• 한국자동차공학회논문집
• /
• 제17권5호
• /
• pp.61-66
• /
• 2009

An experimental investigation was conducted to analyze the effects of biodiesel-ethanol and biodiesel-diesel blended fuels on the characteristics of combustion and exhaust emissions, and size distributions of particulate matter in a single cylinder diesel engine. The three types of test fuel were biodiesel and two blended fuels which were added ethanol and diesel by 20 % volume based fraction into biodiesel, respectively. In this study, the injection rate, combustion pressure, exhaust emissions and size distributions of particulate matter were measured under various injection timings and injection pressures. The experimental results show that biodiesel-ethanol blended fuel has lengthened ignition delay and low combustion pressure in comparison with those of biodiesel and biodiesel-diesel blended fuel even if all fuels indicated similar trends of injection rate under equal injection pressures. In addition, the ethanol blended fuel significantly reduced nitrogen oxidies (NOx) and soot emissions. And then the size distribution of particulate matters shows that blended fuels restrain the formation of particles which were beyond the range of 150nm comparison with biodiesel fuel.

• 한국산학기술학회논문지
• /
• 제15권6호
• /
• pp.3383-3388
• /
• 2014

본 연구는 4실린더 커먼레일 디젤 기관에서 바이오디젤 혼합 연료와 순수한 디젤연료를 사용하여 EGR율을 변화시켰을 때 연소 및 배기 특성을 디젤 연료만을 사용하였을 경우와 비교하기 위하여 실험을 수행하였다. 본 연구에서는 일반적으로 많이 사용되고 있는 기관 회전 속도 2,000rpm에서 바이오디젤 혼합율 20%의 연료와 디젤 연료를 사용하여, EGR율에 다양하게 변화를 주어 실험을 하였다. 실험결과, 연소압력은 바이오디젤 혼합 연료와 디젤 연료 모두 EGR율이 증가할수록 감소하였으며, 도시 평균유효 압력은, 디젤 연료에 비하여 바이오디젤 혼합 연료가 더 높게 나타났다. 배출가스의 경우에, NOx는 EGR율이 증가할수록 디젤 연료에 비하여 바이오디젤 혼합 연료가 더 많이 배출되었다. 또한 NOx는 바이오디젤 혼합 연료와 디젤연료 모두 EGR율이 증가할수록 감소되었다. CO와 Soot, $CO_2$는 EGR율이 증가 할수록 증가하였으며, CO, Soot은 디젤 연료에 비해 바이오디젤 혼합 연료에서 더 작게 배출되었지만 $CO_2$는 더 많이 배출되었다.

• 한국분무공학회지
• /
• 제9권3호
• /
• pp.1-7
• /
• 2004

This experiment was undertaken to investigate the atomization characteristics of the low viscosity biodiesel blended fuel and ultrasonic energy added one. Test fuels were conventional diesel fuel and biodiesel fuel. We compared to the characteristics of viscosity and surface tension, SMD between low viscosity biodiesel blended fuel and ultrasonic energy added one. Sauter mean diameter was measured under the variation of the spray distance. Viscosity and surface tension was measured under the variation of the time trace. To measure the droplet size, we used the Malvern system 2600C. Droplet size distribution was analyzed from the result data of Malvern system. Through this experiment, we found that the condition of the ultrasonic energy added situation had smaller Sauter mean diameter of droplet, viscosity and surface tension than that of the conventional situation.

• 한국자동차공학회논문집
• /
• 제19권4호
• /
• pp.130-136
• /
• 2011

This study describes the effect of EGR rate on the combustion and emissions characteristics of a four cylinder CRDI diesel engine using biodiesel (soybean oil) blended diesel fuel. The test fuel is composed of 30% biodiesel and 70% ULSD (ultra low sulfur diesel) by volumetric ratio. The experiment of engine emissions and performance characteristics were performed under the various EGR rates. The experimental results showed that ignition delay was extended, the maximum combustion pressure and heat release gradually were decreased with increasing EGR rate. Comparing biodiesel blended fuel to ULSD, the injection quantity of biodiesel blended fuel was further increased than ULSD. The emission results showed that $NO_x$ emission of biodiesel blended fuel becomes higher according to the increase of EGR rate. However, in the case of biodiesel blended fuel, HC, CO and soot emissions were decreased compared to ULSD.

• 동력기계공학회지
• /
• 제12권1호
• /
• pp.5-12
• /
• 2008

We measured emission characteristics of CRDI diesel engine equipped with a commercial CPF. Experimental parameters adopted a neat diesel fuel, a blend of diesel fuel with 20% biodiesel, a blend of diesel fuel with 15% biodiesel and 5% ethanol. The experiments were carried out to measure the emission and engine performance according to ESC 13-mode cycles. The maximum torque with biodiesel blend fuel is slightly lower than that of neat diesel fuel in the entire the 13-mode cycles, and 5% ethanol and 15% biodiesel blend fuel is slightly higher than that of neat diesel fuel. THC and CO emissions of the biofuel blended diesel fuel were slightly increased and decreased, and mean conversion efficiencies of THC and CO on the commercial CPF were achieved about 70$\sim$87% in the ESC 13-mode. From the measurement by the Scanning Mobility Particle Sizer(SMPS), the total number and mass of nano-sized particles by a commercial CPF were decreased about 97.8% and 96.8 % in the range of the nano-size from 10.6 to 385nm, respectively.

• 농업과학연구
• /
• 제46권4호
• /
• pp.941-953
• /
• 2019

Biodiesels are being explored as a clean energy alternative to regular diesel, which causes pollution. In this study, the optimum conditions for producing biodiesel (BD) by combining beef tallow, an animal waste resource with a high saturated fatty acid content, and corn oil, a vegetable oil with a high unsaturated fatty acid content, were investigated, and the fuel properties were analyzed. Furthermore, Multivariate Analysis of Variance (MANOVA) was used to verify the optimum conditions for producing biodiesel. The influences of control factors, such as the oil blend ratio and methanol to oil molar ratio, on the fatty acid methyl ester and biodiesel production yield were investigated. As a result, the optimum condition for producing blended biodiesel was verified to be tallow to corn oil blend ratio of 7 : 3 (TACO7) and a methanol to oil molar ratio of 14 : 1. Moreover, the interaction between the oil blend ratio and the methanol to oil molar ratio has the most crucial effects on the production of oil blended biodiesel. In conclusion, the analysis results of the fuel properties of TACO7 BD satisfied the BD quality standard, and thus, the viability of BD blended with waste tallow as fuel was verified.

• 에너지공학
• /
• 제13권4호
• /
• pp.235-241
• /
• 2004

본 연구는 초음파 개질 바이오 디젤유의 점도와 표면장력에 대한 연료의 물리적 특성, 분무 미립화 특성에 관한 심층적이고 체계적인 연구에 중점을 두었다. 이를 규명하기 위하여 초음파 재질 연료와 개질 되지 않은 연료의 상대 비교 분석을 통한 연료특성과 연료분사펌프의 회전수 및 노즐선단 거리변화에 의한 입경측정의 상관성을 정립하였다.

• Korean Chemical Engineering Research
• /
• 제47권2호
• /
• pp.237-242
• /
• 2009

화석연료의 고갈과 원유가격 폭등으로 인해 이를 대체할 수 있는 다양한 연료의 개발이 이루어지고 있다. 동물성 지방이나 식물성 기름의 주성분인 트리글리세라이드를 메탄올과 반응시켜 생산된 바이오디젤은 기존의 석유디젤을 대체할 수 있는 친환경적인 연료로 알려져 있다. 본 연구에서는 국내에서 유통중인 경유에 6종류의 원료별 바이오디젤을 일정 비율로 혼합한 뒤, 다양한 연료특성을 분석하였다. 바이오디젤의 농도가 높아질수록 밀도, 동점도, 인화점이 상승하였고, 저온특성은 악화되는 것을 확인하였다. 또한 경유의 중요한 연료특성인 세탄가를 IQT를 이용해 측정한 결과, 바이오디젤의 혼합비율이 높아질수록, 유도세탄가가 높게 측정되었으며, 특히 팜유로부터 생산된 바이오디젤의 경우, 71.26의 높은 유도세탄가가 측정되었다.

• 동력기계공학회지
• /
• 제9권2호
• /
• pp.14-18
• /
• 2005

In this study, the spray characteristics of blended fuels with biodiesel were investigated. The experiments were performed for the effect of mixing ratio and injection pressures on the spray behavior. Conventional diesel fuel and biodiesel fuel and blended fuels were used as test fuels. Through the spray visualization system, composed of a Halogen lamp and High speed camera. The process of spray injection was visualized. Fuel containing biodiesel has different spray pattern on account of the high viscosity and large surface tension. Through this experimental result, we found that, after solenoid driving pulse generates, the increase of injection pressure enables delay time to get shorter, but the increase of mixing ratio makes delay time lengthen.

• Journal of Advanced Marine Engineering and Technology
• /
• 제38권9호
• /
• pp.1081-1086
• /
• 2014

본 연구는 4실린더 커먼레일 디젤기관에서 식물성 바이오 연료인 카롤라유(Canola oil)와 디젤연료를 혼합하여 사용하였을 때 바이오디젤 혼합율과 엔진 회전수 변화에 따른 연소 및 배기 배출물 특성을 조사하기 위하여 실험을 수행하였다. 실험 결과에 의하면 엔진 회전수 1,000, 1,500, 2,000(rpm)에서 연소 압력은 바이오디젤 혼합율이 증가할수록 감소하고, 2500rpm에서는 바이오디젤 혼합율이 증가할수록 증가 하였으며, 열 발생율은 바이오디젤 혼합율이 증가 할수록 모두 증가하였다. 연료 소비율은 바이오디젤 혼합율이 증가할수록 엔진 회전수가 상승할수록 증가하였다. CO 배출물은 엔진 회전수가 상승할수록, 바이오디젤 혼합율이 증가할수록 감소하였다. $CO_2$, NOx, 배출물은 엔진 회전수가 상승할수록 바이오디젤 혼합율이 증가할수록 증가하였다.