• 자동차안전학회지
• /
• 제10권1호
• /
• pp.45-51
• /
• 2018

There are some ambiguities of the information on the fuel economy provided to the consumers because the standard and the detailed regulations for the fuel economy of the two-wheeled vehicle have not been established in Korea. Since Korea has been a signatory of World Forum for Harmonization of Vehicle Regulations since 1998, it is possible to remove the ambiguities by adopting the WMTC (Worldwide-harmonized Motorcycle Test Cycle) measurement method for the fuel economy of the two-wheel vehicle. As a preliminary study on the WMTC mode fuel economy, road loads measured by coast down method and table method were compared for the two types of two-wheeled motorcycles on sales in domestic market. In the same model, it was confirmed that the deviation of WMTC mode fuel efficiency was below -5% between products. On the other hand, the difference of WMTC fuel economy exceeded 5% between the coast down method and table method.

• Tribology and Lubricants
• /
• 제33권4호
• /
• pp.153-167
• /
• 2017

The aim of this study is to find the change in trend in the eccentricities of two journal bearings supporting the crankshaft of a single cylinder engine and the degree of misalignment of the shaft. We analyze the change in oil film thickness considering the wear scar under mixed-elasto-hydrodynamic lubrication regime at potential wear regions. For this, we first calculate the central eccentricities of the two journal bearings by using the mobility method. Then we calculate the outer end eccentricity by using the geometry of the bearings. Further, the tilting angle and degree of misalignment of the shaft are calculated by using the eccentricities of the two bearings. We show that the eccentricity of bearing #1, on which higher load is applied, increases at the beginning of the start-up cycle and during the coast-down cycle. However, the eccentricity of bearing #2, on which lower load is applied, decreases at the beginning of the start-up cycle and increases during the coast-down cycle. From the results of the analysis of oil film thickness, we show that the mixed-elasto-hydrodynamic lubrication regime for a misaligned shaft is at the initial stages of the start-up cycle for both bearing #1 and #2 and at the final stage of the coast-down cycle for only bearing #1.

• 한국자동차공학회논문집
• /
• 제3권2호
• /
• pp.51-61
• /
• 1995

A coast down test mothod has been used to determine the resistance forces on running vehicle due to the aerodynamic drag, rolling resistance and driveline resistance. Most of the tests, however, are based on the Velocity-Time measurements, which require a sophisticated velocity measuring device and contain much error by nature. In the present study a coast down test method based on Distance-Time measurements is introduced, which contains the original idea of Russian scientist Prof. Petrushov along with the suggestions for improvement of the accuracy.

• 한국식생활문화학회지
• /
• 제1권3호
• /
• pp.279-294
• /
• 1986

In order to survey the traditional salt production at the eastern coast, Young-Hae, in Yi-dynasty, data of salt production were collected through interviewing with whom had received the skill from ancestors and analyzed the data. The results obtained were as follows. Salt-producer take the salt water containing much salt and then he transported the salt-water by having water buckets an back in with using the water-toting device (Mul ji ge). Finally he carried out the irrigation (Mul dae gi) to a ditch (Dorang). It is noteworthy that the East-sea salt production method was not selecting a method of salt-pond style with a bank for salt production but using the salt water transportation fashion without a bank for that. Judging from these facts, we could conclude that traditional salt production method was handed down into the Yi-dynasty from ancient times.

• 한국자동차공학회논문집
• /
• 제3권3호
• /
• pp.1-8
• /
• 1995

In the companion paper of the present paper, a coast down test method to determine the resistance forces on running vehicle based on the distance-time measurement was explained along with the suggestions to improve its accuracy and testing methodology. In the present paper some of the suggestions discussed previously are implemented and actually road tested to see the applicability of the improved method(short distance method) in the field. From the results. it is shown that the short distance method which requires only 600m long proving ground road gives at least comparable results on the accuracy compared to the original S-t method which requires 2000m. It is hoped that the present method be further refiend to give more accurate results.

• 한국전산유체공학회지
• /
• 제19권4호
• /
• pp.52-60
• /
• 2014

Recently, coastal structures have been built to protect coastal areas. However, if a tidal wave caused by an earthquake hits the coast, it would cause catastrophic damages. It is important to analyze the basics and the characteristics of a tsunami to reduce damages caused by natural disasters. In this study, a tsunami passing over different topographical changes is simulated with VOF method based on FVM(Finite Volume Method). The reduction of both scale and velocity is accomplished by similarity analysis, and an initial energy is generated by increasing the water level as needed to create a tsunami as if it is caused by a crustal movement. It is found that the present method is appropriate to simulate the tsunami with its mechanism.

• 한국항해항만학회:학술대회논문집
• /
• 한국항해항만학회 2023년도 춘계학술대회
• /
• pp.17-18
• /
• 2023

2022년 3월 15일부터 해양경찰청에서는 채용경로의 다양화를 위해 승선경력 없이도 해양경찰청 소속의 선박교통관제사(VTS_Of ficer) 채용시험에 응시 가능하도록 선박교통관제사의 자격 기준을 개정하였다. 본 연구를 통해서 선박교통관제업무 현황을 조사하고 현재까지 추진되어 온 선박교통관제규정, 선박교통관제사 자격 제도에 관한 중요한 규정의 제정 및 개정에 관한 사항등을 검토하여 관제 운영 국내 외 사례를 통해 관제 업무 수행 방안 별 장단점을 비교 분석한다. 또한, 선박교통관제사 자격 제도가 추후에 성공적으로 정착할 수 있도록 선박교통관제 업무의 향후 발전 방안을 제시하고자 한다.

• 한국자동차공학회논문집
• /
• 제11권4호
• /
• pp.211-219
• /
• 2003

The main study experiments to obtain engine torque of the vehicle during performance test of the recent automobile. Torque was measured through the engine dynamometer to produces engine torque of the vehicle but the research method calculated engine torque of the vehicle without the engine dynamometer. The performance of the vehicle receive various running resistance. The study certificates performance of certification before a certification of used vehicle didn't carry out and certificate. This way evaluated on road test and chassis dynamometer The result of the study shows that it is much possible to apply the test. After comparing the engine torque of road driving with that of chassis dynamometer, the results are approximately the same. When rapidly speeded up, the road-load vehicle can pitch in some degrees, which may result in the fluctuations of acceleration, and then affect on the engine torque. Therefore it is confirmed that this method is easier way to measure the performance of vehicles.

• 한국해안해양공학회지
• /
• 제19권6호
• /
• pp.596-605
• /
• 2007

본 연구에서는 파랑이 존재하는 수역에서 수평방향으로 분사되는 비부력 원형 난류제트의 거동을 검토하기 위해 수리실험을 수행하였다. 난류제트의 유속은 PIV(particle image velocimetry)기법을 이용하여 측정하였으며, 측정된 순간유속장을 위상평균하여 평균유속장으로 계산하였다. 수리실험에서는 상대적으로 작은 파고의 규칙파가 사용되었으며, 파랑의 분산이 난류제트의 확산현상에 미치는 영향을 제트의 중심선유속과 횡단면유속의 변화를 통하여 관찰하였다. 또한 파랑의 위상변화에 따른 제트 거동을 파악하기 위하여 다른 세 위상순간에서 제트의 거동을 비교하였다. 제트의 중심선유속은 파고가 커짐에 따라 감소하였으며, 횡단면의 폭은 증가함을 알 수 있었다. 제트의 횡단면유속분포 특성인 자기상사성은 파고가 증가할수록 약해졌으나 축방향으로의 단면폭의 변화는 크지 않았다. 또한 파고에 대한 제트의 변화에 비해 파랑 위상에 대해서는 변화가 작음을 알 수 있었다.

• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 1999년도 가을 학술발표회 논문집
• /
• pp.357-364
• /
• 1999

In recently site investigations, the need for the determination of dynamic soil properties such as dynamic modules of rigidity, elasticity, dynamic poison's ratio and damping ratio etc. is increasing for the astigmatic designs of the civil structures. To obtain some of the dynamic properties, measurement of elastic waves velocity, both P and S wave, is required. Among various methods to measure elastic wave velocity such and Down Hole, Cross Hole and Refraction etc., Suspension P.S. Logging has an advantage to use for the off-shore investigation where generation of the shock wave and traveling of the wave is difficult. In suspension P.S. logging, specially designed prove equipped with source of shock wave, two 3-channel receivers, departing 1m distance, and other auxiliary facilities is inserted down in a bore hole bottom and raised in predetermined interval, usually 1m or 2m, and measurement is conducted. P.S. logging have been conducted in a off-shore construction project near InChon in the west coast for the first in the country, and form the result, potential of the liquefaction of the subsoil was evaluated and compared with the conventional method.