing Protocol (CETRP) in Wireless Sensor Networks (WSNs) to prolong network life time through the balanced energy consumption. CETRP selects Cluster Head of cluster tree shape and uses maximum two hops data transmission to the Cluster Head in every level. We show CETRP outperforms BCDCP and TBRP with several experiments.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.10 no.11
• /
• pp.1225-1230
• /
• 2015

MAC protocol for WBAN performs CSMA/CA(:Carrier Sense Multiple Access with Collision Avoidance)algorithm that handles traffic which occurs in emergency with top priority in order to deal with variable data of sensor node for medicine. Emergency message that node sends undergoes collision and delay of transmission by retransmission of emergency message and waste of energy by retransmission. This paper suggests algorithm that minimizes loss of frame caused by collision and applies different backoff parameters by setting order of priority between MAC instruction frame and data frame in CSMA/CA algorithm case which applies order of priority queuing to improve aforementioned problem. According to performance evaluation, it has been found that using suggested MAC protocol showed lower collision probability, higher packet transmission processing ratio and lower packet loss compared with using IEEE 802.15.6.

• Journal of the Korea Society of Computer and Information
• /
• v.24 no.4
• /
• pp.169-176
• /
• 2019

Wireless sensor networks are used to monitor and control areas in a variety of military and civilian areas such as battlefield surveillance, intrusion detection, disaster recovery, biological detection, and environmental monitoring. Since the sensor nodes are randomly placed in the area of interest, separation of the sensor network area may occur due to environmental obstacles or a sensor may not exist in some areas. Also, in the situation where the sensor node is placed in a non-relocatable place, some node may exhaust energy or physical hole of the sensor node may cause coverage hole. Coverage holes can affect the performance of the entire sensor network, such as reducing data reliability, changing network topologies, disconnecting data links, and degrading transmission load. It is possible to solve the problem that occurs in the coverage hole by finding a coverage hole in the sensor network and further arranging a new sensor node in the detected coverage hole. The existing coverage hole detection technique is based on the location of the sensor node, but it is inefficient to mount the GPS on the sensor node having limited resources, and performing other location information processing causes a lot of message transmission overhead. In this paper, we propose an Adjacent Matrix-based Hole Coverage Discovery(AMHCD) scheme based on connectivity of neighboring nodes. The method searches for whether the connectivity of the neighboring nodes constitutes a closed shape based on the adjacent matrix, and determines whether the node is an internal node or a boundary node. Therefore, the message overhead for the location information strokes does not occur and can be applied irrespective of the position information error.

• Journal of KIISE:Computing Practices and Letters
• /
• v.16 no.11
• /
• pp.1071-1075
• /
• 2010

Because a sensor node in wireless sensor networks(WSNs) has limited resources, such as battery capacity and memory, data aggregation techniques have been studied to manage the limited resources efficiently. Because sensor network uses wireless communication, a data can be disclosed by attacker. Thus, the study on data protection schemes for data aggregation is essential in WSNs. But the existing data aggregation methods require both a large number of computation and communication, in case of network construction and data aggregation processing. To solve the problem, we propose a data protection scheme based on Hilbert-curve for data aggregation. Our scheme can minimizes communications among neighboring sensor nodes by using tree-based routing. Moreover, it can protect the data from attacker by doing encryption through a Hilbert-curve technique based on a private seed, Finally, we show that our scheme outperforms the existing methods in terms of message transmission and average sensor node lifetime.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2007.06a
• /
• pp.758-761
• /
• 2007

Digital signal processing technique is applied in wide fields such as speech processing, image processing and spectrum analysis. Therefore, in order to do frequency selective operation digital filter is used in stead of analog filter and sharp filter characteristics can be implemented. Since finite impulse response (FIR) digital filter as nonrecursive type represents linear phase response characteristics and is always stable and is used in fields regarding wave information importantly such as data transmission. And due to frequency characteristics, in order to remove the Gibbs phenomenon generating around a discontinuous point, filter is designed through window function method. Therefore, in this paper to improve performance of FIR digital filter, a modified window function was applied. And the proposed method was compared with conventional methods using peak side-lobe and transition properties in simulations.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.6 no.3
• /
• pp.381-387
• /
• 2011

Measurement controller that acquire and control and observe data from scattering sensors is organic with central control room. Therefore, measurement controller is efficient wireless network than wire network. But, serious problem is happened in security from outside if use wireless network. Therefore, this paper proposed suitable MS-WP cryptographic system to measurement control wireless network to augment network efficiency of measure controller. Result that implement proposed MS-WP cryptographic system by chip level and achieve a simulation, confirmed that 130% processing rate increase and system efficiency are increased double than AES algorithm. Proposed MS-WP cryptographic system augments security and is considered is suitable to measurement controller because that low power is possible and the processing speed is fast.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.21 no.5
• /
• pp.11-18
• /
• 2021

The small radio frequency tracking radar is a tracking system with a radio frequency sensor that identifies a target through all-weather radio frequency signal processing for a target and searches, detects and tracks the target for the major target. In this paper, we describe the development of a board equipped with TMS320C6678 and XILINX FPGA (Field Programmable Gate Array), a high-speed multi-core DSP that acquires target information through all-weather radio frequency and identifies a target through real-time signal processing. We propose DSP-FPGA combination architecture for DSP and FPGA selection and signal processing, and also explain the design of SRIO for high-speed data transmission.