• Journal of the Korean Ceramic Society
• /
• v.26 no.3
• /
• pp.347-360
• /
• 1989

Spinel, mullite, forsterite and cordierite composition powders were synthesized from Mg(NO3)2.6H2O, Al(NO3)3.9H2O and SiCl4-ethanol solution by spray pyrolysis method and the sinterability of these powders were investigated. The bulk density of spinel and mullite specimens sintered at 1,$700^{\circ}C$ for 1hr was 3.56g/㎤(99.5% relative density) and 3.16g/㎤(99.7% relative density), respectively. (Green compacts were made from powders prepared at 1,00$0^{\circ}C$). The bulk density of forsterite and cordierite specimens sintered at 1,480 and 1,40$0^{\circ}C$ for 2hrs were 3.217 and 2.155g/㎤, respectively. (Green compacts were made from powders prepared at 1,00$0^{\circ}C$). The constituent compositions of spinel and mullite specimens sintered at 1,$700^{\circ}C$ for 1hr were 27.5wt% MgO and 70.5wt% Al2O3, respectively. Vickers microhardness and fracture toughness of spinel sintered at the above condition were 13.7GPa and 2.6MN.m3/2, respectively, and room temperature bending strength, 425MPa, was nearly maintained even at the elevated temperature. In the case ofmullite specimens, those values were 13.5GPa, 2.2MN/m3/2 and 430MPa, respectively.

• Proceedings of The Korean Society of Agricultural and Forest Meteorology Conference
• /
• 2016.09a
• /
• pp.41-43
• /
• 2016

• Journal of the Korean Society for Precision Engineering
• /
• v.12 no.7
• /
• pp.46-52
• /
• 1995

This paper proposes methodologies for the development of radiation thermometer using InSb photo-detector of which spectral sensitivity is excellent over the wave length range of 2 .mu. m .approx. 5 .mu. m. The proposed radiation thermometer has broad measurement range from normal to high, up to more than 1000 .deg. C, with high accuracy, and can measure temperature on the material surface or heat emission noncontactely with high speed. Optical system was consisted of two convex lens with foruslength of 15.2mm for infrared lay focusing, Ge filter to cut the short wave length components and sapphire filter to cut the long wave length components. The cold shielded was installed in the whole surface of the light-absorbing element to remove the error- mometer, calibration using black body furnace which has temperature range of 90 .deg. C .approx. 1100 .deg. C was carried out, and temperature calaibration curve was obtained by exponential function curvefitting. The result shows maximum error less than 0.24%(640K .+-. 1.6K) over the measurement range of 90 .deg. C .approx. 700 .deg. C, and from this result the usefulness of the developed thermometer has been confirmed.

• The Korean Journal of Community Living Science
• /
• v.25 no.4
• /
• pp.549-556
• /
• 2014

This study evaluates the thermal insulation and evaporative resistance of a waterproof and breathable garment system and determines the factors influencing its thermal performance. The experimental garments were composed of underwear (shirts with 100% wool and 100% polyester) and outerwear (jackets and pants with a vapor-permeable membrane and a vapor-impermeable membrane). Data on clothing insulation in a dry condition ($10^{\circ}C$) and a wet condition ($10^{\circ}C$, 40% R.H.), evaporative resistance ($34^{\circ}C$, 40% R.H., and $10^{\circ}C$, 40% R.H.), and microclimate vapor pressure were collected and analyzed. According to the results, the thermal insulation of the experimental garment system ranged 1.27~1.40 in the dry condition and 0.40~0.89 in the wet condition at $10^{\circ}C$. Evaporative resistance ranged $41{\sim}525m^2Pa/W$. A decrease in thermal insulation by wetting underwear ranged 31~67% in the cold condition ($10^{\circ}C$). The breathability of the outer garment influenced the decrease in thermal insulation by wetting. The type of underwear fiber influenced the decrease in thermal insulation only when it was used with breathable outerwear. The vapor-permeable outerwear sample with polyester underwear (P_Perm) showed a larger decrease in insulation than that with wool (W_Perm). The evaporative resistance of the vapor-permeable ensemble showed no effect of underwear in the warm condition ($34^{\circ}C$), but polyester underwear showed lower evaporative resistance than wool in the cold condition ($10^{\circ}C$). The vapor-impermeable ensemble showed no difference in evaporative resistance between polyester underwear and wool underwear in both conditions. Future research should consider various clothing ensemble combinations and environmental conditions and evaluate wear comfort by using human subjects.

• Journal of Korean Society of Occupational and Environmental Hygiene
• /
• v.20 no.4
• /
• pp.241-247
• /
• 2010

Recently, indoor air quality (IAQ) has been one of the major concerns of people. Indoor parking lots are subject to be exposed to high concentrations of air pollutants emitted from vehicles. This study was performed to investigate indoor air quality (IAQ) at indoor parking lots. Sampling sites were selected 5 indoor parking lots. Target indoor air quality parameters include a number of criteria pollutants such PM$_{10}$, CO, CO$_2$, and HCHO. In addition, a variation of IAQ according to ventilation system operating was measured at C site (underground parking lot). In general, all pollutants were maintained below indoor air quality maintenance standards. The indoor air quality at indoor parking lots was affected by the availability of the ventilation facility and their operation frequency. At the underground parking lot (C site) with ventilation system, TVOC concentration according to ventilation system operating were found to be lower operating (488.2 ${\mu}g/m^3$) than non-operating (1,401.2 ${\mu}g/m^3$).

• Proceedings of the KIEE Conference
• /
• 1991.07a
• /
• pp.426-431
• /
• 1991

Diakoptic method applied to analyze large power system, always require the efficient tearing algorithm. But conventional tearing methods is not suitable to apply practical power system. This paper presents new tearing algorithm based on factorization path concept of sparse vector method, and applied MPRLD, a kind of optimal ordering algorithm, in ordering step to improve the efficiency of tearing algorithm. Test result of model systems shows that new proposed method in this paper is enable to tear power systems not to be teared by heuristic cluster method, reduces computing time and memory size.

• Journal of Korean Institute of Industrial Engineers
• /
• v.25 no.3
• /
• pp.351-359
• /
• 1999

We present a new approach to the analysis of mobile cellular communication systems under the environment of mixed platforms adopting a guard channel scheme. We assume general cell residence time distributions according to platform-types. Our system model is based on a heterogeneous M/G/c loss system with customer-dependent guard channels, where heterogeneous customers with different service time distributions have different numbers of their own guard channels. We develop the general formula of steady state probabilities for the heterogeneous M/G/c loss system with customer-dependent guard channels. The mean channel occupancy times of new and handoff calls are rigorously derived under a general setting. Finally, our numerical results show that the blocking probability and the forced termination probability are sensitive to the cell residence time distributions.

• Journal of Korean Institute of Industrial Engineers
• /
• v.27 no.1
• /
• pp.89-94
• /
• 2001

There are many queueing systems where customers wait for service up to a certain amount of time and leave the system if they are not served during that time. This paper considers a finite capacity multi-server queueing system with Poisson input and Erlang service time, where a customer becomes a lost customer when his service has not begun within an exponential patient time after his arrival. Performance measures such as average queue length, the average number of customers in service, and the proportion of lost customers can be obtained exactly through the proposed numerical solution procedure.

• Communications of the Korean Mathematical Society
• /
• v.10 no.2
• /
• pp.419-438
• /
• 1995

We investigate a tansient diffusion approximation of queue size distribution in $M^{X}/G^{Y}/c$ system using the diffusion process with elementary return boundary. We choose an appropriate diffusion process which approxiamtes the queue size in the system and derive the transient solution of Kolmogorov forward equation of the diffusion process. We derive an approximation formula for the transient queue size distribution and mean queue size, and then obtain the stationary solution from the transient solution. Accuracy evalution is presented by comparing approximation results for the mean queue size with the exact results or simulation results numerically.

• Proceedings of the KOSOMBE Conference
• /
• v.1998 no.11
• /
• pp.261-262
• /
• 1998

The purpose of this study is to develop 2D brachy-therapy plannig system using Visual C++ on the IBM PC. The method of Semi-orthogonal Localization was used and dose calculation is based on point dose computation model. The GUI of this planning system was designed for user's convenience and the dose distribution of Cs137 brachy-therapy is demonstrated.