• KSII Transactions on Internet and Information Systems (TIIS)
• /
• 제15권8호
• /
• pp.2900-2922
• /
• 2021

In this paper, the power spectral density(PSD) for Multilevel Minimum Shift Keyed signal with modulation index h = 1/2 (M-ary MSK) are derived using the mathematical method of the Markov Chain model. At first, according to an essential requirement of the phase continuity characteristics of MSK signals, a complete model of the whole process of signal generation is built. Then, the derivations for autocorrelation functions are carried out precisely. After that, we verified the correctness and accuracy of the theoretical derivation by comparing the derived results with numerical simulations using MATLAB. We also divided the spectrum into four components according to the derivation. By analyzing these figures in the graphic, each component determines the characteristics of the spectrum. It is vital for enhanced spectral characteristics. To more visually represent the energy concentration of the main flap and the roll-down speed of the side flap, the specific out-of-band power of M-ary MSK is given. OMLCD(Optimum Maximum Likelihood Coherent Detection) of M-ary MSK is adopted to compare the signal received with prepared in advance in a code element T to go for the best. And M-ary MSK BER(Bit Error Rate) is compared with the same ary PSK (Phase Shift Keying) with M=2,4,6,8. The results show the detection method could improve performance by increasing the length of L(memory inherent) in the phase continuity.

• ETRI Journal
• /
• 제42권1호
• /
• pp.54-66
• /
• 2020

Nowadays, the broad availability of cameras and embedded systems makes the application of computer vision very promising as a supporting technology for intelligent transportation systems, particularly in the field of vehicle tracking. Although there are several existing trackers, the limitation of using low-cost cameras, besides the relatively low processing power in embedded systems, makes most of these trackers useless. For the tracker to work under those conditions, the video frame rate must be reduced to decrease the burden on computation. However, doing this will make the vehicle seem to move faster on the observer's side. This phenomenon is called the fast motion challenge. This paper proposes a tracker called dynamic swarm particle (DSP), which solves the challenge. The term particle refers to the particle filter, while the term swarm refers to particle swarm optimization (PSO). The fundamental concept of our method is to exploit the continuity of vehicle dynamic motions by creating dynamic models based on PSO. Based on the experiments, DSP achieves a precision of 0.896 and success rate of 0.755. These results are better than those obtained by several other benchmark trackers.

• 설비공학논문집
• /
• 제9권2호
• /
• pp.144-152
• /
• 1997

Film absorption involves simultaneous heat and mass transfer in the vapor-liquid system. In the present work, the absorption process of water vapor by an aqueous soluton of LiBr flowing inside of the vertical tube was investigated. The continuity, momentum, energy and diffusion equations for the solution film and vapor were formulated in integral forms and solved numerically. The model could predict the film thickness, the pressure gradient, and the heat and mass transfer rate. Particularly the effects of vapor flow conditions on the absorption process were investigated in terms of the vapor Reynolds number. As the vapor Reynolds number increased, the shear stress at the vapor-solution interface also increased. Consequently solution film became thinner at higher vapor flowrate under the co-currentflow condition. Thinner film was capable of higher heat transfer to the wall and leaded to higher absorption rate of the water vapor into the solution film.

• 대한기계학회논문집
• /
• 제17권5호
• /
• pp.1150-1160
• /
• 1993

본 연구에서는 보압과정시 급속한 압력구배에 의한 관성항의 영향을 고려하기 위해 수정된 Hele-Shaw 모델과 압축열 발생항, 온도와 압력의 변화에 따른 수지의 밀 도 이완현상에 대한 모델의 도입 및 유한요소법을 이용한 수치해석적 방법을 제시하여 정확한 잔류압력을 구하고 성형조건 및 물성치에 따른 수지의 거동을 살펴보고자 한다.

• 대한기계학회논문집B
• /
• 제22권4호
• /
• pp.499-509
• /
• 1998

In the absorption process of water vapor in a liquid film, the composition of the gas phase, in which a non-absorbable gas is combined with the absorbate influences the transport characteristics remarkably. In the present study, the absorption processes of water vapor into aqueous solution of lithium bromide in the presence of non-absorbable gases were investigated analytically. The continuity, momentum, energy and diffusion equations for the solution film and gas phase were formulated in integral forms and solved numerically. It was found that the mass transfer resistance in gas phase increased with the concentration of non-absorbable gas. However the primary resistance to mass transfer was in the liquid phase. As the concentration of non-absorbable gas in the absorbate increased, the liquid-vapor interfacial temperature and concentration of absorbate in solution decreased, which resulted in the reduction of absorption rate. The reduction of mass transfer rate was found to be significant for the addition of a small amount of non-absorbable gas to the pure vapor, especially at the outlet of an absorber where non-absorbable gases accumulated. At higher non-absorbable gas concentration, the decrease of absorption flux was almost linear to the volumetric concentration of non-absorbable gas.

• 대한기계학회논문집B
• /
• 제28권12호
• /
• pp.1632-1639
• /
• 2004

Numerical calculation has been performed to investigate the transport phenomena in the horizontal reactor which has two different gas inlets for MOCVD(metalorganic chemical vapor deposition). The full elliptic governing equations for continuity, momentum, energy and chemical species are solved by using the commercial code FLUENT. It is investigated how thermal characteristics, reactor geometry, and the operating parameters affect flow fields, mass fraction of each reactants. The numerical simulations demonstrate that flow rate of each species, inlet geometry of the reactor, and its distance from the susceptor as well as the inclination of upper wall of reactor can be used effectively to optimize reactor performance. The commonly used idealized boundary conditions are also investigated to predict flow phenomena in the actual deposition system.

• 대한설비공학회:학술대회논문집
• /
• 대한설비공학회 2007년도 동계학술발표대회 논문집
• /
• pp.99-104
• /
• 2007

Tracer gas technique is widely used to measure the ventilation rates and/or ventilation effectiveness of building spaces. However, the conventional method using a single tracer gas can measure only outdoor air change rates in a single zone. This paper deals with the multi-gas tracer technique to measure air exchange rates between rooms. Interzonal air movements are important to characterize overall ventilation performance of complicated multi-zone buildings. Experiments are conducted in a simple two-room model with known airflow rates using tracer gases of SF6 and R134a. The concentration decays of two tracer gases are measured after simultaneous injections in each room. The governing equations are derived from the continuity and the mass balance of each room. The data reduction procedure are developed to obtain the inter-room airflow rates using the governing matrix inversion, and various data manipulation methods are tested, such as data shift, interpolation, smoothing, and etc, to improve the estimate and interpretation of the results.

• 한국컴퓨터정보학회논문지
• /
• 제18권2호
• /
• pp.59-68
• /
• 2013

LTE-Advanced 망에서 핸드오버가 발생하면 멀티미디어 트래픽의 전송이 지연 및 손실에 의하여 영향 받기 때문에, 일관된 QoS를 유지하기 위한 효율적인 자원 관리 방안이 필요하다. 본 논문은 핸드오버 시에 OFDMA 시스템에서 이종 트래픽의 QoS를 보장하기 위한 부하제어 기반의 자원 관리 방안을 제안한다. 이를 통하여 음성, 영상, 데이터 서비스 등 자원할당 요구 사항이 서로 다른 멀티미디어 서비스들의 서비스 연속성을 지원할 수 있다. 핸드오버 실패율과 패킷 손실률을 성능척도로 하여 수행된 시뮬레이션 결과에 의하면 제안된 방안은 기존 방안에 비하여 더 우수한 성능을 가짐이 확인된다.

• 인터넷정보학회논문지
• /
• 제24권2호
• /
• pp.1-10
• /
• 2023

The Multi-access Edge Computing (MEC) paradigm equips network edge telecommunication infrastructure with cloud computing resources. It seeks to transform the edge into an IT services platform for hosting resource-intensive and delay-stringent services for mobile users, thereby significantly enhancing perceived service quality of experience. However, erratic user mobility impedes seamless service continuity as well as satisfying delay-stringent service requirements, especially as users roam farther away from the serving MEC resource, which deteriorates quality of experience. This work proposes a deep reinforcement learning based service mobility management approach for ensuring seamless migration of service instances along user mobility. The proposed approach focuses on the problem of selecting the optimal MEC resource to host services for high mobility users, thereby reducing service migration rejection rate and enhancing service availability. Efficacy of the proposed approach is confirmed through simulation experiments, where results show that on average, the proposed scheme reduces service delay by 8%, task computing time by 36%, and migration rejection rate by more than 90%, when comparing to a baseline scheme.

• 한국농촌건축학회논문집
• /
• 제24권4호
• /
• pp.25-32
• /
• 2022

The purpose of this study is to provide design guidelines necessary for creating disability-friendly campuses. To this end, a literature survey and a survey on the current educational welfare facilities for disabled college students were conducted. The fact-finding survey was conducted in writing and visiting evaluations on 19 campuses located in Gangwon-do(province). The results of this study are summarized as follows: 1) The college enrollment rate of the disabled has doubled since 2000, but it was found to be half of the enrollment rate based on school enrollment, and the number of students who gave up in the middle is increasing. This is due to an obstacle in the learning environment, so it is necessary to improve welfare facilities. 2) As a result of evaluating the status of educational welfare support for students with disabilities, it was found that the overall evaluation result was improved, but the absolute evaluation result was less than 70%, and it was not improved. 3) As a result of evaluating the actual conditions of the intermediate facilities, indoor facilities, sanitary facilities, guidance and other facilities, and unit spaces, it is necessary to expand and improve them due to the lack of disabled parking marks, continuity of access roads, pedestrian safety passages, lifts, and rest areas for the disabled.