• Journal of Soil and Groundwater Environment
• /
• v.21 no.1
• /
• pp.49-60
• /
• 2016

Distribution and behavior of baseline soil CO₂ were investigated in a candidate geologic CO₂ storage site in Pohang, with measuring CO₂ concentrations and carbon isotopes in the vadose zone as well as CO₂ fluxes and concentrations through ground surface. This investigation aimed to assess the baseline CO₂ levels and to build the CO₂ monitoring system before injecting CO₂. The gas in the vadose zone was collected using a peristaltic pump from the depth of 60 cm below ground surface, and stored at gas bags. Then the gas components (CO₂, O₂, N₂, CH₄) and δ¹³C_CO2 were analyzed using GC and CRDS (cavity ringdown spectroscopy) respectively in laboratory. CO₂ fluxes and CO₂ concentrations through ground surface were measured using Li-COR in field. In result, the median of the CO₂ concentrations in the vadose zone was about 3,000 ppm, and the δ¹³C_CO2 were in the wide range between −36.9‰ and −10.6‰. The results imply that the fate of CO₂ in the vadose zone was affected by soil property and vegetations. CO₂ in sandy or loamy soils originated from the respiration of microorganisms and the decomposition of C₃ plants. In gravel areas, the CO₂ concentrations decreased while the δ¹³C_CO2 increased because of the mixing with the atmospheric gas. In addition, the relation between O₂ and CO₂, N₂, and the relation between N₂/O₂ and CO₂ implied that the gases in the vadose zone dissolved in the infiltrating precipitation or the soil moisture. The median CO₂ flux through ground surface was 2.9 g/m²/d which is lower than the reported soil CO₂ fluxes in areas with temperate climates. CO₂ fluxes measured in sandy and loamy soil areas were higher (median 5.2 g/m²/d) than those in gravel areas (2.6 g/m²/d). The relationships between CO₂ fluxes and concentrations suggested that the transport of CO₂ from the vadose zone to ground surface was dominated by diffusion in the study area. In gravel areas, the mixing with atmospheric gases was significant. Based on this study result, a soil monitoring procedure has been established for a candidate geologic CO₂ storage site. Also, this study result provides ideas for innovating soil monitoring technologies.

• Korean Chemical Engineering Research
• /
• v.60 no.1
• /
• pp.86-92
• /
• 2022

Recently, the bio-healthcare market is enlarging worldwide due to various reasons such as the COVID-19 pandemic. Among them, biometric measurement and analysis technology are expected to bring about future technological innovation and socio-economic ripple effect. Existing systems require a large-capacity battery to drive signal processing, wireless transmission part, and an operating system in the process. However, due to the limitation of the battery capacity, it causes a spatio-temporal limitation on the use of the device. This limitation can act as a cause for the disconnection of data required for the user's health care monitoring, so it is one of the major obstacles of the health care device. In this study, we report the concept of a standalone healthcare monitoring module, which is based on both triboelectric effects and electromagnetic effects, by converting biomechanical energy into suitable electric energy. The proposed system can be operated independently without an external power source. In particular, the wireless foot pressure measurement monitoring system, which is rationally designed triboelectric sensor (TES), can recognize the user's walking habits through foot pressure measurement. By applying the triboelectric effects to the contact-separation behavior that occurs during walking, an effective foot pressure sensor was made, the performance of the sensor was verified through an electrical output signal according to the pressure, and its dynamic behavior is measured through a signal processing circuit using a capacitor. In addition, the biomechanical energy dissipated during walking is harvested as electrical energy by using the electromagnetic induction effect to be used as a power source for wireless transmission and signal processing. Therefore, the proposed system has a great potential to reduce the inconvenience of charging caused by limited battery capacity and to overcome the problem of data disconnection.

• Journal of Nutrition and Health
• /
• v.48 no.5
• /
• pp.407-418
• /
• 2015

Purpose: Given that the indicators related to chronic diseases are important to evaluating goals of the national health policy, the aim of this study was to develop dietary behavior items available in the Korea National Health and Nutrition Examination Survey. Methods: The dietary behavior items were developed based on the literature reviews, need assessment of the field, expert focus-group interviews, and expert advisory meeting. Questions for each dietary behavior item were developed by reflecting on environmental, personal, and behavior factors of the ecological frame and then revised through expert focus-group interview and expert advisory meeting. The understanding and reliability of the developed questionnaire were assessed by cognitive interview and test-retest reliability. Results: The developed items were sodium and salt intake, added and simple sugar intake, enough time to consume a meal for all ages, caffeine drinks and fresh/healthy food intake for children and adolescents, and limited dietary intake, fresh/healthy food intake for seniors. In most questions except some questions on sodium and salt intake, subjects understood over 70% and consistency of responses based on the kappa values was acceptable. Conclusion: Developed dietary behavior items are expected to be useful for evidence-based nutrition policy, interventions and research targeting dietary patterns through investigating and monitoring dietary behavior patterns.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.11 no.5
• /
• pp.531-538
• /
• 2016

Driving behaviors such as speeding and illegal u-turn which violate traffic rules are main causes of car accidents, and they can lead to serious accidents. Bus drivers are less aware of dangers of illegal u-turn, and infrastructures such as traffic enforcement equipment and watchmen are deficient. This research aims to develop technology for estimating driving behaviors based on map-matching in order to prevent illegal u-turns. For this research, 23,782 of u-turn permit data and 146,000 of speed limit data are collected nationwide, and an estimation algorithm is built with these data. Then, an application based on android is developed, and finally, tests are conducted to assess the accuracy in data computations and GPS data map-matching, and to extrapolate driving behavior. As a result of the tests, the accuracy results in the map-matching is 86% and the assessment of driving behavior is 83%, while the display of the data output yielded 100% accuracy. Additional research should focus on improvement in accuracy through the development of a robust monitoring system, and study of service scenarios for technology application.

• Science of Emotion and Sensibility
• /
• v.10 no.3
• /
• pp.373-381
• /
• 2007

The purpose of this study was to extract important problem features for care of senile dementia patients. Selected cognitive ability test (Korean Mini-Mental State Examination: K-MMSE) and survey of basic & problem characteristics were conducted on 110 hospitalized senile dementia patients and 30 normal subjects. Problem features of senile dementia patients were extracted using factor analysis. The frequency difference of problem features due to the gender and dementia severities was verified using one-way ANOVA. Twenty problem features were extracted by the factor analysis. According to the gender, there are significant differences in the frequency of problem features in violent language & confabulation, collecting behavior, and repetitive behavior. According to the dementia severities, there are significant differences in the frequency of all problem features except abnormal sexual behavior and audio-visual disorder. The result of this study is expected to be used for the development of the senile dementia patients' life-care monitoring system.

• Korean Journal of Agricultural Science
• /
• v.25 no.2
• /
• pp.260-270
• /
• 1998

The field tests were performed to suggest the rational method for stability evaluation of soft clay. The behavior of settlement-displacement obtained by field monitoring system was to compare and analyze the results of the observationed method, and to investigate the complex behavior of soft clay with filling height. The results of this study are summarized as follows. 1. The horizontal displacement was suddenly increased when physical properties of soft clay showed maximum values and the part of the turning point. The values of these properties were available to the fundamental data for stability evaluation. The shear deformation appeared that difference of the horizontal displacement was maximum values. 2. Although the stability of embankment by step filling showed the unstable part over the failure standard line, the embankment was confirmed stable. So the evaluation of the stability of embankment is reasonable to use the inclination of curve than failure standard line. 3. The horizontal displacement and relative settlement were increased as same ratio at improvement ground. Estimation of shear deformation using Terzaghi's modified bearing capacity should consider the relations of embankment load and undrained shear strength at nonimprovement ground, and minimum safety factor is recommended to use larger than 1.2. 4. Excess pore water pressure was increased with increasing of filling height and decreased with maintain the filling height. The embankment was unstable when filling height was exceed the evaluation standard line, and the behavior of excess pore water pressure and horizontal displacement could use as a standard of judgement of the filling velocity control because their behavior were agree with each other.

• Journal of Intelligence and Information Systems
• /
• v.9 no.3
• /
• pp.23-47
• /
• 2003

Traditional studies for customer relationship management (CRM) generally focus on static CRM in a specific time frame. The static CRM and customer behavior knowledge derived could help marketers to redirect marketing resources fur profit gain at that given point in time. However, as time goes, the static knowledge becomes obsolete. Therefore, application of CRM to an online retailer should be done dynamically in time. Customer-based analysis should observe the past purchase behavior of customers to understand their current and likely future purchase patterns in consumer markets, and to divide a market into distinct subsets of customers, any of which may conceivably be selected as a market target to be reached with a distinct marketing mix. Though the concept of buying-behavior-based CRM was advanced several decades ago, virtually little application of the dynamic CRM has been reported to date. In this paper, we propose a dynamic CRM model utilizing data mining and a Monitoring Agent System (MAS) to extract longitudinal knowledge from the customer data and to analyze customer behavior patterns over time for the Internet retailer. The proposed model includes an extensive analysis about a customer career path that observes behaviors of segment shifts of each customer: prediction of customer careers, identification of dominant career paths that most customers show and their managerial implications, and about the evolution of customer segments over time. furthermore, we show that dynamic CRM could be useful for solving several managerial problems which any retailers may face.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.10 no.3
• /
• pp.165-175
• /
• 2006

To analyze the deformation and failure of slopes, generally, two types of model, Polynomial model and Growth model, are applied. These two models are focused on the behavior of the slope by time. Therefore, this research is more focused on predicting of slope failure than analyzing the slope behavior by time. Generally, Growth model is used to analyze the soil slope, to the contrary, Polynomial model is used for rock slope. However, 3-degree polynomial($y=ax^3+bx^2+cx+d$) is suggested to combine two models in this research. The main trait of this model is having an asymptote. The fields to adopt this model are Gosujae Danyang(soil slope) and Youngduk slope(rock slope), which are the cut-slope near national road. Data from Gosujae are shown the failure traits of soil slope, to the contrary, those of Youngduk slope are shown the traits of rock slope. From the real-time monitoring data of the slope, 3-degree polynomial is proved as excellent system to analyze the failure and behavior of slope. In case of Polynomial model, even if the order of polynomials is increased, the $R^2$ value and shape of the curve-fitted graph is almost the same.

• Journal of the Korea Society of Computer and Information
• /
• v.24 no.10
• /
• pp.149-157
• /
• 2019

Recent research has been actively carried out on systems that want to optimize resource utilization by analyzing the intended behavior and pattern of behavior of objects (users, consumers). A service system that applies information about an object's location or behavior must include a location trigger processing system for tracking an object's real-time location. In this paper, we analyze design problems for the implementation of a context-awareness based location trigger system, and present system models based on analysis details. For this purpose, this paper introduces the concept of location trigger for intelligent location tracking techniques about moving situations of objects, and suggests a mobile agent system with active rules that can perform monitoring and appropriate actions based on sensing information and location context information, and uses them to design and implement the location trigger system for context-awareness based location services. The proposed system is verified by implementing location trigger processing scenarios and trigger service and action service protocols. In addition, through experiments on mobile agents with active rules, it is suggested that the proposed system can optimize the role and function of the application system by using rules appropriate to the service characteristics and that it is scalable and effective for location-based service systems. This paper is a preliminary study for the establishment of an optimization system for utilizing resources (equipment, power, manpower, etc.) through the active characteristics of systems such as real-time remote autonomous control and exception handling over consumption patterns and behavior changes of power users. The proposed system can be used in system configurations that induce optimization of resource utilization through intelligent warning and action based on location of objects, and can be effectively applied to the development of various location service systems.

• Tunnel and Underground Space
• /
• v.31 no.6
• /
• pp.610-622
• /
• 2021

The DECOVALEX project is one of the representative international cooperative projects to enhance the understanding of the complex Thermo-Hydro-Mechanical-Chemical(THMC) coupled behavior in the high-level radioactive waste disposal system based on the numerical simulation. DECOVALEX-2023 is the current phase consisting of 7 tasks, and Task C aims to model the THM coupled behavior in the disposal system based on the Full-scale Emplacement (FE) experiment at the Mont-Terri underground rock laboratory. This study performs the numerical simulation based on the OGS-FLAC developed for the current study. In the numerical model, we emplaced the heater with constant power horizontally based on the FE experiment and monitored the pressure development, temperature increase, and mechanical deformation at the specific monitoring points. We monitored the capillary pressure as the primary effect inducing the flow in the buffer system, and thermal stress and pressurization were dominant in the surrounding rocks' area. The results will also be compared and validated with the other participating groups and the experimental data further.