• 한국재료학회지
• /
• 제21권12호
• /
• pp.690-696
• /
• 2011

In this study, nano-sized tin oxide powder with an average particle size of below 50 nm is prepared by the spray pyrolysis process. The influence of air pressure on the properties of the generated powder is examined. Along with the rise of air pressure from $0.1kg/cm^2$ to $3kg/cm^2$, the average size of the droplet-shaped particles decreases, while the particle size distribution becomes more regular. When the air pressure increases from $0.1kg/cm^2$ to $1kg/cm^2$, the average size of the dropletshaped particles, which is around 30-50 nm, shows hardly any change. When the air pressure increases up to $3kg/cm^2$, the average size of the droplet-shaped particles decreases to 30 nm. For the independent generated particles, when the air pressure is at $0.1kg/cm^2$, the average particle size is approximately 100 nm; when the air pressure increases up to $0.5kg/m^2$, the average particle size becomes more than 100 nm, and the surface structure becomes more compact; when the air pressure increases up to $1kg/cm^2$, the surface structure is almost the same as in the case of $0.5kg/cm^2$, and the average particle size is around 80- 100 nm; when the air pressure increases up to $3kg/cm^2$, the surface structure becomes incompact compared to the cases of other air pressures, and the average particle size is around 80-100 nm. Along with the rise of air pressure from $0.1kg/cm^2$ to $0.5kg/cm^2$, the XRD peak intensity slightly decreases, and the specific surface area increases. When the air pressure increases up to $1kg/cm^2$ and $3kg/cm^2$, the XRD peak intensity increases, while the specific surface area also increases.

• 한국환경보건학회지
• /
• 제21권2호
• /
• pp.7-11
• /
• 1995

This study was carried out to investigate the change of average specific resistance according to filtration pressure, suspension concentration and filters for study phenomena occurring in cake filtration. As the results of this study, the following conclusions were obtained. It was estimated that the average specific resistance of filtration Was decreased in proportion to decreased of filtration pressure. But in very pressure, average specific resistance was increased. The average specific resistance value on filter medium by various pressure was showed as same trends under constant suspension concentration. This phenomenon was though that a carrain amount of fine particles in the cake was found to migrate throught the cake in the case of very thin at very low pressure. In relation to the change of suspension concentration, average specific resistance value become low according to decreased in supension concentration.

• 상하수도학회지
• /
• 제24권5호
• /
• pp.573-580
• /
• 2010

Average pressure in a pipe network is one of critical factors to estimate the flow distribution and to calculate UARL (Unavoidable Annual Real Losses) value in ILI (Infrastructure Leakage Index). While its collection period and measuring location are essential to obtain average pressure, their standard method have not been established so far. In this study, proper method including its procedure for data collection period and measuring point for average pressure were suggested using non-exceedance probability concept in the water distribution network.

• 한국전문물리치료학회지
• /
• 제12권2호
• /
• pp.1-10
• /
• 2005

Pressure ulcers are serious complications of tissue damage that can develop in patients with diminished pain sensation and diminished mobility. Pressure ulcers can result in irreversible tissue damage caused by ischemia resulting from external loading. There are many intrinsic and extrinsic contributors to the problem, including interface tissue pressure, shear, temperature, moisture, hygiene, nutrition, tissue tolerance, sensory and motor dysfunction, disease and infection, posture, and body support systems. The purposes of this study were to investigate the relationship between buttock interface pressure and seating position, wheelchair propulsion speed. Seated-interface pressure was measured using the Force Sensing Array pressure mapping system. Twenty subjects propelled wheelchair handrim on a motor-driven treadmill at different velocities (40, 60, 80 m/min) and seating position used recline ($100^{\circ}$, $110^{\circ}$, $120^{\circ}$) with a wheelchair simulator. Interface pressure consists of average (mean of the pressure sensor values) and maximum pressure (highest individual sensor value). The results of this study were as follows; No significant correlation in maximum/average pressure was found between a static position and a 40 m/min wheelchair propulsion (p>.05). However, a significant increase in maximum/average pressure were identified between conditions of a static position and 60 m/min, and 80 m/min wheelchair propulsion (p<.05). No significant correlation in maximum pressure were found between a $90^{\circ}$ recline (neutral position) and a $100^{\circ}$, $110^{\circ}$, or $120^{\circ}$ recline of the wheelchair back (p>.05). No significant difference in average pressure was found between conditions of a $90^{\circ}$ recline and both a $100^{\circ}$ and $110^{\circ}$ recline of wheelchair back. However, a significant reduction in average pressure was identified between conditions of a $90^{\circ}$ and $120^{\circ}$ recline of wheelchair back (p<.05). This study has shown some interesting results that reclining the seat by $120^{\circ}$ reduced average interface pressure, including the reduction or prevention in edema. And interface pressure was greater during dynamic wheelchair propulsion compared with static seating. Therefore, the optimal seating position and seating system ought to provide postural control and pressure relief. We need an education on optimal seating position and a suitable propulsion speeds for wheelchair users.

• 대한통합의학회지
• /
• 제5권4호
• /
• pp.1-9
• /
• 2017

Purpose : This study was conducted among 195 adults in their 20s. To analyze the impact of the slope types of the scapulae on the plantar surface of the foot, the average pressure (AP), the maximum pressure (MP), the average of local distribution values, and the average movement of the center of pressure (COP) of the different slope types of the scapulae were compared. Method : The anterior-posterior slopes of the scapulae were measured by comparing the slopes of the left and right sides of the scapulae based on the differences in the height and the slope of the coracoid process and the angulus inferior scapulae. Those whose left side of the scapulae had an anterior slope were categorized as type 1, and those whose right side of the scapulae had an anterior slope, as type 2. The average plantar pressure, the center of plantar pressure, the maximum plantar pressure, and local distribution values were analyzed using a plantar pressure analyzer of the FSA. Result : In terms of the AP of the left and right feet, there was no statistically significant difference both in types 1 and 2 on the left and right feet. The comparison results of the MP and the average of local distribution values of the two slope types of the scapulae showed that there was no statistically significant difference on the X-axis both in types 1 and 2 on the left and right feet, but that there was a large statistically significant difference on the Y-axis both in types 1 and 2. That is, the MP of the right foot of the left anterior slope type was located more on the hindfoot than that of the right anterior slope type, and the MP of the left foot of the left anterior slope type was located more on the hindfoot than that of right anterior slope type. Conclusion : This study can be used as fundamental data to predict differences in the location and size of the COP and changes in plantar pressure distribution depending on the slope types of the scapulae, and control the distribution for therapeutic purposes.

• Journal of Chest Surgery
• /
• 제20권1호
• /
• pp.30-38
• /
• 1987

Sixty-eight consecutive patients have been subjected to total corrective surgery of tetralogy of Fallot at the Hanyang University Hospital between August 1975 and December 1984. Of these, the pressure of chambers and great arteries were measured, before and immediately following an operation in 39 of the survived group and 11 of the expired group. The values of postoperative peak pressure were correlated with the outcome of the operation. The result are as followings; 1] Compared to the average peak pressure of right atrium in the survived group, 14.46*4.16 mmHg, that in the expired group, 19.36*8.19 mmHg, was significantly lower, 2] Compared to the average systolic pressure of right ventricle in the survived group, 56.72z16.37 mmHg, that in the expired group, 70.45*15.26 mmHg, was significantly lower. 3] Compared to the average systolic pressure of pulmonary artery in the survived group, 33.26*12.95 mmHg, that in the expired group, 37.55*11.63 mmHg, was higher. But the difference was not significant. 4] Compared to the average peak pressure of left atrium in the survived group, 17.41*6.90 mmHg, that in the expired group, 31.18*12.47 mmHg, was significantly higher. 5] Compared to the average systolic pressure of left ventricle in the survived group, 103.82~12.83 mmHg, that in the expired group, 90.55*20.02 mmHg, was significantly lower. 6] Compared to the average value of the right ventricle-pulmonary artery systolic pressure gradient [RV-PA] in the survived group, 24.95a15.44 mmHg, that in the expired group, 35.09*17.01 mmHg, was significantly higher. 7] Compared to the average value of the right ventricle to left ventricle systolic pressure ratio [RV/LV] in the survived group, 0.55*0.15, that in the expired group, 0.80a0.20, was significantly higher. 8] Compared to the average value of the pulmonary artery-left atrium peak pressure gradient [PA-LA] in 15.85x12.29 mmHg that in the expired group, 4.18x6.00 mmHg, was significantly lower. It is, therefore, suggested that in the operating room, PA-LA is as valuable as RV - PA, RV/LV in making important surgical decision and predicting the prognosis.

• 대한조선학회논문집
• /
• 제48권4호
• /
• pp.330-335
• /
• 2011

This paper presents estimation of average compressive strengths of three types of stiffened panels under lateral pressure and axial compression based on simplified formulas from CSRs and nonlinear FEAs. FEA scenarios are prepared based on the slenderness ratios of the stiffened panels used for in-service vessels. The seven step lateral pressures by 1bar increment are imposed on FE models assuming maximum 30m water height. The number of FEAs for FB-, AB-, and TB-stiffened panels is totally 189 times. FEA results show that existence of pressure can evolves significant reduction of ultimate strengths, meanwhile CSR formulas do not take into account the lateral pressure effect. Lateral pressure acting on the stiffened panel with higher column slenderness ratio more reduces the ultimate strengths than those with smaller column slenderness ratio. A new concept of relative average compressive strain energy instead of the ultimate strength is introduced in order to rationally compare the average compressive strength through complete compressive straining regime. The differences of the ultimate strengths between CSR formulas and FEA results are relatively small for FB- and AB-stiffened panels, but larger discrepancies of relative average compressive strain energies are shown.

• 한국우주과학회:학술대회논문집(한국우주과학회보)
• /
• 한국우주과학회 2010년도 한국우주과학회보 제19권1호
• /
• pp.39.3-39.3
• /
• 2010

Solar-terrestrial links in short-time scales(daily ~monthly) are extensively explored in recent years: such as a response of low cloud amounts to the Forbush decrease, a response of Northern Atlantic oscillation index to sudden increase in electric field intensity of solar wind and so on (e.g., Svensmark et al., 2009; Boberg & Lundstedt, 2002). In this study, we perform the superposed epoch analysis to see any possible response of the sea-level pressure over Korean peninsula to the fast solar wind stream. Data sets are daily values, and zero days are determined to be days when the solar wind velocity exceeds 800km/s. Average profile of superposed sea-level pressure shows a gradual increase during the first 2 days and a decrease afterward below the normal level with a low pressure condition maintained for a few days. This result indicates that the sea-level pressure may respond to the fast solar wind stream. In other words, the average profile of sea-level pressure mimics the average velocity profiles. The correlation coefficient between two average profiles is 0.80, with 2 day lag.

• The Korean Journal of Physiology
• /
• 제4권1호
• /
• pp.47-54
• /
• 1970

The effects of excess salt ingestion or/and a prolonged electrical stimulation of the hypothalamus on the arterial blood pressure were studied in cats. The average mean arterial pressure determined in 12 control animals were $112.2{\pm}2.6\;mmHg$. In 15 animals in which 2% NaCl solution (2g/Kg of body wegight/day) was given for 20 days, average mean arterial pressure elevated to $147.7{\pm}6.1\;mmHg$. It was also found in four of them that salt-induced high blood pressure started to decline when salt solution was replaced by tap water. On the other hand, No change in average mean arterial pressure was observed in 10 animals, whose hypothalamus had been electrically stimulated for 28 days. In 11 animals in which the hypothalamus was stimulated with simultaneous excess salt ingestion for 20 days, there was a marked elevation in average mean arterial pressure which, however, does not significantly differ from that observed in excess salt ingested group. From the results obtained from the present experiment, it is concluded that 1) the hypertension is induced by an excess salt ingestion in cats, 2) the mean arterial pressure of cats is not affected at least by an increment of sympathetic tone for 4 weeks resulting from the electrical stimulation of posterior area of the hypothalamus, 3) in sodium·induced high blood pressure cats, four weeks of increment in sympathetic tone by the hypothalamic stimulation does not further elevate mean arterial pressure.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2005년도 춘계학술대회논문집
• /
• pp.291-294
• /
• 2005

In this study, we compared and analyzed the floor impact sound insulation performance produced by the rating methods. The rating methods are using reversed A-weighting curve, A-weighted sound pressure levels and arithmetic average. On-site floor impact sound pressure levels of living room and room are measured. The results of this study are 1)the rating using reversed A-weighting curve for heavy-weight impact sound's standard deviation is lower than that of light-weight impact sound, 2)the number of rating using A-weighted sound pressure levels and arithmetic average is larger than that of using reversed A-weighting curve, and 3)the number of rating using reversed A-weighting curve mainly depends on impact sound pressure level of 63Hz in heavy-weight impact sound.