• Korean Chemical Engineering Research
• /
• v.50 no.1
• /
• pp.177-181
• /
• 2012

Dye-sensitized solar cells(DSSCs) based on $TiO_2$ film photo anode incorporated with different amount of grapheme nanosheet(GNS) are fabricated and their photovoltaic performance are investigated. The $TiO_2$-GNS composite electrode has been prepared by a direct mixing method. The DSSC performance of this composite electrode was measured using N3 dye as a sensitizer. The performance of DSSCs using the $TiO_2$-GNS composite electrodes is dependent on the GNS loading in the electrodes. The results show that the DSSCs incorporating 0.01 wt% GNS in $TiO_2$photo anode demonstrates a maximum power conversion efficiency of 5.73%, 26% higher than that without GNS. The performance improvement is ascribed to increased N3 dye adsorption, the reduction of electron recombination and back transport reaction as well as enhancement of electron transport with the introduction of GNS. The presence of both $TiO_2$(anatase) and GNS has been confirmed by FieldEmission Scanning Electron Microscopy(FE-SEM). The decrease in recombination due to GNS in DSSCs has been investigated by the Electrochemical Impedance Spectroscopy.

• Korean Journal of Food Science and Technology
• /
• v.30 no.4
• /
• pp.832-841
• /
• 1998

In order to economically utilize flour brew with Bifidobacterium bifidum as a bread improver, the effect of flour brew on the rheological properties of dough, growth curve and acid production, and symbiosis with yeast were investigated. Growth of bifidobacteria was not increased more than initial seed volume but was consistent during 24 hours of incubation. pH was decreased and T.T.A was increased up to 12 hours of incubation. Symbiosis between bifidobacteria and yeast was little. Bifidobacteria produced more lactic acid than acetic acid in flour brew and the opposite in skim milk broth. This result was inferred from Lactobacillus sp. inherent in flour. On rheological properties of dough, farinograms of flour showed progressively decreasing baking absorption, mixing time and stability as the amount of flour brew increased. The validation of extensograms showed that R/E ratio linearly increased with increment of flour brew, and nearly doubled in all treatments comparing to that of control, which suggest the reduction of actual fermentation time. On visco/amylograms, malt index increased with addition of flour brew, accordingly showing the decrease in viscosity. Break down and set back value decreased with increment of flour brew, suggesting that staling rate of bread can be delayed.

• Asian-Australasian Journal of Animal Sciences
• /
• v.10 no.2
• /
• pp.164-169
• /
• 1997

The present experiment was conducted to evaluate the effects of feed processing and feeding methods on growth performance and carcass characteristics of growing-finishing pigs. A total of 72 pigs (LYD, 22.24 kg BW) were employed for a 90-d feeding trial. Treatments were 1) mash dry feeding (MD), 2) mash wet feeding (MW), 3) pellet dry feeding (PD), and 4) extruded pellet dry feeding (EPD). Corn, soybean meal and wheat bran in the basal diets were extruded before mixing and pelleting for EPD diet production. Ileal or fecal digestibility and carcass traits including lean meat percentage and weights of stomach ulcer were also examined. During the growing period, pigs fed PD showed improved (p < 0.05) average daily gain (ADG) and feed conversion (F/G) over those fed MD, whereas no significant differences in average daily feed intake (ADFI) were found among dietary treatments. Finisher pigs fed MD showed lover, but not significant, ADG and F/G than those fed MW, PD or EPD. For the overall period, pigs fed PD grew faster (p < 0.05) than those fed MD or EPD. Feed intake was different between the two feeding methods (MD vs MW), and between the two processed feeds (PD vs EPD). The digestibility of crude fat was higher (p < 0.05) in pigs fed EPD than in pigs fed mash feeds. NFE digestibility of EPD treatment was also higher (p < 0.05) than that of PD. Back fat (10th rib area) was thicker (p < 0.05) tn pigs fed MD than in pigs fed EPD. other carcass traits including incidence of esophagogastric ulcers were not different among treatments. In conclusion, pelleting appeared to bo the desirable processing methods and wet feeding could also be recommended for growing-finishing pigs.

• Journal of Korean Society of Transportation
• /
• v.17 no.4
• /
• pp.111-124
• /
• 1999

The Purpose of this thesis is to develop a vehicle classification algorithm using single Magnetometer detector during presence time of vehicle detection and is to examine a held application from field test. We collected data using Magnetometer detector on freeway and used digital data to change voltage values according to magnetic flux density in analysis. We collected these datum during the presence time and then obtained characteristics from wave form in these datum. Based on these characteristics, We used the following three methods for this a1gorithm :1. Template Matching Method,2. Neural Network Method using Back-propagation Algorithm 3. Complex Method using changed slope points and mixing method 1, 2. Of course, Before processing of over three methods, These data were processed normalizing by 20, 40 of size in only X axis and moving average by 0, 3, 4, 5 of size. Vehicle classification were Processed in three steps ; 2, 3, 5 types classification. In 2 types vehicle classification, recognition rate is 83% by template matching method.

• Journal of Korea Technical Association of The Pulp and Paper Industry
• /
• v.42 no.1
• /
• pp.41-47
• /
• 2010

Increasing ash content of the paper is one of the most effective methods for saving raw materials and steam consumption and improving optical properties and better print quality. However, the increase of filler loading or filler content using a conventional wet end system is limited due to severe loss in strength properties, affecting runnability and product quality. This is because the filler has no ability to make bonding with cellulosic fibers. Therefore, if the technology to give filler the bonding ability is developed, the ash content of the paper can be increased more than ever. This study was carried out to modify PCC by coating its surface with starch contributing to better bonding with fibers. To prepare the modified PCC, cationic starch was selected as a polymer and then pretreatment was done by mixing PCC and cationic starch. Consequently, the pretreated PCC contributed to higher tensile strength, stiffness and opacity than the conventional filler, such as GCC and untreated PCC. However, CIE whiteness and ISO brightness decreased slightly compared to conventional fillers.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.44 no.3
• /
• pp.225-229
• /
• 1999

Unstable seedling stand establishment of wet direct seeding culture of rice is one of the major elements preventing the extension of its culture area. In order to develop methods of seedling stand improvement in direct seeded rice on flooded surfaces, three field experiments were conducted on silty loam soil using a cultivar 'Donjinbyeo' for three years, mainly focusing on water management after seeding and seed soaking with plant growth regulators (PGRs). Under the condition of shallow flooding after seeding, seedling stand rate increased and floating seedling rate decreased in both early and normal season seeding compared to deep flooding. With earlier draining time after seeding, there was a tendency towards preferential growth of the seminal root, increase of seedling stand and decrease of the floating seedling rate. Therefore the highest seedling numbers per unit area and the lowest floating seedling numbers were found upon drainage at 1 day after seeding (DAS), while a contrary tendency was shown upon conventional drainage at 7 DAS. Seed soaking with PGRs such as Metalaxyl or mixing of Metalaxyl with gibberellic acid (GA$_3$) significantly increased the seedling stand. In addition the effects of PGR treatment on seedling stand and the early growth of plants were greater under flooded conditions than under drained conditions after seeding, although draining of water after seeding improved the seedling establishment rate more when compared with the PGR treatment. These results suggest that draining management after seeding or maintaining of shallow flooding for a week is the most effective method to improve the seedling stand rate in wet direct seeding.

• Proceedings of the Korean Radioactive Waste Society Conference
• /
• 2004.02a
• /
• pp.245-256
• /
• 2004

The extraction of three kinds of amido podands, N,N,N'N'-tetrabutyl-3-oxa-pentanedi- amide (TBDGA), N,N,N'N'-tetra-isobutyl-3-oxa-pentanediamide(TiBDGA) and N,N,N'N'-tetra- butyl-3,6-dioxa-oct-anediam- ide(TBDOODA) on U(VI),Pu(IV), Am(III), Eu(III) and other metal ions is studied in nitric acid solutions. 40%octanol-kerosene is chosen as diluents to eliminate third phase and emulsion. TBDGA and TiBDGA show extraction selectivity to An(III) and Ln(III) much higher than to U(VI) and Pu(IV). Fe, Ru and Mo is poorly extracted by the three kinds of amid podands in 2~3mol/L $HNO_3$ solutions. Aiming to eliminate interface crude when using simulated HLLW solution in the system of 0.2mol/L TBDGA/Octanol＋kerosene, acetohydroxyamic acid was adapted. Distribution ratio of zirconium was decreased when adding acetohydroxyamic acid in aqueous solution, and interface crude disappeared as mixing extractant with HLLW. The counter-current extraction test is carried out in a set of miniature mixer-settler, with 0.2mol/L TBDGA/ 40% octanol-kerosene as extractant to separate U(VI), Pu(IV), Am(III) and Eu(III) from simulated high level liquid waste(HLLW) solution. In battery A, lanthanides and actinides are coextracted into organic phase with the recovery of 99.98% for U(Ⅵ), >99.99% for Pu(IV), and >99.99% for Am(III) and Eu(III) respectively. In battery R1, 99.99% U, 86.2% Pu and a part of Am or Eu are stripped into aqueous phase by 0.2mol/L acetohydroxyamic acid (AHA) in 0.01mol/L $HNO_3$ solution. In battery $R_2$, Am, Eu and remained Pu are completely back-extracted by 0.2mol/L AHA. This separation process contains no salt reagent, and it is not necessary to dilute HLLW feed.

• Journal of the Korean Society of Propulsion Engineers
• /
• v.3 no.4
• /
• pp.58-66
• /
• 1999

The flow characteristics of supersonic ejectors is often subject to compressibility, unsteadiness and shock wave systems. The numerical works carried out thus far have been of one-dimensional analyses or some Computational Fluid Dynamics(CFD) which has been applied to only a very simplified configuration. For the design of effective ejector-pump systems the effects of secondary mass flow on the supersonic ejector flow should be fully understood. In the present work the supersonic ejector-pump flows with a secondary mass flow were simulated using CFD. A fully implicit finite volume scheme was applied to axisymmetric compressible Navier-Stokes equations. The standard two-equation turbulence model was employed to predict turbulent stresses. The results obtained showed that the flow characteristics of constant area mixing tube types were nearly independent of the secondary flow rate, but the flow fields of ejector system with the second-throat were strongly dependent on the secondary flow rate due to the effect of the back pressure near the primary nozzle exit.

• Ocean and Polar Research
• /
• v.26 no.2
• /
• pp.175-185
• /
• 2004

To delineate Late Pleistocene paleoceanographic change of the West Pacific, we analyzed the oxygen and carbon isotopic ratios of two planktonic foraminifera species (G. sacculifer and N. dutertrei) from a piston core (KODOS-313) taken from the West equatorial Pacific, and they are compared with the published results of the East Pacific (ODP site 847 and RC 11-210), in terms of relative amounts and mass accumulation rates of $CaCO_3$ and eolian component, back to marine isotopic stage (MIS) 6. Differences in oxygen and carbon isotope values between two foraminifear species ($0.75%_{\circ}$ in ${\delta}^{18}O$, $0.05%_{\circ}$ in ${\delta}^{13}C$) are less than those of the East Pacific ($1.30%_{\circ}$ in ${\delta}^{18}O$, $0.14%_{\circ}$ in ${\delta}^{13}C$), which indicates smaller vertical contrasts in both temperature and nutrient between mixing-zone and thermocline in the West Pacific. Strong deviation in${\delta}^{18}O$ of G. sacculifer from SPECMAP suggests the carbonate fraction of KODOS-313 was subjected to partial dissolution by bottom water under lysocline. Lower accumulation rates of $CaCO_3$ and eolian component during glacial times are likely due to low sedimentation rate (ave. 0.75 cm/1000 yr) combined with carbonate dissolution in KODOS-313 site. However, the high $CaCO_3$ contents during the glacial periods clearly follow the general pattern of equatorial Pacific ocean.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2008.11a
• /
• pp.581-584
• /
• 2008

In this study, it is willing to present that fundamental data for proposing quantitatively shrinkage cracking evaluation method such as plat-ring type restrained test method. To examine suitable size of specimen of plat-ring type restrained test method, Evaluated concrete about restrained shrinkage crack properties of numerical analysis of 3D solid element using the MIDAS program, drying shrinkage deformation, restrained shrinkage stress, crack area and crack point with inside ring diameter of specimen in 100mm, 150mm, 200mm and high of Specimen in 30mm, 50mm after curing in condition of constant temperature and usual habit of temperature 20${\pm}$3$^{\circ}$C, humidity 60${\pm}$5%. As a result, it was available about suitable estimation with inside ring diameter of specimen in more than 150mm and high of Specimen in 50mm. Hereafter, it is considered that the study concerning environmental condition and mixing factor in plat-ring type restrained test method is need.