• Transactions on Electrical and Electronic Materials
• /
• v.11 no.4
• /
• pp.170-173
• /
• 2010

Nanocrystalline cadmium sulfide (CdS) thin films were prepared using chemical bath deposition in a solution bath containing $CdSO_4$, $SC(NH_2)_2$, and $NH_4OH$. The CdS thin films were investigated using X-ray diffraction (XRD), photoluminescence (PL), and Fourier transform infrared spectroscopy (FTIR). The as-deposited CdS thin film prepared at $80^{\circ}C$ for 60 min had a cubic phase with homogeneous and small grains. In the PL spectrum of the 2,900 A-thick CdS thin film, the broad red band around 1.7 eV and the broad high-energy band around 2.7 eV are attributed to the S vacancy and the band-to-band transition, respectively. As the deposition time increases to over 90 min, the PL intensity from the band-to-band transition significantly increases. The temperature dependence of the PL intensity for the CdS thin films was studied from 16 to 300 K. The $E_A$ and $E_B$ activation energies are obtained by fitting the temperature dependence of the PL intensity. The $E_A$ and $E_B$ are caused by the deep trap and shallow surface traps, respectively. From the FTIR analysis of the CdS thin films, a broad absorption band of the OH stretching vibration in the range $3,000-3,600\;cm^{-1}$ and the peak of the CN stretching vibration at $2,000\;cm^{-1}$ were found.

• Journal of the Korean institute of surface engineering
• /
• v.41 no.1
• /
• pp.28-32
• /
• 2008

In this paper CdS thin films, which were widely used window layer of the CdS/CdTe and the CdS/$CuInSe_2$ heterojunction solar cell, were grown by chemical bath deposition, which is a very attractive method for low-cost and large-area solar cells, and the structural, optical and electrical properties of the films was studied. As the thiourea/$CdAc_2$ mole ratio was increased, the deposition rate of CdS films prepared by CBD was increased due to increasing reaction velocity in solution and the optical bandgap was increased at higher thiourea/$CdAc_2$ mole ratio due to larger grain size and continuous microstructure. The minimum resistivity of the films was at thiourea/$CdAc_2$ mole ratio of 3.

• Proceedings of the Korea Crystallographic Association Conference
• /
• 2000.11a
• /
• pp.23-23
• /
• 2000

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.14 no.2
• /
• pp.104-110
• /
• 2001

Structural, optical and electrical properties of Cd$_{1-x}$ Zn$_{x}$S films deposited by chemical bath deposition(CBD), which is a very attractive method for low-cost and large-area solar cells, are presented. Especially, in order to control more effectively the zinc component of the films, zinc acetate, which was used as the zinc source, was added in the reaction solution after preheating the reaction solution and the pH of the reaction solution decreased with increasing the concentration of zinc acetate. The films prepared after preheating and pH control had larger zinc component and higher optical band gap. The crystal structures of Cd$_{1-x}$ Zn$_{x}$S films was a wurtzite type with a preferential orientation of the (002) plane and the lattice constants of the films changed from the value for CdS to those for ZnS with increasing the mole ratio of the zinc acetate. The minimum lattice mismatch between Cd$_{1-x}$ Zn$_{x}$S and CdTe were 2.7% at the mole ratio of (ZnAc$_2$)/(CdAc$_2$+ZnAc$_2$)=0.4. As the more zinc substituted for Cd in the films, the optical transmittance improved, while the absorption edge shifted toward a shorterwavelength. the photoconductivity of the films was higher than the dark conductivity, while the ratio of those increased with increasing the mole ratio of zinc acetate. acetate.

• Applied Science and Convergence Technology
• /
• v.27 no.2
• /
• pp.38-41
• /
• 2018

We demonstrate the growth of a sheet-like ZnO membrane on ZnO nano rod layers. The growth process is composed of 3 steps of ZnO seed formation, ZnO nano rod growth and sheet-like ZnO membrane formation on those nano rods. To confirm the fundamental growth mechanism, the lattice structures of each step were analyzed by X-ray diffraction (XRD) and scanning electron microscope (SEM) measurement. Analysis of the relation between the texture coefficient and the surface shape of the ZnO membrane on the ZnO nano rods shows that the surface morphology of ZnO nano structures can be controlled using the temperature of the growing solution and the concentration of the chemical solution.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.24 no.8
• /
• pp.616-621
• /
• 2011

In this paper, CdS thin films, which were widely used window layer of the CdTe and the Cu(In,Ga)$Se_2$ thin film solar cell, were grown by chemical bath deposition, and effects of pH of reaction solution on the structural and optical properties were investigated. For pH<10.5, as the pH of reaction solution was higher, the deposition rate of CdS films was increased by improving ion-by-ion reaction in the substrate surface and the crystallinity of the films was improved. However, when the pH was higher than 10.5, the deposition rate was decreased because of smaller $Cd^{2+}$ ion concentration in the reaction solution. Also, the crystallinity of the films were deteriorated. The CdS films deposited at lower pH showed poor optical transmittance due to adsorbed colloidal particles, while the transmittance was improved for higher pH.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.31 no.3
• /
• pp.177-181
• /
• 2018

We prepared ZnS thin films via chemical bath deposition (CBD) in an aqueous solution of ammonia ($NH_3$) and hydrazine ($N_2H_4$). The composition ratio of hydrazine used was 0%, 17%, 22%, 29%, or 50%. We investigated the effects of hydrazine and ammonia on the growth, and the structural and optical properties of ZnS in terms of surface uniformity, voids, and grain size. We found that during the growth of ZnS films, hydrazine was very effective for improving the surface morphology and layer uniformity with fast layer formation, while it had no effect on the bandgap energy, $E_g$.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.18 no.3
• /
• pp.199-205
• /
• 2005

Polycrystalline cadmium sulfide(CdS) thin films were deposited on glass substrate by chemical bath deposition(CBD) and vacuum evaporation (VE) techniques. VE-CdS films consisted primarily of hexagonal phase, whereas CBD CdS films containing primarily the cubic form. VE-grown films were shown to have better crystallinity than CBD-grown films. The grain size of the CBD films is smaller than the ones of VE films. VE-CdS films exhibited relatively high transmittance in the above-gap region and band gap compared with CBD films. However, CdTe solar cells with these low quality CBD-CdS layers yield higher and more stable characteristics. Current-voltage-temperature measurements showed that the current transport for both cells was controlled by both tunneling and interface recombination but the cells with CBD-CdS displayed less tunneling.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.22 no.8
• /
• pp.682-688
• /
• 2009

A periodic away of zinc oxide(ZnO) micro-rods as fabricated by using chemical bath deposition and photo-lithography. Vertically aligned ZnO micro-rods array was successfully grown by chemical bath deposition method on ZnO seed layer. The ZnO seed layer was deposited on glass and the patterning was made by standard photo-lithography technique. The selective growth of ZnO micro-rods as achieved with the masked ZnO seed layer. The fabricated ZnO micro rods were found to be single crystalline and have grown along hexagonal c-axis direction of (0002) which is same as the preferred growth orientation of ZnO seed layer.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.9 no.2
• /
• pp.117-123
• /
• 2009

$Pb_{x}Cd_{1-x}S$ films are prepared in the composition range of 0.05${\leq}x{\leq}$0.25, using a chemical bath deposition growth technique under optimum conditions amide at realizing good photo response. The x-ray diffraction results show that the films are of PbS-CdS composite with individual CdS and PbS planes. The films exhibit two direct band gaps, 2.4 eV attributed to CdS, while the other varies continuously from 2.4 eV to 1.3 eV. The films surface morphology is smooth with crystallite, whose grain size increases with increasing mole fraction (x). The decrease in band gap with increase in lead concentration suggests inter-metallic compound of PbS (Eg=0.41 eV) with CdS (Eg=2.4 eV)