• Journal of the Korean Institute of Telematics and Electronics D
• /
• v.35D no.12
• /
• pp.83-91
• /
• 1998

Fiber Bragg grating which has a blazed ang1e to the plane of incident wave generates a side-mode as well as main-mode. The side-mode has an identical characteristics with a long period grating that couples with a cladding mode, so rejects the special wavelength. We experimented on the side-mode characteristics with two fibers which Ge doped depressed index fiber and very high photosensitive H$_2$ loaded step index fiber according to the tilted angle. Also, using a phase mask equipped with rotation plate which has 0.02$^{\circ}$ resolution, we can control the bandwidth and the peak value of a total loss spectrum by aligned tilted grating in a fiber and using this, tried to compose the ASE band rejection filter of the Erbium doped fiber amplifier.

• Korean Journal of Optics and Photonics
• /
• v.11 no.5
• /
• pp.306-311
• /
• 2000

This paper deals with the development of Laser Doppler Vibrometer (LDV) that can mea~ure the tlequency and amphlude of the ultrasonic vibralion. Hc-Ne laser (632.8 om) is used as a light source, and Michelson interferometer in winch frequency of the objective beam is shIfted by Bragg cell IS adopted The frequency modulated signal centered at 40 MHz flom the PIN diode IS amplified. down-col1vel1ed to 2.5 MHz, filtered and digiLized. The voltage output that is proportional to the velocity of the vibratwg surface is obtawed using digItal PLL. A microprocessor is used to extract the frequcncy aud amplitude of the vibratIOn from the voltage output. It is found that the developed LDV can measure up to 300 kHz vibratIOn and the mlillmUITI measurable amplitude is I nm at 300 kHz. We believe thatlhis LDV can be used to measure the vibratIOn of the heavy electric maclllnery and micro-size structures. tures.

• Journal of the Korean Electrochemical Society
• /
• v.14 no.1
• /
• pp.9-15
• /
• 2011

The composite membranes comprising of sulfonated polymers as matrix and ionic liquids as ion-conducting medium in replacement of water are studied to investigate the effect of annealing of the sulfonated polymers. The polymeric membranes are prepared on recast Nafion containing the ionic liquid, 1-ethyl-3-methylimidazolium tetrafluoroborate ($EMIBF_4$). The composite membranes are characterized by thermogravitational analyses, ion conductivity and small-angle X-ray scattering. The composite membranes annealed at $190^{\circ}C$ for 2 h after the fixed drying step showed better ionic conductivity, but no significant increase in thermal stability. The mean Bragg distance between the ionic clusters, which is reflected in the position of the ionomer peak (small-angle scattering maximum), is larger in the annealed composite membranes containing $EMIBF_4$ than the non-annealed ones. It might have been explained to be due to the different level of ion-clustering ability of the hydrophilic parts (i.e., sulfonic acid groups) in the non- and annealed polymer matrix. In addition, the ionic conductivity of the membranes shows higher for the annealed composite membranes containing $EMIBF_4$. It can be concluded that the annealing of the composite membranes containing ionic liquids due to an increase in ion-clustering ability is able to bring about the enhancement of ionic conductivity suitable for potential use in proton exchange membrane fuel cells (PEMFCs) at medium temperatures ($150-200^{\circ}C$) in the absence of external humidification.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.6 no.3
• /
• pp.343-348
• /
• 2011

With the rapid and wide-spread use of mobile communications much attention has been focussed on propagation in the urban area crowed with buildings. It is often surrounded by hills, forests, and mountains. The importance of surface scattering interference between transmitters and receivers on the rough surfaces has been interested and investigated. Therefore, a prediction method is necessary to estimate the influence of rough surfaces on microwave radio propagation. Moreover, most of the mobile communications are performed based on the digital communication system rather than the analog one. In this case, we must pay more careful attention to the signal delay caused by the phase delay due to the multi-path propagation. In this paper we have analyzed numerically scattering of electromagnetic waves from Composite structures by using FVTD (Finite Volume Time Domain) method. We consider two different types of rough surfaces such as periodic and composite structures.

• Journal of radiological science and technology
• /
• v.40 no.4
• /
• pp.621-626
• /
• 2017

In this paper, an optical dosimetric system for radiation dose measurement is developed and characterized for 100 MeV proton beams in KOMAC(Korea Multi-Purpose Accelerator Complex). The system consists of 10 wt% Ultima GoldTM liquid organic scintillator in the ethanol, a camera lens(50 mm / f1.8), and a high sensitivity CMOS(complementary metal-oxide-semiconductor) camera (ASI120MM, ZWO Co.). The FOV(field of view) of the system is designed to be 150 mm at a distance of 2 m. This system showed sufficient linearity in the range of 1~40 Gy for the 100 MeV proton beams in KOMAC. We also successfully got the percentage depth dose and the isodose curves of the 100 MeV proton beams from the captured images. Because the solvent is not a human tissue equivalent material, we can not directly measure the absorbed dose of the human body. Through this study, we have established the optical dosimetric procedure and propose a new volume dose assessment method.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2010.02a
• /
• pp.208-208
• /
• 2010

본 연구에서는 투명전도성산화막으로 적용 가능한 Ga이 도핑된 ZnO(GZO)의 성장 및 후처리 과정에 따른 구조적, 전기적, 광학적 특성을 관찰하였다. GZO 박막은 상온과 $200^{\circ}C$, 50~250 mTorr (50 mTorr 단계)에서 RF 마그네트론 스퍼터법으로 증착하였다. 이와 같은 조건에서 성장 된 박막의 특성을 분석하여 최적의 온도 및 작업압력에서 RF power를 변화시켜 박막을 성장한 후 질소 및 수소를 이용한 후처리 공정을 통하여 GZO 박막을 제작, 각 조건에 따른 구조적, 전기적 및 광학적 특성 변화를 조사하였다. XRD 측정에서, 열처리 전 시료에서는 GZO (002) 상의 Bragg-Angle 위치가 호스트 물질 ZnO의 기준위치보다 낮은 각도 쪽에서 나타났으며, 이는 Ga이 Zn와 치환되지 못하고 격자 내에 침입형태로 존재함에 따른 것으로 판단된다. 열처리 이후 전반적으로 분위기 가스의 종류에 관계없이 결정성, 광투과율 및 전기적 특성이 향상되는 것이 관측되었다. 질소 분위기에서 열처리된 GZO 박막의 경우, 전반적으로 박막 증착 시 초기 작업압력의 증가에 따라 비저항이 증가하는 현상이 관측되었다. 반면, 수소 분위기에서 열처리된 박막에서는 박막 증착 초기 작업 압력이 증가함에 따라 비저항이 감소하는 경향이 관측되었다. 이러한 결과는 XPS(X-Ray Photoelectron Spectroscopy)로 분석한 결과, 질소 분위기에서 열처리된 GZO 박막은 O-H 결합이 Zn-O 결합에 비해 과도하지 않은 반면, 수소화 처리된 GZO 박막에서 Zn-O 결합에 비해 과도한 O-H 결합이 존재하기 때문으로 관측되었다. 그러한 이유는 O-H 결합이 GZO 박막 내 산소 결공($V_o$)과 밀접한 관계가 있기 때문이며, O-H 결합의 증가는 $V_o$-H 결합체의 증가를 의미하기 때문이다.

• Smart Structures and Systems
• /
• v.18 no.3
• /
• pp.405-423
• /
• 2016

In this study, the feasibility of using telecommunication single-mode optical fiber (SMF) as a distributed fiber optic strain and crack sensor was evaluated in concrete pavement monitoring. Tensile tests on various sensors indicated that the $SMF-28e^+$ fiber revealed linear elastic behavior to rupture at approximately 26 N load and 2.6% strain. Six full-scale concrete panels were prepared and tested under truck and three-point loads to quantify the performance of sensors with pulse pre-pump Brillouin optical time domain analysis (PPP-BOTDA). The sensors were protected by precast mortar from brutal action during concrete casting. Once air-cured for 2 hours after initial setting, half a mortar cylinder of 12 mm in diameter ensured that the protected sensors remained functional during and after concrete casting. The strains measured from PPP-BOTDA with a sensitivity coefficient of $5.43{\times}10^{-5}GHz/{\mu}{\varepsilon}$ were validated locally by commercial fiber Bragg grating (FBG) sensors. Unlike the point FBG sensors, the distributed PPP-BOTDA sensors can be utilized to effectively locate multiple cracks. Depending on their layout, the distributed sensors can provide one- or two-dimensional strain fields in pavement panels. The width of both micro and major cracks can be linearly related to the peak strain directly measured with the distributed fiber optic sensor.

• Smart Structures and Systems
• /
• v.7 no.4
• /
• pp.303-317
• /
• 2011

A specially designed tendon, which is proposed by embedding an FBG sensor into the center king cable of a 7-wire strand tendon, was applied to monitor the prestress force and load transfer of ground anchor. A series of tensile tests and a model pullout test were performed to verify the feasibility of the proposed smart tendon as a measuring sensor of tension force and load transfer along the tendon. The smart tendon has proven to be very effective for monitoring prestress force and load transfer by measuring the strain change of the tendon at the free part and the fixed part of ground anchor, respectively. Two 11.5 m long proto-type ground anchors were made simply by replacing a tendon with the proposed smart tendon and prestress forces of each anchor were monitored during the loading-unloading step using both FBG sensor embedded in the smart tendon and the conventional load cell. By comparing the prestress forces measured by the smart tendon and load cell, it was found that the prestress force monitored from the FBG sensor located at the free part is comparable to that measured from the conventional load cell. Furthermore, the load transfer of prestressing force at the tendon-grout interface was clearly measured from the FBGs distributed along the fixed part. From these pullout tests, the proposed smart tendon is not only expected to be an alternative monitoring tool for measuring prestress force from the introducing stage to the long-term period for health monitoring of the ground anchor but also can be used to improve design practice through determining the economic fixed length by practically measuring the load transfer depth.

• Journal of Aerospace System Engineering
• /
• v.12 no.6
• /
• pp.32-40
• /
• 2018

An impact localization for a carbon fiber reinforced plastic (CFRP) composite plate was performed using the multiplexed fiber bragg grating (FBG) sensors and the error-outlier based impact localization algorithm. We found that the optimal impact localization with the maximum error of 31.82 mm and the averaged error of 6.31 mm are obtained when the error threshold (ET) and constant level (CL) are 0.3 nm and 110, respectively. Moreover, the detailed process of impact localization under certain optimal parameters and the relevant results were thoroughly investigated. We conclude that the multiplexed FBG sensors and the error-outlier based impact localization algorithm are suitable for an impact localization on composite structures, and expect that they can be utilized for various structural health monitoring (SHM) in the future.

• Advances in nano research
• /
• v.7 no.4
• /
• pp.233-240
• /
• 2019

The present research work reports in-vitro anti-cancer activity of biologically synthesized ZnO nanoparticles (ZnO NPs) against human carcinoma cells viz SCC-40, SK-MEL-2 and SCC-29B using Sulforhodamine-B (SRB) Assay. ZnO NPs were synthesized by a unique and novel biological route using Temperature-gradient phenomenon where the extract of combination of Catharanthus roseus (L.) G. Don (C. roseus), Azadirachta indica (A. indica), Ficus religiosa (F. religiosa) and NaOH solution were used as synthesis medium. The morphology of the ZnO NPs was characterized by Transmission Electron Microscopy (TEM). TEM images reveal that particle size of the samples reduces from 76 nm to 53 nm with the increase in reaction temperature and 68 nm to 38 nm with the increase in molar concentration of NaOH respectively. XRD study confirms the presence of elements and reduction in crystallite size with increase in reaction temperature and NaOH concentration. The diffraction peaks show broadening and a slight shift towards lower Bragg angle ($2{\theta}$) which represents the reduction in crystallite size as well as presence of uniform strain. The FTIR spectra of the extract show transmittance peak fingerprint of Zn-O bond and presence of bioactive molecules These NPs exhibit inhibition greater than 50% for SCC-40, SK-MEL-2 and SCC-29B cell lines and more than 50% cell kill for SCC-29B cells at concentrations < $80{\mu}g/ml$. Nanoparticles with smallest size have shown better anti-cancer activity and peculiar cell-selectivity. The combination of extracts of these plants with ZnO NPs can be used in targeted drug delivery as an effective anti-cancer agent, a potential application in cancer treatment.