• 한국전기전자재료학회논문지
• /
• 제13권3호
• /
• pp.241-246
• /
• 2000

We fabricated Bi-2223 multi-filaments superconductor tape and evaluated the effect of twisting on the microstructural evolution and critical current. Twist pitches of the tapes are in the range of 70- 8mm and uniformly deformed. It was observed that grain size and the degree of texture decreased as decreasing pitch probably due to the formation of the irregular interface between Ag and filaments. In addition critical current of the tapes decreased to 6.5 A with decreasing pitch to 8mm, showing 48% of degradation compared to the untwisted tapes decreased to 6.5 A with decreasing pitch to 8mm, showing 48% of degradation compared to the untwisted tape(12.5 A). These reduction of critical current may be related to the interface irregularity smaller grain size worse texture and the presence of cracks due to the induced strain during twisting processing.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2002년도 춘계학술대회 논문집 초전도 자성체
• /
• pp.59-63
• /
• 2002

The purpose of this paper is to investigate the crystal texture of the 2223 phase and its relationship with PIT processing parameter. Ag-sheathed Bi-2223 multi-filament tapes were prepared by changing rolling reduction ratio. We analysed the degree of texture for 2223 phase after heat-treatment. According to X-ray pole-figure, the texture of the filaments located near surface and center were not so different each other for all rolling conditions. we found a little higher degree of texture for 60% rolling reduction. But its difference is not so high compared with those tapes with a lower rolling reduction ratio. Reaction induced texturing seemed to contribute with a large portion under present condition.

• 전기학회논문지
• /
• 제56권6호
• /
• pp.1035-1038
• /
• 2007

We designed and manufactured a 1.8T high temperature superconducting(HTS) insert coil for a NMR magnet operated at 4.2 K. Suitable HTS superconductor and HTS coil were carefully designed and developed. We have selected multi-filamentary Bi2223 conductor fabricated by American Superconductor Corporation(AMSC). The selected conductor consists of Bi2223 filaments of 55, silver stabilizer and stainless steel reinforcement tapes. Therefore, it shows good hoop strength as well as compression tolerance. The conductor has a tape cross-section of 0.31mm x 4.8mm. the Bi2223 conductor shows large anisotropy of critical current. The critical current of conductor in magnetic field parallel to the flat surface are much higher than that in magnetic field perpendicular. The HTS coil has an inner diameter of 78 mm, an outer diameter of 127 mm and a coil length of 600 mm. In this paper, the detailed design, fabrication and test results on the HTS insert coil are presented.

• 대한전기학회논문지:전기물성ㆍ응용부문C
• /
• 제49권11호
• /
• pp.589-595
• /
• 2000

In this papre, AC losses of Bi-2223 tapes with different twist pitch of superconducting core were fabricated, measured and analyzed. These samples produced by a powder-in-tube method are multi-filamentary tape with Ag matrix. Also, it's produced by non-twist and different twist pitch(8, 10, 13, 30, 50, 70 mn). The critical current measurement was carried out under the environment in Liquid nitrogen and in zero field by 4-probe method. And the AC loss measurement was carried out under the environment of applied time-varying transport current by transport method. From experiment, the critical current is larger non-twist than twisted filament. And, the AC loss by Norris equation is higher non-twisted tape than 13mm twisted tape. Also, it is confirmed that of AC loss of tape having non-twist pitch larger than those having differnet twist pitch.

• 한국세라믹학회지
• /
• 제35권2호
• /
• pp.137-144
• /
• 1998

고온초전도체 61심 Bi-2223 선재간의 초전도 접합부위를 화학적 부식 및 열적· 기계적 반복 공정에 의하여 제조하였다. 초전도 선재 테이프의 은 피복재 한쪽 표면을 초전도체와 반응하지 않는 부식액(NH4OH:H2O2=1:1)으로 화학적으로 제거한 다음, 두 시편을 일출가압 성형하여 접합시편을 제조하였고 일련의 서로 다른 열적· 기계적 처리를 거쳐 접합부의 물성 및 미세구조를 분석하였다. 접합부를 따라 임계전류(Ic) 변화와 전류전압 곡선의 특성을 측정하기 위하여 여러 단자를 접합부 주위에 설치하여 부위별 I~V 특성을 측정한 결과 단심선재에 비하여 다심선재에서 선재 전체의 통전 능력을 좌우하는 천이구간의 임계전류값이 높았다. 그러나 단심에 비해 다심선재는 천이급속도를 나타내는 n값이 다심선재내 각각의 초전도 core들의 상호작용에 의하여 낮은 값을 나타내었다. 접합부의 임계전류 통전성은 반복적인 가압성형 공정과 서냉반응 열처리 공정에 의하여 향상되었다.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 1993년도 추계학술대회 논문집
• /
• pp.43-46
• /
• 1993

Superconducting cable (Ic: 60 A at 77K. 10 filaments) with Bi high-Tc superconducting system was developed by powder - in - tube method. Pressing and sintering process of the cables were repeated for growth of 2223 high-Tc superconducting phase. The cable can be fabricate by twist method that is nessary for high current density and cooled circulative system. This cab1e system can be used for commercial.

• 한국초전도저온공학회:학술대회논문집
• /
• 한국초전도저온공학회 2003년도 학술대회 논문집
• /
• pp.120-122
• /
• 2003

We jointed Bi(Pb)-Sr-Ca-Cu-O multifilament tapes and evaluated their electrical properties. In order to improve connectivity of multifilarnents, single-filament tape was inserted between two multifilament tapes or multifilament was stepped by mechanical remove. The critical current ratio (CCR) and n-value of the jointed tapes were evaluated as a function of uniaxial pressure. It was observed that CCR and n-value were 24.8-29.0% and 2.5-2.8 for lap-jointed tape. On the other hand, the corresponding values were improved to 51.8-61.9% and 2.9-5.1 for three stepped jointed tape, and 63.4-67.9% and 3.4-4.2 for double MSM lap-jointed tape, respectively. These improvements are to be due to better interconnection between filaments of two tapes.