• Journal of Biomedical Engineering Research
• /
• v.30 no.3
• /
• pp.213-220
• /
• 2009

In this study, we have developed a novel step detection algorithm for gait evaluation of patients with hemiplegia based on trunk accelerometry device. For this, we have used a bandpass filter and a least square acceleration (LSA) filter which is characterized by emphasizing the peak or valley point of the acceleration signals for each 3-axis accelerometer signals. To evaluate the algorithm, the detected steps by developed algorithm and real steps by the motion analysis system were compared. As a result, we could obtain the sensitivity of 96.44%, the specificity of 99.94% and the accuracy of 99.90% for the patients' data sets and the sensitivity of 100%, the specificity of 99.93% and the accuracy of 99.93% for the normal data sets. In conclusion, the developed algorithm is useful for the step detection for patients with hemiplegia as well as normal subjects.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.24 no.10
• /
• pp.964-970
• /
• 2013

This paper presents a bandpass wireless 3-D chip to chip interface technique. The proposed technique uses direct amplitude modulation of the free running oscillator which especially utilizes the coupling capacitance between two stacked chips as a part of the resonator. Therefore, the oscillator is three dimensionally configured and a simple envelope detector can be used as a receiver without any additional matching circuitry. The proposed link was designed and fabricated using 110 nm CMOS technology and experimental results successfully showed the data transmission at a data rate of 2 Gb/s for the stacked chips with a thickness of 50 ${\mu}m$ consuming 4.32 mW. The sizes of the Tx and Rx chips are 0.045 $mm^2$ and 0.029 $mm^2$, respectively.

• Geophysics and Geophysical Exploration
• /
• v.19 no.2
• /
• pp.84-90
• /
• 2016

The validation of performance test for newly developed or old-used sensor is very important in the earthquake monitoring and seismology using earthquake data. Especially the frequency response of the sensor is mainly used to correct the earthquake data. The technique of the calculation of phase and amplitude with Hilbert transformation for earthquake data that is filtered with band limited frequency in time domain is applied to calculate the frequency response of the sensor. This technique was tested for the acceleration sensors, CMG-5T of 1g and 2g installed on the vibration table at the laboratory and we could obtain satisfactory result. Tohoku large earthquake in 2011 observed at the station SNU that has accelerometer, ES-T and seismometer, STS-2 operated by KIGAM was also used to test the field data applicability. We could successfully get the low frequency response of broad band sensor, STS-2. The technique by using band limited frequency filter and Hilbert transformation showed the superior frequency response to the frequency spectrum ratio method for noisy part in data.

• Korean Journal of Optics and Photonics
• /
• v.26 no.1
• /
• pp.30-37
• /
• 2015

The design and implementation of a radiative temperature measurement system for a flash light are carried out. Since a massive amount of energy is emitted within a very short time, it is impossible to measure the temperature of a flash with a conventional method. It is also irrelevant to measure one with an optical noncontact method. In this paper, a radiative temperature measurement system using the ratio of spectral radiances over mid- and long-wavelength infrared (IR) is designed and implemented. The implemented system utilizes optical bandpass filters to divide the wavelengths within the mid- and long-wavelength IR ranges, and pyroelectric IR detectors to measure the incident optical power of each wavelength-divided channel. It is shown that the measured radiative temperature of a flash is in the range of 1393 to 1455 K. This temperature-measurement system can be utilized to obtain information about the spectral radiance of a flash as a light source, which is of crucial importance to approaching the modeling and simulation of the various effects of a flash.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.45 no.6
• /
• pp.8-12
• /
• 2008

A ring resonator based band-pass filter enabling enhanced sideband suppression was proposed and demonstrated. It is composed of a single-ring based band-pass section combined with a band-rejection section based on two different coupled rings. The sideband region of the transfer characteristics of the first band-pass filter section was selectively suppressed by means of the band-rejection section without causing any excessive insertion loss. As a result, the overall transfer characteristics of the proposed filter was unproved so that its sideband suppression was elevated to allow for sharper roll-off and narrower bandwidth. In this work, a conventional single-ring band-pass filter and a proposed filter including the band-rejection section were designed and fabricated. As for the achieved device performance, with the center frequency at about 4 GHz, the sideband suppression ratio was increased as much as 8 dB and the 3-dB bandwidth was reduced from 98 MHz to 48 MHz by about 51% with no remarkable excessive insertion loss as expected. And the quality factor of the device was increased by about 105%.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.21 no.3
• /
• pp.307-314
• /
• 2010

In this paper, a novel ultra-wideband microstrip-to-suspended stripline(SSL) transition is proposed, and SSL filters with low-loss and high selectivity have been realized using this transition. Since the proposed transition has low-loss and wide bandwidth characteristic, the design procedure of SSL filters become simplified. Additionally, the designed filters do not require extra time-consuming tuning. As design examples, SSL low-pass and high-pass filters have been implemented, and a implemented bandpass filter with connection of the low and high-pass filters performs 2.3~10.5 GHz bandwidth with less than 1.2 dB insertion loss and high selectivity.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.21 no.3
• /
• pp.245-252
• /
• 2010

This paper proposes an improved filter synthesis method for dual-band filters based on coupled lines loaded with shunt stubs. The conventional design method relies on equality of the response of the conventional single-band filter and its dual-band counterpart at two frequencies. On the other hand, the proposed method is based on equivalence of the propagation constants and the image impedances of the two filters. Therefore, the proposed method does not suffer from bandwidth reduction phenomena, which requires complex compensating process in the conventional method. Also, the alternative design parameters provided by the demonstrated method enable to construct dual-band filters with more flexibility. For experimental verification, a Chebyshev type dual-band filter with center frequencies at 1 GHz and 3.5 GHz is designed and fabricated. The measured results are in excellent agreement with the full-wave simulated results.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.18 no.4
• /
• pp.468-480
• /
• 1993

In this paper, at first, the characteristics of double mode SAW (DMS) resonator are analysed by applying the wave guide model and coupled mode theory to 1-port resonator. The DMS resonators (2-pole), which are arranged in a close, parallel configuration of two identical 1-port resonators on a single plate, and 4-pole DMS filters are designed and fabricated at the center frequency of 150.15 MHz with 3-dB bandwidth of 80 KHz. The empirical design characteristics are obtained from the comparison of experimental and theoretical values resulted from several fabrications, and the narrow bandpass filters are implemented on the basis of the above empirical results, which can be used to mobile communication systems. A ST-cut quartz substrate is selected for the stable temperature-frequence characteristics, and high resolution photolithography is applied to the fabrication of filter to get the fine electrode patterns.

• The Journal of the Korea Contents Association
• /
• v.17 no.9
• /
• pp.300-309
• /
• 2017

This paper examines the cyclical fluctuation of 'construction orders' and 'construction investment' using HP filter, Bandpass filter and Beveridge-Nelson decomposition methods. The main results are as follows. As a result of the analysis of the cyclical fluctuation of construction orders, it was analyzed that there were about 7 cyclical fluctuations from 1976 to the first quarter of 2017. Construction orders for cyclical fluctuations peaked in the second quarter of 2015 and turned to a downward trend. On the other hand, construction investment has experienced about 6 cycles of fluctuations during the same period, and it has been rising continuously since the bottom of 3Q12. This is consistent with the general theory that construction orders precede construction investments. In addition, the comparison of the construction orders, construction investment, and GDP amplitude shows that the GDP amplitude is the smallest and stable, and the construction orders have the greatest variation in amplitude. Therefore, construction orders should be adjusted by government policy depending on economic fluctuations.

• Journal of the Institute of Convergence Signal Processing
• /
• v.10 no.4
• /
• pp.214-219
• /
• 2009

This paper proposes a watermarking algorithm considering the frequency characteristics of Haegeum sounds for copyright protection of digital Haegeum sound contents. The harmonics of Haegeum sounds commonly have large magnitude values in 1500Hz~2000Hz and 2800Hz~3500Hz so that those bands are selected to embed a watermark. The proposed method computes the FFT (fast Fourier transform) of the original sound signal and embeds the watermark bits generated by PN (pseudo noise) sequence into the harmonics in the selected bands. Furthermore, the proposed method is robust to lowpass filter, bandpass filter, cropping, noise addition, MP3 compression attacks and the maximum BER (bit error rate) is 1.41% after lowpass filter attack. To measure the quality of the watermarked sound, subjective listening test, MUSHRA (multiple stimuli with hidden reference and anchor), was conducted. The mean value of MUSHRA listening test is bigger than 98 and 96.67 for every Haegeum sounds and Korean classical music with Haeguem, respectively.