• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2001년도 하계학술대회 논문집 B
• /
• pp.1101-1104
• /
• 2001

This paper describes a newly developed power conditioner with variable current loop gain. The power conditioner consists of a do-link capacitor and three phase inverter with coupled inductor. This system is very well operated to compensate current harmonics and asymmetries caused by nonlinear load and unbalance loads. The power conditioner shapes the source current sinusoidal in phase with source voltage. A 100kVA power conditioner was built and the controller is realized with DSP Experimental results for many load conditions are presented to verify the performance of the controller.

• Macromolecular Research
• /
• 제15권6호
• /
• pp.575-580
• /
• 2007

Water-soluble, chiral conducting, poly(diphenylamine) (PDPA) nanocomposites were synthesized by chemical oxidative polymerization of diphenylamine in the presence of poly(acrylic acid) (PAA) as a template and camphor sulphonic acid (CSA) as the chiral inductor, Composites were formed as stable aqueous dispersions under different experimental conditions, such as DPA to PAA molar ratios, PAA molecular weight, etc. Circular dichroism(CD) spectra of the composites indicated the induction of chirality to PDPA. Compared to simple chiral PANI, the PDPA/PAA/CSA nanocomposites showed a different Cotton effect. The appearance of a CD band in the composite was complimentary to the bisignate, exciton-coupled band in the UV-Visible spectrum. FTIR spectra indicated the intimate mixing of PDPA and PAA.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2008년도 추계학술대회 논문집 Vol.21
• /
• pp.84-85
• /
• 2008

In this paper, differential cross coupled LC VCOs with two noise frequency filtering techniques are proposed. Both VCOs are based on symmetric capacitor with asymmetric inductor tank structure. The VCO using low pass filtering technique shows low phase noise of -130.40 dBc/Hz at 1 MHz offset when the center frequency is 1.619 GHz. And the other VCO using band pass filtering technique shows -127.93 dBc/Hz at 1 MHz offset frequency when center frequency is 1.604 GHz. Two noise frequency filtering techniques are approached with different target.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2000년도 춘계학술대회논문집
• /
• pp.1204-1209
• /
• 2000

Many analytical and experimental studies on the active suppression of nonlinear panel flutter by using piezoceramic patch have been carried out. However, these active control methods have a few important problems; a large amount of power is required to operate actuators, and additional apparatuses such as sensor systems and controller are needed. In this study passive suppression schemes for nonlinear flutter of composite panel, which is believed to be more robust suppression system than active control in practical operation, are proposed by using piezoelectric inductor-resistor series shunt circuit. Toward the end, a finite element equation of motion for an electromechanically coupled system is proposed using the Hamilton's principle. To achieve the best damping effect, optimal shape and location of the piezoceramic(PZT) patches are determined by using genetic algorithms. The results clearly demonstrate that the passive damping scheme by using piezoelectric shunt circuit can effectively attenuate the flutter.

• 전기학회논문지
• /
• 제57권5호
• /
• pp.816-820
• /
• 2008

The RF inductive discharge of inductively couples plasma (ICP) continues to attract growing attention as an effective plasma source in many industrial applications, the best known of which are plasma processing and lighting technology. Although most practical ICPs operate at 13.56 [MHz] and 2.65 [MHz], the trend to reduce the operating frequency is clearly recognizable from recent ICP developments. In an electrodeless fluorescent lamp, the use of a lower operating frequency simplifies and reduces cost of RF matching systems and RF generators and can eliminate capacitive coupling between the inductor coil and plasma, which could be a strong factor in wall erosion and plasma contamination. In this study, We discussed simulation and experimental results when changing ferrite position in antenna.

• 한국철도학회:학술대회논문집
• /
• 한국철도학회 1999년도 춘계학술대회 논문집
• /
• pp.328-335
• /
• 1999

Three phase full bridge rectifier has been used to obtain dc voltage from three phase ac voltage source. The rectifier system has drawbacks that power factor is low and power flow is unidirectional. Therefore, when dc voltage increases due to regeneration of power the dynamic resister for dissipation of regeneration power must be installed. But three phase PWM converter can be controlled to operate with unity power factor and bidirectional power flow. Therefore when the PWM converter is used as do supply system, the dissipating resistor is not necessary. On this thesis, in order to design a controller having good performance, the hee phase PWM converter is completely modeled by using circuit DQ-transformation and thus a general and simple instructive equivalent circuit is obtained; the inductor set becomes a second order gyrator-coupled system and three phase inverter becomes a transformer as well. Under given phase angle(${\alpha}$) and modulation index(MI) of the three phase inverter, the dc and ac characteristics are obtained by analysis of the transformed equivalent circuit The validity of the equivalent circuit is confirmed through PSPICE simulation. And based on the dc and ac characteristics a controller with unity power factor is proposed.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2005년도 전력전자학술대회 논문집
• /
• pp.511-513
• /
• 2005

In this paper, the electrical characteristics of the non-contact transformer is presented using conventional coupled inductor theory. In high power applications, the non-contact transformer is so bulky and heavy that it poses some maintenance problems. Therefore it should be divided into some light transformer modules. This paper shows the analytic method of how to measure the parameters of the multiple connected non-contact transformer The analytical results are verified through measurement.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2018년도 전력전자학술대회
• /
• pp.428-429
• /
• 2018

본 논문은 결합 인덕터를 이용한 입력 전류 리플이 없는 고승압 캐스케이드 부스트 DC-DC 컨버터를 제안한다. 기존 캐스케이드 부스트 컨버터의 단점을 보완하기 위해 제안되었다. 제안된 컨버터는 1차 부스트 단의 보조회로에 의해 입력 전류 리플이 상당히 제거되었으며 2차 부스트 단에 결합 인덕터를 적용하여 높은 전압 이득을 달성하였다. 제안된 컨버터는 이론적 해석과 200[V]-200[W]하드웨어 시작품을 제작하여 검증하였다.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2013년도 전력전자학술대회 논문집
• /
• pp.401-402
• /
• 2013

최근 화석에너지의 고갈과 환경문제, 그리고 원유가 폭등 등의 이유로 신재생에너지의 혁신적인 기술과 보급이 시급하다. 태양광 및 풍력에너지는 무한정 청정에너지로서 세계적으로 많은 연구개발이 진행되고 있다. 풍력 및 태양광을 같이 병행해 사용하면 기상조건에 대한 상호보완적인 효과를 볼 수 있지만 인덕터가 차지하는 공간이 늘어나 컨버터의 부피가 커지고 비용이 증가하는 단점이 있다. 본 논문에서는 인덕터 두 개를 하나의 결합 인덕터로 사용한 풍력/태양광 하이브리드 일체형 컨버터를 제안하고, 최적의 결합계수를 선정하여 입력 전류리플의 저감을 시뮬레이션을 통해 검증한다.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2013년도 전력전자학술대회 논문집
• /
• pp.190-191
• /
• 2013

본 논문에서는 고역률 및 고효율 동작이 가능한 단일 전력단 forward-flyback 컨버터를 제안한다. 기존 단일전력단 forward 컨버터의 경우, 입력 전압이 출력 전압보다 낮은 경우 Dead zone 구간이 발생하여 고역률 획득이 어려우며, 자화 인덕터 offset 전류가 크기 때문에 자기소자의 손실로 인한 고효율 동작이 어렵다. 본 논문에서 제안하는 forward-flyback 컨버터는 2차 측에 삽입된 DC 블러킹 캐패시터에 의해 자화 인덕터의 offset 전류를 감소 할 수 있고, 입력 전압에 관계 없이 항상 출력 측으로 에너지를 전달 할 수 있으므로 고효율 및 고역률 획득에 유리하다. 또한 coupled inductor를 사용한 출력 인덕터에 의해 출력 다이오드에는 각 각 동일한 전류가 흐르며, 전압 스트레스를 감소시킬 수 있는 장점이 있다. 제안된 단일 전력단 forward-flyback 컨버터의 타당성을 검증을 위하여 45W급 LED 전원 공급장치의 시작품 제작을 통한 실험 결과를 제시한다.