• Journal of the Institute of Electronics and Information Engineers
• /
• v.53 no.5
• /
• pp.47-54
• /
• 2016

In the underwater environment, high resolution can be achieved in the range direction by transmitting and receiving a signal of a particular band and/or waveform. The design of a transmit signal used in the active sonar is very important in order to detect a cylindrical object within a short distance less than 1 km, which is the detection distance of this paper. Designing a transmit signal optimal to a sonar requires appropriate selection of its center frequency and bandwidth, which allows the maximum detection distance of a sonar. In this paper, in terms of maximizing echo excess and signal to noise ratio (SNR), optimum frequency analysis is carried out under various conditions of diverse parameters. In addition, the investigation focused on the determinating a bandwidth is also performed for the purpose of satisfying the performance requirement of range resolution and azimuth resolution.

• Journal of Korea Multimedia Society
• /
• v.13 no.1
• /
• pp.102-110
• /
• 2010

H.264 SVC(Scalable Video Coding) provides the advantages of low disk storage requirement and high scalability. However, a streaming server or a user terminal has to extract a bit stream from SVC file. This paper proposes a bit stream extraction method which can get the maximum PSNR value while date bit rate does not exceed the available network bandwidth. To do this, this paper obtains the information about extraction points which can get the maximum PSNR value offline and decides the spatial/temporal resolution of a bit stream at run-time. This resolution information along with available network bandwidth is used as the parameters to a bit stream extractor. Through experiment with JSVM reference software, we proved that proposed bit stream extraction method can get a higher PSNR value.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.34 no.4C
• /
• pp.349-354
• /
• 2009

In this paper, a new motion compensation scheme to reduce external memory access frequency which is one of the major bottlenecks for real-time decoding is proposed. Most H.264/AVC decoders store reference pictures in external memories due to the large size and reference blocks are read into the decoder core as needed during decoding. If the reference data access is done for each reference block in decoding sequence, the memory bandwidth can be unacceptable for real-time decoding. This paper presents a memory access scheme for motion compensation to read as many reference data as possible with reduced memory access frequency by analyzing reference data access pattern for each macroblock. Experimental results show that the proposed motion compensation scheme leads to approximately 30% improvement in memory bandwidth requirement.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.48 no.11
• /
• pp.73-82
• /
• 2011

As a demand of IP based packet service is increasing, transport network is evolving from circuit based transport technology using TDM to Ethernet based packet transport technology. In this paper we introduce packet transport network based on PBB-TE and MPLS-TP and propose a quality of service(QoS) management scheme to satisfy various user requirements in packet transport network. The proposed flow-based QoS management scheme guarantees that per-flow bandwidth control satisfies the predefined QoS requirement perfectly under bandwidth congestion condition by using perflow and per-PTL tunnel management. In order to evaluate the proposed scheme we defined flow and PTL tunnel per input frame and configured QoS parameters for each flow and PTL tunnel respectively. Simulation was done by using OPNET modeler 16.0 version.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.25 no.8B
• /
• pp.1341-1347
• /
• 2000

For the DRT satellite transponder system, BER and total SNR to be required in the earth terminal are evaluated under the condition of HPA nonlinearity in the FBJ(full-band jamming) or PBJ(partial-band jamming) of uplink and downlink. In case that the satellite Inter bandwidth( Ws) is same to the earth terminal bandwidth($W_r$),in conditions of uplink JSR 10[dB], downlink JSR 10[dB] and processing gain 30[dB], linear transponder system shows that uplink SNR needs to be 14.2[dB] to achieve the total SNR 10[dB] requirement in downlink SNR 14[dB]. However, Nonlinear transponder system with OBO(output backoff) 2[dB] requires 20.1 [dB] uplink SNR. From the above results, the nonlinearity of HPA in the satellite transponder causes the degradation of BER performance so that it is of interest to consider the power increase.

• Journal of KIISE:Computing Practices and Letters
• /
• v.8 no.5
• /
• pp.590-597
• /
• 2002

Currently, with the increasing demand for combining cellular phone and PDA, various kinds of PDA-phones are being developed. A typical PDA-phone consists of a CDMA processor and a PDA processor. Generally, a UART serial communication port is used for inter-processor communication. However, the CDMA standard will need more data bandwidth over 2Mbps with the emergence of IMT-2000. The bandwidth requirement is beyond the capability of UART. In this paper, several inter-processor communication mechanisms are analyzed and especially Dual Port Memory and USB were chosen as the candidates for the new communication mechanism. A prototype PDA-phone board has been implemented for experiment. The experimental result shows that Dual Port Memory is better than USB in cost performance.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.26 no.7
• /
• pp.1032-1039
• /
• 2022

In this paper, we designed and implemented a cavity bandpass filter combined with a cross-coupling equalizer structure to enhance Group delay for 5G mobile network repeater, which can replace the SAW (Surface Acoustic Wave) type bandwidth filter used in the existing mobile communication system. Using the 3D EM simulation tool (HFSS), the resonance frequency, the coupling coefficient between resonators, and external quality coefficient between resonators were calculated. Based on this, a 12th bandpass filter was constructed to have attenuation characteristics of more than 20dB at the edge end of both sides of the band with a metal cavity structure with a frequency band of 3500MHz to 3600MHz and bandwidth of 97.85MHz. The designed bandpass filter satisfies the group delay time requirement for the 5G mobile communication standard and the in-band and out-band frequency responses.

• Journal of KIISE:Computing Practices and Letters
• /
• v.14 no.7
• /
• pp.657-668
• /
• 2008

Traditional off-the-shelf file server has several potential drawbacks to store data blocks. A first drawback is a lack of practical de-duplication consideration for storing data blocks, which leads to worse storage capacity waste. Second drawback is the requirement for high performance computer system for processing large data blocks. To address these problems, this paper proposes a clustering backup system that exploits file fingerprinting mechanism for block-level de-duplication. Our approach differs from the traditional file server systems in two ways. First, we avoid the data redundancy by multi-level file fingerprints technology which enables us to use storage capacity efficiently. Second, we applied a cluster technology to I/O subsystem, which effectively reduces data I/O time and network bandwidth usage. Experimental results show that the requirement for storage capacity and the I/O performance is noticeably improved.

• The Journal of the Acoustical Society of Korea
• /
• v.30 no.8
• /
• pp.461-467
• /
• 2011

Accurate classification of input signals is the key prerequisite for variable bit-rate coding, which has been introduced in order to effectively utilize limited communication bandwidth. Especially, recent surge of multimedia services elevate the importance of speech/music classification. Among many speech/music classifier, the ones based on support vector machine (SVM) have a strong selling point, high classification accuracy, but their computational complexity and memory requirement hinder their way into actual implementations. Therefore, techniques that reduce the computational complexity and the memory requirement is inevitable, particularly for embedded systems. We first analyze implementation of an SVM-based classifier on embedded systems in terms of execution time and energy consumption, and then propose two techniques that alleviate the implementation requirements: One is a technique that removes support vectors that have insignificant contribution to the final classification, and the other is to skip processing some of input signals by virtue of strong correlations in speech/music frames. These are post-processing techniques that can work with any other optimization techniques applied during the training phase of SVM. With experiments, we validate the proposed algorithms from the perspectives of classification accuracy, execution time, and energy consumption.

• Journal of Satellite, Information and Communications
• /
• v.10 no.3
• /
• pp.26-31
• /
• 2015

This paper deals with a size-reduced Ku-band waveguide limiter. Basically, it passes the signal from 16.125 GHz through 16.375 GHz, but when excessively high power is injected to the input port, it should change to a bandstop filter. Furthermore, it is required to change to bring attenuation by more than 20 dB and 50 dB over a narrow band and the entire passband, respectively. Therefore, in order to meet this requirement, a limiting device is implemented with multiple PIN-diode posts that enable the limiter to be the bandpass filter and stopband one at the off and on states of the PIN-diode switch, respectively. So, the design goes through the equivalent circuit modelling and the geometry is realized in the accurate electromagnetic analysis CAD tool. Finally, the result is discussed to shed light on whether it complies with the aforementioned requirement.