• Korean Journal of Materials Research
• /
• v.17 no.4
• /
• pp.222-226
• /
• 2007

[ $SiO_2$ ]thin films containing Si-nanocrystals and $Er^{3+}$ were fabricated by the RF-sputtering method. Intense emission of $Er^{3+}$ was observed at 1530 nm region after the annealing of the film at $1050^{circ}C$ for 5 min. Channel waveguides were fabricated using such films for the core. The films containing Si higher than 2.4 at% exhibited the change in stress from compression to tension after annealing, which induced the fatal loss-increase in waveguide. The optical gain might be attained by the Er-doped waveguide with Si lower than 2.4 at% by a visible-light-excitation.

• Journal of the Korea Concrete Institute
• /
• v.23 no.2
• /
• pp.169-176
• /
• 2011

In this study, the flexural test for reinforced high performance fiber reinforced cementitious composites (R/HPFRCC) members has been conducted in order to investigate the flexural behavior including the effect of an ordinary tensile reinforcing bar. Through the test, it was observed that the flexural strength increased due to the stable tensile stress transfer of HPFRCC, even up to the ultimate state. In addition, no localized crack appeared until the yielding of the reinforcement. From the layered section analysis of the tested members, it was found that the analysis with the tensile model obtained from the tension stiffening test showed better agreement with the flexural test results, whereas the analysis with direct tension test results overestimated the flexural capacity. Through the experimental and analytical studies, two flexural failure modes have been defined in this paper; concrete crushing at the top compression layer or tensile failure at the bottom tensile layer of the beam section. Based on these two flexural failure modes, a simple formula that estimates the ultimate flexural strength of the member has been proposed in this paper. The proposed equations can be useful in a design and an analysis of R/HPFRCC members.

• Journal of Oriental Neuropsychiatry
• /
• v.16 no.2
• /
• pp.277-285
• /
• 2005

Tension Myositis Syndrome is defined as the muscle syndromes affected by brain signal as a result of stress. Furthermore, painful muscles cause tensional emotions in body system. Pain is the result of mutual co-operations between the brain and muscles. Unpleasant feelings increase the pain intensity. In addition, painful muscles were seen to have influences on the brain neurological system. Therefore, in spite of physical treatments, chronic pain has a tendency to be persistent and incurable. For psychological cures, We applied deep breathing, muscle relaxation therapy for anxious, sensitive chronic neck pain patient, then we evaluated her Visual Analogue Scale in reference to subjective feelings of pains every other day at 9 PM. In conclusion, We found that deep breathing and muscle relaxations helped reduce the feeling of pains for those who suffered from anxiety, tensional pains. Therefore, relaxation therapies are necessary methods for pain controls as well as physical treatments.

• Journal of the Korea Concrete Institute
• /
• v.26 no.4
• /
• pp.475-482
• /
• 2014

This paper presents the experimental results concentrically reinforced concrete tension members and compares cracking behavior of amorphous steel fiber and normal steel fiber reinforced concrete members. Two kind of steel fibers were included as a major experimental parameter together with the six cover thickness to bar diameter ratio ($c/d_b$). The presence of amorphous steel fibers effectively controlled the splitting cracks initation and propagation. In the amorphous steel fiber reinforced specimens, no splitting cracks were observed that becomes higher with cover thickness to bar diameter ratio is 2.0. Crack spacing of the each specimens reinforced with amorphous steel fibers and normal steel fibers becomes larger with the increase in cover thickness, and also measured maximum and average crack spacing are significantly smaller than current design code provision. Based on the measured crack spacings, a relationships for predicting the crack spacing is proposed using the measured average crack spacing in amorphous steel fiber reinforced concrete tension members.

• Journal of Oral Medicine and Pain
• /
• v.32 no.1
• /
• pp.113-120
• /
• 2007

Although most cases of tension-type headache(TTH) are myogenic headache, in some cases, arthralgia appears, such as the disorder of the temporamandibular joint. This study is designed to compare the clinical patterns of arthralgia to those of myalgia, when both symptoms are co-existing. Among 167 patients who visit our clinic during a certain period, whose chief complaint was TTH, 18 patients were the arthralgia group, 50 patients were the myalgia group, and 99 patients who have both arthralgia and myalgia were the arthromyalgia group. Three groups were asked to answer the questionnaires about their age, gender, and oral parafunction such as bruxism or clenching. Then we gathered statistics on the data from the accomplished questionnaires. 1. There was statistical significance in age among the three groups(p=0.02). 2. There was no statistical significance in sex and oral parafunction among the three groups. 3. There was statistical significance the myalgia group was older than the arthromyalgia group(p<0.03). The results of the study show that as patients become older, TTH with myalgia happens more frequently than TTH with arthralgia and myalgia does.

• Clean Technology
• /
• v.19 no.4
• /
• pp.481-486
• /
• 2013

Alkali-surfactant-polymer (ASP) solution was manufactured by using the domestic surfactants for enhanced oil recovery. Domestic surfactants such as linear alkylbenzene sulfonic acid (LAS) and dioctyl sulfosiuccinate (DOSS) were used. This surfactants were purchased from AK chemtech Co., Ltd. (Korea). LAS and DOSS were blended and the ratio of LAS to DOSS are 1:1 and 2:1. Decane was used as a model compound of the crude oil. Surfactant solution and decane were blended to analyze microemulsion. Brine-oil-surfactant are mixed at varying concentration of brine from 0.8 to 3.6 wt.%. Increasing salinity causes the phase transition of microemulsion from water to middle to oil. Also, by measuring the surface tension and interfacial tension using pendent drop tensiometer and Huh's equation optimal ratio of the ASP solution was determined.

• Archives of Pharmacal Research
• /
• v.27 no.6
• /
• pp.646-652
• /
• 2004

The objective of this study was to determine the acute effect of trimetazidine (TMZ) on the pre-fatigue, fatigue and post-fatigue contractile characteristics and tension-frequency relationships of isolated rat diaphragm muscle. Muscle strips were taken from the ventral-costal aspects of the diaphragm muscle of rats killed by decapitation. The muscle strips were suspended in organ baths containing Krebs solution, with a gas mixture of 95% $O_2$ and 5% $CO_2$ at $37^{\circ}C$ and pH 7.35-7.45. After determining the thermoregulation and optimum muscle length the muscles were subjected to direct supramaximal stimulation with 0.05 Hz frequency square pulses for periods of 0.5 msec to obtain control values. After adding $5{\times}10^{-6}{\;}and{\;}5{\times}10^{-5}$ M trimetazidine solution to the respective bath media, the contractile parameters of the muscles were recorded. The contractile parameters were also recorded for both the trimetazidine and tri-metazidine-free media after application of the high frequency fatigue protocols. Later, the tension-frequency relationship was determined by applying stimulating pulses of 10, 20, 50 and 100 Hz to the muscle strips. Whilst the twitch tension obtained from the $5{\times}10^{-6}{\;}and{\;}5{\times}10^{-5}$ M trimetazidine media showed numerical increases compared to that of the controls, these were not statistically significant (p>0.05). The contraction time exhibited a dose dependent increase (p<0.001), whilst the contraction and relaxation rates did not differ significantly. The isometric contraction forces obtained with the different stimulating frequencies showed a significant increase in the tetanic contraction only at 100 Hz (p<0.05). A comparison of the pre- and post-fatigue twitch tensions in the trimetazidine media showed the post- fatigue twitch tensions to be significantly higher than those of the pre-fatigue contraction forces (p<0.05). In the $5{\times}10^{-6}{\;}and{\;}5{\times}10^{-5}$ M trimetazidine media the increases in the post-fatigue contraction force were 22 and 30%, respectively. These results demonstrated that in isolated rat diaphragm muscle, TMZ significantly limited the mechanical performance decrease during fatigue. It is our opinion that trimetazidine contributed to the observed fatigue tolerance by eliminating the factors of fatigue, due to preservation of intracellular calcium homeostasis, provision of the ATP energy levels needed by ATPase dependent pumps and especially by keeping the intracellular pH within cer-tain limits.

• Composites Research
• /
• v.30 no.2
• /
• pp.116-125
• /
• 2017

The purpose of this study is to develop silicon carbide fiber showing an excellent mechanical properties under highly oxidative conditions at high temperature. Polycarbosilane(PCS) as a preceramic precursor was used for making the SiC fiber. PCS fiber was taken by melt spinning method followed by melting the PCS at $300{\sim}350^{\circ}C$ in N2 gas. The Curing of PCS fiber was carried out in air oxygen chamber, prior to high temperature pyrolysis. Degree of cure was calculated by characteristic peak's ratio of Si-H to $Si-CH_3$ in FT-IR spectra before and after curing of PCS fiber. The properties of SiC fiber was affected greatly by the degree of cure. The SiC fiber produced by controlling fiber tension during heat treatment showed good properties. The SiC fiber exposed to $1000^{\circ}C$ at air from 1 min. up to maximum 50 hrs showed around 60% reduction in tensile strength. We found that large amount of carbon content on the fiber surface after long-term exposure has resulted in lower tensile strength.

• The Korea Journal of Herbology
• /
• v.38 no.2
• /
• pp.1-7
• /
• 2023

Objectives : From this study, we sight to identify Anti-stress effect of Chenwangbosim-Dan (Tianwangbuxin-Dan) Extract∘Fermented Rice Extract (GABA : gamma-aminobutyric acid 30%) Complex Methods : In order to measure the degree of functional evaluation of tension relief due to stress, it was evaluated whether the psychological indicators VAS(Visual Analog Scale) and POMS(Profile Of Mood State) were improved. Which is generally used for stress measurement and has a high frequency of clinical use. All clinical trial subjects were required to take the drug once a day at 9 ± 30 min in the morning for 2 weeks. Results : After intake, the group that Chenwangbosim-Dan(Tianwangbuxin-Dan) Extract∘Fermented Rice Extract (GABA : gamma-aminobutyric acid 30%) Complex had a statistically significant improvement effect compared to before intake due to an improved 30.81% of the VAS scores. The POMS-T score improved 54.13%, the POMS-V score improved 117.5% and the POMS-F score improved 59%, which had a statistically significant effect compared to Placebo group (p<0.001). There is a significant difference between two group, so even considering the placebo effect, the anti stress effect was confirmed in the Chenwangbosim-Dan (Tianwangbuxin-Dan) Extract∘Fermented Rice Extract (GABA : gamma-aminobutyric acid 30%) Complex intake group. Conclusions : The above results showed that the Chenwangbosim-Dan(Tianwangbuxin-Dan) Extract∘Fermented Rice Extract (GABA : gamma-aminobutyric acid 30%) Complex had an anti-stress effect. Therefore, it is expected to be developed as a safe and comfortable mental care health functional food that can reduce the risk of drug abuse.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.14 no.8
• /
• pp.3631-3637
• /
• 2013

Gangway bellows in this study is the double wrinkled neoprene rubber component to accept various deviations between the carriage end parts of the articulated type high speed railway vehicle(HSRV). The fatigue failure of the bellows has a harmful effect on the riding comfort for the passengers with the increase of noise and ringing in the ears due to air-tightness failure during pass through a long tunnel. In this study, to assure the safety of gangway bellows of the HSRV, non-linear analysis of the gangway bellows considering triaxial angular displacement(rolling /yawing/pitching) between the carriage end parts are performed. The non-linear properties of the rubber are determined by uniaxial tension and equi-biaxial tension test. Moreover, from the results of non-linear analysis, the effects of the angular displacements and frictional coefficients are evaluated.