• Journal of Korea Water Resources Association
• /
• v.53 no.8
• /
• pp.617-626
• /
• 2020

This study investigates changes of bifurcation discharge ratio, flow velocity distributions and characteristics of separation zone due to variation of bifurcation angle by using TELEMAC-2D model. When the bifurcation angle is reduced from 90° to 45° without changing the boundary conditions, the bifurcation discharge ratio increased by 1.5 times from 0.523 to 0.785 because of increasing the radius of curvatures, the inertia force of the downstream flow, and the pressure gradient by the downstream boundary conditions. The bifurcation discharge ratio increases non-linearly whenever the bifurcation angle decreases by 15° intervals from 90° to 45° in flow with the upstream Froude number of 0.45 to 0.74. In flow with a maximum Froude number of 0.74, the rate of increase for bifurcation discharge ratio is 31.1% and the minimum value. When the Froude number is 0.58, the bifurcation discharge ratio is 0.7 or less, and the maximum rate of increase for that ratio is 53.5%. As the upstream Froude number decreases less than 0.58, the bifurcation discharge ratio exceeds 0.7, and the rate of increase decreases. When the upstream Froude number is 0.4 higher, the dimensionless width and length changing ratio of the separation zone are about 2.56 and 5.5 times higher than in 0.4 or less.

• Journal of Ocean Engineering and Technology
• /
• v.19 no.2 s.63
• /
• pp.60-66
• /
• 2005

This paper investigates the relationship between the fleet-angle of the hoisting rope and the swaying and pitching angles of a cargo in container cranes. It is found that for a given disturbance, when the fleet-angle is large, the sway Angle becomes smaller, but the pitching angle becomes larger. Therefore, for a quick suppression of a sway motion, it is desirable to have a large fleet-angle. The compatibility and bifurcation conditions, regarding instability, are characterized.

• Korea-Australia Rheology Journal
• /
• v.21 no.3
• /
• pp.175-183
• /
• 2009

This article describes the numerical investigation of blood flow in the stenosed artery bifurcation with acceleration of the human body. Using the commercial software FLUENT, three-dimensional analyses were performed for six simulation cases with different body accelerations and bifurcation angles. The blood flow was considered to be pulsation flow, and the blood was considered to be a non-Newtonian fluid based on the Carreau viscosity model. In order to consider periodic body acceleration, a modified, time-dependent, gravitational-force term was used in the momentum equation. As a result, flow variables, such as flow rate and wall shear stress, increase with body acceleration and decrease with bifurcation angle. High values of body acceleration generate back flow during the diastolic period, which increases flow fluctuation and the oscillatory shear index at the stenosis.

• Journal of computational fluids engineering
• /
• v.16 no.4
• /
• pp.64-71
• /
• 2011

Cerebral aneurysm mostly occurs at a bifurcation of the circle of Willis. When the cerebral aneurysm is ruptured, a disease like subarachnoid hemorrhage and stroke is caused and this can be even deadly for patients. Generally it is known that causes of the intracranial aneurysm are a congenital deformity of the artery and pressure or shear stress from the blood flow. A blood flow pattern and the geometry of the blood vessel are important factors for the aneurysm formation. Research for several hemodynamic indices has been performed and these indices can be used for the prediction of aneurysm initiation and rupture. Therefore, the numerical analysis was performed for hemodynamic characteristics of the blood flow through the cerebral artery applying the various bifurcation angle and flow rate ratio. We analyze the flow characteristics using indices from the results of the numerical simulation. In addition, to investigate the flow pattern in the aneurysm according to the bifurcation angle and the flow rate ratio, we performed the numerical simulation on the supposition that the aneurysm occurs.

• 한국전산유체공학회:학술대회논문집
• /
• 2011.05a
• /
• pp.161-168
• /
• 2011

Cerebral aneurysm mostly occurs at a bifurcation of the circle of Willis. When the cerebral aneurysm is ruptured a disease like subarachnoid hemorrhage and stroke is caused and this can be even deadly for patients. Generally it is known that causes of the intracranial aneurysm are a congenital deformity of the artery and pressure or shear stress from the blood flow. A blood flow pattern and the geometry of the blood vessel are important factors for the aneurysm formation. Research for several hemodynamic indices has been performed and these indices can be used for the prediction of aneurysm initiation and rupture. Therefore, the numerical analysis was performed for hemodynamic characteristics of the blood flow through the cerebral artery applying the various bifurcation angle and flow rate ratio. We analyze the flow characteristics using indices from the results of the numerical simulation. In addition, to investigate the flow pattern in the aneurysm according to the bifurcation angle and the flow rate ratio, we performed the numerical simulation on the supposition that the aneurysm occurs.

• Advances in aircraft and spacecraft science
• /
• v.3 no.4
• /
• pp.447-470
• /
• 2016

Limit cycle oscillations (LCO) as well as nonlinear aeroelastic analysis of a swept aircraft wing with cubic restoring moments in the pitch degree of freedom is investigated. The unsteady aerodynamic loading applied on the wing is modeled by using the strip theory. The harmonic balance method is used to calculate the LCO frequency and amplitude for the swept wing. Finally the super and subcritical Hopf bifurcation diagrams are plotted. It is concluded that the type of bifurcation and turning point location is sensitive to the system parameters such as wing geometry and sweep angle.

• Proceedings of the KSME Conference
• /
• 2003.11a
• /
• pp.741-746
• /
• 2003

The main objective of present study is to obtain information for flow characteristics, such as velocity and wall shear stress, of bifurcation in blood vessel. Branch flows for Newtonian fluids are simulated by using Fluent V.6.0. The numerical simulations are carried out for five cases divided by different values of bifurcation angle and area ratio. As a result of simulation, high wall shear stress is appeared at the bifurcated region. As increasing bifurcation angle, pressure drop is increasing. In addition, as the area is decreasing, pressure drop and wall shear stress is increasing.

• Journal of computational fluids engineering
• /
• v.13 no.3
• /
• pp.44-50
• /
• 2008

The present study is carried out in order to investigate the effect of the periodic acceleration in the stenosed and bifurcated blood vessels. The blood flow and wall shear stress are changed under body movement or acceleration variation. Numerical studies are performed for various periodic acceleration phase angles, bifurcation angles and section area ratios of inlet and outlet. It is found that blood flow and wall shear stress are changed about ${\pm}20%$ and ${\pm}24%$ as acceleration phase angle variation with the same periodic frequency. also wall shear stress and blood flow rate are decreased as bifurcation angle increased.

• Korean Journal of Veterinary Research
• /
• v.19 no.1
• /
• pp.1-8
• /
• 1979

Detailed human gross anatomic structures have been characterized. No similar data are available in nonhuman primate species in spite of close phylogenic similarity found between man and nonhuman primates. The ever increasing incidence of lung cancer and air pollution related respiratory ailments found in man emphasizes the need for an ideal animal model for studying pathogenesis of these various human pulmonary diseases. Thus, detailed investigation of pulmonary structures found in various species of nonhuman primates is warranted. For determining primate gross pulmonary anatomic structure, published works concerning the number of tracheal cartilage, angle of tracheal bifurcation, caliber of trachea, lung lobe and bifurcation position of trachea recorded for several species of nonhuman pimates, were reviewed. Limited information is available concerning the number of tracheal cartilage, width of tracheal cartilage, angle of bronchus, caliber of trachea and bronchus, and the bifurcation position of the trachea including the length of bronchus on nonhuman primates. Since scanty data have been gathered with no specific reference to their age, sex and body weight, they have no comparative values.

• 정보저장시스템학회:학술대회논문집
• /
• 2005.10a
• /
• pp.177-178
• /
• 2005

The load/unload behavior of the hard disk drive slider is studied in terms of the air bearing static characteristics. The numerical continuation methods are applied to calculate suspension force - equilibrium position curve. The critical preloads of the femto size slider are analyzed. The hi-stability conditions are depicted on the skew angle - preload diagram. The perturbation method is used to check the stability of the solution branches.