• Journal of the Korean Ceramic Society
• /
• v.28 no.1
• /
• pp.46-52
• /
• 1991

The hydroxyapatite powders were prepared by the reaction of Ca(CH3COO)2$.$H2O and H3PO4 in aqueous solution. Effect of Ca/P mole ration and pH value on the powder characteristics were investigated. For phosphoric acid was dissociated to PO43- ion above pH 10, the preparation condition of hydroxyapatite by H3PO4 solution had this value. Dried powders were agglomerated each other. The mean agglomerate particle diameter was minimum when the condition was pH 11, Ca/P=1.75 and its specific surface area was 97㎡/g. All powders had poor crystallinity and small CO2. It prevented CaCO3 from using aspirator in preparation and maturing time. In most cases, hydroxyapatite was decomposed into ${\beta}$-TCP at more than 800$^{\circ}C$, into ${\alpha}$-TCP at 1200$^{\circ}C$. However non-decomposed hydroxyapatite was remained in Ca/P=1.85.

• Applied Chemistry for Engineering
• /
• v.8 no.6
• /
• pp.1000-1005
• /
• 1997

The properties of ceramics by solid-state reaction with hydroxyapatite[$Ca_{10}(PO_4)_6(OH)_2$], which was isolated from tuna bone by wet milling process were investigated. The bulk density $2.93g/cm^3$ at $1350^{\circ}C$ was close to the calculated density $3.21g/cm^3$. On X-ray measurements, the major phases were identified as hydroxyapatite at below $1300^{\circ}C$, but the whitlockite [$Ca_3(PO_4)_2$] phases were appeared due to a decomposition of hydroxyapatite with temperature. The microstructures of sintering specimens were shown as small closed pores between grain boundaries. The mean bending strength of the sintered hydroxyapatite by solid-state reaction is about 58 MPa and this value is higher than that of the articular cartilage maximum strength, 40MPa.

• The Korean Journal of Ceramics
• /
• v.1 no.3
• /
• pp.131-136
• /
• 1995

It has been reported that the biocement obtained by mixing $CaO-SiO_2-P_2O_5$ glass powders with ammonium phosphate solution has biocompatibility as will as high strength. The hardening mechanism and hydroxyapatite forming mechanism were discussed when $53.6%CaO_1,\; 38.1%SiO_2,\; 7.7P_2O_6,\; 0.6%CaF_2$(mole %) glass powder was reacted with ammonium phosphate solution and reacted in tris-buffer solution, respectively. High strength hardened biocement was obtained for the specimen with $CaNH_4PO_4\;H_2O$ crystal when the glass powder was mixed with ammonium phosphate solution, and hydroxyapatite crystal was rapidly formed only in the sample with $CaNH_4PO_4\;H_2O$ crystal when it was reacted in tris-buffer solution.

• Journal of the Korean Ceramic Society
• /
• v.35 no.4
• /
• pp.330-330
• /
• 1998

Active belite cement clinkers were synthsized by using natural raw materials with borax and calcium phosphate ({{{{ {Ca }_{3 }( {PO}_{4}) }}2) In both case {{{{alpha ^、 {C }_{2 }S }} were formed but borax was more efficient. The cement syn-thesized with the addition of borax was hydrated with the addition of anhydrite(5 wt%) and slag(30wt%, 40wt% 50wt%) The addition of 50wt% slag with anhydrite was good for strength development in 7days and the compressive strength was developed to twice than no addition of slag at 28 days strength.

• Applied Biological Chemistry
• /
• v.30 no.1
• /
• pp.77-87
• /
• 1987

The mutant with high productivity, X. malvacearum SNUF 560-6, was acquired from the X. malvacearum SNUF 560 with low productivity by UV-light irradiation. It was preserved is lyophilized stock culture and it was transferred to PDA slant to maintain viability fortnightly. Fermentations were started by retransfering to MY agar slant from PDA stok culture. The experiments for optimal xanthan gum production were studied in a chemically defined medium. Of the carbon and nitrogen sources tested, 0.4% sucrose medium and 10mM glutamic acid medium yielded the highest xanthan gun production respectively. The addition of 10g/l succinic acid stimulated xanthan gum production. Also 65mM $PO_4\;^{-3}\;(12.6g/l\;KH_2PO_4)$ was effective on xanthan gum production. Finally, medium 1 and medium 2 which have high xanthan gum production potencies were achieved in this stud. The components of medium 1 and medium 2 were as follows: Medium 1 : sucrose 40g/l glutamate 10mM $PO_4\;^{-3}\;54mM\;(KH_2PO_4\;12.65g/l)$ Citrate 2g/l $MgSO_4{\cdot}7H_2O\;0.2g/l$ $H_3BO_3\;0.005/l$ ZnO 0.006/l $FeCl_2{\cdot}6H_2O\;0.0024g/l$ $CaCO_3\;0.02g/l$ Medium 2 : $Sucrose\;40g/l\;(NH_4)_2SO_4\;2g/l$ $PO_4\;^{-3}\;65mM\;(KH_2PO_4\;12.65g/l)$ Succinate 10g/l $MgSO_4{\cdot}7H_2O\;0.02g/l$ $H_3BO_3\;0.06g/l$ ZnO 0.006g/l $FeCl_2{\cdot}6H_2O\;0.0024g/l$ $CaCO_3\;0.02g/l$.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.15 no.6
• /
• pp.263-268
• /
• 2005

The ceramic balls impregnated with $20{\sim}40nm$ sized Ag colloid were examined for heavy metals absorption and antibacterial activities in the drinking water. The preparation conditions of ceramic ball that the porosity was excellent were as follows: starting material: 85 wt% $Ca_{10}(PO_4)_6(OH)_2$, binder: 5 wt% PVA and 15 wt% ${\alpha}-Ca_3(PO_4)_2$, heating temperature: $1000^{\circ}C$, duration: 3 hrs. The ceramic balls obtained under these conditions showed specific surface area of $110m^2/g$, pore size of $120{\mu}m$ and porosity of 80%. Also, as the results of a performance test on a rate of adsorbing and removing heavy metals in the drinking water by using the.AAS, heavy metals such as Zn, Mn, Fe and Cu were removed to the extent that their content became 0.03mg/l or lower after 1 day and they showed an excellent bactericidal activity that all coliforms were killed after 3 hrs.

• Horticultural Science & Technology
• /
• v.29 no.1
• /
• pp.29-35
• /
• 2011

Individual ion concentrations and ionic contributions to EC reading in the circulated nutrient solution are the important factors to be considered for stable EC-based closed-loop soilless culture. This study was conducted to determine appropriate ion-analysis intervals of the circulated nutrient solutions based on ion concentration, ion balance, and ion electrical conductivity under different renewal intervals in EC-based nutrient control systems for sweet peppers (Capsicum annum L. 'Fiesta') in early growth stage. Average node numbers of the plants were 13 and 18 when the experiment started and finished, respectively, and three plants were grown in each rockwool slab. Four different renewal intervals of circulated nutrient solutions such as 1, 2, 3, and 4 weeks were used as treatment. Nutrient solutions were supplied to the plants based on integrated radiation. Drainage was collected into drain tanks after irrigation ended in the day and then mixed with fresh water until the EC reaches 2.69 $dS{\cdot}m^{-1}$. The replenished nutrient solution was supplied to the plants in the next day. Ion concentrations of the individual ions periodically analyzed in the circulated nutrient solutions showed no significant differences among the treatments during the experimental period. Ion concentrations of $K^+$, $Ca^{2+}$, $Mg^{2+}$, $Na^+$, $NO_3{^-}$, ${SO_4}^{2-}$, ${PO_4}^{3-}$, and $Cl^-$ varied within 5-8, 11-14, 2.0-2.7, 0.5-0.6, 14-19, 4-5, 1-4, and 0.3-0.5 $meq{\cdot}L^{-1}$, respectively. Ion balance showed a consistent tendency over all the treatments and especially $K^+$ : $Ca^{2+}$ and ${SO_4}^{2-}$ : ${PO_4}^{3-}$ played great roles in the cation and anion balances in the nutrient solutions, respectively. Activity coefficients of ions such as $K^+$, $NO_3{^-}$, and $H_2PO_4{^-}$ varied within 0.8-0.9 and those of $Ca^{2+}$, $Mg^{2+}$, ${SO_4}^{2-}$ varied within 0.5-0.6, showing little changes with time. Ionic contributions of $K^+$ and $NO_3{^-}$ to EC reading were the greatest followed by $Ca^{2+}$, ${SO_4}^{2-}$, and $Mg^{2+}$ in the order. From the results, we thought that allowable ranges in ion concentration, ion balance, and subsequent individual ionic contributions to EC reading would be obtained within 4-week renewal interval of nutrient solution in EC-based closed-loop soilless culture for sweet pepper plants.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.26 no.7
• /
• pp.873-880
• /
• 2020

After pre-treatment of oyster shells according to particle size (0 ~ 1, 1 ~ 2, 2 ~ 5 mm) and pyrolysis temperature (400(P400), 500(P500), 600(P600), 800(P800)℃), changes in the properties of sediments mixed with pre-treated oyster shells were investigated. The primary component of the oyster shell was changed from CaCO3 to CaO at temperatures above 700℃. The Ca2+ concentration in P800 was 790 mg/L, which was 2 ~ 3 times higher than those in the control and other experimental samples. Ca2+ elution significantly increased at the pyrolysis temperature over than 600℃. In oyster shells pyrolyzed over 600℃, the pH of the pore water increased by 0.1 ~ 0.5, due the hydrolysis of CaO formed by the pyrolysis of CaCO3. The PO4-P of the overlying and pore water in P600 and P800 were 0.1 ~ 0.2 mg/L lower than those of the control. The increased pH and elution of Ca2+ from oyster shells should suppress the upwelling of PO4-P from the sediment. Based on the above results, it was confirmed that the pyrolysis temperature of oyster shells influenced NH3-N and PO4-P concentrations in the sediment; however, the particle size of oyster shells had little effect. The results of this study can be used as a foundation for research on the use of pyrolyzed oyster shells to improve low-contamination coastal benthic environments.

• Journal of the Korean Ceramic Society
• /
• v.27 no.1
• /
• pp.1-6
• /
• 1990

Preparation and heavy metal ion adsorption of sumicron hydroxy apatite were studied in this experiment. Submicron HAP was synthesized with Ca(OH)2 solution and H3PO4.Ca(OH)2 solution was made from water-quenching of CaCO3 heated at 1, 00$0^{\circ}C$ and 20%-H3PO4 was dropped into this Ca(OH)2 solution heated at 8$0^{\circ}C$. XRD pattern of prepared powder showed HAP crystal. The average particle size and sahpe of HAP were 0.25${\mu}{\textrm}{m}$ and sphere type. As a adsorbent, 1.0g of the prepared HAP powder in 1 liter of artifical 5ppm heavy matal waste water was sufficient, and more effective at pH7-9.

• Journal of the Korean Ceramic Society
• /
• v.55 no.5
• /
• pp.480-491
• /
• 2018

Calcium phosphates (CaP) were prepared by a wet chemical method. Micro-crystalline dicalcium phosphate (DCPD) was precipitated at $37^{\circ}C$ and pH 5.0 using $Ca(OH)_2$ and $H_3PO_4$. The precipitated DCPD solution was kept at $37^{\circ}C$ for 96 h. Artificial bone cement was composed of DCPD, $Ca(H_2PO_4)_2{\cdot}H_2O$ (MCPM), and $CaSO_4{\cdot}1/2H_2O$, $H_2O$ and aqueous poly-phosphoric acid solution. The wet prepared CaP powder was used as a matrix for the bone cement recipe. With the addition of aqueous poly-phosphoric acid, the cement hardening reaction was started and the CaP bone cement blocks were fabricated for the mechanical strength measurement. For the tested blocks, the mechanical strength was measured using a universal testing machine, and the microstructure phase analysis was done by field emission scanning electron microscopy and X-ray diffraction. The cement hardening reaction occurred through the decomposition and recrystallization of MCPM and $CaSO_4{\cdot}1/2H_2O$ added on the surface of the wet prepared CaP, and this resulted in grain growth in the bone cement block.