• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.57 no.2
• /
• pp.191-197
• /
• 2008

This paper describes the effect of transient state in underground transmission and distribution lines installed together in the same tunnel. Two systems installed in the same tunnel are operated by the common grounding. This paper analyzed that how much one of the two kinds of systems influences the other systems during the transient state by EMTP/ATPDraw. Single line-to-ground fault and lightning surge were selected in transient state condition. These cases were simulated variously according to the variation of common grounding magnitude, fault location and lightning surge magnitude. It is evaluated that the analyzed results will be used for establishment and operating materials of common grounding in the same tunnel.

• Journal of Welding and Joining
• /
• v.17 no.5
• /
• pp.98-106
• /
• 1999

In GMAW, the spatters are generated according to the variation of the arc. Of the arc is stable, Few spatters are generated. But if unstable, too many spatters are generated. So, this means the spatters are dependent on the arc state. The aim of this study is to accurately estimate the arc state. To do this, the generated spatters were captured under the some welding conditions, and the waveforms of the arc voltage and welding current were collected. From the collected signals, the waveform factors and their standard deviations were extracted. Using these factors as input parameters of multi-layer artificial neural network, the learning for the weight of the generated spatters is performed and the estimation results to the real spatter are assessed. Obtained results are as follow: the linear correlation coefficient between the estimated result and the real spatters was 0.9986. And although the average convergence error was set 0.002, the estimated error to the real spatter was within 0.1 gr/min at each welding condition. In the estimation for the weight generated spatters, the result with multi-layer neural network was far better than with multiple regression analysis. Especially, even though under the welding condition which the arc state is unstable (the spatter is generated much more), very excellent estimation performance was shown.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.7 no.8
• /
• pp.150-159
• /
• 1999

Exhaust system is composed of several parts. Among, them , design of muffler system strongly influences on engine efficiency and noise reduction. So , through comprehension of flow characteristics inside muffler is necessary . In this study , three-dimensional steady and unsteady compressible flow analysis was performed to understand the flow characteristics, pressure loss and amplitude variation of pulsating pressure. The computational grid generation was carried out using commercial preprocessor ICEM CFD/CAE. And the three-dimensional fluid motion inside the muffler was analyzed by STAR-CD, the computational fluid dynamics code. RNG k-$\varepsilon$ tubulence model was applied to consider the complexity of the geometry and fluid motion. The steady and unsteady flow field inside muffler such as velocity distribution, pulsating pressure and pressure loss was examined. In case of unsteady state analysis, velocity of inlet region was converted from measured pulsating pressure. Experimental measurement of pressure and temperature was carried out to provide the boundary and initial condition for computational study under three engine operating conditions. As a result of this study, we could identify the flow characteristics inside the muffler and obtain the pressure loss, amplitude variation of pulsating exhaust gas.

• Progress in Superconductivity
• /
• v.6 no.2
• /
• pp.138-141
• /
• 2005

Bi-2223/Ag tapes need to be safe, even it is under the over-critical current state for the protection of a superconducting power machine. However, it is not easy to identify the condition for the safe operation because of their broad S/N transition region. In this paper, for the study of the operation condition of Bi-2223/ Ag tapes, we investigated the V-I curves and the temperature variation of Bi-2223/ Ag tapes experimentally, applying alternating over-currents, and analyzed the relationship between resistance and temperature increase. For the experiments, a Bi-2223/Ag tape of 57 A $I_c$ was prepared, and the over-critical current characteristics under adiabatic state from $LN_2$ was measured. From the experiments, we confirmed that the Joule heating predicted by V-I curve corresponded with the increase of the measured temperature exactly. Using the results, a safe operation condition of Bi-2223 tape was discussed.

• The Journal of the Convergence on Culture Technology
• /
• v.3 no.3
• /
• pp.37-42
• /
• 2017

We are designed to control the lipoid variation of the structure system with the stratum corneum on the skin. The skin structure is consisted of a morphology how to use the lipoid component, and the given skin structure is consisted of the mechanical shapes of the intercellular route and transcellular route, and is confirmed to control the variation state of the structure capacity. The skin impedance is appeared to result the value of measurement such as shapes of ${\lambda}-Lip-RSC$, ${\lambda}-Lip-RSL$, ${\lambda}-Lip-CSG$, ${\lambda}-Lip-CSS$ and ${\lambda}-Lip-RSB$. The condition is showed to the alteration difference value of the intercellular route and transcellular route. And, composition condition is established to separate the division parts for conversion system that is constructed with the alteration modeling. We will be possible to progress the improvement effectiveness of the continuous skin control system on the skin.

• Journal of Korean Tunnelling and Underground Space Association
• /
• v.25 no.6
• /
• pp.447-458
• /
• 2023

In this study, a comparison model considering the stochastic characteristics of the load and member resistance of the shield tunnel segment lining as well as the variability of the boundary condition was selected and reliability analysis was performed, and the adequacy of the limit state design was analyzed by calculating the probability of failure and reviewing the structural safety. For the analysis considering the probability characteristics of these ground constants, the ground spring coefficient was considered as the mean value by calculating the quantitative value by applying the Muirwood formula, and the coefficient of variation was selected based on the existing research data to review the models according to the change of ground boundary conditions. Through the structural analysis of these models and the reliability analysis using MCS technique, the failure probability and reliability index were calculated to examine the changes in the failure probability due to changes in ground boundary conditions.

• Journal of Environmental Science International
• /
• v.9 no.5
• /
• pp.369-374
• /
• 2000

The estuary of Nakdong river is very influenced by the freshwater contained nutrients and organic materials. The response results of these influences are eutrophication and red tide outbreak in this region. Concentration of chlorophyll a was 0.78~62.55$\mu\textrm{g}$/L in February 1.20~21.29$\mu\textrm{g}$/L in April 1.88~188.35$\mu\textrm{g}$/L in June and 0.78~11.21$\mu\textrm{g}$/L in August respectively. The decrease of chlorophyll a is considered that residence time is shorten by increase of freshwater discharge and unfavorable growth condition of phytoplankton is created by diffusion of low salinity and increase of turbidity. The phytoplankton maximum region located inner side of this estuary during winter season whereas it was moved to outer side when mean discharge of the Nakdong risver was increased, Therefore the variation of phytoplankton maximum region was affected by input discharge from the Nakdong river basin.

• Korean Journal of Ecology and Environment
• /
• v.45 no.2
• /
• pp.174-189
• /
• 2012

The objective of this study was to determine the weight-length relations and condition factor (K) of Zacco platypus, along the trophic gradients from oligotrophic to eutrophic state in six reservoir ecosystems ($B_aR$, $Y_yR$, $J_yR$, $G_pR$, $Y_dR$, and $M_sR$), during 2008~2010. The species was selected as a sentinel species for the study, due to its wide distribution and wide trophic gradient. The analysis of trophic state index (TSI), based on total phosphorus (TP) and chlorophyll-a (Chl-a), indicated that reservoirs of $Y_yR$ and $B_aR$ were classified as to be in an oligotrophic state (30~40), the $J_yR$ and $G_pR$ as mesotrophic (40~50), and the $Y_dR$ and $M_sR$ as eutrophic state (50~70). Total 47 species and 26,226 individuals were sampled from 6 reservoirs and sensitive species dominated in the oligotrophic reservoirs ($Y_yR$ and $B_aR$). In the mean time, the tolerant speciesdominated the community in the mesotrophic ($J_yR$ and $G_pR$) and eutrophic ($Y_dR$ and $M_sR$) reservoirs. Regression analysis of body weight, against the total length, indicated that the regression coefficient (b value) was lower in the oligotrophic reservoir (2.77~2.79) than the mesotrophic (3.07~3.17) and eutrophic reservoirs (3.15~ 3.21). This result suggests that the population growth rate Zacco platypus reflected the trophic gradients of the reservoirs. The analysis of condition factor (K) against the total length showed positive slopes (b>3.0) in mesotrophic and eutrophic reservoirs, and a negative slope (b<3.0) in oligotrophic reservoir. The variation of the regression slope of "b" in Z. platypus was accounted for 79.7% [$b=0.012{\times}TSI(TP)+2.395$, p=0.017] by the variation of TSI (TP) and 82.2% [$b=0.013{\times}TSI(Chl-a)+2.36$, p=0.013] by the variation of TSI (Chl-a). The proportion of DELT abnormality increased as the trophic state increases in the reservoirs. The overall data suggest that the growth of the fish populations, based on the length-weight relations and condition factor, reflected the trophic state of nutrient and phytoplankton biomass of the reservoir waters. Thus, in spite of the tolerant characteristics of Z. platypus, hypertrophic states might negatively affect the health of the population.

• Journal of Electrical Engineering and Technology
• /
• v.13 no.3
• /
• pp.1355-1362
• /
• 2018

In order to obtain a better understanding of the ageing process of the field composite insulators, it is necessary to explore a quantitative-valuation method for the aging state evaluation. And the linear relationship between volume resistivity and temperature is proposed. In this paper, the composite insulators with different lengths of operating lives from two manufacturers were tested. The relationship between trap characteristics and volume resistivity-temperature characteristics were analyzed based on Thermal Stimulated Current (TSC), volume resistivity-temperature test, Scanning Electron Microscope (SEM) and Fourier Transform Infrared Spectroscopy (FTIR). Furthermore, the application of trap characteristics in the quantitative evaluation of aging state of composite insulators was discussed. The results showed that there was a general negative correlation between the relative variation ratio of trap charges and the volume resistivity-temperature characteristics. Meanwhile, the physicochemical properties would change with the aging time, which would result in the increasing of electron traps. Combined with the TSC and volume resistivity test results, the trap characteristic thresholds which indicated the serious age of the composite insulators had been proposed.

• Proceedings of the KSME Conference
• /
• 2000.04b
• /
• pp.205-212
• /
• 2000

Induction motors. having axial cooling channels in stator and rotor are designed for better cooling performance. Traction motors are one of those examples. And, thermal analysis gain more attention with the Increased demand of the motors, for reliable operation and life prolongation. was Induced to effective thermal conductivity through modeling. Through. fundamental comparison experiment, heat source experiment and transient state experiment, the induction motor using inverter was examined to produce heat source with frequency level and traced to thermal variation at starting and stopping. And thermal analysis using thermal network was compared with a transient state experiment.