• Proceedings of the IEEK Conference
• /
• 2001.06b
• /
• pp.137-140
• /
• 2001

This paper shows an asynchronous comparator circuit for 1.2Gbps signal receiver that converts 1.2Gbps data rate input signals with less than 100㎷ swing to on-chip CMOS compatible voltage levels in a 0.35${\mu}{\textrm}{m}$ CMOS process. Folded-cascode nMOS input stage with source-coupled pMOS input stage cover rail-to-rail input common-mode range. Drastic gain-bandwidth increment due to gain-boosting stage with positive-feedback latch as well as wide input common-mode range make designed circuit be suitable for a fully differential signal receiver. HSPICE simulation results show that worst-case sensitivity is less than 20㎷ and maximum propagation delay is 640-psec. And also we verified 3.97㎽ power consumption with 150㎷ differential swing amplitude at 1.2Gbps.

• Proceedings of the KIEE Conference
• /
• 2008.07a
• /
• pp.1442-1443
• /
• 2008

본 논문에서는 인쇄회로기판과 도전체 샤시(Chassis)가 연결되었을 때의 복사성 방사(Radiated Emission)의 감소에 대해서 연구하였다. Current Driven 메커니즘 등가회로를 사용하여 전자파 방사의 주요한 원인중 하나인 Common-mode Current를 인쇄회로기판과 Chassis가 연결된 구조에 적용하였다. Chassis의 유무에 따라 복사성 방사의 감소를 확인하고자 2-layer 인쇄회로기판과 SECC(Steel Electro galvanized Cold-rolled Coil) 재질의 Chassis를 나사(Screw)를 통하여 전기적으로 연결하였을 때를 시뮬레이션 하였고, 제작된 구조물을 3m 무반향실에서 복사성 방사를 측정한 후 시뮬레이션과 결과를 비교하였다. 결과로 30MHz$\sim$45MHz에서 최대 10dB 감소의 효과가 있음을 확인하였다.

• Proceedings of the KIPE Conference
• /
• 2002.07a
• /
• pp.91-94
• /
• 2002

This paper presents a novel active common-mode EMI filter for the PWM inverter application. The proposed filter is based on the current sensing and compensation circuit and it utilizes a fast transistor amplifier for the current compensation. The amplifier utilizes an isolated low-voltage dc power supply for its biasing and it is possible to construct the active filter independent of the source voltage of the equipment. Thus the proposed active filter can be used in any application regardless of its working voltage. The effectiveness of the proposed circuit is verified by experimental results.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2002.08a
• /
• pp.567-570
• /
• 2002

The LVDS (Low Voltage Differential Signaling) I/O cells, fully compatible with ANSI TIA/ EIA-644 LVDS standard, are designed using a 0.35${\mu}m$ standard CMOS technology. With a single 3V supply, the core cells operate at 1.34Gbps and power consumption of the output driver and the input receiver is 10. 5mW and 4.2mW, respectively. In the output driver, we employ the DCMFB (Dynamic Common-Mode FeedBack) circuit which can control the DC offset voltage of differential output signals. The SPICE simulation result of the proposed output driver shows that the variation of the DC offset voltage is 15.6% within a permissible range. In the input receiver, the proposed dual input stage with a positive feedback latch covers rail-to-rail input common-mode range and enables a high-speed, low-power operation. 5-channels of the proposed LVDS I/O pair can handle display data up to 8-bit gray scale and UXGA resolution.

• Journal of Power Electronics
• /
• v.11 no.4
• /
• pp.512-519
• /
• 2011

This paper gives a detailed analysis of the direct torque control (DTC) strategy in a five-level drive and proposes a 24-sector switching table. The known problems in low-voltage drives such as bearings currents and an overvoltage phenomenon which leads to premature failure are reviewed and the occurrence of these problems in medium voltage drives has been investigated. Then a solutions to these problems is presented and the switching table to deal with these problems is modified. Simulation and experimental results on a 3kVA prototype confirm the proposed solution. In implementing the above strategy a TMS320F2812 is used.

• Journal of Chest Surgery
• /
• v.28 no.12
• /
• pp.1160-1166
• /
• 1995

From 1980 through 1993, sixty one patients having traumatic flail chest were analysised retrospectively at the Department of Thoracic and Cardivascular Surgery, Chonbuk National University Hospital. There were 47 men and 14 women, mean age, 49.3 years, age range 4 to 82 years. The most common mode of trauma was automobile accident, common combined other organ injuries were skeletal injury [ 36 patients and neurologic injury [ 20 patients . In the mode of treatment, ventilator therapy was done in 34 cases and operative stabilization was done in 18 cases [ Kirschner or steel wire: 9 cases, Judet`s strut: 9 cases . Sixteen patients died [26 % . The main factors associated with fatal outcome were shock [ p < 0.002 , head injury [ p < 0.005 , and more than 50 years of age [ p < 0.05 . In fatal cases, 14 patients died during in ventilator therapy [ 14/34, 41 % and 2 patients died following operative stabilization of chest wall [ 2/18, 11 % .The overall cause of death was septicemia, ARDS, ARF, hypovolemic shock and hypoxic brain damage.

• Journal of Biosystems Engineering
• /
• v.32 no.2 s.121
• /
• pp.97-101
• /
• 2007

A CRDI diesel engine used to commercial vehicle was fueled with diesel fuel and 5% biodiesel blended fuel (BDF 5%) and tested at the Seoul-10 mode for 150 hours. Engine dynamometer testing was completed at regularly scheduled intervals to monitor the engine performance and exhaust emissions. To check the engine parts (valve, injector), the engine was inspected after 150 hours running test. It was concluded that there was no unusual deterioration of the engine, or the changes in engine power (below 2.6%), smoke (below 6.2%), NOx (below 2%) and durability characteristics in spite of operation of 150 hours run with BDF 5%. The difference of kinetic viscosity for engine oil (before and after durability testing) was below 0.36%

• Proceedings of the KIPE Conference
• /
• 2018.07a
• /
• pp.390-391
• /
• 2018

본 논문은 직류단 전원을 공유하는 복수의 인버터로 구성된 시스템에서 EMI 저감을 위한 연동제어 PWM 생성 기법을 제안한다. PWM 제어에 의한 스위칭시 전력단 중성점에서 커먼모드 전압이 생성되고, 기생 캐패시터를 통해 전원라인으로 유입되어 EMI 노이즈가 발생된다. 복수의 인버터 시스템에서도 동일한 현상이 나타나고, 이로인한 불특정한 커먼모드 전류가 발생한다. 본 논문에서는 2개의 인버터를 PWM 시점의 동기제어를 통해 커먼모드 노이즈를 상쇄하고자한다. 제안한 제어 기법을 검증하기 위하여 시뮬레이션으로 분석하며, 간이 실험 통해 검증한다.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2003.05a
• /
• pp.956-959
• /
• 2003

In the semiconductor and the optical industry a new transport system which can replace the common system is required. The common systems are driven by magnetic field and conveyer belt. The magnetic field damages semiconductor and contact force scratches the optical lens. The ultrasonic wave driven system solve these problem. In this paper the object transport system using the excitation of ultrasonic wave is proposed. The experiments for finding the optimal excitation frequency, finding phase-difference between two ultrasonic wave get orators are performed. The effect of transporting speed according to the change of weight and amplification voltage are verified. In addition, the system performance for actual use is evaluated.

• Proceedings of the KIPE Conference
• /
• 2005.07a
• /
• pp.321-324
• /
• 2005

This paper describes the application of newly developed conducted EMI reduction technique of SVPWM in induction motor drive. The newly developed common mode voltage reduction SVPWM technique doesn't any zero-voltage vector states for inverter control. Hence it can restrict the common mode voltage better than conventional PWM technique. The proposed technique is verified through simulation and experimental results. And by applying vector-controled system, the proposed technique have superior ability of reducing EMI and equal control performance comparing conventional SVPWM technique.