• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.17 no.2
• /
• pp.207-211
• /
• 2004

We have performed computer simulation to obtain a globa1 optimization of power consumption and viewing angle characteristic of reflective twisted nematic (R-TN) mode liquid crystal display (LCD) with sin81e polarizer and λ/4 plate. Our studies shout that with increasing the twist angle, a steepness of reflectance-voltage curve increase, operation voltages decreases, the region where contrast ratio (CR) greater than 10 increases but the reflectance of the white state starts to decrease at above the twist angle of 75$^{\circ}$. Above the twist angle of 90$^{\circ}$, the R-TN mode LCD shows the most favorable combination of low consumption and good viewing angle characteristic.

• Journal of the Ergonomics Society of Korea
• /
• v.18 no.1
• /
• pp.91-108
• /
• 1999

In our previous work using a motion analyzer and 3-dimensional sonic digitizer, the arm shapes for 23 women in their early twenties were classified into three characteristic types. In order to design sleeves, suitable for arm movements for the three characteristic arm shapes, a relationship between arm length variation and shoulder/elbow angles has been investigated for four cases of arm movements (flexion, extension, adduction and abduction). Each arm movement can be characterized by the changes in shoulder angle and the changes in elbow angle at the maximal shoulder angle. In all the four cases of arm movements, the changes of shoulder length and cap height are largest at the maximal shoulder angle. These changes were little affected by changes in elbow angle. The changes in the lower arm length and the difference between cap height and upper arm length are the largest at the maximal elbow angle of the maximal shoulder angle. There is a linear relationship between cap height and shoulder angle during arm movements; thus, in designing sleeves the cap height can be determined from the regression of cap height vs. shoulder angle.

• Progress in Superconductivity and Cryogenics
• /
• v.16 no.1
• /
• pp.27-31
• /
• 2014

2G HTS tapes are widely used for various electric machines. In addition, stacked or parallel connected HTS tapes are essentially used to raise transport current level for large capacity electric machines. Therefore, critical current characteristic of stacked tapes need to be studied. Recently developed 2G HTS tapes are fabricated with various defects doping so that tapes possess pinning center to improve the critical current characteristic. During this process, the critical current is determined minimum value in not perpendicular magnetic field but a specific magnetic field angle according to the reported research. However, the effects of magnetic field angle to critical current of multi-stacked 2G HTS tapes have not been examined. In this paper, field coil which is a race-track coil wound by using an HTS tape with iron-core was fabricated to apply angle adjustable magnetic field to the 2G HTS tape samples. We measured critical current of single and multi-stacked two tapes that have different characteristic depending on various magnetic field angle and magnitude in liquid nitrogen environment. Furthermore, results of single and multi-stacked tapes were compared and analyzed.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2009.06a
• /
• pp.32-33
• /
• 2009

We propose viewing angle switchable liquid crystal display(LCD) associated with fringe-field switching (FFS) mode with high aperture ratio characteristic. This device is composed of R(red), G(green), B(blue), pixel and W(white) pixel in which R,G,B pixel shows image and white pixel for both viewing angle control and image. Conventional viewing angle controllable liquid crystal display has not transmittance because the liquid crystal only tilts up without rotates in viewing angle control region. In this paper, we suggested that the device has high transmittance characteristic because the LC directors are rotated in which viewing angle control region are generated fringe electric field.

• Geomechanics and Engineering
• /
• v.28 no.2
• /
• pp.107-116
• /
• 2022

The steady state of unsaturated soil takes a long time to achieve. The soil seepage behaviours and hydraulic properties depend highly on the wetting/drying rate. It is observed that the soil-water characteristic curve (SWCC) is dependent on the wetting/drying rate, which is known as the dynamic effect. The dynamic effect apparently influences the scanning curves and will substantially affect the seepage behavior. However, the previous models commonly ignore the dynamic effect and cannot quantitatively describe the hysteresis scanning loops under dynamic conditions. In this study, a dynamic hysteresis model for SWCC is proposed considering the dynamic change of contact angle and the moving of the contact line. The drying contact angle under dynamic condition is smaller than that under static condition, while the wetting contact angle under dynamic condition is larger than that under static condition. The dynamic contact angle is expressed as a function of the saturation rate according to the Laplace equation. The model is given by a differential equation, in which the slope of the scanning curve is related to the slope of the boundary curve by means of contact angle. Empirical models can simulate the boundary curves. Given the two boundary curves, the scanning curve can be well predicted. In this model, only two parameters are introduced to describe the dynamic effect. They can be easily obtained from the experiment, which facilitates the calibration of the model. The proposed model is verified by the experimental data recorded in the literature and is proved to be more convenient and effective.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.22 no.9
• /
• pp.840-846
• /
• 2011

In this paper, reflection and RCS characteristic of the EGS(Electromagnetic Gradient Surface) due to incident angle and polarization is analyzed. Incident angle, ${\theta}_i$, is rotated from $0^{\circ}$ to $50^{\circ}$ with $10^{\circ}$ steps and perpendicular and parallel polarization of incident wave are also considered each incident angle. Reflection and RCS characteristic is not much affected by variation of polarization for normal incidence(${\theta}_i=0^{\circ}$). Reflection pattern has different characteristic due to variation of incident angle and polarization but the EGS has about 2 dB of RCS difference due to polarization in RCS characteristic.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.9 no.1
• /
• pp.75-83
• /
• 2001

In this paper, numerical analysis is used to find the effects of inclination of rear end on flow characteristic around an automobile. The reference slant angle of rear end is 28.6$^{\circ}$, the slant angle of rear end is decreased to 24$^{\circ}$, 26.6$^{\circ}$ and also increased to 31.6$^{\circ}$, 36.4$^{\circ}$. The 3-D incompressible Navier-Stockes equations are solved by the iterative time marching scheme. The computed surface pressure coefficients were compared with experimental results and a good agreement has been achieved. The A- and C-pillar vortex and other flow phenomena around the ground vehicle are evidently shown. The variation of aerodynamic coefficients of drag, lift with respect to inclination angle of rear end are systematically studied. The flow characteristic on the automobile surface with respect to change of inclination of rear end have been also studied.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2010.06a
• /
• pp.173-173
• /
• 2010

We proposed viewing angle switchable liquid crystal display(LCD) associated with fringe-field switching (FFS) mode with high aperture ratio characteristic. In the device, single pixel is separated into two regions, named as main pixel for displaying images and sub pixel for viewing angle control. In sub pixel region, add the common electrode on the top substrate and the initial alignment of liquid crystal is Hybrid Alignment Nematic (HAN) state. In conclusion, we suggested that the device has high aperture ratio characteristic because the LC directors are rotated in which viewing angle control region are generated fringe electric field.

• Journal of ILASS-Korea
• /
• v.4 no.4
• /
• pp.30-37
• /
• 1999

The breakup characteristics of liquid sheet formed by the liquid rocket injector has a close relation with the combustion efficiency. In this paper, basic characteristics of droplet size and velocity distribution were measured with PDPA for the Like Doublet Impinging Injector. Test variables were the angle of impact, the diameter of orifice and jet velocity. Water was used as test fluid. As a result, for impingement angle less than 90 degree, following correlations were obtained between drop size and design parameters : $D_{32}({\mu}m)=295.0{\times}V^{-0.09}\times(2\theta)^{-0.1}{\times}d^{0.072}$. For impingement angle greater than 100 degree, drop sizes were increased but eventually converged to a certain limiting value.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.16 no.12
• /
• pp.8901-8907
• /
• 2015

Conventional streetlight with the not-adjustable light distribution characteristic is generating light pollution such as glare, damage to the crops and disturbed sleep, because beam of streetlight is not distributed evenly according to the surrounding areas and road conditions. In this paper, we proposed the new structure LED streetlight controlled light irradiation angle according to the surrounding areas and road conditions. Proposed LED streetlight are available to the adjustable light distribution characteristic using the half-circle angle control device. Result of measurement and simulation, beam angle is made available to control at least from $100^{\circ}$ up to $154^{\circ}$, average illumination exceeded 15% of KS regulation and overall uniformity exceeded more than 50% of KS regulation. the Developed large capacity LED streetlight luminaire is considered to minimize glare and light pollution and optimize uniformity ratio of illuminance.