• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.20 no.5
• /
• pp.1-6
• /
• 2019

Organic dye-doped silica nanoparticles are used as a promising nanomaterials for bio-labeling, bio-imaging and bio-sensing. Fluorescent silica nanoparticles(NPs) have been synthesized by the modified $St{\ddot{o}}ber$ method. In this study, dye-free fluorescent silica NPs of various sized were synthesized by Sol-Gel process as the modified $St{\ddot{o}}ber$ method. The functional material of APTES((3-aminopropyl)triethoxysilane) was added as an additive during the Sol-Gel process. The as-synthesized silica NPs were calcined at $400^{\circ}C$ for 2 hours. The surface morphology and particle size of the as-synthesized silica NPs were characterized by field-emission scanning electron microscopy. The fluorescent characteristics of the as-synthesized silica NPs was confirmed by UV lamp irradiation of 365 nm wavelength. The photoluminescence (PL) of the as-synthesized silica NPs with different size was analyzed by fluorometry. As the results, the as-synthesized silica NPs exhibits same blue fluorescent characteristics for different NPs size. Especially, as increased of the silica NPs size, the intensity of PL was decreased. The blue fluorescence of dye-free silica NPs was attributed to linkage of $NH_2$ groups of the APTES layer and oxygen-related defects in the silica matrix skeleton.

• Journal of Korean Society of Water and Wastewater
• /
• v.24 no.4
• /
• pp.433-442
• /
• 2010

BER at different packing ratios of bio-ring media(BRM) was tested to investigate the effect of varying hydraulic retention time (HRT) and current density on the nitrate removal and current efficiency. In the preliminary batch mode experiment of BERs, current density was applied at 2.0 A/$m^2$, 4.0 A/$m^2$, 4.8 A/$m^2$, which correspond to the designation of reactor #1, #2, #3, respectively. The reactor #2 showed a highest nitrate removal rate of 162.0 mg $NO_3{^-}$-N/L/d, and the kinetics of nitrate removal rate was defined as the Zero order reaction. In the primary experiment of BERs, four BERs packed with BRM were operated in varying HRT and current, and the packing ratios of reactor #1, #2, #3 and #4 were 0%, 8%, 16%, 24%. respectively. This results of the experiments indicated that the nitrate removal rate and current efficiency were increased significantly cause of growing of autotrophic denitrification microorganisms on the surface of cathode and media by increasing of the current density and decreasing of HRT. However, The decreasing of nitrate removal rate and current efficiencies were observed in the condition of HRT of 5.25 hr and 4.8 A/$m^2$ of current density. With more increasing current density and decreasing of HRT, the hydrogen inhibition occurred at the surface of cathode. Moreover, nitrate removal rate by autotrophic denitrification microorganisms attached on the media surface was observed to be limited by no longer increasing dissolved hydrogen concentration of each reactor. In conclusion, the highest nitrate nitrogen removal and current efficiency could be achieved when the BER was operated at the conditions of 7 hr HRT, current density of 4.0 A/$m^2$, and 16% packing ratio. And it was found that the amount of nitrate removal by microorganisms attached on the surface of cathode and media (BRM) was 178.2 mg/L and 52.2 mg/L respectively. and the amount of nitrate removal per MLVSS was 0.435 g $NO_3{^-}$-N/g $MLVSS{\cdot}d$ and 0.336 $NO_3{^-}$-N/g $MLVSS{\cdot}d$.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.40 no.11
• /
• pp.34-41
• /
• 2003

In this paper, 60GHz band transmitter and receiver for wireless LAN are designed and implemented using the broband amplifier and mixer fabricated by standard 0.1${\mu}{\textrm}{m}$ MIMIC process of MINT. Output power and gain of the RF transmitter are 0 ㏈m and 1.7㏈, respectively. Noise figure and gain of the receiver are 4.2㏈ and l5.7dB, respectively. Considering the sensitivity and LOS test, this system can communicate with BER of below than 10$^{-6}$ at a distance more than 35m. DSSS, which is strong for concealment and disturbance, is adopted.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.27 no.2C
• /
• pp.184-190
• /
• 2002

This paper compares and analyzes and analyzes the transmission performance of the OpenCable system and the DBD-C system which are adopted as the digital CATV transmission standard in U.S.A. and Europe respectively through computer simulation under the same channel environment. We considered the channel environment including the random noise and the CTB (Composite Tripple Beats) noise as channel impairments in order to compare the two standard fairly. Additionally, we analyzed the transmission performance of the OpenCable system for the various interleaving depths. We implemented each transmission system by software, and we analyzed BER values with respect to the C/N in order to compare their transmission performance. As a result of the computer simulation, to get the BER of ${10}^{-6}$ the OpenCable system requires 1.2 dB kiwer C/N than the DVB-C system in the 64-QAM mode, and the two system require similar C/N in the 256-QAM mode.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.46 no.10
• /
• pp.79-85
• /
• 2009

The design of a 3.2 Gb/s serial link receiver in $0.18{\mu}m$ CMOS process is presented. The major factors limiting the performance of high-speed links are transmission channel bandwidth, timing uncertainty. The design uses a multi-level signaling(4-PAM) to overcome these problems. Moreover, to increase data bit-rate and lower BER, we designed this circuit by using a current mode amplifier, Current-mode Logic(CML) sampling latches. The 4-PAM receiver achieves 3.2 Gb/s and BER is less than $1.0\;{\times}\;10^{-12}$. The $0.5\;{\times}\;0.6\;mm^2$ chip consumes 49 mA at 3.2 Gb/s from a 1.8-V supply.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.44 no.6 s.360
• /
• pp.28-33
• /
• 2007

The front-end system having a capable of 2x reading and writing of BD-R/Ra/ROM is developed. Its readability is improved by adopting 5-tap adaptive partial response maximum likelihood (PRML) with the PR(a,b,c,d,e) type channel. Due to the proposed PRML, less than $2{\times}10^{-4}$ of the bit error rate (BER) is achieved with radial and tangential tilt margin of over${\mp}0.6{\circ}$ on 25GB disc in 2x speed. The method of an optimum Power control (OPC) for stable writing of various BD-R/RE is proposed. The developed chip contains 14-million transistors in a $60mm^2$ dies, and is fabricated in $0.18-{\mu}m$ CMOS technology.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.48 no.10
• /
• pp.25-32
• /
• 2011

We have analyzed adjacent cell dependency of threshold voltage shift caused by the cell to cell interference, and we proposed a 3-adjacent-cell model to model the pattern dependency of the threshold voltage shift. The proposed algorithm is verified by using MATLAB simulation and measurement results. In the experimental results, we found that accuracy of the proposed simple 3-adjacient-cell model is comparable to the widely used conventional 8-adjacient-cell model. The Bit Error Rate (BER) of LSB and of MSB is improved by 28.9% and 19.8%, respectively, by applying the proposed algorithm based on 3-adjacent-cell model to 20nm-class 2-bit MLC NAND flash memories.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.43 no.10 s.352
• /
• pp.1-9
• /
• 2006

In this paper, a couple of 10Gb/s transimpedance amplifiers are realized in a 0.18um standard CMOS technology for optical communication applications. First, the voltage-mode inverter TIA(I-TIA) exploits inverter input configuration to achieve larger effective gm, thus reducing the input impedance and increasing the bandwidth. I-TIA demonstrates $56dB{\Omega}$ transimpedance gain, 14GHz bandwidth for 0.25pF photodiode capacitance, and -16.5dBm optical sensitivity for 0.5A/W responsivity, 9dB extinction ration and $10^{-12}$ BER. However, both its inherent parasitic capacitance and the package parasitics deteriorate the bandwidth significantly, thus mandating very judicious circuit design. Meanwhile, the current-mode RGC TIA incorporates the regulated cascade input configuration, and thus isolates the large input parasitic capacitance from the bandwidth determination more effectively than the voltage-mode TIA. Also, the parasitic components give much less impact on its bandwidth. RGC TIA provides $60dB{\Omega}$ transimpedance gain, 10GHz bandwidth for 0.25pF photodiode capacitance, and -15.7dBm optical sensitivity for 0.5A/W responsivity, 9dB extinction ration and $10^{-12}$ BER. Main drawback is the power dissipation which is 4.5 times larger than the I-TIA.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.7 no.4
• /
• pp.646-651
• /
• 2003

In this paper, we investigate the performance comparisons of various turbo interleavers which are adopted as a standard such as IMT-2000 and satellite DVB(digital video broadcasting). The bit error rate performance is calculated by the fixed point computer simulations over Rayleigh fading channels. For a fair comparison, the simulation is performed on the basis of equal the interleaver size as we can. From the results, it is shown that the turbo interleaver in W-CDMA outperforms the turbo interleavers in CDMA2000 and satellite DVB. The performance gains are even larger as the interleaver size is increased.

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.15 no.3
• /
• pp.954-962
• /
• 1991

본 연구에서는 횡 방향으로 속도구배를 타내는 a=.part.W/.part.z에 대한 방정식을 3차원 운동량 방정식으로 부터 유도한 준 3차원 수학적 모델을 성정하여 해석하였다. 또한 수치 해석을 위하여 Chen에 의하여 고안된 유한 해석법과 2-방정식 저 레이놀즈 K-.epsilon. 난류모델, 그리고 Maeng에 의해 제시된 경계 공정 좌표계를 사용하였다. 그리 고 프로그램의 검증을 위하여 G.Ber geles가 수행한 실험치와 비교하여 그 타당성을 입증하였다.