• 환경영향평가
• /
• 제23권1호
• /
• pp.11-17
• /
• 2014

Since the Renewable Portfolio Standard (RPS) would be started in 2012, the use of renewable energy should be 11% of total energy use including bio-fuel in 2030. The economic efficiency for renewable energy in B power plant was considered with the bio-diesel, wind power and solar power. The Net Present Value (NPV) and Benefit/Cost Ratio(BC) were used for the economic efficiency with the cost and benefit analysis. In case of bio-diesel, the cost resulted from the fuel conversion and the benefit would be created with trade and environmental improvement. With regard to wind power and solar power, the construction cost would be required and benefit factors would be same as the bio-diesel. The wind power was the best of economic efficiency of renewable energy as the results of NPV and BC ratio. Whereas, the market of wind power was very popular and the techniques of wind power has been developing rapidly.

• 한국공작기계학회논문집
• /
• 제12권6호
• /
• pp.97-103
• /
• 2003

Currently, due to serious increase of pollution scones, lots of technology has been involved to reduce exhaust gas in diesel engine. But the amounts of exhaust gas can not be decreased somehow due to the increase of diesel vehicles. Moreover, emission standards of each counties are being stringent in advanced countries such as USA and Europe. In the near future, sulfur contents in fuel must be essentially reduced f3r health and environment because sulfur can basically reduce exhaust gas. Therefore, when will be applied to Bio-diesel and ULSD, they could reduce sulfur contents of fuel without aftertreatment and might conform the influence of engine performance, emission, smoke and fuel consumption.

• Journal of Mechanical Science and Technology
• /
• 제19권3호
• /
• pp.870-876
• /
• 2005

It seems very difficult to comply with upcoming stringent emission standards in vehicles. To develop low emission engines, better quality of automotive fuels must be achieved. Since sulfur contents in diesel fuels are transformed to sulfate-laden particulate matters as a catalyst is applied, it is necessary to provide low sulfur fuels before any Pt-based oxidation catalysts are applied. In general, flash point, distillation $90\%$ and cetane index are improved but viscosity can be worse in the process of desulfurization of diesel fuel. Excessive reduction of sulfur may cause to degrade viscosity of fuels and engine performance in fuel injection systems. This research focused on the performance of an 11,000 cc diesel engine and emission characteristics by the introduction of ULSD, bio-diesel and a diesel oxidation catalyst, where the bio-diesel was used to improve viscosity of fuels in fuel injection systems as fuel additives or alternative fuels.

• International Journal of Automotive Technology
• /
• 제6권1호
• /
• pp.15-21
• /
• 2005

The purpose of this paper is to experimentally investigate the engine pollutant emissions and combustion characteristics of diesel engine fueled with ethanol-diesel blended fuel (bio-diesohol). The experiments were performed on a single-cylinder DI diesel engine. Two blend fuels were consisted of $15\%$ ethanol, $83.5\%$ diesel and $1.5\%$ solublizer (by volume) were evaluated: one without cetane improver (E15-D) and one with a cetane improver (E15-D+CN improver). The engine performance parameters and emissions including fuel consumption, exhaust temperature, lubricating oil temperature, Bosch smoke number, CO, NOx, and THC were measured, and compared to the baseline diesel fuel. In order to gain insight into the combustion characteristics of bio-diesohol blends, the engine combustion processes for blended fuels and diesel fuel were observed using an Engine Video System (AVL 513). The results showed that the brake specific fuel consumption (BSFC) increased at overall engine operating conditions, but it is worth noting that the brake thermal efficiency (BTE) increased by up to $1-2.3\%$ with two blends when compared to diesel fuel. It is found that the engine fueled with ethanol-diesel blend fuels has higher emissions of THC, lower emissions of CO, NOx, and smoke. And the results also indicated that the cetane improver has positive effects on CO and NOx emissions, but negative effect on THC emission. Based on engine combustion visualization, it is found that ignition delay increased, combustion duration and the luminosity of flame decreased for the diesohol blends. The combustion is improved when the CN improver was added to the blend fuel.

• 공업화학
• /
• 제23권2호
• /
• pp.232-240
• /
• 2012

바이오디젤(BD)은 식물성 오일 또는 동물성 지방과 같이 재생산 가능한 원료로부터 유래된 긴 사슬 지방산의 단일 알킬에스테르로, 디젤연료에 비해 낮은 온도에서 연료특성이 열악한 것으로 알려져 있다. 디젤연료의 경우, 많은 저온 유동성 향상제가 개발되어 있지만 바이오 디젤은 디젤연료와 주요 구성성분이 다르기 때문에 디젤연료용 저온 유동성 향상제를 바이오디젤에 사용 시 저온 유동성 향상에 한계가 따른다. 이에 본 연구는 동절기에 바이오디젤의 저온 특성을 향상시키고자 에스테르 반응으로 합성한 알킬 메타크릴레이트 단량체(Stearyl methacrylate, Lauryl methacrylate)와 무수말레인산을 이용하여 저온 유동성 향상제를 합성하였고, 알킬아민을 이용한 개환 반응을 실시하였다. 이렇게 합성된 저온 유동성 향상제를 $^1H-NMR$ 및 FT-IR을 통해 분석하였으며, GPC로 분자량을 측정한 후 SoybeanBD와 PalmBD에 1000~10000 ppm의 농도로 첨가하여 저온특성을 조사하였다. 그 결과 SoybeanBD에 LMA2SMA6MA2-C8A 공중합체 첨가 시 유동점이 $12.5\;^{\circ}C$ 강하됨을 확인하였다.

• Environmental Engineering Research
• /
• 제25권3호
• /
• pp.290-298
• /
• 2020

A large residual fraction of aliphatic components of diesel prevails in soil, which has adverse effects on the environment. This study identified the most bio-recalcitrant aliphatic residual fraction of diesel through total petroleum-hydrocarbon fractional analysis. For this, the strain Acinetobacter sp. K-6 was isolated, identified, and characterized and investigated its ability to degrade diesel and n-alkanes (C₁₈, C₂₀, and C₂₂). The removal efficiency was analysed after treatment with bacteria and nutrients in various soil microcosms. The fractional analysis of diesel degradation after treatment with the bacterial strains identified C₁₈-C₂₂ hydrocarbons as the most bio-recalcitrant aliphatic fraction of diesel oil. Acinetobacter sp. K-6 degraded 59.2% of diesel oil and 56.4% of C₁₈-C₂₂ hydrocarbons in the contaminated soil. The degradation efficiency was further improved using a combinatorial approach of biostimulation and bioaugmentation, which resulted in 76.7% and 73.7% higher degradation of diesel oil and C₁₈-C₂₂ hydrocarbons, respectively. The findings of this study suggest that the removal of mid-length, non-volatile hydrocarbons is affected by the population of bio-degraders and the nutrients used in the process of remediation. A combinatorial approach, including biostimulation and bioaugmentation, could be used to effectively remove large quantities of aliphatic hydrocarbons persisting for a longer period in the soil.

• 한국분무공학회지
• /
• 제19권2호
• /
• pp.55-63
• /
• 2014

Pyrolysis oil (PO), also known as Bio crude oil (BCO), has the potential to displace significant amounts of fuels that are currently derived from petroleum sources. PO has been regarded as an alternative fuel for petroleum fuels to be used in diesel engine. However, the use of PO in a diesel engine requires modifications due to low energy density, high water contents, low acidity, and high viscosity of the PO. One of the easiest way to adopt PO to diesel engine without modifications is emulsification of PO with the fuels that has higher cetane number. However, PO that has high amount of polar chemicals is immiscible with non polar hydrocarbons of diesel. Thus, to stabilize a homogeneous phase of diesel-PO blends, a proper surfactant should be used. In this study, a DI diesel engine operated with diesel and diesel-PO emulsions was experimentally investigated. Performance and gaseous & particle emission characteristics of a diesel engine fuelled by diesel-PO emulsions were examined. Results showed that stable engine operation was possible with the emulsions and engine output power was comparable to diesel operation.

• Journal of Microbiology and Biotechnology
• /
• 제13권4호
• /
• pp.578-583
• /
• 2003

The desulfurization genes (dszABC) were cloned from Gordonia nitida. Nucleotide sequences similarity between the dszABC genes of G. nitida and those of Rhodococcus rhodochrous IGTS8 was 89%. The similarities of deduced amino acids between the two were 86% for DszA, 86% for DszB, and 90% for DszC. The G. nitida dszABC genes were expressed in several different Escherichia coli strains under an inducible trc promoter. Cultivation of these metabolically engineered E. coli strains in the presence of 0.2 mM dibenzothiophene (DBT) allowed the conversion of DBT to 2-hydroxybiphenyl (2-HBP), which is the final metabolite of the sulfur-specific desulfurization pathway. The maximum conversion of DBT to 2-HBP was 16% in 60 h. Recombinant E. coli was applied for the deep desulfurization of diesel oil supplemented into the medium at 5% (v/v). Sulfur content in diesel oil was decreased from 250 mg sulfur/1 to 212.5 mg sulfur/1, resulting in the removal of 15% of sulfur in diesel oil in 60 h.

• Journal of Advanced Marine Engineering and Technology
• /
• 제33권2호
• /
• pp.252-258
• /
• 2009

Engine bench tests has been done on a common-rail diesel engine with bio-diesel fuel to study effects of B100 and B20 on output power, fuel consumption and emissions. Test results show that B100 and B20 could reduce PM, HC, CO emission and smoke, but power decrease, fuel consumption increase and NOx increase obviously, B100 reduce PM and DS with $50%{\sim}70%$ and $80%{\sim}85%$ compared with diesel fuel, while B20 reduce PM and DS with $25%{\sim}35%$ and $30%{\sim}40%$. NOx of B100 and B20 increase $5%{\sim}20%$ compare to diesel.

• 한국분무공학회지
• /
• 제20권2호
• /
• pp.88-94
• /
• 2015

Recently, exhaust gas regulation has been gradually strengthened due to depletion of fossil fuels and environmental problem like a global warming. Due to this global problem, the demand for eco-friendly vehicle development is rapidly increasing. A clean diesel vehicle is considered as a realistic alternative. The common-rail fuel injection system, which is the key technology of the clean diesel vehicle, has adopted injection strategies such as high pressure injection, multiple injection for better atomization of the fuel. In addition, the emission regulations in the future is expected to be more stringent, which a conventional engine is difficult to deal with. One of the way for actively proceeding is the study of alternative fuels. Among them, the bio-diesel has been attracted as an alternative of diesel. So, in this study, spray characteristics of bio-diesel was analyzed in the common-rail fuel injection system with three injectors driven by different operating mechanism.