• Explosives and Blasting
• /
• v.26 no.2
• /
• pp.77-91
• /
• 2008

According as demand for superannuated building increases recently, much researches about demolition method of construction are going on. This case study executed to center library building located in Dankook University. Explosives demolition method applied Progressive Collapse. Explosives demolition main blasting floors are 2, 4floor, assistance blasting floor is 1 floor. In the nearest distance (150 m), Vibration measurement result were 0.0302 cm/sec (PPV). Change was not in measurement value is crack gauge which install beforehand.

• Explosives and Blasting
• /
• v.14 no.3
• /
• pp.3-9
• /
• 1996

The scope of this cable works was as follows, it was drilled two shafts, NO. 1 shaft (${\phi}6.8m{\times}31m$), NO.2 shaft (${\phi}6.8m{\times}33m$), ) and it was connected two shaft in Tunneling. The first, it was needed to investigate the surey of influenced of vibration and noise by blastig to near by housing structure. 2nd, it was essential to decide the boundary line of influenced for agriculture water and portable water, by draw down of underground water. Blasting works has been done successfully without any problem, but by draw down of underground water, with in 250m level from #1 shaft, agriculture well drilled 8 place and portable water well drilled 7 place for near by farmers.

• Explosives and Blasting
• /
• v.27 no.1
• /
• pp.38-46
• /
• 2009

Recently, as a reduction method of vibration and noise, an electronic detonation which has an accuracy of time and a freedom of input delay time was introduced. A waveform composition program can determine a delay time and accomplish simulation under environment similar to real blast using a delay time. In this study, optimum delay time which controls vibration is obtained and real measurement vibration level is estimated by a waveform composition program.

• Tunnel and Underground Space
• /
• v.9 no.1
• /
• pp.72-77
• /
• 1999

New criteria to evaluate blasting damage to structure is proposed considering environmental caused daily deformation of cracks in structures. Results from 3 brick houses in fishing village shows that more than 10 times higher vibration level than design criteria of 0.5 kine is required to cause structural damage.

• Explosives and Blasting
• /
• v.15 no.3
• /
• pp.20-32
• /
• 1997

The pressure-time profile of the explosion gases can be controlled fot the use of cartridge explosives with two techniques Known as Decoupling and Spacing the charges. Decoupling consists in leaving and empty space between the explosive column and wall of the blast hole. Four different decoupling index, 1.4, 1.8, 2.34, 3.0 are selected in this field study. The level of ground vibrations with each decoupling index are measured and the empirical particle vibrations with each decoupling index are measured and the empirical particle velocity equation from these data was obtained. The condition of new cracks at blast hole are also examined. As the decoupling index in increased, the level of the blast vibration is decreased,. But the cracks in rock masses are efficiently formed to remove the broken rock. The vibration constant associated with a given site $K=1564.5(D.I)^{-1.3233}$ in terms of D.I(decopling index).

• Explosives and Blasting
• /
• v.24 no.2
• /
• pp.33-39
• /
• 2006

The blasting vibration prediction in Korea is mainly carried out by the scaled distance method. The delay interval of the scaled distance method is generally considered to be 8ms, where the effect of vibration between adjacent holes is not included. In this study, the origin and issues of 8ms criterion are reviewed from literatures and Langefors' 2.5T criterion is applied to evaluate the applicabilities of 8ms, 17ms and 25ms intervals in which a vibration does not affect an adjacent hole.

• Explosives and Blasting
• /
• v.30 no.2
• /
• pp.1-8
• /
• 2012

The only law related to airblast and ground vibration control in Korea is the Noise and Vibration Control Act enforced by the Ministry of Environment. But this law mainly deals with the annoyance aspects of noises and vibrations in ordinary human life. Hence, the law defines the safety criteria of ground vibration as the vibration level (VL) of dB(V) unit. The ground vibrations produced from blasting, however, have the unique characteristics that can be shown in shock vibrations, and the duration is also very short compared to the vibrations from machinery, tools or facilities. Hence, vibration regulations for blasting operations usually define the safety criterion as the peak particle velocity (PPV) considering the effect of ground vibrations to structural damage. Notwithstanding, there are several attempts that predict VL from PPV or estimate VL based on the scaled distances (SD; in unit of $m/kg^{1/2}$ or $m/kg^{1/3}$) without considering their frequency spectra. It appears that these attempts are conducted mainly for the purpose of satisfying the law in blasting contracts. But, in principle there could no correlation between peaks of velocity and acceleration over entire frequency spectrum. Therefore, such correlations or estimations should be conducted only for the waves with the same or very similar frequency spectra.

• Journal of the Korean Professional Engineers Association
• /
• v.23 no.2
• /
• pp.81-93
• /
• 1990

The blasting to construct subways in Seoul, Korea. have often increased complaints of ground vibration. In order to prevent the damage to structures, it was necessary to predict the level of blasting induced vibration and to determine the maximum charge weight per delay within a allowable vibration level. A total of 109 blasts were recorded at ten sites. Blast-to-structure distances ranged from 8 to 84.2 meter, where charge weight varied from 0,1125 to 7.85 kg per delay. The data from blast were studied to determine the effect of explosives type on the vibration constants(k). Vibration constants were also analyzed in terms of compressive strength of rock and blasting patterns.

• Explosives and Blasting
• /
• v.26 no.1
• /
• pp.15-21
• /
• 2008

In case of estimating the shocking vibration during the blasting demolitions, the weight and falling height of the structure, that is a potential energy, had been considered. But, this study presented a new equation which used the impulse concerning a falling weight instead of potential energy as a method of predicting the shock vibration. In this experiment, the data of the impulse were compared with the data of the potential energy by performing the free-fall, and all data were comparatively analyzed by the regression analysis method. Also, the method of the superposition theory, which is calculated by the diminution ratio according to distance, the free-fall difference according to height, and the time giving the shock to the ground according to the breakdown pattern, was compared with the previous vibration data occurring from the blasting demolitions in the same conditions. As a result, this study suggests that the impulse and the method of superposition theory be applied as a method of predicting the shocking vibration. Therefore, these results could be expected to estimate the shocking vibration more accurately than the previous method.

• Explosives and Blasting
• /
• v.31 no.1
• /
• pp.11-22
• /
• 2013

This study compared and analysed ground vibration, size of underwater background noise in fish farms and underwater object noise of blasting and obtained ground vibration prediction equation through a regression analysis and correlation equation between underwater object noises in order to predict degrees of underwater noise in blasting and organize underwater noise control regulations. Before the study, when background noise of fish and shellfish farms with different conditions was measured, levels of background noise were different according to environmental characteristics of each farm. Ground vibration which causes underwater noise was measured to obtain a correlation equation between ground vibration and underwater object noise. Therefore, if underwater noise is predicted for each construction with a use of a correlation and permissible standards appropriate for each condition are applied for design and construction, financial loss from damages to fish and shellfish caused by development of insufficient technological and engineering logic can be prevented and successful construction with safety of underwater creatures guaranteed can be achieved.