• 한국자동차공학회논문집
• /
• 제17권5호
• /
• pp.115-126
• /
• 2009

This paper studied on the application of the crashworthiness regulations of Korean Railway Safety Law and Urban Transit Safety Law to the urban Maglev vehicle of KIMM. The Urban Maglev vehicle has to comply with the crashworthiness regulations for urban transit vehicles. The collision load cases have been simulated by using explicit finite element analysis. From the numerical results, the crashworthiness regulations of the Urban Transit Safety Law were completely satisfied, but maximum crash pulse requirement in 25 km/h crash event and no plastic deformation requirement in 10 km/h crash event in the Korean Railway Safety Law were not. If a commercial urban Maglev vehicle is developed in the near future, it is necessary that some soft buffing and energy absorbing devices are adopted in its front end so as to satisfy the crashworthiness regulations of the Korean Railway Safety Law.

• 대한인간공학회지
• /
• 제13권1호
• /
• pp.15-25
• /
• 1994

Based on Fatal Accident Reporting System (FARS) data, safety belt effect- tiveness in preventing fatalities is investigated for the following five types of crashes: frontal, left, rear, right, and rollover. Passenger cars containing two occupants, a driver and a right front passenger, are included in this analysis. For each crash type, these cars containing the two occupants are classified into four categories according to the safety belt usage categories for the two front seat occupants, namely, both belted, both unbelted, and either one was belted but not both. Relative risks of driver and right front passenger fatalities are compared among these four cases. For each crash type, two independent estimates of safety belt effectiveness are obtained for drivers and for right front passengers. The weighted average of the two estimates is calculated for drivers and for right front passengers for the five crash types. Using FARS data starting 1978 throught 1983, safety belts are more effective in rollover accidents than in frontal collisions. In rollover accidents, safety belt effectiveness estimate for drivers is $68%{\pm} 6% $ and that for right front passengers is $71%{\pm}6% $ , in which the error limits indicate one standard error. Sfety belt effectiveness estimates for drivers and right front passengers involved in frontal collisions are $41%{\pm} 9% $ and $37%{\pm} 10% $ , respectively. For left and right sided collisions and for both drivers and right-front-passengers, none of the four estimates are significantly different from 0%, statistically : however, when left and right sided collisions are combined with far sided occupants(drivers involved in right sided collisions and right front passengers involved in left sided collisions) safety belt effectiveness is significant, $38%{\pm} 12% $ . For rear collisions, the estimate for drivers shows statistically significant positive effect, $60%{\pm}23% $ . while for right-front-passengers the estimate is not significantly different from 0%. These results show that a safety belt is an effective restraint system not only in frontal crashes but also in a variety of crashes.

• 한국산학기술학회논문지
• /
• 제17권3호
• /
• pp.171-176
• /
• 2016

본 논문은 도로안전시설물의 공용중 부식 발생으로 인한 기능 손실을 줄일 수 있는 방안으로 고내식성 용융합금도금 강판을 적용한 도로안전시설물을 제안한다. 고내식성 용융합금도금강판을 적용한 도로안전시설물 제품에 대한 신뢰성 있는 충돌성능 평가 기초자료를 제공할 목적으로 고내식강이 적용된 교량난간 제품에 대한 충돌 시뮬레이션 및 실물 차량 충돌시험 연구를 수행한다. 시뮬레이션 및 실차충돌 시험 결과, 변형률 속도 의존성을 고려할 수 있는 정교한 동특성 재료모델을 도입한 충돌 시뮬레이션을 통해 얻어지는 충돌 거동과 실물 차량 충돌 시험 결과가 매우 유사한 것으로 도출되었다. 본 논문에서 제안된 고내식성 용융합금도금 강판을 적용한 교량난간은 실물 차량 충돌 시험의 충돌성능 평가 기준을 모두 충족시켜 현장 적용을 앞두고 있다.

• 수산해양교육연구
• /
• 제28권1호
• /
• pp.221-234
• /
• 2016

Open port has the designated course and traffic jam of ships happens often. This fact may connect to ship crash easily. And the accident happens due to violation of navigation mainly. In ship crash between Neoblue and Shinkwang 7 at incheon open port, the Korean incheon maritime safety tribunal shows that the violation of navigation and duty of attention at the open port would produce ship crash directly. Wherefore, the interpretation and application of navigation are important to protect future ship crash accident. The points of navigation as objects of study are divided into two categories, interpretation and application of navigation on crashing between the ship which navigate the designated course and the ship which enter into the designated course from the another course or outside the course, interpretation and application of navigation on crashing between two or more ships, which navigate violating the navigation every ships and violating agreement rule each other. And as conclusion, I refer the legal responsibility both Neoblue and Shinkwang 7 in detail. The results of this study as follows : First, in case of crashing between the ship which navigate the designated course and the ship which enter into the designated course from the another course or outside the course, public order in open port act can be applied by priority. However, in applying the public order the principle of trust and reasons of crew, cause and effect, the time of navigation application are mandatory considerations. Second, in case of crashing between two or more ships, which navigate violating the navigation every ships and violating agreement rule each other, we should focus on the reasons of crew. Also, the reasons of crew need strict conditions. These means that the awareness of crash danger and recognition of special circumstance including limit state of ships, existence of emergency danger, non escaping crash danger by only observance of navigation. And in case of this state the public order the principle of trust and reasons of crew, cause and effect, the time of navigation application should be considered by priority, too.

• 자동차안전학회지
• /
• 제6권1호
• /
• pp.5-9
• /
• 2014

Over the past ten years, since the introduction of the side crash test regulation in Europe, much research work has been performed internationally to develop new and modified test procedures to improve the level of occupant protection offered by vehicles in side crash test. This research has been co-ordinated and finally contributed to development of an AE-MDB(Advanced European Moving Deformable Barrier) and WorldSID (Worldwide Side Impact Dummy). EuroNCAP(European New Car Assessment Program) has the plan to conduct AE-MDB side crash test using WorldSID from 2015 by replacing Progressive MDB and EuroSID II. Automobile manufacturers need to respond to these changes closely. This paper is to find dominant control factor and analyze it of WorldSID 50%ile dummy injury through AE-MDB side crash test by predicting best and worst condition. And control factors will be validated within EuroNCAP regulations. This paper is analyzed by DFSS(Design for six sigma) which contains 5 control factors and is evaluated by ANOVA with the data as a result of LS-DYNA analysis correlated with crash pulse from 50 kph AE-MDB side crash test using WorldSID 50%ile dummy.

• 한국자동차공학회논문집
• /
• 제9권2호
• /
• pp.116-129
• /
• 2001

Traditional occupant analysis has been performed with a pre-determined crash puse which is produced from a test and the involved components are designed based on the analysis resuls. The method has limitations in that the design does not have much freedom. Howrver, if a good crash pulse is proposed, the body structure can be modified to generate the crash pulse. Therefore, it is assumed that the crash pulse can be changed to imptove the occupant crash performance. A preferable crash pulse is determined to minimize the occupant injuty. A constraint is established to keep the phenomena of physics valid. The response surface method(RSM) is adopted for the optimization process. An RSM in a commercial code is utilzed by interfacing with an in-house occupant analysis program called SAFE(Safety Analysis For occupant crash Enviroment). Design of involved components called is carried out through optimization with the RSM. The advantages of the RSM are investigated as opposed to other methods, and the tesults are compared. Also, the design under the new crach pulse is compared with that trom the pre-detetmined pulse.

• 대한토목학회논문집
• /
• 제42권3호
• /
• pp.399-407
• /
• 2022

도로안전시설 설치 및 관리 지침 차량방호 안전시설 편에서 충격흡수시설은 실물충돌시험을 통해 성능 기준을 만족하는 제품만을 현장에 설치하도록 하고 있다. 그러나 기존의 설치된 충격흡수시설의 경우 설치 환경에 따라 방호해야할 구조물과의 폭 차이로 인하여 방호성능을 발휘하지 못하는 문제점이 있다. 이에 본 연구에서는 다양한 환경에 적용하기 위하여 높이 150 mm의 W형 가드레일을 200 mm 간격으로 4단 배치하는 충격흡수시설을 LS-DYNA 컴퓨터 시뮬레이션을 이용하여 개발하고 실물충돌시험을 통하여 성능 기준을 검증하였다. 시뮬레이션을 통해 개발한 충격흡수시설이 CC2등급의 성능 기준을 만족한다는 것을 실물충돌시험으로 확인하였고 시뮬레이션 결과와 실물충돌시험 결과를 비교 분석하여 충돌 시뮬레이션의 결과가 유의미하다는 것을 확인하였다.

• 한국자동차공학회논문집
• /
• 제15권5호
• /
• pp.72-77
• /
• 2007

Since 2000, sports utility vehicles(SUVs) occupy about 40% of domestic vehicle sales. As sports utility vehicle sales are increased the probability of crash accident between SUVs and passenger vehicles increases. Generally, SUVs are heavier than passenger vehicles and their drive height and front end stillness are higher than passenger vehicles. Because of these characteristics SUVs cause more severe injury and fatal injury in SUV to passenger vehicle head-on impact. To evaluate SUV's aggessivity to passenger vehicle, we carried out SUV to passenger vehicle head-on crash test. And finally the way how to reduce incompatibility between SUVs and passenger vehicles is suggested.

• 복합신소재구조학회 논문집
• /
• 제5권2호
• /
• pp.15-20
• /
• 2014

This study carried out passenger safety assessment by real car crash simulation of composite post structures for road facilities. The effects of different material properties of composites for various parameters are studied using the LS-DYNA finite element program for this study. In this study, the existing finite element analysis of steel post structures using the LS-DYNA program is further extended to study dynamic behaviors of the structures made of various composite materials. The numerical results for various parameters are verified by comparing different models with displacements and stress distribution occurred in the post and car.

• 자동차안전학회지
• /
• 제9권1호
• /
• pp.13-18
• /
• 2017

In recent years, NCAP regulations of many countries have induced automaker to improve the vehicle crashworthiness. But, the current NCAP regulations don't cover all types of traffic accidents. And rapid-increasing market share of compact cars and SUVs has brought for both consumer and automaker to pay more attention on crash compatibility. So, many countries have tried to develop the new crash test mode and update the present crash test mode. Especially, Euro NCAP has been developing a new impact protocol of the car-to-car frontal offset impact including the crash compatibility assessment. There are plans to introduce this new protocol in 2020, and it will be replaced the current Euro NCAP frontal offset impact. The test dummy in the front seats of this new test mode will be changed from 50% Hybrid-III male to 50% THOR male. This paper will address the vehicle responses, the occupant responses and the vehicle compatibility performance from a full vehicle crash test using the new car-to-car frontal offset test protocol of Euro NCAP.