• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.18 no.3
• /
• pp.318-326
• /
• 1993

It is not easy to diagnose rapidly the cause of trouble in the signal service which is currently provided by the fully electronic switching system such as TDX. To solve these problems, it is necessary to acquire and analyze the service signal. This paper describes the development of PCM acquirer which can analyze the signal characteristics by acquiring the PCM signal in SHW(subhighway). Also an algorithm which analyzes the acquired signal and determines the signal frequency si discussed by using CZT.

• Proceedings of the KIEE Conference
• /
• 2004.07d
• /
• pp.2344-2346
• /
• 2004

시간-주파수 영역 반사파 계측 시스템의 상용화를 위해서 현재 범용 장비들을 통해 구현되었던 신호 발생부, 신호 습득부. 신호 분배부, 신호 처리부의 실제 구현이 필요하다. 따라서, 본 논문에서는 그 첫 번째 단계로 시간-주파수 영역 반사파 계측 시스템에서 핵심부분인 신호 발생기를 AD9854 칩과 mega128 컨트롤러를 이용해 구현한다. 시간-주파수 영역 반사파 계측시스템의 신호 발생기 부분은 시간-주파수 영역 반사파계측 방법의 기준 신호인 첩 신호를 발생시키는 부분이다. 긴 주기를 가지는 첩 신호를 실제로 발생시키기 위해 아날로그 디바이스(Analog Device)사의 범용 통신칩으로 사용되는 AD9854와 AD9854를 제어하기 위해 아트멜(Atmel)사의 mega 128 컨트롤러를 사용하여 구현한다. 구현된 첩 신호 발생기를 실제 시간-주파수 영역 반사파 계측 시스템에 적용하여 그 성능을 검증한다.

• Proceedings of the IEEK Conference
• /
• 2009.05a
• /
• pp.19-21
• /
• 2009

The reflectometry for locating the fault at a cable is the same as a problem estimating the time delay between the incident and the reflected signals. In this paper, we propose a method for estimating the time delay between the two signals. The proposed method is based on the modeling of the Gaussian enveloped linear chirp signal in the Gaussian noise environment. The phase and the instantaneous frequency of the received signal are estimated by linear Kalman filtering. From the estimated instantaneous frequency, we can measure the time interval between the center frequencies of the incident and the reflected signals. The time interval is the same as the time delay between the incident and the reflected signals. In a simulation assuming that the cable has open fault at the end of the cable, the proposed method showed a good result in estimating the time delay.

• Proceedings of the IEEK Conference
• /
• 2008.06a
• /
• pp.321-322
• /
• 2008

CSS(Chirp Spread Spectrum) technology adopt SDS-TWR algorithms of TOA(Time of Arrival) using velocity of specific medium and ToF(Time of Flight) to measure a distance, but this method always has a regular error on distance regardless of a real distance, as a result, in far distance, it decrease a error on distance relatively, but in near distance, it increase a error on distance relatively. in this paper, we propose and test new method measuring a distance more precisely in near distance using CSS and RSSI

• Structural Monitoring and Maintenance
• /
• v.1 no.2
• /
• pp.159-171
• /
• 2014

Real-time near and far-field monitoring of concrete structural components gives enough information on the time and condition at which damage occurs, thereby facilitating damage detection while in the same time evaluate the cause of the damage. This paper experimentally investigates an integrated monitoring technique for near and far-field damage detection in concrete structures based on simultaneous use of electromechanical admittance technique in combination with guided wave propagation. The proposed sensing system does not measure the electromechanical admittance itself but detect time variations in output voltages of the response signal obtained across the electrodes of piezoelectric transducers bonded on surfaces of concrete structures. The damage identification is based on the spectral estimation MUSIC algorithm. Experimental results show the efficiency and performance of the proposed measuring technique.

• Journal of the Korean Institute of Telematics and Electronics A
• /
• v.32A no.8
• /
• pp.119-125
• /
• 1995

Strained multiple quantum well(SMQW) PBH-DFB-LDs emitting at 1.55$\mu$m wavelength has been fabricated using OMVPE and LPE crystal growth tecnique. Using the SMQW active layer, a linewidty enhancement factor of 2.65 was obtained at lasing wavelength and consequnently, packaged 42 modules showed a very low average chirp of 0.44nm at 2.5Gbps NRZ direct modulation. The 77 devices showed average threshold current of 8.72mA and average slope efficiency of 0.181 mW/mA, and single longitudinal mode operation with SMSR larger than 30dB up to 5mW. Among the 77 devices, standard deviation of lasing wavelength of 3.57nm was obtained owing to a good crystal growth uniformity.

• Journal of the Korean Institute of Telematics and Electronics B
• /
• v.30B no.5
• /
• pp.73-81
• /
• 1993

We have developed a system which can analyze the status of signal sent from/received to a signalling service equipment within the fully electronic switching system such as TDX-10. The system has such functions that acquire PCM signal of the preferred channel from the subhighway of the thirth-two channel by which a Universal Signal Tr ansceiver Unit(USTU) is connected with Time Switch Unit (TSU), and then classify the type of signal such as R2MFC/DTMF/CCT/VOICE, and determine the digit. Up to now, we have analyzed the frequency spec trum using the FFT. This paper describes the developement of PCM acquirer which can analyze the signal characteristics by acquiring the PCM signal in SHW(subhighway), and proposes the CZT(Chirp Z-Transform) algorithm. An algorithm which analyzes the acquired signal and determines the signal frequency and the corresponding power spectrum using the CZT is also discussed here.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.52 no.6
• /
• pp.702-708
• /
• 2019

The range resolution of echo sounders can be improved by enhancing the transducer bandwidth. We designed a bandpass matching network for expanding the bandwidth of a transducer by scaling in both impedance and frequency after transforming a lowpass network into a bandpass configuration for a third-order Bessel filter. We measured the effect of the Bessel matching network for a 50 kHz sandwich type transducer on the transmitting voltage response (TVR), receiving sensitivity (SRT) and figure of merit (FOM), using a chirp echo sounder system. Both the simulation and experimental results indicated that the transducer with a bandpass matching network was capable of producing a symmetrical acoustic output over a wider bandwidth (8.25 kHz) than was the transducer without a matching network (3.75 kHz). By implementing the Bessel matching network, we achieved a 120% bandwidth enhancement.

• Proceedings of the KOSOMBE Conference
• /
• v.1998 no.11
• /
• pp.115-116
• /
• 1998

Pulse echo techniques have been used for the conventional medical ultrasound imaging systems. However, their resolution is limited in the transmitted signal power. To overcome this limit, pulse compression method used in the radar systems was proposed. This system transmits a continuous coded signal and then compresses the received signal into the short and high resolution pulse by using correlator. The reflectors can be detected by cross-correlation between the transmitted signal and the received signal with the depth information. In this paper, we will present a comparative study of the performances of the most common sequences(pseudo-chirp, m-sequences, modified Golay code). The best result for improving resolution is obtained with the modified Golay Code.

• Electrical & Electronic Materials
• /
• v.11 no.11
• /
• pp.28-36
• /
• 1998

Widely tunable diodes integrated with periodically sampled and chirped DBR(distributed Bragg reflector) and an EA(electroabsorption) modulator are analyzed dynamically using the improved largesinal time-domain model. The tuning characteristics of sampled- and chirped-grating DBR laser diodes are demonstrated theoretically. The results of the simulation agree well with those of the experiment. And the intensity-modulation properties of the laser diodes integrated with an EA modulator are calculated. It is shown that the external modulation has the lower frequency chirp by 1/20 for the same extinction ratio than the direct modulation, and also the short pulse train can be generated using the optical gating of an EA modulator.