• Tunnel and Underground Space
• /
• v.20 no.5
• /
• pp.352-359
• /
• 2010

Stability of twin tunnels depends on the pillar width and the ground condition. In this study, large scale model tests were conducted for investigating the influence of the pillar width of twin tunnels on their behavior in the regular horizontal jointed rock mass. Jointed rocks was composed of concrete blocks. Pillar width of twin tunnels varied in 0.29D, 0.59D, 0.88D and 1.18D, where D is the tunnel width. During the test, pillar stress, lining stress, tunnel distortion, and ground displacement were measured. Lateral earth pressure coefficient was kept in a constant value 1.0. As a result, it was found that the pillar stress and the displacement of the ground and tunnel were increased by decreasing pillar width. The maximum displacement rate was measured just after the upper excavation in each construction sequence. And the maximum influence position was the right shoulder of the preceeding tunnel at the pillar side. It was also found that for the stability assessment the inner displacement was more critical than the crown displacement. The influence zone was formed at the pillar width 0.59D~0.88D that was smaller than 0.8D~2.0D, which was proposed by experience for a good ground condition. And it would be concluded that horizontal joints could also influence on the stability of the twin tunnels.

• Tunnel and Underground Space
• /
• v.20 no.2
• /
• pp.82-91
• /
• 2010

Grouting technology is one of the ground improvement methods used in water controlling and reinforcement of rock mass in underground structure construction. It is necessarily required to find out the characteristics of grout flow through discontinuities in a rock mass for an adequate grout design and performance assessment. Laminar flow is not always applicable in simulating a grout flow in a rock mass, since the rock joints usually have apertures at a micro-scale and the flow through these joints is affected by the joint roughness and the velocity profile of the flow changes partially near the roughness. Thus, the influence of joint roughness and aperture on the grout flow in rough rock joint was numerically investigated in this study. The commercial computational fluid dynamics code, FLUENT, was applied for this purpose. The computed results by embedded Herschel-Bulkley model and VOF (volume of fluid) model, which are applicable to simulate grout flow in a narrow rock joint that is filled with air and water, were well compared with that of analytical results and previously published laboratory test for the verification. The injection pressure required to keep constant injection rate of grout was calculated in a variety of Joint Roughness Coefficient (JRC) and aperture conditions, and the effect of joint roughness and aperture on grout flow were quantified.

• Korean Journal of Ecology and Environment
• /
• v.47 no.spc
• /
• pp.57-65
• /
• 2014

Spatial and temporal distributions of zooplankton were measured in an oligotrophic pumped storage-type hydroelectric reservoir which was composed of two reservoirs exchanging water daily, with water going up at night and going down during the day. Repetitive diel disturbance of the water column can be a unique feature of this reservoir system. Chl-${\alpha}$ concentration was highest in the early winter season. Phytoplankton density was lower in summer monsoon due to high flushing rate on rainy days. The zooplankton density was higher in the smaller upper reservoir possibly due to lower fish density in the upper reservoir. In the seasonal variation a time gap was observed between the phytoplankton bloom and the zooplankton bloom (particularly a rotifer, Keratella cochlearis). It is likely to that Keratella production is partially supported by heterotrophic food sources than phytoplankton. The dominance of a mixotrophic dinoflagellate (Peridinium bipes f. ocultatum) might have complicated the trophic relationship between phytoplankton and zooplankton. Our results provide some ecological information of zooplankton community in a highly disturbed alpine reservoir ecosystem relying on mostly allochthonous organic matter.

• Korean Journal of Food Science and Technology
• /
• v.52 no.2
• /
• pp.125-129
• /
• 2020

In this study we developed a method for determining the geographic origin of soybeans by combining energy dispersive X-ray fluorescence spectrometry with statistical analysis. In 2018, 197 soybean samples (100 Korean domestic samples and 97 foreign samples) were collected for the construction of a geographic origin model. The mineral concentrations of 26 elements were measured and determined via the fundamental parameters approach. One-way analysis of variance, t-test, and canonical discriminant analysis were employed to reveal five elements (P, Ni, Br, Zn, and Mn) that could be used for the determination of geographic origins. The sensitivity, specificity, and efficiency for the above method were 91.0, 95.9, and 93.4%, respectively. Validation results from 60 samples collected in 2019 showed a predictive rate of 93.3% for Korean domestic soybeans and 100.0% for foreign soybeans. In conclusion, the combination of energy dispersive X-ray fluorescence spectrometry and chemometrics could be used to effectively determine the geographic origin of soybeans.

• Journal of Food Hygiene and Safety
• /
• v.27 no.4
• /
• pp.339-348
• /
• 2012

The purpose of this study is to predict the economic size of foods-for-elderly market, which will be valuable information for establishing related policy and backup system. After setting the scope of related industry, detailed information for current market situation was investigated and a systematic forecast for market changes in the future was performed. Economic growth, changes in consumer expenditure and economic status of the elderly, current subscription of medical insurance and saving for pension were reflected. In addition, a survey toward related firms was completed and changes in aged population and incidence of chronic disease in the elderly were taken into account. Results show that the annual growth rate of the market was predicted to be the minimum 4.54% through the maximum 8.32% from 2010 to 2025 and its market size was forecasted to be the minimum 7,073 ten million won through the maximum 10,976 ten million won. It is expected that the market of foods-for-elderly will grow rapidly with development of foods technology and fast increase of aged population. Especially, growth of health functional foods and foods for special dietary uses for elderly will be distinguished. However, it seems that related firms are on the hedge, watching current trend of the related industry. This may results in insufficient supply against the demand. Therefore, policy for foods-for-elderly should be introduced and systematically administered, including R&D support, standardization and authentication for foods-for-elderly, construction of related database system.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.9 no.3
• /
• pp.771-778
• /
• 2008

Effects of establishments of more sewer systems on water quality in Nam River, Deokchun River, and Jinyang Lake were analyzed for various scenarios using QUAL2E, WASP 7 water quality model. Three different scenarios were tested: 1) 20.8% of sewer diffusion rate which is same to the existing condition. 2) Expansion of sewer system to 65.2% which would emit less pollutants, BOD 2350.5 kg/d, TN 216.0 kg/d, TP 44.0kg/d. 3) Pollutants emission to maintain first grade water quality in Nam River, Jinyang Lake, BOD and TN in the case 2 were 7.69%, 2.10% lower than those in the case 1 in the Nam River. And in the Jinyang Lake, BOD, TN, and TP in the case 2 were 10.25%, 1.37%, 2.94% lower than those in the case 1. However the simulations showed that water quality could not hold down first grade water quality standard level with the establishments of more sewer systems. To satisfy the criteria in the Nam River and Jinyang Lake, BOD emission must be reduced 27.2%, 37.05% compared to those in the case 1.

• Resources Recycling
• /
• v.26 no.5
• /
• pp.12-21
• /
• 2017

Red mud generated in the alumina manufacturing process contains various valuable resources, but it is not comprehensively recycled yet causing severe environmental problems. In Korea, red mud is producing about 200,000 tons annually and most of them are landfilled or disposed. Red mud's recycling technology is also being developed in many countries, but red mud's recycling technologies are still lacking compared to the production rate. In this study, we analyzed the characteristics and the amount of red mud, and the current status and technology development trend. Red mud has shown that recycling studies are being carried out in fields such as construction, recycling, metal recovery, adsorbent, and pollution stabilization. In particular, technologies for recovering rare earths have been developed as worldwide because of their high economic value. The data analyzed in this study will be used as basic data for the further development of technologies in the future.

• Resources Recycling
• /
• v.29 no.1
• /
• pp.53-61
• /
• 2020

This study aimed to develop a foam concrete material for a ground repair system that has low strength and low fluidity by using an eco-friendly binder, which substitutes industrial by-products for more than 90% of cement. Basic properties were evaluated after substituting a small amount of calcium sulfo aluminate (CSA) for the binder to improve the sinking depth rate and volume change, commonly found when it had a large amount of industrial by-products. The substitution rates of CSA for the eco-friendly binder used for the foam concrete were 2.5, 5, and 10%. Fresh properties, hardened properties, pore structure, and hydrates were analyzed. Experimental results showed that using only 2.5% of CSA could improve the deep sinking depth which occurred when using an eco-friendly binder. As a result, the weight difference between the upper, middle, and lower parts of cast specimens was improved even after being hardened. The addition of CSA also contributed to the formation of small, uniformly sized closed pores and improved initial strength. However, when the proportion of CSA increased, the long-term strength decreased. However, it satisfied the target strength when 5% or less of CSA was used. The results of this study revealed that it was possible to manufacture foam concrete with low strength and high fluidity for repairing ground satisfying target qualities by adding 2.5% of CSA to the eco-friendly binder containing a large amount of industrial by-products.

• Journal of the Korea Management Engineers Society
• /
• v.23 no.4
• /
• pp.49-72
• /
• 2018

Before the financial crisis of 1997 in Korea, many industrial sectors across the country have achieved remarkable economic growth since the 1970s because of the development of large-scale equipment industries such as civil engineering, steel, construction and chemical industries. However, after the financial crisis, the economic growth rate has slowed down. Also, the global recession and the rise of China in the global business environment have led to a long-term recession in the national industry as a whole. In current economic environment, it is not easy for the companies even having excellent resources to continue its competitive advantage. Moreover, the chemical industry, which has an influence as a basic industry of other industries, misses the point of transformation into a high value-added industry, as shown in previous research. In order to meet the rapidly changing global business environment, Korean chemical companies should have a dynamic capabilities which to rapidly reallocate and consolidate the resources and capabilities they possess. The dynamic capabilities to convert, rearrange and develop the resources possessed by the company in the direction of creating high added value and to promptly search for, absorb, transform and fuse newly required capabilities and resources should be continuously applied to Korean chemical companies. It is the core competence to secure competitive advantage. In order to secure the dynamic capabilities of the company, the dynamic capabilities of individual employees should be strengthened and employees should be able to demonstrate their own leadership so that they can proactively work and self-manage in a positive direction. Previous studies have focused mainly on the dynamic capabilities of firms. However, the competence of the human resources that make up the enterprise leads to the capabilities of the enterprise, and the human resources themselves are also important corporate resources. This paper focuses on the dynamic capabilities of individuals and strives to clarify the causal relationship between dynamic capabilities, self-leadership, and organizational effectiveness which have direct or indirect effects on management outcome. The reasons for choosing the chemical industry are based on the fact that a domestic chemical companies are in a long-term recession, and they lacks a innovation and value creation capabilities. Also, chemical industry has a large impact on the national economy.

• Journal of Digital Convergence
• /
• v.17 no.11
• /
• pp.1-7
• /
• 2019

This study analyzed the effects of labor aging on labor productivity using panel statistics of 16 local governments from 1995 to 2017. The aging of the labor force, defined as the proportion of workers aged 60 or older in total employment, in the results of the panel regression analysis considering regional fixed effects and various adjustment variables, has a very consistent and significant negative effect on labor productivity. For every 1% increase in aging, labor productivity decreases by about 0.14 ~ 0.20%. In addition, the per capita capital stock and human capital considered as adjustment variables contributed to the increase of labor productivity, and the unemployment rate, which is a proxy variable of the economic fluctuation, has a significant negative effect on labor productivity as expected. The coefficient of the industrial structure, which represents the share of the service industry in the whole industry, was positive, but is not significant. The results of this study suggest that the design and construction of economic and educational policies that can maintain and expand human capital are necessary to curb the reduction in labor productivity expected by the aging workforce.