• Composites Research
• /
• 제15권3호
• /
• pp.30-38
• /
• 2002

다른 광섬유 센서와 마찬가지로 광섬유 브래그 격자센서도 삽입가능의 장점을 가진다. 삽입가능과 관련된 실제적 가티를 높이기 위해서 본 논문에서는 복합재 평판에 삽입된 브래그 격자센서의 안전성과 스펙트럼특성이 연구되었다. 피복광섬유와 피복이 벗겨진 광성유의 삽입 환경이 현미경 분석에 의해 수행되어졌고 이 현미경 사진들과 성형모니터링 (cure monitoring)의 결과를 기초하여, 저복굴절(Li-Bi) 광섬유에 새겨진 브래그 격자의 단일 브래그 조건을 붕괴하는 주원인이 성형 잔류음력임을 확인했고 이로 인해 광성유가 겪게 되는 응력/변형률 상태를 정략적으로 보고하였다. 또한 성형모니터링은 브래그 공진파장이 어떻 게 분리되어져 가는지 묘사하였고 횡응력 미감도 브래그 격자(TIG)가 재코팅 방법에 의해 쉽게 획득되어짐을 보였다. TIG는 실시간 신호 처리와 관련하여 중요만 장점으로 작용한다.

• 센서학회지
• /
• 제30권6호
• /
• pp.446-450
• /
• 2021

Non-dispersive infrared (NDIR) gas sensors typically use an optical filter that transmits a discriminating 4.26 ㎛ wavelength band to measure carbon dioxide (CO2), as CO2 absorbs 4.26 ㎛ infrared. The filter performance depends on the transmittance and full width at half maximum (FWHM). This paper presents the fabrication, sensitivity, and selectivity characteristics of a distributed Bragg reflector (DBR)-based Fabry-Perot filter with a simple structure for CO2 detection. Each Ge and SiO2 films were prepared using the RF magnetron sputtering technique. The transmittance characteristics were measured using Fourier-transform infrared spectroscopy (FT-IR). The fabricated filter had a peak transmittance of 59.1% at 4.26 ㎛ and a FWHM of 158 nm. In addition, sensitivity and selectivity experiments were conducted by mounting the sapphire substrate and the fabricated filter on an NDIR CO2 sensor measurement system. When measuring the sensitivity, the concentration of CO2 was observed in the range of 0-10000 ppm, and the selectivity was measured for environmental gases of 1000 ppm. The fabricated filter showed lower sensitivity to CO2 but showed higher selectivity with other gases.

• 한국재료학회지
• /
• 제20권6호
• /
• pp.307-311
• /
• 2010

Positron annihilation lifetime spectroscopy is applied to BaSrFBr : Eu film which is used for the phosphore layer, and afterwards the reliability and self-consistency of source corrections in the positron lifetime spectroscopy is investigated using a $^{22}Na$ positron emitter covered by thin foils. The positron lifetime showed no significant change through the various proton irradiation energies. It is unusual that the measurements of the defects indicate that most of the defects were likely to have been generated by X-ray radiation. This may have resulted from the Bragg peaks of the proton characteristics. The Bragg peak does not affect the defect signals enough to distinguish the lifetimes and intensities in a material that is includes multi-grains. The lifetime ($\tau_1$) associated with positron annihilations in the Ba, Br, and Eu of the sample was about 250 ps, and due to the annihilations at F-centers or defects from the irradiated protons in sample, the lifetime ($\tau_2$) was about 500 ps.

• 한국항공우주학회지
• /
• 제31권6호
• /
• pp.30-35
• /
• 2003

본 논문에서는 편광 유지 광섬유 브래그 격자(PMFBG) 센서를 제작하고 신호특성을 파악하였으며, 횡방향 변형률(transverse strain)을 측정하였다. PMFBG 센서는 위상 마스크와 엑시머 레이저를 이용해서 제작하였으며, 반사파는 내부 복굴절율의 영향으로 기존의 FBG 센서와 다르게 두개의 피크를 가지는 것을 확인할 수 있었다. 또한 PMFBG 센서는 자체적으로 2개의 광축을 가지고 있으므로 이 광축을 찾는 실험을 수행하였다. 제작된 PMFBG 센서를 에폭시 시편에 삽입하여, 센서에 가해지는 횡방향 변형률을 측정하였다. PMFBG 센서의 광원으로서 파장 이동 광섬유 레이저(WSFL)를 사용하였다. 실험결과, PMFBG 센서로 측정된 변형률은 스트레인 게이지로 측정한 변형률과 잘 일치하였다.

• 조명전기설비학회논문지
• /
• 제20권5호
• /
• pp.64-71
• /
• 2006

전력설비의 비정상적인 온도변화를 감시할 목적으로 10개의 광섬유격자를 이용하여 $1[^{\circ}C]$ 이내의 온도분해능을 가지는 준분배형 광섬유 온도센서를 제작하였다. 파장가변 FP 필터를 스캔하여 얻어지는 PD 출력파형의 피크위치를 검색하여 광섬유격자 센서의 출력변화를 읽어내었고, 가우시안 line-fitting 알고리즘으로 광섬유격자의 반사스펙트럼 왜곡에 의한 영향을 보상하고 정밀도를 향상시켰다. 제작한 센서시스템과 기준 온도계로 사용한 thermocouple 간의 측정값 오차는 1[%] 이내이며, 선형화 오차는 약 0.37[%]으로 측정되었다.

• 센서학회지
• /
• 제15권6호
• /
• pp.391-396
• /
• 2006

Free-standing multilayer distributed Bragg reflectors (DBR) porous silicon dielectric mirrors, prepared by electrochemical etching of crystalline silicon using square wave currents are treated with polystyrene to produce flexible, stable composite materials in which the porous silicon matrix is covered with caffeine-impregnated polystyrene. Optically encoded DBR PSi/polystyrene composite films retain the optical reflectivity. Optical characteristics of DBR PSi/polystyrene composite films are stable and robust for 2 hrs in a pH=7 aqueous buffer solution. The appearance of caffeine and change of DBR peak were simultaneously measured by UV-vis spectrometer and Ocean optics 2000 spectrometer, respectively.

• 전기전자학회논문지
• /
• 제14권4호
• /
• pp.263-269
• /
• 2010

본 논문에서는 Germanium 및 Germanium과 Boron이 도핑 된 광섬유의 FBG를 이용한 파장가변 형 전광 필터의 고온 특성을 고찰하고, 온도 변화에 대한 파장가변 형 FBG 필터의 반사도, 선폭, 정규화 굴절률 차의 특성 변화를 수치해석을 통해 비교 고찰 하였다. 굴절률 차의 변화에 따른 FBG 필터의 반사 스펙트럼은 온도 안정성에 영향을 받으며, Germanium이 도핑 된 광섬유의 FBG 필터가 Germanium과 Boron이 도핑 된 광섬유의 FBG 필터보다 온도변화에 더 안정성을 가짐을 알 수 있다. 또한 $500^{\circ}C$ 까지의 온도에 대해서는 두 가지 모두 필터로서 온도변화에 안정성을 가짐을 알 수 있다.

• 한국의학물리학회:학술대회논문집
• /
• 한국의학물리학회 2002년도 Proceedings
• /
• pp.216-218
• /
• 2002

Fluence and LET spectrum for 290,400 MeV/u $\^$12/C and 400 MeV/u $\^$20/Ne beams have been measured by a $\Delta$E-E counter telescope. Total charge-changing cross sections are deduced from measured fluence. The measured cross sections agree with previous measurements, however, they are disagreement with a model calculation. To dose-averaged LETs, the model calculation can reproduce the measured LETs except for peak LETs at Bragg peak region.

• 전자공학회논문지D
• /
• 제35D권3호
• /
• pp.63-69
• /
• 1998

In this paper, a new input method is proposed to improve shift-invariant property of a photorefractive correlator andwe implemented real-time optical pattern recognition system using it. In the conventional photorefractive correlator, it is vrey difficult to satisfy the Bragg condition in the pattern recognition process. So, correlation peak is decreased heavily for the shift of input image. If a liquid crystal television(LCTV) without an anlyzer is used as input device, we can get the correlation result regardless of shift of input image because beam path is not changed during storage of holographic filter and correlation process. Also recording time of a holographic matched filter in photorefractive crystal is reduced and the correlation peak is increased because incident beam on the LCTV is transmitted completely. Therefore total optical efficiency is improved. We compared and analyzed the correlation results of proposed photorefractive correlator by computer simulation and optical experiment. We used a BaTiO$_{3}$ single crystal which has high diffraction efficiency in optical experiment.

• Journal of the Korean Association of Oral and Maxillofacial Surgeons
• /
• 제47권4호
• /
• pp.315-320
• /
• 2021

Carbon-ion radiotherapy (CIRT) is on the rise as a treatment choice for malignant tumor. Compared to conventional radiotherapy, particle beams have different physical and biological properties. Particle beam provides a low entry dose, deposits most of the energy at the endpoint of the flight path, and forms an asymptotic dose peak (the "Bragg peak"). Compared to protons, carbon with its larger mass decreases beam scattering, resulting in a sharper dose distribution border. We report a 50-year-old male who underwent CIRT without surgical resection on osteosarcoma of the mandible. After CIRT, the patient's pain was gone, and the malignant mass remained stable with accompanying necrosis. Nine months later, however, magnetic resonance imaging demonstrated progression of the left mandibular osteosarcoma with pulmonary metastases. After multidisciplinary discussion, concurrent chemoradiotherapy was conducted. While necrotic bone segments came out of the mandible during subsequent periodic outpatient visits, the tumor itself was stable. Thirty months after his first visit and diagnosis, the patient is waiting for chemotherapy. Although CIRT is superior in treating radioresistant hypoxic disease, CIRT is in its infancy, so care must be taken for its indications and complications.