• The Journal of Korean Institute of Communications and Information Sciences
• /
• 제23권4호
• /
• pp.926-931
• /
• 1998

In this paper, a code sequence generation method of the Suehiro sequence is suggested. In this method, a code sequence is generated only with integer sums and modular techniques. the auto-correlation and cross-correlation characteristics of the sequence generated by the method are investigated. The sequence generated by the suggested method has the orthogonality and satisfies the mathematical lower bound of the cross-correlation.

• The Journal of the Acoustical Society of Korea
• /
• 제39권3호
• /
• pp.207-215
• /
• 2020

There are several methods for the time delay estimation between signals to two receivers. Among these methods, Generalized Cross Correlation (GCC), which estimates the relative delay from the cross-correlation between the different signals at the two receivers, is a traditionally well-known method. However, when using a narrow band Continuous Wave (CW) signal, the GCC method degrades the estimation performance from relatively higher signal-to-noise ratio than when using a wideband signal. To improve this phenomenon, this paper examines four different pre-processors for GCC using narrow band single frequency signals. Simulation shows that the performance gain of the preprocessed GCC is up to 9 dB for a 100 msec CW signal as well as up to 4 dB for a 1 s CW signal.

• The Journal of the Acoustical Society of Korea
• /
• 제36권5호
• /
• pp.345-352
• /
• 2017

We propose a methods which is reducing direction estimation error of sound source in the reverberant and noisy environments. The proposed algorithm divides speech signal into voice and unvoice using VAD. We estimate the direction of source when current frame is voiced. TDOA (Time-Difference of Arrival) between microphone array using the GCC-PHAT (Generalized Cross Correlation with Phase Transform) method will be estimated in that frame. Then, we compare the peak value of cross-correlation of two signals applied to estimated time-delay with other time-delay in time-table in order to improve the accuracy of source location. If the angle of current frame is far different from before and after frame in successive voiced frame, the angle of current frame is replaced with mean value of the estimated angle in before and after frames.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• 제29권3B호
• /
• pp.259-267
• /
• 2009

Generalized Extreme Value (GEV) distribution is recommended for flood frequency and extreme rainfall distribution in many country. L-moment method is the most common estimation procedure for the GEV distribution. In this study, the relationships between the cross-site correlations between extreme events and the cross-correlation of estimators of L-moment ratios (L-moment Coefficient of Variation (L-CV) and L-moment Coefficient of Skewness (L-CS)) for data generated from GEV distribution were derived by Monte Carlo simulation. Those relationships were fit to the simple power function. In this Monte Carlo simulation, GEV+ distribution were employed wherein unrealistic negative values were excluded. The simple power models provide accurate description of the relationships between cross-correlation of data and cross-correlation of L-moment ratios. Estimated parameters and accuracies of the power functions were reported for different GEV distribution parameters combinations. Moreover, this study provided a description about regional regression approach using Generalized Least Square (GLS) regression method which require the cross-site correlation among L-moment estimators. The relationships derived in this study allow regional GLS regression analyses of both L-CV and L-CS estimators that correctly incorporate the cross-correlation among GEV L-moment estimators.

• Proceedings of the Acoustical Society of Korea Conference
• /
• 한국음향학회 2004년도 춘계학술발표대회 논문집 제23권 1호
• /
• pp.225-230
• /
• 2004

Leak noise is a good source to identify the exact location of a leak point of underground water pipelines. Water leak generates broadband noise from a leak location and can be propagated to both directions of water pipes. However, the necessity of long-range detect ion of this leak location makes to identify low-frequency acoustic waves rather than high frequency ones. Acoustic wave propagation coupled with surrounding boundaries including cast iron pipes is theoretical analyzed and the wave velocity was confirmed with experiment The leak locations were identified both by the acoustic emission (AE) method and the cross-correlation method. In a short-range distance, both the AE method and cross-correlation method are effective to detect leak position. However, the detect ion for a long-range distance required a lower frequency range accelerometers only because higher frequency waves were attenuated very quickly with the increase of propagation paths. Two algorithms for the cross-correlation function were suggested and a long-range detection has been achieved at real underground water pipelines longer than 300m.

• Transactions of The Korea Fluid Power Systems Society
• /
• 제6권1호
• /
• pp.1-9
• /
• 2009

This study presents an analytical model of an automotive steering hose containing tuner(flexible spiral metal tube) to reduce the ripple pressure induced by steering vane pump. The double-wall side branch composed in a steering hose containing tuner was analogically considered as a filter in a conduit. Specialized test equipment was manufactured for the estimation of speed of sound in a conduit and measurement of amplitude ratio between the propagated ripple pressures of inlet and outlet of the steering hose. Experimental data of entire frequency ranges can be obtained through the test once in short time. The results of three points' measurement method and cross-correlation method to estimate the speeds of sound in a hose, tuner, and side branch respectively reveal that cross-correlation method can be used practically. The results of simulation and experiment were so close, especially in the range of engine idling speed, that the proposed analytical model in this study was validated. Sensitivity analyses and experiments show that longer tuner is preferable, and that the positive-positive composition of the steering hoses containing tuner is superior to others to attenuate ripple pressure.

• Journal of information and communication convergence engineering
• /
• 제9권6호
• /
• pp.747-752
• /
• 2011

The position detection of overlapping area in the interframe for image stitching using auto and cross correlation function (ACCF) and compounding one image with the stitching algorithm is presented in this paper. ACCF is used by autocorrelation to the featured area to extract the filter mask in the reference (previous) image and the comparing (current) image is used by crosscorrelation. The stitching is detected by the position of high correlation, and aligns and stitches the image in shifting the current image based on the moving vector. The ACCF technique results in a few computations and simplicity because the filter mask is given by the featuring block, and the position is enabled to detect a bit movement. Input image captured from CMOS is used to be compared with the performance between the ACCF and the window correlation. The results of ACCF show that there is no seam and distortion at the joint parts in the stitched image, and the detection performance of the moving vector is improved to 12% in comparison with the window correlation method.

• Journal of information and communication convergence engineering
• /
• 제8권2호
• /
• pp.163-167
• /
• 2010

In underwater acoustic communication, acoustic signals from transducers or hydrophones are used. And the underwater acoustic communication channels are very complicated, because of vertical distribution of acoustic velocity according depths, and reflections from boundaries like as surface or bottom. For the implementation of the underwater acoustic communication channel, the image method or ray tracing method have been used. In this paper, we introduce a new approach for implementation of underwater acoustic communication channel using the simulation of the Transmission Line Matrix Modeling and cross-correlations from the input and output signals.

• Communications for Statistical Applications and Methods
• /
• 제14권2호
• /
• pp.301-307
• /
• 2007

A effective teaching method on correlation coefficient for elementary level statistics course is discussed in this article. The well known inequalities, such as Theorem 368 of Hardy et al. (1952), are used for the interpretation of concept of covariance. An Excel example is provided for the illustration of concept of correlation coefficient.

• Industrial Engineering and Management Systems
• /
• 제1권1호
• /
• pp.79-86
• /
• 2002

This paper proposes a new algorithm for estimating ARMA model parameters. In estimating ARMA model parameters, several methods such as generalized least square method, instrumental variable method have been developed. Among these methods, the utilization of a bootstrap type algorithm is known as one of the effective approach for the estimation, but there are cases that it does not converge. Hence, in this paper, making use of a cross correlation function and utilizing the relation of structural a priori knowledge, a new bootstrap algorithm is developed. By introducing theoretical relations, it became possible to remove terms, which is liable to include much noise. Therefore, this leads to robust parameter estimation. It is shown by numerical examples that using this algorithm, all simulation cases converge while only half cases succeeded with the previous one. As for the calculation time, judging from the fact that we got converged solutions, our proposed method is said to be superior as a whole.