• 대한기계학회논문집
• /
• 제9권2호
• /
• pp.158-173
• /
• 1985

본 연구에서는 상호작용상류의 난류경계층에 분출을 가해서 경계층을 불안정 화시키고 이 불안정화된 난류경계층과 사각입사충격파와의 상호작용을 실험적으로 연 구하였다. Squire-Smith와는 다른 실험모형의 새로운 형태를 제시하였고 상호작용영 역에서 경계층의 압력분포 및 속도분포를 측정해서 충격파반사의 형태를 밝혔다.

• Journal of Mechanical Science and Technology
• /
• 제15권5호
• /
• pp.646-655
• /
• 2001

This paper reports the effects of nozzle exit boundary layer swirl on the instability modes of underexpanded supersonic jets emerging from plane rectangular nozzles. The effects of boundary layer swirl at the nozzle exit on thrust and mixing of supersonic rectangular jets are also considered. The previous study was performed with a 30°boundary layer swirl (S=0.41) in a plane rectangular nozzle exit. At this study, a 45°boundary layer swirl (S=1.0) is applied in a plane rectangular nozzle exit. A three-dimensional unsteady compressible Reynolds-Averaged Navier-Stokes code with Baldwin-Lomax and Chiens $\kappa$-$\xi$ two-equation turbulence models was used for numerical simulation. A shock adaptive grid system was applied to enhance shock resolution. The nozzle aspect ratio used in this study was 5.0, and the fully-expanded jet Mach number was 1.526. The \"flapping\" and \"pumping\" oscillations were observed in the jets small dimension at frequencies of about 3,900Hz and 7,800Hz, respectively. In the jets large dimension, \"spanwise\" oscillations at the same frequency as the small dimensions \"flapping\" oscillations were captured. As reported before with a 30°nozzle exit boundary layer swirl, the induction of 45°swirl to the nozzle exit boundary layer also strongly enhances jet mixing with the reduction of thrust by 10%.

• 한국가시화정보학회지
• /
• 제4권2호
• /
• pp.44-50
• /
• 2006

A visualization study on the boundary layer and near-wake of an NACA 0012 airfoil was con-ducted in order to investigate the influence of boundary layer behavior on the near-wake at low Reynolds numbers. The present study is investigated at static angles of attack ${\alpha}=0^{\circ},\;3^{\circ},\;6^{\circ}$ and $Re=2.3{\times}10^4,\;3.3{\times}10^4,\;4.8{\times}10^4$ by using a smoke-wire technique. The results of this study show that the laminar boundary layer on the airfoil surface is attached to the surface at ${\alpha}=0^{\circ}$, and that laminar separation of boundary layer on the airfoil surface occurs at ${\alpha}=3^{\circ}$. Furthermore, reattachment of the boundary layer occurs in the case of ${\alpha}=6^{\circ}$. In the current study, the location of the laminar separation point moves upstream as the Reynolds number and the angle of attack increase.

• Nuclear Engineering and Technology
• /
• 제34권6호
• /
• pp.553-565
• /
• 2002

In this paper, the robust control scheme with the improved control performance within the boundary layer is proposed. In the control scheme, the robust controller based on the traditional variable structure control method is modified to have the adaptation within the boundary layer. From this controller, the width of the boundary layer where the robust control input is smoothened out can be given by an appropriate value. But the improved control performance within the boundary layer can be achieved without the so-called control chattering because the role of adaptive control is to compensate for the uncovered portions of the robust control occurred from the continuous approximation within the boundary layer Simulation tests for circular navigation of an underwater wall-ranging robot developed for inspection of wall surfaces in the research reactor, TRIGA MARK III, confirm the performance improvement. Notational Conventions Vectors are written in boldface roman lower-case letters, e.g., x and y. Matrices are written in upper-case roman letters, e.g., G and B. And ∥.∥ means the Euclidean norm.

• 대한기계학회논문집B
• /
• 제21권10호
• /
• pp.1273-1283
• /
• 1997

Experiments of shock wave/turbulent boundary layer interaction were conducted by using a supersonic wind tunnel. Nominal Mach number was varied in the range of 1.6 to 3.0 by means of different nozzles. The objective of the present study is to investigate the effects of boundary layer flow bleed on the interaction flow field in a straight tube. Two-dimensional slits were installed on the tube walls to bleed the turbulent boundary layer flows. The bleed flows were measured by an orifice. The ratio of the bleed mass flow to main mass flow was controlled within the range of 11 per cent. The wall pressures were measured by the flush mounted transducers and Schlieren optical observations were made for almost all of the experiments. The results show that the boundary layer flow bleed reduces the multiple shock waves to a strong normal shock wave. For the design Mach number of 1.6, it was found that the normal shock wave at the position of the silt was resulted from the main flow choking due to the suction of the boundary layer flow.

• 한국전산유체공학회지
• /
• 제18권2호
• /
• pp.56-65
• /
• 2013

Two compression ramp problems and an impinging shock problem are computed to investigate influence of turbulence models and eddy viscosity on the shock-wave / boundary layer interaction. A Navier-Stokes boundary layer generation code was applied to the generation of inflow boundary conditions. Computational results are validated well with the experimental data and effects of turbulence models are investigated. It is shown that the behavior of turbulence (eddy) viscosity directly affects both the extent of the separation and shock-wave positions over the separation.

• 대한조선학회지
• /
• 제16권3호
• /
• pp.35-47
• /
• 1979

Wave resistance of a parabolic thin ship, with its boundary layer and wake taken into account, was calculated up to second order. In addition to the double-model source distribution on the centerplane, image sources of the wave potential were calculated to keep the body introduced boundary condition undisturbed. Boundary layer and wake effects on the wave-making resistance were included by generating an irrotational flow which matches that exterior to the boundary layer and wake. For this purpose, the boundary layer and wake were calculated. The wave resistance refined with second-order corrections are found to be very important for wave resistance calculations even at moderate Froude numbers($Fr=0.2{\sim}0.3$). Wave-potential corrections are dominate around the bow. On the other hand, Viscosity plays and important role at the stern with its boundary layer and wake development.

• International Journal of Fluid Machinery and Systems
• /
• 제1권1호
• /
• pp.24-32
• /
• 2008

Bleeding away a part of the boundary layer next to the wall is an effective method for controlling boundary-layer distortions from incident shock waves or curvature in geometry. When the boundary-layer flow is supersonic, the physics of bleeding with and without an incident shock wave is more complicated than just the removal of lower momentum fluid next to the wall. This paper reviews CFD studies of shock-wave/boundary-layer interactions on a flat plate with bleed into a plenum through a single hole, three holes in tandem, and four rows of staggered holes in which the simulation resolves not just the flow above the plate, but also the flow through each bleed hole and the plenum. The focus is on understanding the nature of the bleed process.

• Journal of Advanced Marine Engineering and Technology
• /
• 제27권6호
• /
• pp.753-758
• /
• 2003

In this study. an experiment has been performed to investigate distributions of static pressure around a circular cylinder in a uniform shear flow which is made by a specially designed wind tunnel. From the computation program(BLAYER), various boundary layer value are obtained depending on the shear flow rate. It is basical design data that boundary layer flow phenomenon of nuclear power plant heat exchanger tube surroundings. airfoil. and others flow fields.

• Journal of the Korean Society for Industrial and Applied Mathematics
• /
• 제6권2호
• /
• pp.63-73
• /
• 2002

The influence of unsteady boundary layer magnetohydrodynamic flow with thermal relaxation of perfectly conducting fluid, past a semi-infinite plate, is considered. The governing non linear partial differential equations are solved using the method of successive approximations. This method is used to obtain the solution for the unsteady boundary layer magnetohydrodynamic flow in the special form when the free stream velocity exponentially depends on time. The effects of Alfven velocity $\alpha$ on the velocity is discussed, and illustrated graphically for the problem.