• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 2008년도 추계 학술발표회
• /
• pp.407-426
• /
• 2008

The bentonite slurry has been used as the stabilize suspension for wet process bored pile construction in Thailand. The bentonite suspension has benefit on filtration in the sand layer, but it creates thick cake film along pile shaft and loose sedimentation at pile toe. The base grouting technique was widely used to rectify the soft base or loose sedimentation problem of bored pile. The base grouting technique was not increased only end bearing capacity, but was also more increase in skin friction capacity of the bored piles. The comprehensive researches on base grouting was carried out by installing PVC casing inside the shaft to allow the drilling through the pile base in order to collect the soil sample below the pile tip. The polymer based slurry recently was used to replace the bentonite slurry to overcome the thick cake film along pile shaft as well as loose sedimentation at pile toe. The extent research on polymer slurry by physical model was performed to verify the real behavior of polymer. The appropriate mixing ratio of polymer was proposed. The design skin friction coefficient, $\beta$ and end bearing coefficient, Nq, for sand layer base on fully instrumented tested pile were proposed. The application on remedial of the lose capacity bored pile with large displacement in Bangladesh was proposed and discussed.

• 한국토양환경학회지
• /
• 제3권3호
• /
• pp.3-10
• /
• 1998

토양의 산/염기 완충능은 토양-오염물질-공극수로 이루어진 시스템의 pH에 직접적인 영향을 미치므로 오염물질의 토양내 거동예측시에 많은 영향을 미치는 매우 중요한 토양의 성질이다. 본 연구는 이중확산층이론과 two layer electrostatic 흡착모델을 응용하여 토양의 산/염기 완충능의 이론모델을 유도하고 이 모델의 적용절차를 제시하였다. 산-염기 적정실험을 통하여 두 종류의 카올리나이트의 완충능을 실측하고 이를 본 연구에서 개발된 모델의 예측치와 비교하였다.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2002년도 하계학술대회 논문집
• /
• pp.318-321
• /
• 2002

This paper presents a proper condition to achieve high conversion efficiency using PC1D simulator on sri-crystalline Si solar cells. Various efficiency influencing parameters such as rear surface recombination velocity and minority carrier diffusion length in the base region, front surface recombination velocity, junction depth and doping concentration in the Emitter layer, BSF thickness and doping concentration were investigated. Optimized cell parameters were given as rear surface recombination of 1000 cm/s, minority carrier diffusion length in the base region 200 $\mu\textrm{m}$, front surface recombination velocity 100 cm/s, sheet resistivity of emitter layer 100 Ω/$\square$, BSF thickness 5 $\mu\textrm{m}$, doping concentration 5${\times}$10$\^$19/ cm$\^$-3/. Among the investigated variables, we learn that a diffusion length of base layer acts as a key factor to achieve conversion efficiency higher than 19 %.

• 한국진공학회:학술대회논문집
• /
• 한국진공학회 2014년도 제46회 동계 정기학술대회 초록집
• /
• pp.449.1-449.1
• /
• 2014

GaAs태양전지는 일반적으로 22%이상의 변환효율을 가지는 차세대 태양전지이다. GaAs태양전지의 변환효율은 태양광이 조사되었을 때, p-type emitter와 n-type base의 p-n접합으로 생기는 Voc, Isc, FF 인자들로 인하여 그 값이 결정되는데, 이때 각 layer의 물리적 parameter에 의해 그 효율이 변한다. 일반적으로는 각 parameter가 증가할 때, 더욱 많은 전자로 인하여, 저 높은 변환효율을 기대할 수 있겠으나, 전자의 재결합이나 mobility의 감소와 같은 이유로 변환효율은 감소 될 수 있다. GaAs태양전지의 base layer의 두께와 도핑농도를 simulation한 결과 두께 $2.6{\mu}m$, 도핑농도 $7{\times}E17cm^{-3}$와 두께 $2.7{\mu}m$, 도핑농도 $8{\times}E17cm^{-3}$에서 25.86%의 가장 높은 에너지 효율을 가짐을 확인 할 수 있었다.

• 한국농공학회:학술대회논문집
• /
• 한국농공학회 2003년도 학술발표논문집
• /
• pp.219-222
• /
• 2003

Bech scale tests were performed to evaluate the adaptability of industrial wastes, especially bottom ash, salg and phosphogypsum among others, for constructing the surface layer of a landfill or reclamation, which function is a vegetation base layer. In the test, columes test were used to check the extraction characteristics of wastes and small PVC soil-box that equipped the drainage device was used to model a performance of layers and to monitor the growth of plants at the composite layer of those. Tests have been continued during one and half year and It has been verified that bottom ash and phosphogypsum look like as a valuable material to safely reuse as the vegetation base layer even though some unconfined factors are remain.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• 제10권4호
• /
• pp.1846-1863
• /
• 2016

High dynamic range (HDR) images can present the perfect real scene and rich color information. A commonly encountered problem in practical applications is how to well visualize HDR images on standard display devices. In this paper, we propose a multi-scale decomposition method using guided filtering for HDR image tone mapping. In our algorithm, HDR images are directly decomposed into three layers：base layer, coarse scale detail layer and fine detail layer. We propose an effective function to compress the base layer and the coarse scale detail layer. An adaptive function is also proposed for detail adjustment. Experimental results show that the proposed algorithm effectively accomplishes dynamic range compression and maintains good global contrast as well as local contrast. It also presents more image details and keeps high color saturation.

• 한국표면공학회지
• /
• 제22권1호
• /
• pp.26-42
• /
• 1989

It has between investigated that the optimum spaying conditions, such as, spraying distance, fusing temperature and fusing time, ect, in a Ni-cr base self fluxing alloy sprayed on the mild steel substrate by oxygen-acetylenc flame spraying. Sprayed specimens on various conditions were fuused in a vacuum furnace and the results were as follows. The optimum spraying condition for excellent coating layer are obtained under spraying distances, fusing temperature and fusing and time ; 180~240mm,1050~110$0^{\circ}C$and 15~30min, respectively. The adhesive strength and surface hurface hardness of the as sprayed specimens were very low by mechanical bonding becaus of the diffusion layer during process. The carbides and borides and formed in the sprayed coating layer and densification of the layer was resulted from the elimination of pores and oxides. The hardness of sprayed coating layer, particularly in the high temperature, was superior to ordinary tool steels.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• 제12권4호
• /
• pp.1638-1654
• /
• 2018

The heterogeneous network (HetNet) has been one of the key technologies in Long Term Evolution-Advanced (LTE-A) with growing capacity and coverage demands. However, the introduction of femtocells has brought serious co-layer interference and cross-layer interference, which has been a major factor affecting system throughput. It is generally acknowledged that the resource allocation has significant impact on suppressing interference and improving the system performance. In this paper, we propose a hybrid-clustering algorithm based on the $Mat{\acute{e}}rn$ hard-core process (MHP) to restrain two kinds of co-channel interference in the HetNet. As the impracticality of the hexagonal grid model and the homogeneous Poisson point process model whose points distribute completely randomly to establish the system model. The HetNet model based on the MHP is adopted to satisfy the negative correlation distribution of base stations in this paper. Base on the system model, the spectrum sharing problem with restricted spectrum resources is further analyzed. On the basis of location information and the interference relation of base stations, a hybrid clustering method, which takes into accounts the fairness of two types of base stations is firstly proposed. Then, auction mechanism is discussed to achieve the spectrum sharing inside each cluster, avoiding the spectrum resource waste. Through combining the clustering theory and auction mechanism, the proposed novel algorithm can be applied to restrain the cross-layer interference and co-layer interference of HetNet, which has a high density of base stations. Simulation results show that spectral efficiency and system throughput increase to a certain degree.

• 한국건축시공학회:학술대회논문집
• /
• 한국건축시공학회 2004년도 학술.기술논문발표회
• /
• pp.85-90
• /
• 2004

We divided the planting bale into waterproof layer, drainage layer and soil layer so at to investigate changes of live load according to species of wood and composition of the base to make rooftops green. The results are follows, 1. As concerning construction and live load for green roof, sheet waterproofing is superior. 2. When materials of drainage are changed crushed gravel into artificial lightweight graval or ferrite, live load of planting bale is decreased about 22% and 25% in order. 3. When ingredients of soil are chased normal sand into volcanic sand, live load of base is decreased about 28%. Especially, when it is changed into ferrite, 54% of live load is decreased. 4. In this study, all live load we concerned excesses the standard about roof live load of office, school and house. Hence, structure has to be concerned thoroughly when making rooftops green. But, we judge that various methods for making rooftops green can be applied if we consider roof garden when we plan new buildings.

• 한국지진공학회논문집
• /
• 제19권3호
• /
• pp.85-92
• /
• 2015

Response spectra of a building are made with a SDOF system taking into account a first mode shape, even though higher modes may affect on the dynamic responses of a high-rise building. A soft soil layer under a building also affects on the responses of a building. In this study, seismic responses of a MDOF system were investigated to examine the effects of higher modes on the response of a tall building by comparing them with those of a SDOF system including the kinematic interaction effect. Study was performed using a pseudo 3D finite element program with seven bedrock earthquake records downloaded from the PEER database. Effects of higher modes on the seismic responses of a tall building were investigated for base shear force and base moment of a MDOF system including story shear forces and story moments. Study results show that higher modes of a MDOF system contribute to a reduction of base shear force up to 1/4-1/5 of KBC and base moment. The effect of higher modes is more significant on the base shear force than on the base moment. Maximum story shear force and moment occurred at the top part of a building rather than at a base in the cases of tall buildings differently from short buildings, and higher modes of a tall building affected on the base forces making them almost constant at the base. A soft soil layer also affects some on the base shear force of a high-rise building independently on the soft soil type, but a soft soil effect is prominent on the base moment.