• Clean Technology
• /
• v.16 no.2
• /
• pp.132-139
• /
• 2010

The Cu-Mn mixed oxide catalysts with different molar ratios of Cu/(Cu+Mn) prepared by co-precipitation method have been investigated in CO oxidation at $30^{\circ}C$. The catalysts used in this study were characterized by X-ray Diffraction (XRD), $N_2$ sorption, X-ray photoelectron spectroscopy (XPS), and $H_2$-temperature programmed reduction $(H_2-TPR)$ to correlate with catalytic activities in CO oxidation. The $N_2$ adsorption-desorption isotherms of Cu-Mn mixed oxide catalysts showed a type 4 having pore range of 7-20 nm and BET surface area was increased from 17 to $205\;m^2{\cdot}g^{-1}$ with increasing of Mn content. The XPS analysis showed the surface oxidation state of Cu and Mn represented $Cu^{2+}$and the mixture of $Mn^{3+}$ and $Mn^{4+}$, respectively. Among the catalysts studied here, Cu/(Cu+Mn) = 0.5 catalyst showed the highest activity at $30^{\circ}C$ in CO oxidation and the catalytic activity showed a typical volcano-shape curve with respect to Cu/(Cu+Mn) molar ratios. The water vapor showed a prohibiting effect on the efficiency of the catalyst which is due to the competitive adsorption of carbon monoxide on the active sites of catalyst surface and finally the formation of hydroxyl group with active metals.

• Applied Chemistry for Engineering
• /
• v.24 no.6
• /
• pp.599-604
• /
• 2013

In this study, Ti added Mn-Cu mixed oxide catalysts were prepared by a co-precipitation method and used for the low temperature (< $200^{\circ}C$) selective catalytic reduction (SCR) of NOx with $NH_3$. Physicochemical properties of these catalysts were characterized by BET, XRD, XPS, and TPD. Mn-Cu mixed oxide catalysts were found to be amorphous with a large surface and they showed high SCR activity. Experimental results showed that the addition of $TiO_2$ to Mn-Cu oxide enhanced the SCR activity and $N_2$ selectivity. Ti addition led to the chemically adsorbed oxygen species that promoted the oxidation of NO to $NO_2$ and increased the number of $NH_3$ adsorbed-sites such as $Mn^{3+}$.

• Journal of the Korean Applied Science and Technology
• /
• v.33 no.1
• /
• pp.129-135
• /
• 2016

CO oxidation was performed with Cu-Mn and Cu-Zn co-precipitated catalysts as differential precipitant, metal ratio and calcination temperature. The effects of differential metal mole ratio and calcination temperature in mixed metal oxide catalyst were investigated with CO oxidation reaction. Physiochemical properties were studied by XRD, $N_2$ sorption and SEM. 2Cu-1Mn with $Na_2CO_3$ catalyst calcined at $270^{\circ}C$ has a large surface area $43m^2/g$ and the best activity for CO oxidation. $Cu_{0.5}Mn_{2.5}O_4$ in XRD peak shows the lower activity than others. The catalytic activity over the catalyst calcined $270^{\circ}C$ displayed the highest conversion, and it was better activity comparing with Pt catalysts CO conversion.

• Journal of the Korean Applied Science and Technology
• /
• v.33 no.2
• /
• pp.401-410
• /
• 2016

The $Pt-Sn/Al_2O_3$ catalysts mixed with metal oxides for propane dehydrogenation were studied. $Cu-Mn/{\gamma}-Al_2O_3$, $Ni-Mn/{\gamma}-Al_2O_3$, $Cu/{\alpha}-Al_2O_3$ was prepared and mixed with $Pt-Sn/Al_2O_3$ to measure the activity for propane dehydrogenation. As standard sample, $Pt-Sn/Al_2O_3$ catalyst mixed with glassbead was adopted. In the case of catalytic activity test after non-reductive pretreatment of catalyst and metal oxide, $Pt-Sn/Al_2O_3$ mixed with $Cu-Mn/{\gamma}-Al_2O_3$ showed higher conversion of 15% and similar selectivity at $576.5^{\circ}C$, compared to conversion of 8% in standard sample. In the case of catalytic activity test after reductive pretreatment of catalyst and metal oxde, $Cu/{\alpha}-Al_2O_3$ showed higer yield than standard sample. But, increase of yield of most of samples after reductive pretreatment was not significant, so it was found that lattice oxygen of $Cu-Mn/{\gamma}-Al_2O_3$ is effective to propane dehydrogenation.

• Journal of Korean Society of Environmental Engineers
• /
• v.28 no.3
• /
• pp.249-256
• /
• 2006

Catalytic combustion of toluene was investigated on the Cu-Mn oxide catalysts prepared by the impregnation(Imp) and the deposition-precipitation(DP) methods. The mixing of copper and manganese has been found to enhance the activity of catalysts. It is then found that catalytic efficiency of the Cu-Mn oxide catalyst prepared by the DP method on combustion of toluene is much higher than that of the Cu-Mn oxide catalyst prepared by Imp method with the same chemical composition. The catalyst prepared by the deposition-precipitation method observed no change of toluene conversion at time on stream during 10 days and at the addition of water vapor. On the basis of catalyst characterization data, it has been suggested that the catalysts prepared by the DP method showed uniform distribution and smaller particle size on the surface of catalyst and then enhanced reduction capability of catalysts. Therefore, we think that the DP method leads on progressive capacity of catalyst and promotes stability of catalyst. It was also presumed that catalytic conversion of toluene on the Cu-Mn oxide catalyst depends on redox reaction and $Cu_{1.5}Mn_{1.5}O_4$ spinel phase acts as the major active sites of catalyst.

• Proceedings of the KAIS Fall Conference
• /
• 2012.05a
• /
• pp.30-32
• /
• 2012

본 연구에서는 Cu, Mn을 함침 시킨 상용 제올라이트13X 촉매에 CO 산화 전환 반응에 영향을 연구하였다. 촉매 제조는 담지량별로 Cu, Mn을 서로 다른 비율로 물리 혼합하여 상용 제올라이트에 담지하였다. 함침방법은 과잉용액 함침법을 사용하였고, 건조 후 공기분위기에서 소성하여 산화물 형태로 담지하였다. 기본적인 촉매 특성은 X-선 회절분석, 질소흡탈착 등온곡선을 이용하여 기공크기, 기공부피, 비표면적을 구하였으며, FT-IR, 주사현미경, $NH_3$-TPD/TPR, EDX로 특성을 분석하였다. 촉매 산화반응 실험은 고정층 반응기에서 수행하였으며, 외경1/4 inch(내경 4 mm)석영관에 촉매를 중진하고 Gas Chromatograph로 배출가스를 측정하여 Cu-Mn 제올라이트 촉매의 일산화탄소 산화반응을 연구하였다. 일산화탄소 농도, 온도 및 공간속도, Cu-Mn 함량 비율에 따른 산화반응 실험을 수행하여 최적 산화조건과 촉매를 도출하였다.

• Proceedings of the KAIS Fall Conference
• /
• 2012.05a
• /
• pp.33-35
• /
• 2012

본 연구에서는 전이금속 Cu, Mn이 함침된 제올라이트를 사용하여 일산화탄소의 흡착능을 연구하였다. 금속 복합 산화물촉매 제조는 Cu, Mn을 서로 다른 비율로 물리 혼합하여 지지체에 담지하였다. 제올라이트 분자체는 상용 13X를 사용하였다. 함침방법은 과잉용액 함침법을 사용하였고, 건조 후 소성 하여 산화물 형태로 담지하였다. 합성된 개질 흡착제의 표면특성 분석은 $N_2$흡착 및 탈착곡선을 통한 질소흡착 특성 분석으로 기공크기, 기공분포, 비표면적을 구하였으며, FT-IR, X-선 회절분석, 전자주사현미경, $NH_3$-TPD/TPR 으로 특성을 분석하였다. 흡착 실험은 고정층 반응기에서 수행하였으며, 내경 4 mm 석영관에 흡착제를 충진하고 흡착파과곡선을 Gas Chromatograph로 측정하여 Cu-Mn 제올라이트 촉매의 일산화탄소 흡착 성능을 연구하였다. Cu-Mn 함량 비율과 흡착조업조건에 따른 흡착능을 측정하여 최적 흡착조건을 구하였다.

• Proceedings of the Korean Institute of Industrial Safety Conference
• /
• 2002.11a
• /
• pp.301-304
• /
• 2002

화재대피용 방독마스크의 주요한 기능은 상온에서의 일산화탄소 제거이며, 가장 효과적인 방법은 촉매에 의한 것이다. 일산화탄소 제거를 위한 호흡용 보호구의 정화통 충진재로써 범용으로 쓰이는 촉매는 Hopcalite로 Cu와 Mn이 혼합된 산화물 촉매이다. 그러나 이들 촉매는 상온에서 CO의 제거효율이 낮아 많은 양을 충진해야 하는 어려움이있다.(중략)

• The Korean Journal of Quaternary Research
• /
• v.10 no.1
• /
• pp.27-52
• /
• 1996

금강 퇴적물의 지화학적 특성을 파악하기 위하여 상류에서 하류까지 21개의 표층 퇴적물을 채취하고 총금속(Al, Fe, Mn, Cr, Co, Ni, Cu, Zn, Pb) 입도별 금속 및 존재형태별 금속을 분석하였다. 또한 하천에서 연안역까지 미량금속의 공간적 변화를 보기 위해 부유물 을 일정 간격으로 채취하여 미량금속을 분석하였다. 퇴적물 중 미량 금속 함량을 평균 입도 와 밀접히 관계하여 변화하며 세립질실트 이하 부분에서 가장높은 함량을 보였고 이 높은 함량은 하천 부유물 중 금속 함량과 Mn을 제외하고 거의 유사한 수준이었다. Pb은 조립질 모래에서도 높은 함량을 보이는데 이는 조립질 모래에 많이 포함된 정장석에 의한 영향이 되고 세립질 실트에서의 높은 금속 함량은 세립한 중광물에 의한 영향이다. Mn과 Pb을 제 안한 금속들은 퇴적물 중 주로(70% 이상) 결정 격자와 관계하여 존재하는데 이는 퇴적물의 주구성 입도가 조립하여 금속이 풍부하고 세립한 중광 물에 의한 영향이 크기 때문이다. 하 천에서 염하구로 금속 함량이 급격히 감소하는데 이는 용존 $Mn^{+2}$이온이 $MnO_2$로 변화하는 산화반응과 하천구역에서의 퇴적 그리고 염하구에서 금속이 적어 진 입자(염하구 내에서 유기물 분해/용해로 만들어지거나 재부유 작요에 의한 조립질 물질) 와 하천 부유물과의 혼합작용에 의해 이루어진다.

• Applied Chemistry for Engineering
• /
• v.5 no.2
• /
• pp.327-336
• /
• 1994

The synergistic effects in mechanical mixture catalysts of Mo-V-O and metal oxide were investigated for the selective oxidation of acrolein. The metal oxides used are $SnO_2$, ${\alpha}-Sb_2O_4$, $WO_3$, ${\alpha}-Al_2O_3$, CuO, $MnO_2$, $Cu_2O$, MgO, CoO, and ZnO. Mechanical mixtures of Mo-V-O plus $SnO_2$ or ${\alpha}-Sb_2O_4$ had resulted in higher conversion of acrolein and higher yield of acrylic acid than Mo-V-O. The origin of the synergy is attributed to the cooperation of Mo-V-O and $SnO_2$ or ${\alpha}-Sb_2O_4$, in which $SnO_2$ or ${\alpha}-Sb_2O_4$ forms dissociated oxygens at their oxygen vacancies and transports them to Mo-V-O. $Cu_2O$, MgO, CuO, and $MnO_2$, increased conversion of acrolein but decreased yield of acrylic acid. CoO and ZnO inhibited the catalytic performance of Mo-V-O. The different role of these metal oxides is explained in terms of their oxidation-reduction properties.