• Journal of Environmental Science International
• /
• v.26 no.12
• /
• pp.1333-1339
• /
• 2017

Coal-fired power plants emit various Particulate Matter(PM) at coal storage pile and ash landfill as well as the stack, and affect the surrounding environment. Field Emission Scanning Electron Microscopy and Energy Dispersive X-ray analyzer(FE-SEM/EDX) were used to develop identification factor and the physico-chemical analysis of PM emitted from a power plant. In this study, three samples of pulverized coal, bottom ash, and fly ash were analyzed. The pulverized coal was spherical particles in shape and the chemical composition of C-O-Si-Al and C/Si and C/Al ratios were 200~300 on average. The bottom ash was spherical or non-spherical particles in shape, chemical composition was O-C-Si-Al-Fe-Ca and C/Si and C/Al ratios were $4.3{\pm}4.6$ and $8.8{\pm}10.0$. The fly ash was spherical particles in shape, chemical composition was O-Si-Ai-C-Fe-Ca and C/Si and C/Al ratios were $0.5{\pm}0.2$ and $0.8{\pm}0.5$.

• Journal of the Korean GEO-environmental Society
• /
• v.25 no.5
• /
• pp.29-37
• /
• 2024

This study aimed to investigate the changes in chemical components that occur when weak clay is mixed with steel slag modified with calcium oxide, and to understand the expression characteristics of compressive strength according to hydrophilicity and curing time. XRF testing, SEM imaging, vane shear strength and uniaxial compressive strength testing were conducted. Calcium (Ca) released from the steel slag increases the Ca content in clay by increasing the number of crystal particles and forming a coating layer known as calcium silicate hydrate (CaO-SiO₂-H₂O) through chemical reactions with SiO₂ and Al₂O₃ components. The weak clay stabilized with steel slag is classified into an initial inactive zone where strength relatively does not increase and an activation zone where strength increases over curing time. The vane shear strength of the initial inactive area was found to be 4.4 to 18.4 kN/m² in the state of the weight mixing ratio Rss 30% (steel slag 30% + clay 70%). In the case of the active area, the maximum uniaxial compressive strength increased to 431.8 kN/m² after 480 hours of curing time, which increased due to the apparent adhesion strength of clay through pozzolanic reaction. Therefore, considering the strength expression characteristics of stabilized mixed clay based on the mixing ratio (Rss) during the recycling of steel slag can enhance its practicality in civil engineering sites.

• Journal of the Korean Magnetics Society
• /
• v.6 no.4
• /
• pp.204-210
• /
• 1996

M type hexa-ferrites were prepared by means of a solid state reaction using mill scale, $Fe_{2}O_{3}$, and the mixture of mill scale and $Fe_{2}O_{3}$. The mixture of powders were calcined at $1150^{\circ}C$ for 2 hrs. and sintered at $1250^{\circ}C$ for 2 hrs, with varing the mole ratio of $Fe_{2}O_{3}$/$BaCO_{3}$, by 5.2~6.0. And the magnetic properties and morphologies of Baferrites with impurities such as $SiO_{2},\;Al_{2}O_{3},\;MgO,\;CaO\;and\;Na_{2}O$ in the mill scale were investigated. The magnetic properties were worsened by the addition of $Na_{2}O because of non-reacted iron oxide and intermediate compound of $BaFe_{2}O_{4}$ but they were improved apparently by the addition of $Si_{2}$ and $Al_{2}O_{3}$ in the composition of $BaO.5.6Fe_{2}O_{3}$. Moreover, $M_{s}$ decreased but $_{B}H_{C}$ increased through the addition of $Al_{2}O_{3}$ in Ba-ferrite. ${(BH)}_{max}$ of sintered BM($BaCO_{3}$, mill scale mixture) and BFM($BaCO_{3}$, $Fe_{2}O_{3}$, and null scale mixture) were 0.86 and 1.04 MGOe, respectively, and the magnetic properties were changed around $440^{\circ}C$.

• The Journal of the Petrological Society of Korea
• /
• v.12 no.3
• /
• pp.135-153
• /
• 2003

In order to understand its origin and petrogenesis, petrochemical studies of major, trace elements, REE, and stable isotopes of oxygen and carbon from the Hongcheon Fe-REE deposits have been investigated. The Hongcheon Fe-REE deposit intruding into Precambrian metasedimentary rocks consists of magnetite, various carbonates such as ankerite, siderite, magnesite and strontianite, monazite, aegirine-augite, Na-amphibole, and sulfides. Compared with major elements abundances of typical ferro-carbonatites, the Hongcheon Fe-REE deposit is enriched in FeO and depleted in CaO with increasing of $SiO_2$, where $TiO_2$and $A1_2O_3$increased and CaO, FeO, MgO and $P_2O_5$ are slightly decreased, but those are rather scattered and their trends are somewhat ambiguous. V Ni, U and Rb slightly increasing with of $SiO_2$increase and scattering or no trends of other detected elements. Nb, Zr and Zn are depleted then the abundances of typical ferro-carbonatites (Woolley and Kempe, 1989). In rare earth elements a large enrichment of total REE (maximum 14.8 wt%) and LREE relative to chondrites and HREE depleted more then the values of ferro-carbontites therefore La/Lu ratios shows large abundances (max. 16,197). The results of stable isotopes of O and C from minerals of ankerite and strontianite and whole rocks represent studied rocks are from igneous carbonatitic melts. Although petrochemical characteristics of the Hongcheon Fe-REE deposits are somewhat different from normal ferro-carbonatites from the world, this discrepancy suggests another conclusion that petrochemical characteristic of the studied Fe-REE mineralized rocks are similar to those of phoscorites from Kovdor, Russia and Sokli, Finland showing the same petrochemical compositions described above.

• Journal of Powder Materials
• /
• v.25 no.6
• /
• pp.494-500
• /
• 2018

In this study, the effect of the content of $MgO-CaO-Al_2O_3-SiO_2$ (MCAS) glass additives on the properties of AlN ceramics is investigated. Dilatometric analysis and isothermal sintering for AlN compacts with MCAS contents varying between 5 and 20 wt% are carried out at temperatures ranging up to $1600^{\circ}C$. The results showed that the shrinkage of the AlN specimens increases with increasing MCAS content, and that full densification can be obtained irrespective of the MCAS content. Moreover, properties of the AlN-MCAS specimens such as microhardness, thermal conductivity, dielectric constant, and dielectric loss are analyzed. Microhardness and thermal conductivity decrease with increasing MCAS content. An acceptable candidate for AlN application is obtained: an AlN-MCAS composite with a thermal conductivity over $70W/m{\cdot}K$ and a dielectric loss tangent (tan ${\delta}$) below $0.6{\times}10^{-3}$, with up to 10 wt% MCAS content.

• Journal of the Korean Ceramic Society
• /
• v.34 no.7
• /
• pp.693-698
• /
• 1997

The refractive index and dispersion in the (100-x)(0.6CaO.0.4Al2O3).xSiO2(x=0~30) glasses were investigated. As the amount of SiO2 increased, the refractive index decreased. The change of refractive index was attributed to the change of the molar refraction rather than the molar volume. When the amount of SiO2 was smaller than 20 mol%, the average electronic transition energy gaps(E0) and the electronic oscillator strengths(Ed) were about 10.9($\pm$0.1) nd 18($\pm$0.5)eV, respectively. However E0 and Ed of the glass (CAS30) with 30 mol% SiO2 increased to 12.63 and 19.89eV, respectively. The similar results was observed in the variation of Abbe Number. Abbe number of the glass in the range of 0~20 mol% SiO2 was about 46 and that of CAS30 increased to 60. The zero-material dispersion wavelength({{{{ lambda }}0) of pure calcium aluminate glass was 1.8 ${\mu}{\textrm}{m}$. As the amount of SiO2 increased, the zero-material dispersion wavelength shifted to a shorter wavelength. {{{{ lambda }}0 of CAS30 was 1.5 ${\mu}{\textrm}{m}$, that is currently using for the optical telecommunication system.

• Korean Journal of Soil Science and Fertilizer
• /
• v.12 no.3
• /
• pp.153-167
• /
• 1979

Proposal on the ways to determine the optimum levels of nutrients application on rice to maximize the yield was made paying attention on the desirable ratios among the major nutrients including N (organic matter) K, $SiO_2$, Ca, Mg. Following are the summary of the discussion. 1. For the higher yields, the balanced nutrients absorption is important. 2. Silica plays an important role in leading the applied N to increased yield. 3. Level of N application should be determined taking account of soil organic matter and abailable silicate contents. The higher the ratio of $SiO_2$/O.M. the more N can be applied for higher yield. 4. Different rice cultivars responds to the ratio of $SiO_2$/O.M. in soils, in different manner, in translating the applied N into yield. 5. By altering the ratio of $SiO_2$/O.M. through the application of silicate fertilizer or organic matter, the requirement of N in accordance with varietal characteristics can be determined. 6. When amount of N determined by above mentioned approaches, level of K application can be determined upon the basis of the ratio of $K/\sqrt{Ca+Mg}$ in soils.

• Economic and Environmental Geology
• /
• v.34 no.1
• /
• pp.55-70
• /
• 2001

Granitoids in the Younggwang-Kimje area can be divided into two types of granite. One is foliated granite (Cheongup and Kochang foliated granites) developed along the NE-SW direction kwangju fault system and the other is undeformed granite (Kimje and Younggwang granites) developed in the western part of the area. $SiO_2$ content of study area, Younggwang granite is 62.8-74.0%, Kochang foliated granite is 64.5-74.4%, Cheongup foliated granite is 64.5-70.2%, Kimje granite is 63.4-72.0%. The result indicated that these granitoids belong to the intermediate and acidic rock. In Harker's diagram, as $SiO_2$ increases, $Al_2O_3$, $Fe_2O_3$, MgO, CaO, $TiO_2$> $P_2O_{5}$s and MnO decrease, but $K_2O$ increases. In AFM diagram, Younggwang granite, Kochang foliated granite, Cheongup foliated granite and Kimje granite belong to calk-alkaline rock series. And in triangular diagrams of normative Qz-Or-Pl and An-Ab-Or, they are located in granodiorite and granite region. On the co-variation diagrams of trace elements with silica, Ba, Co, Li, Nb, An, Rb elements show increasing patterns. The diagrams of ACF and $Na_2O$ vs. $K_2O$ ratios indicate that granitoids of the study area belong to I-type.

• Transactions of Materials Processing
• /
• v.15 no.3 s.84
• /
• pp.213-219
• /
• 2006

To improve the strength of glass is being studied in order to contribute to weight saving of flat panel displays. Generally, the strength achieved of glass-ceramics is higher as is the fracture toughness by the formation of a heterogeneous phase inside glass. In this study, Ag-doped $45SiO_2-24CaO-24Na_2O-4P_2O_5\;and\;70SiO_2-10CaO-24Na_2O-10TiO_2$ glasses were irradiated to strengthen by crystallization using femto-second laser pulse. XRD, Nano-indenter and SEM etc., irradiation of laser pulse without heat-treated samples was analyzed. Samples irradiated by laser had higher value($4.4{\sim}4.56^*10-3Pa$) of elastic modulus which related with strength of glass than values heat-treated samples and these are $1.2{\sim}1.5$ times higher values than them of mother glass. This process can be applicable to the strengthening of thinner glass plate, and it has an advantage over traditional heat-treatment and ion-exchange method.

• Journal of the Korean Ceramic Society
• /
• v.22 no.5
• /
• pp.35-42
• /
• 1985

$eta$-Sialon powders were prepared by reduction-nitridation from mixture of Wando pyrophyllite and graphite as a reducing agent at 135$0^{\circ}C$ in 80% $N_2$-20% $H_2$ atmosphere. As the reaction products $Si_2ON_2$, $\beta$-$Si_3N_4$ a--$Si_3N_4$ and $\beta$-SiC were observed. Additive agents of MgO, CaO, $Y_2O_3$ were used for promoting the reduction and nitridiation aeaction. The present study was conducted to investigate the effects of silica-carbon ratio ($SiO_2$/C=weight ratio), raction time gas flow rate pellet size and powder packing on synthesis of $\beta$-Sialon from Wando pyropyllite.