• Environmental Analysis Health and Toxicology
• /
• 제21권4호
• /
• pp.317-322
• /
• 2006

We have investigated the genotoxicity of 1,2,4-trimethylbenzene using Ames reverse mutation test. In Ames reverse mutation test, 1,2,4-trimethylbenzene treatment at the dose of 100, 50, 25, 12.5, $6.25{\mu}g/plate$ did not induce mutagenicity in Salmonella typhimurium TA98, TA100, TA1535, TA1537 and in Escherichia coli WP2uvrA with and without metabolic activation. These results indicate that 1,2,4-trimethylbenzene has no mutagenic potential under the rendition in this study.

• 한국지반공학회논문집
• /
• 제25권7호
• /
• pp.55-64
• /
• 2009

본 연구에서는 실제 현장조건을 고려하여 토목섬유의 화학저항성을 측정하기 위한 개선된 시험방법이 제안되었다. 이를 위하여 시공조건에 가장 근접한 시험법을 규격화하기 위한 인덱스 및 성능시험이 실시되었으며, Arrhenius 식에 의한 가속모델을 적용하여 실험 데이터를 해석하였다. 전반적인 실험 결과를 분석, 비교하여 현장 시공조건에 부합한 개선된 토목섬유의 화학저항성 시험방법을 확립하고 그 가능성을 제시하였다.

• 한국콘크리트학회:학술대회논문집
• /
• 한국콘크리트학회 1993년도 봄 학술발표회 논문집
• /
• pp.1-5
• /
• 1993

In the country, due to short comings of natural aggregates of good quality, it is common to use crushed stones. However, the investigation has not been done on the chemical reaction of crushed stones. This study tested and analyzed the aggregate chemical reaction by petrographic examination(ASTM C 295) for the test aggregates which had been tested by chemical method(ASTM C 289) in the first year. As a result, most of test aggregates didn't show any reaction but many have common deleterious mineral. Therefore, there exists the possibility of chemical reaction in petrogrphic point of view

• Korean Journal of Chemical Engineering
• /
• 제35권11호
• /
• pp.2290-2295
• /
• 2018

An acceleration stress test (AST) was performed to evaluate the durability of a polymer membrane in a polymer electrolyte membrane fuel cell (PEMFC) for 500 hours. Previous studies have shown that hydrogen crossover measured by linear sweep voltammetry (LSV) increases when the polymer membrane deteriorates in the AST process. On the other hand, hydrogen crossover of the membrane often decreases in the early stages of the AST test. To investigate the cause of this phenomenon, we analyzed the MEA operated for 50 hours using the AST method (OCV, RH 30% and $90^{\circ}C$). Cyclic voltammetry and transmission electron showed that the electrochemical surface area (ECSA) decreased due to the growth of electrode catalyst particles and that the hydrogen crossover current density measured by LSV could be reduced. Fourier transform infrared spectroscopy and thermogravimetric/differential thermal analysis showed that -S-O-S- crosslinking occurred in the polymer after the 50 hour AST. Gas chromatography showed that the hydrogen permeability was decreased by -S-O-S- crosslinking. The reduction of the hydrogen crossover current density measured by LSV in the early stages of AST could be caused by both reduction of the electrochemical surface area of the electrode catalyst and -S-O-S- crosslinking.

• Corrosion Science and Technology
• /
• 제15권2호
• /
• pp.84-91
• /
• 2016

The transport and deposition of corrosion products in pressurized water nuclear reactor (PWR) steam generators have led to corrosion (SCC, denting etc.) problems. Lancing, mechanical cleaning and chemical cleaning have been used to reduce these problems. The methods of lancing and mechanical cleaning have limitations in removing corrosion products due to the structure of steam generator tubes. But high temperature chemical cleaning (HTCC) with EDTA is the most effective method to remove corrosion products regardless of the structure. However, EDTA in chemical cleaning aqueous solution and chemical cleaning environments affects the integrity of materials used in steam generators. The nuclear power plants have to perform the pre-test (also called as qualification test (QT)) that confirms the effect on the integrity of materials after HTCC. This is one of the series studies that assess the effect, and this study determines the effects of 20 % EDTA aqueous solution on defective tubes in high temperature chemical cleaning environments. The depth and magnitude of defects in steam generator (SG) tubes were measured by eddy current test (ECT) signals. Surface analysis and magnitude of defects were performed by using SEM/EDS. Corrosion rate was assessed by weight loss of specimens. The ECT signals (potential and depth %) of defective tubes increased marginally. But the lengths of defects, oxides on the surface and weights of specimens did not change. The average corrosion rate of standard corrosion specimens was negligible. But the surfaces on specimens showed traces of etching. The depth of etching showed a range on the nanometer. After comprehensive evaluation of all the results, it is concluded that 20 % EDTA aqueous solution in high temperature chemical cleaning environments does not have a negative effect on defective tubes.

• Safety and Health at Work
• /
• 제6권3호
• /
• pp.184-191
• /
• 2015

Chemical mutagenicity is a major hazard that is important to workers' health. Despite the use of large amounts of allyl chloride, the available mutagenicity data for this chemical remains controversial. To clarify the mutagenicity of allyl chloride and because a micronucleus (MN) test had not yet been conducted, we screened for MN induction by using male ICR mice bone marrow cells. The test results indicated that this chemical is not mutagenic under the test conditions. In this paper, the regulatory test battery and several assay combinations used to determine the genotoxic potential of chemicals in the workplace have been described. Further application of these assays may prove useful in future development strategies of hazard evaluations of industrial chemicals. This study also should help to improve the testing of this chemical by commonly used mutagenicity testing methods and investigations on the underlying mechanisms and could be applicable for workers' health.

• 한국신뢰성학회지:신뢰성응용연구
• /
• 제7권1호
• /
• pp.31-43
• /
• 2007

The function of O-ring seals is to prevent leakage during the service life of the components in which they are installed. The life prediction of O-ring is very important at various industry fields. Generally, to evaluated the long-term performance of O-ring in severe environments has applied a life prediction technique based on accelerated life test (ALT). In this work, Accelerated thermal aging test(l20, 130, 140, $150^{\circ}C$) of O-ring was applied for life prediction of O-ring. The property changes after thermal aging test was measured using TGA, DSC, FT - IR, Video Microscope and SEM. Shape parameter and life prediction were obtained using MINITAB program.

• 한국환경농학회지
• /
• 제37권3호
• /
• pp.229-234
• /
• 2018

In vitro 소핵시험(vitMNT)은 유전독성의 유망한 대체시험법 중 하나로, OECD에서 TG로 채택되어 화학물질의 등록에 사용되고 있다. 본 시험에서는 CHL cell을 사용한 vitMN test에서 소핵을 판별하기 위한 최적화된 세포질 조건을 찾고자 하였으며, 양성대조물질로 MMC와 Col을 사용하고 세포 염색을 위해 giemza 용액을 사용하였다. 시험결과, 세포현탁을 위해 사용되는 고정액의 acetic acid의 농도는 1%로 하는 것이 band의 두께와 세포질의 퍼짐성 측면에서 적당하였다. 또한 세포의 깨짐을 최소화하는 최종 고정액의 적하시간은 현탁 후 1~4시간이었다. 이러한 결과는 vitMNT에서 소핵관찰의 신속성, 용이성 및 정확성을 확보하는데 도움이 될 것이다.

• 한국소성가공학회:학술대회논문집
• /
• 한국소성가공학회 2006년도 춘계학술대회 논문집
• /
• pp.234-238
• /
• 2006

In this research, an analysis of damaged instance and forming fault for disc part in automotive steel wheel was performed. Rolled steel material, which had been used in the manufacturing of the damaged disc part, was prepared for tensile test, quantitative analysis of chemical component and acquirement of scanning electron microscope images. Although the results of mechanical properties and chemical component ratio for the material satisfied the suggested specification, some material inherent problem was found in the scanning electron microscope images. Finally, in an analysis of chemical component for the damaged disc part used in road condition, mismatching of chemical component ratio between the suggested specification and test result was found.

• Tribology and Lubricants
• /
• 제18권5호
• /
• pp.319-323
• /
• 2002

Polyol esters were synthesized by condensation reaction of polyols (PE and DiPE) and linear acids such as valeric acid, caproic acid, heptylic acid and caprylic acid. The structures of polyol esters were confirmed by gas chromatography. Hot tube test was used test was used to measure thermal stability of polyol esters and its thermal properties depended on the structure of acid moiety contained in polyol esters.