• Journal of the Institute of Electronics and Information Engineers
• /
• v.50 no.11
• /
• pp.36-40
• /
• 2013

A novel design method of ultra wideband bandpass filter using CRLH transmission line with Dumbell type DGS is presented in this paper. Defected Ground Structure and microstrip interdigital capacitor are used to design the ultra wideband (UWB) filter. CRLH transmission line has composite characteristics of low pass and high pass filter. As control of cutoff frequency of low pass and high pass response on CRLH transmission line, we can get characteristic of UWB filter. We designed and simulated for CRLH transmission lines with one, two, four, and eight cells. A UWB filter using four cells CRLH is designed and fabricated to verify the results. The characteristics of designed filter have center frequency of 5GHz and relative bandwidth of 88%.

• ETRI Journal
• /
• v.43 no.6
• /
• pp.957-965
• /
• 2021

A miniaturized wideband band-pass filter with a 3-dB fractional bandwidth of 109.3% (1.53 GHz to 5.22 GHz), high out-of-band attenuation greater than 25 dB, and wide upper stopband up to 14 GHz is proposed. The design consists of a dual-composite right/left handed resonator, embedded open-circuited stub, and a pair of quarter-wavelength short-circuited stubs. These elements are coupled in the near distance to form a miniature filter with a compact occupied area of 0.21 λ_g×0.19 λ_g (≈ 0.013 cm²). The optimized filter has multitransmission poles in the passband, substantially improving the return loss and insertion loss characteristics. The behavior of the passband and stopband is verified against the results of a lumped element model and matrix analysis with a full-wave moment-based analysis and actual measurements. The results of this verification and a comparison with the performance of filters in other references indicate that the proposed filter is very efficient and applicable to compact microwave systems.

• Journal of Advanced Navigation Technology
• /
• v.21 no.1
• /
• pp.84-89
• /
• 2017

This paper presents a dual-wideband bandpass filter (BPF) with high band-to-band isolation and skirt selectivity using distributed composite right/left-handed (CRLH) transmission line (TL) quad-mode resonators (QMRs). The results of the proposed distributed CRLH TL unit cell analysis are used to establish the scattering parameters and the resonance frequencies of the QMR constituting the dual-wideband BPF. A novel dual-wideband bandpass filter is designed and fabricated, using the derived scattering characteristics. The measured results show that the fabricated dual-wideband bandpass filter has an insertion loss of less than 1.08dB in the lower band, and of 2.01dB in the upper band, a bandwidth of 2.8-5.52GHz and 9.68-12.26GHz, and a band-to-band isolation of more than 38dB, from 6.34-8.42GHz.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.14 no.1
• /
• pp.109-116
• /
• 2014

This paper presents a high-efficiency digital class-D audio amplifier using a composite interpolation filter for portable audio devices. The proposed audio amplifier is composed of an interpolation filter, a delta-sigma modulator, and a class-D output stage. To reduce power consumption, the designed interpolation filter has an optimized composite structure that uses a direct-form symmetric and Lagrange FIR filters. Compared to the filters with homogeneous structures, the hardware cost and complexity are reduced by about half by the optimization. The coefficients of the digital delta-sigma modulator are also optimized for low power consumption. The class-D output stage has gate driver circuits to reduce shoot-through current. The implemented class-D audio amplifier exhibited a high efficiency of 87.8 % with an output power of 57 mW at a load impedance of $16{\Omega}$ and a power supply voltage of 1.8 V. An outstanding signal-to-noise ratio of 90 dB and a total harmonic distortion plus noise of 0.03 % are achieved for a single-tone input signal with a frequency of 1 kHz.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2016.05a
• /
• pp.409-411
• /
• 2016

Salt and pepper noise is caused by various causes such as camera malfunction, storage media memory error, and transmission channel error. Representative filters to remove salt and pepper noise include SMF(standard median filter), CWMF(center weighted median filter), and AMF(adaptive median filter). However previous filters have inadequate noise removal characteristics in high density salt-and-pepper noise environment. Therefore the study suggested a composite filter which, through noise evaluation, preserves original pixels when the central pixel is non-noise, and uses spatial weighted value mask and median when there is noise.

• Proceedings of the KIEE Conference
• /
• 2001.11c
• /
• pp.348-351
• /
• 2001

In this paper, the Gm-C filter for low voltage and low power applications using a fully-differential transconductor is presented. The designed transconductor using the series composite transistors and the low voltage composite transistors has wide input range at low supply voltage. A negative resistor load (NRL) technology for high DC gain of the transconductor is employed with a common mode feedback(CMFB). As a design example, the third-order Elliptic lowpass filter is designed. The designed filter is simulated and examined by HSPICE using TSMC $0.35{\mu}m$ CMOS n-well parameters. The simulation results show 138kHz cutoff frequency and 11.05mW power dissipation with a 3.3V supply voltage.

• ETRI Journal
• /
• v.38 no.2
• /
• pp.366-375
• /
• 2016

This paper describes an algorithm to suppress composite noise in a two-microphone speech enhancement system for robust hands-free speech communication. The proposed algorithm has four stages. The first stage estimates the power spectral density of the residual stationary noise, which is based on the detection of nonstationary signal-dominant time-frequency bins (TFBs) at the generalized sidelobe canceller output. Second, speech-dominant TFBs are identified among the previously detected nonstationary signal-dominant TFBs, and power spectral densities of speech and residual nonstationary noise are estimated. In the final stage, the bin-wise output signal-to-noise ratio is obtained with these power estimates and a Wiener post-filter is constructed to attenuate the residual noise. Compared to the conventional beamforming and post-filter algorithms, the proposed speech enhancement algorithm shows significant performance improvement in terms of perceptual evaluation of speech quality.

• Journal of the Korean Society for Precision Engineering
• /
• v.12 no.7
• /
• pp.74-81
• /
• 1995

In this paper, a composite controller cosisted of bandpass feedback controller and LQG/LTR controller is applied to a quarter-car model moving on a randomly profiled road. The LQG/LTR controller is used to achieve a design transfer toop. A bandpass feedback controller is adopted to eliminate the response due to the disturbance, which generally can not be measured, confined within an interested frequence range. The random road profile considered as colored noise is shaped from white noise by use of shaping filter. The performance of the composite control system is compared with that of an LQG/LTR control system.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.49 no.1
• /
• pp.68-72
• /
• 2012

In this paper, highly linear power amplifier using bandpass filter based on metamaterial and Composite Right- / Left-Handed (CRLH) structure is proposed. The proposed bandpass filter consist of the series capacitor, series microstrip line and the parallel inductor, parallel microstrip line. The insertion loss is minimized at operation frequency and the $2^{nd}$ harmonic is suppressed by the bandpass filter using the CRLH structure. And we improved the Adjacent Channel Leakage Ratio (ACLR) using the characteristic of the proposed bandpass filter. At 2.14 GHz, we have obtained the output power of 38.83 dBm, the $2^{nd}$ harmonic of .61.33 dBc, the $3^{rd}$ IMD of .54.67 dBc, and ACLR of .51.33 dBc at 5 MHz offset, -56.50 dBc at 10 MHz offset, respectively.

• Journal of Integrative Natural Science
• /
• v.6 no.4
• /
• pp.244-250
• /
• 2013

Three types of functionalized flexible optical composite films based on Bragg structure porous silicon interferometer have been successfully fabricated by casting a toluene solution of polystyrene onto the free-standing porous silicon. The optical properties of composite films are measured. Surface functionalization of porous silicon is determined by FT-IR measurement. Reflectance and transparence properties of composite films are measured for the possible application of tunable optical filter and indicate that the transmission peak occurred at the identical location where the reflection peak appeared.