• The Research Journal of the Costume Culture
• /
• v.31 no.5
• /
• pp.627-639
• /
• 2023

This study seeks to increase the satisfaction of elderly men when purchasing and wearing ready-to-wear clothes by designing a slacks pattern suitable for their body type, which is determined by analyzing their lower bodies using virtual avatars and 3D virtual simulation system. The study found the following. First, based on virtual visualization of the comparison slacks pattern, the waistline position was consistently the lowest scored question among the evaluation survey items. Interpretation of this dissatisfaction suggests that, because the front waistline falls below the abdomen, the lower body, and especially the abdominal shape, is unpleasantly emphasized. Second, by using a virtual simulation system, the study developed a new slacks pattern that considered the concerns of elderly men. The primary measurement changes were as follows: front waist girth W/4+1.5cm+0.5cm, back waist girth W/4+1.5cm-0.5cm, front hip girth H/4+2.5cm-0.5cm, back hip girth H/4+2.5cm+0.5cm. Third, the new slacks pattern's appearance was evaluated more highly than the comparison pattern, confirming the new pattern's appropriateness for elderly men. This study demonstrates how slacks and other clothing patterns designed in a 3D virtual garment simulator can be used to design more appealing clothing for elderly men, increasing the satisfaction of wearing ready-made clothes at older ages.

• Journal of Advanced Marine Engineering and Technology
• /
• v.26 no.2
• /
• pp.248-255
• /
• 2002

Miller cycle was studied and analyzed by engine performance simulation to achieve very low fuel consumption and to meet the IMO NOx regulation on a medium speed diesel engine. Based on the performance simulation results the intake valve closing time for HYUNDAI HiMSEN 6H21/32 engine was set at 0deg.ABDC(After Bottom Dead Center). Also, the simulation results indicated that significant NOx reduction could be achieved with low reduction of fuel consumption. The performance simulation investigated the effect of compression ratio and turbocharger on fuel consumption and NOx concentration in combination with Miller cycle. The results indicated a significant reduction of fuel consumption with keeping NOx concentration. The results of performance simulation were compared with measured data to verify simulation results. The comparison showed the maximum error was 2.34% in exhaust temperature. Also, the experimental result showed that improvement in BSFC(Brake Specific Fuel Consumption) was 5.8g/kwh with keeping NOx level similar to simulation result.

• Journal of the military operations research society of Korea
• /
• v.3 no.1
• /
• pp.115-121
• /
• 1977

• Proceedings of the Korea Society for Simulation Conference
• /
• 2003.06a
• /
• pp.179-184
• /
• 2003

HLA-RTI is middleware for the distribute simulation that developed in the US Department of Defense. This provides fast accomplishment speed and reliability than distribute simulation Middleware by transfer. However, DDM(Data Distribution Management) service is used as data filtering technology in the existing HLA-RTI. As for this, the problem that network traffic increases in data exchange between the mobility simulation objects is generated. it proposes applying agent technology to the mobility simulation object in order to solve these problems in this paper in this. And this paper applies that to practical simulation and analyzes performance between each data filtering technology with comparison.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.44 no.11
• /
• pp.82-88
• /
• 2007

In this paper, we present a pattern comparison algorithm for reducing fault candidate lists. The number of fault candidates determines the total fault simulation time. To decrease the total fault diagnosis time, the reduction of the number of fault candidates is essential. Critical path tracing determines fault candidate lists detected by a set of tests using a backtracing algorithm starting at the primary outputs of a circuit. The proposed algorithm reduces fault candidates comparing failing patterns with good patterns during critical path tracing process. As we reduce all fault candidates of the circuit to more accurately suspected fault candidates, we can greatly reduce fault simulation time. The proposed algorithm greatly increases simulation speed than that of a conventional backtracing method. The proposed algorithm is applicable to both combinational and sequential circuits. Experimental results on ISCAS#85 and ISCAS#89 benchmark circuits showed fault candidates are pruned and fault diagnosis time is also decreased in proportion to fault candidate decrease.

• Structural Engineering and Mechanics
• /
• v.75 no.4
• /
• pp.487-496
• /
• 2020

Most of the previous works on numerical analysis of galloping of transmission lines are generally based on the quasisteady theory. However, some wind tunnel tests of the rectangular section or hangers of suspension bridges have shown that the galloping phenomenon has a strong unsteady characteristic and the test results are quite different from the quasi-steady calculation results. Therefore, it is necessary to check the applicability of the quasi-static theory in galloping analysis of the ice-covered transmission line. Although some limited unsteady simulation researches have been conducted on the variation of parameters such as aerodynamic damping, aerodynamic coefficients with wind speed or wind attack angle, there is a need to investigate the numerical simulation of unsteady galloping of two-dimensional iced transmission line with comparison to wind tunnel test results. In this paper, it is proposed to conduct a two dimensional (2-D) unsteady numerical analysis of ice-covered transmission line galloping. First, wind tunnel tests of a typical crescent-shapes iced conductor are conducted firstly to check the subsequent quasisteady and unsteady numerical analysis results. Then, a numerical simulation model consistent with the aeroelastic model in the wind tunnel test is established. The weak coupling methodology is used to consider the fluid-structure interaction in investigating a two-dimension numerical simulation of unsteady galloping of the iced conductor. First, the flow field is simulated to obtain the pressure and velocity distribution of the flow field. The fluid action on the iced conduct at the coupling interface is treated as an external load to the conductor. Then, the movement of the conduct is analyzed separately. The software ANSYS FLUENT is employed and redeveloped to numerically analyze the model responses based on fluid-structure interaction theory. The numerical simulation results of unsteady galloping of the iced conduct are compared with the measured responses of wind tunnel tests and the numerical results by the conventional quasi-steady theory, respectively.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2001.11a
• /
• pp.320-323
• /
• 2001

A computer simulation was performed to distinguish quantitatively a color reaction in a urine analysis systems by using the spectral power distribution of LEDs, the spectral reflectance of a urine strip, and the spectral sensitivity of photodiode. The CIE tristimulus values and CIE chromaticity coordinates ware modified to be conformable with real color reactions in a urine strips. Results on color simulation showed a of real color in comparison with those obtained by Colorimeter CM2C(Color Savvy).

• Journal of Korea Water Resources Association
• /
• v.33 no.S1
• /
• pp.157-163
• /
• 2000

• Proceedings of the Korea Water Resources Association Conference
• /
• 2000.05a
• /
• pp.157-163
• /
• 2000

• 한국연소학회:학술대회논문집
• /
• 2012.04a
• /
• pp.275-278
• /
• 2012

We investigate the interaction between the propagation of detonation and inserted gaps in the high explosive. The Eulerian-based multi-material simulation code validated through comparison with experimental results was used. A series of gap materials is used to understand the detonation propagation characteristic in the presence of multiple gaps.