• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2002년도 춘계학술대회 논문집 센서 박막재료 반도체재료 기술교육
• /
• pp.132-136
• /
• 2002

In this paper, aging characteristics of outdoor silicone rubber insulator resulting from the acid rain have been investigated with regards to nitrate ion $({NO_{3}}^{-1})$. For this purpose, silicone rubber was aged by immersing into the nitric solutions with different level pH during 1500 hours and various tests (tracking, $tan{\delta}$, breakdown voltage, SEM, EDS, contact angle) were performed. It was observed that the degradation was increased to pH 2.5 slightly and at pH 1.5 highly. And thus, it could be expected that there is certain critical point between pH 1.5 and 2.5, which leads to throught degradation.

• 대한전기학회논문지
• /
• 제35권10호
• /
• pp.465-472
• /
• 1986

The present study was carried out to investigate the mechanism which control the voltage instability and the breakdown of CVD Al2O3 on Si substrates. Our sample were metal-Al2O3-Oi Capacitors with both Al and Au field plates. Electron injection and trapping, with resultant positive flatband voltage shift, occur at fields as low as 1-2[MV/cm.] We developed an approximate method for computing the location of the centroid of the trapped electrons. Our results indicate that the electrons are trapped near the injecting interface, at least for fields less than about 5[MV/cm ] Because of continued charging, a true steady state is probably never reached, and the only unique I-V curve is the one obtained initially, when the traps are empty. We measured this I-V curve for both polarities of applied voltage, using a fresh sample for each point. The observed current densities are much larger than those obtained in thermally grawn SiO2.

• 한국재료학회지
• /
• 제12권2호
• /
• pp.103-111
• /
• 2002

The thermally insulated underground pipelines have been used for district heating system. The sensor wire embedded in the insulation was used for monitoring the insulating resistance between the sensor wire and the pipe. The resistance measurement system detects corrosion of steel pipe under insulation. The corrosion and stress corrosion cracking(SCC) characteristics of sensor wire in synthetic ground water were investigated using the electrochemical methods and constant load SCC tests. The polarization tests were used to study the electrochemical behavior of sensor wire. The sensor wire was passivated at temperatures ranging from 25 to $95^{\circ}C$. However, the applied sensing current larger than passive current resulted in breakdown of passive film. The constant load SCC tests were performed to investigate the effects of applied current and load on the fracture behavior. Stress-corrosion cracks initiated at pits that were produced by sensing current. The growth of the pit involves a tunnelling mechanism, which leads to ductile fracture.

• 대한전자공학회논문지
• /
• 제27권5호
• /
• pp.709-715
• /
• 1990

SiO2 films were nitrided by tungsten-halogen heated rapid thermal annealing in ammonia gas at temperatures of 900-1100\ulcorner for 15-180sec. The nitroxide films were analyzed using Auger electron spectroscopy. MIS caapcitors were fabricated using these films as gate insulators. I-V and C-V characteristics of MIS capacitors were investigated. The AES depth profiles of nitroxide film show that the nitrogen rich layer is, at the early stage of nitridation, formed at the surface of nitroxide film and near the interface between nitroxide and silicon. Nitridation of SiO2 makes the film have a larger effective average refractive index. The thermal nitridation of SiO2 on silicon causes the flatband voltage shift due to the change of the fixed charge density. It is found that the dominant conduction mechanism in nitroxide is Fowler-Nordheim tunneling. Rapid thermal nitridation of 200\ulcornerSiO2 on silicon results in an improvement in the dielectric breakdown electric field.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1989년도 하계종합학술대회 논문집
• /
• pp.383-385
• /
• 1989

Nitrided oxides have been recently investigated for the application as a replacement of thermally grown $SiO_2$in the MIS devices. In this paper, thin oxides were nitrided in the $N_2$plasma ambient. After B - T stress is performed on the sample, it was noticed that the current density is increased. From the I - V measurement, dominant conduction mechanism of oxynitride films appeared to be Fowler - Nordheim emission. And also its breakdown strength is increased about 2.2 MV/cm compared with the oxide films.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2010년도 하계학술대회 논문집
• /
• pp.100-100
• /
• 2010

Because of power consumption increase, global wanning, and limitation of installation, not only high reliability and interruption capability but also compact and light power apparatuses are needed. To improve the insulation performance, the high E field concentration phenomena was considered. Breakdown mechanism in vacuum is different from that in other insulation materials. therefore, It is necessary to understand the electric field distribution and insulation characteristics. This paper discusses the simulation and LI(light impulse) test of the shield of outside vacuum interrupter As a result, FEM simulation and LI test show that improve distribution of electrical field and equi-potential line. due to external shield. in this case, outside shield induced electric field of triple junction point.

• 대한기계학회:학술대회논문집
• /
• 대한기계학회 2002년도 학술대회지
• /
• pp.775-778
• /
• 2002

In order to analyse the mechanism of a flow tone around a cavity, the correlations between the flow in the cavity and the boundary layer flow in front of the cavity are studied experimentally in this paper. The instability In the boundary layer forms the vortex at the front edge of the cavity and the flow tone is occurred by the vortex breakdown at the rear edge of the cavity Therefore, the boundary layer measurement is important in the cavity flow control. We measure the velocity of the boundary layer at the entrance of the cavity using hot-wire anemometry and the flow tone around the cavity by microphone. The boundary layer characteristic is changed by the various angle of the flap on the front edge of the cavity, while it is less influenced by the ratio of length and depth of the cavity.

• 산업경영시스템학회지
• /
• 제33권3호
• /
• pp.93-101
• /
• 2010

Regarding project management, many organizations have developed and distributed general project management knowledge systems, and application fields use the knowledge systems to apply the process suitable for characteristics of a project. This study suggests project management process models to apply to product development projects and introduces the application cases. This product development project management process model is composed of five top processes of initiation and preparation, planning, implementation management, control, and termination and transfer. The five processes are re-divided into 18 bottom processes. These processes are expressed as input, control, output, and mechanism by using the IDEF0 model. This model is applied to the new car development project of a Korean automobile company and introduces the cases, which shows a project charter, a work breakdown structure, a project schedule, a progress s-curve, a risk register, and a performance report.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1996년도 하계학술대회 논문집 C
• /
• pp.1870-1872
• /
• 1996

This paper presents dielectric characteristics of $SF_6$ gas stressed by the non-oscillating and oscillating impulse voltages in inhomogeneous fields disturbed by metallic protrusion. The propose of this investigation is to present the predischarge development and dielectric characteristics of $SF_6$ gas under VFTOs. The experiments were carried out using a needle-to-plane and two needles-to-plane gap geometries in the gas pressure ranges from 0.1 to 0.5 MPa. The gap separation was 22 mm and the needle-shaped protrusions were made of stainless steel 10 mm in length and 1.0 mm in diameter. As a result, it was found that the breakdown mechanism and predischarge current are principally dependent on applied voltage waveform and polarity.

• Reproductive and Developmental Biology
• /
• 제28권4호
• /
• pp.267-273
• /
• 2004

Maturation of oocytes is maintained by complex procedures along with follicular genesis and is a critical step for embryonic development. Purine known as an oocyte maturation regulator is present in follicular fluid. In this study, the roles of guanosine as a strong inhibitor of GVBD and a modulator of cyclic GMP concentration in ooyctes were revealed. Denuded immature oocytes were treated with guanosine, and the maturation rates and cGMP concentration of oocytes were measured. GVBD was blocked in a concentration dependent manner by guanosine, but this effect was reversible. However, GVBD was lagged yet not significant by adenosine. Both guanosine and adenosine modified cGMP concentration in oocytes. The characteristic of the guanosine-treated oocyte was significantly higher cGMP compared with the adenosine-treated oocyes at initial time of the maturation. Based these results, guanosine may be a strong and reversible GVBD inhibitor. Although the precise mechanism of guanosine presently is unclear, the results suggest that guanosine may lead the accumulation of cGMP in oocyte cytoplasm, which in turn suppresses GVBD.