• 한국구조물진단유지관리공학회 논문집
• /
• 제20권4호
• /
• pp.84-93
• /
• 2016

전자기파가 콘크리트 교량 바닥판을 통과할 때 에너지 손실 메카니즘에 의해 신호의 감쇠가 발생하며, 이는 콘크리트의 상대유전율과 전도도, 그리고 지리적 산란 손실의 영향에 따른 것으로 알려져 있다. 본 연구에서는 건전한 콘크리트에 대해서는 레이더파의 감쇠가 상부철근의 깊이와 선형관계에 있다는 점에 착안하여, 일체식 콘크리트 교량 바닥판에서 상태평가 지표로서의 레이더파의 신호감쇠를 실 교량에 적용하여 그 유용성에 대해 검토하였다. 연구결과, 손상된 콘크리트 교량 바닥판에서는 건전한 상태에 비해 상대적으로 큰 감쇠가 일어나며, 레이더 수신파의 총감쇠량에서 반사체의 깊이에 대해 선형적 관계인 부분을 제거하고 난 보정감쇠량은 일체식 콘크리트 교량 바닥판의 상태평가에 유용한 것으로 나타났다. 실제 공용 중인 손상 교량 바닥판에 적용한 결과, 제안된 방법은 교면에서 상부철근까지의 콘크리트 상태를 신뢰성 있게 평가할 수 있으며, 특히, 일체식 바닥판의 주손상요인인 상부철근의 부식환경을 간접적으로 평가할 수 있는 것으로 판단된다.

• 한국의학물리학회지:의학물리
• /
• 제32권4호
• /
• pp.153-158
• /
• 2021

Purpose: This study evaluated the features of a pressure mapping system for patient motion monitoring in radiation therapy. Methods: The pressure mapping system includes an MS 9802 force sensing resistor (FSR) sensor with 2,304 force sensing nodes using 48 columns and 48 rows, controller, and control PC (personal computer). Radiation beam attenuation caused by pressure mapping sensor and signal perturbation by 6 and 10 mega voltage (MV) photon beam was evaluated. The maximum relative pressure value (mRPV), average relative pressure value (aRPV), the center of pressure (COP), and area of pressure distribution were obtained with/without radiation using the upper body of an anthropomorphic phantom for 30 minutes with 15 MV. Results: It was confirmed that the differences in attenuation induced by the FSR sensor for 6 and 10 MV photon beams were small. The differences in mRPV, aRPV, area of pressure distribution with/without radiation are about 0.6%, 1.2%, and 0.5%, respectively. The COP values with/without radiation were also similar. Conclusions: The characteristics of a pressure mapping system during radiation treatment were evaluated on the basis of attenuation and signal perturbation using radiation. The pressure distribution measured using the FSR sensor with little attenuation and signal perturbation by the MV photon beam would be helpful for patient motion monitoring.

• 한국해양공학회지
• /
• 제36권5호
• /
• pp.326-339
• /
• 2022

Recently, not only Korea but also the world has been suffering from problems related to coastal erosion. The hard defense method has been primarily used as a countermeasure against erosion. However, this method is expensive and has environmental implications. Hence, interest in other alternative methods, such as the eco-friendly vegetation method, is increasing. In this study, we aim to analyze the hydraulic characteristic of submerged rigid vegetation according to the cross-sectional change through a hydraulic experiment and numerical simulation. From the hydraulic experiment, the reflection coefficient, transmission coefficient, and energy dissipation coefficient were analyzed according to the density, width, and multi-row arrangement of the vegetation zone. From numerical simulations, the flow field, vorticity distribution, turbulence distribution, and wave distribution around the vegetation zone were analyzed according to the crest depth, width, density, and multi-row arrangement distance of the vegetation zone. The hydraulic experiment results suggest that the transmission coefficient decreased as the density and width of the vegetation zone increased, and the multi-row arrangement condition did not affect the hydraulic characteristics significantly. Moreover, the numerical simulations showed that as the crest depth decreased, the width and density of vegetation increased along with vorticity and turbulence intensity, resulting in increased wave height attenuation performance. Additionally, there was no significant difference in vorticity, turbulence intensity, and wave height attenuation performance based on the multi-row arrangement distance. Overall, in the case of submerged rigid vegetation, the wave energy attenuation performance increased as the density and width of the vegetation zone increased and crest depth decreased. However, the multi-row arrangement condition did not affect the wave energy attenuation performance significantly.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1988년도 전기.전자공학 학술대회 논문집
• /
• pp.51-54
• /
• 1988

In this paper, Digital signal processing method is deserved by the tissue characteristic quantization. Linear phase velocity is studied using linear signal, and the slope which attenuation characteristics are decreased is analysed according to frequency increase. A more efficient method determining the minimum phase function is developed from the spectral magnitud function.

• 대한전기학회논문지:전기물성ㆍ응용부문C
• /
• 제51권7호
• /
• pp.316-321
• /
• 2002

In this Paper, the channel characteristics of the medium voltage(22.9kV) power line to analysis the broadband power line communication in the frequency range up to 30MHz was measured. With the sideband electrical coupler in the operating frequency range from DC to 30MHz, we measured characteristic impedance, noise and attenuation of the medium voltage power line, and then characteristic impedance was measured at the state of unloaded medium voltage power line by Scattering parameter method of Vector Network Analyzer. As a measurement result, Channel impedance shows 100~380$\Omega$ at the less than 15MHz and 70~230$\Omega$ at the more than 15 MHz. Noise characteristics of power line shows -75dBm at 20MHz and Narrowband interference noise was from 3 MHz to 7MHz.

• 대한전자공학회논문지TC
• /
• 제48권12호
• /
• pp.35-41
• /
• 2011

본 논문에서는 손실매질의 다층구조로 이루어진 마이크로 스트립선로의 손실특성의 개선을 위한 새로운 구조를 제안한다. MIS 구조로 된 전송선로의 Si와 SiO2층 사이에 0전위를 가진 도체를 일정한 간격의 주기적인 배열로 고안된 새로운 모델의 MIS구조에 대한 유한차분법을 이용한 해석방법이 사용된다. 특히 전송선로에 대한 유전체의 영향을 줄이기 위하여 0전위를 가진 주기적인 결합의 도체로 이루어진 구조가 시간영역의 신호를 통해 시험된다. 다양한 0전위 도체의 간격(갭)에 따른 주파수 의존적인 추출된 전송선로 파라미터와 등가회로 파라미터가 주파수 함수로서 나타내진다. 또한 본 논문에서 고안된 구조에 대해 특성임피던스와 유효유전상수의 큰 변화 없이 대칭 결합선로의 quality factor가 개선됨을 볼 수 있다.

• 한국통신학회논문지
• /
• 제29권9A호
• /
• pp.983-990
• /
• 2004

본 논문에서는 중 전압 전력선을 이용한 전력선 통신대 LC) 네트워크의 입력임피던스를 계산하였다. 먼저 전송 선로 모델을 이용하여 전력선 통신 네트워크의 입출력 단 모델을 제시하였으며, 여기에 전력선의 방사성 손실, 도체손실, 유전체 손실 등에 의한 감쇠상수를 적용시켜 임피던스를 계산하였다 계산결과 방사성 손실에 의한 강쇠 가 가장 크게 나타났으며, 전력선의 특정임피던스가 매우커서 입력 단에서의 반사가 심하기 때문에 입력임피던스 가 일정한 주기를 가지는 정재파 형태로 나타남을 알 수 있었다 또한 입력임피던스의 주기는 동축선로의 길이에 주로 의존하고, 크기는 주로 전력선의 특성임피던스 및 손실에 의존하였다 실제 측정결과 계산 치와 측정치가 매 우 유사함을 알 수 있었다.

• 지구물리와물리탐사
• /
• 제7권1호
• /
• pp.45-50
• /
• 2004

This paper describes a method of detecting formation boundaries, and permeable fractures, from frequency-domain Stoneley wave logs. Field data sets were collected between the depths of 330 and 360 m in well EE-4 in the Higashi-Hachimantai geothermal field, using a monopole acoustic logging tool with a source central frequency of 15 kHz. Stoneley wave amplitude spectra were calculated by performing a fast Fourier transform on the waveforms, and the spectra were then collected into a frequency-depth distribution of Stoneley wave amplitudes. The frequency-domain Stoneley wave log shows four main characteristic peaks at frequencies 6.5, 8.8, 12, and 13.3 kHz. The magnitudes of the Stoneley wave at these four frequencies are affected by formation properties. The Stoneley wave at higher frequencies (12 and 13.3 kHz) has higher amplitudes in hard formations than in soft formations, while the wave at lower frequencies (6.5 and 8.8 kHz) has higher amplitudes in soft formations than in hard formations. The correlation of the frequency-domain Stoneley wave log with the logs of lithology, degree of welding, and P-wave velocity is excellent, with all of them showing similar discontinuities at the depths of formation boundaries. It is obvious from these facts that the frequency-domain Stoneley wave log provides useful clues for detecting formation boundaries. The frequency-domain Stoneley wave logs are also applicable to the detection of a single permeable fracture. The procedure uses the Stoneley wave spectral amplitude logs at the four frequencies, and weighting functions. The optimally weighted sum of the four Stoneley wave spectral amplitudes becomes almost constant at all depths, except at the depth of a permeable fracture. The assumptions that underlie this procedure are that the energy of the Stoneley wave is conserved in continuous media, but that attenuation of the Stoneley wave may occur at a permeable fracture. This attenuation may take place at anyone of the four characteristic Stoneley wave frequencies. We think our multispectral approach is the only reliable method for the detection of permeable fractures.

• Journal of Power Electronics
• /
• 제17권1호
• /
• pp.305-313
• /
• 2017

A novel interference isolation method is proposed by using several designed coils in capacitive power transfer systems as isolation impedances. For each designed coil, its stray parameters such as the inter-turn capacitance, coil resistance and capacitance between the coil and the core, etc. are taken into account. An equivalent circuit model of the designed coil is established. According to this equivalent circuit, the impedance characteristic of the coil is calculated. In addition, the maximum impedance point and the corresponding excitation frequency of the coil are obtained. Based on this analysis, six designed coils are adopted to isolate the interference from power delivery. The proposed method is verified through experiments with a power carrier frequency of 1MHz and a data carrier frequency of 8.7MHz. The power and data are transferred parrallelly with a data carrier attenuation lower than -5dB and a power attenuation on the sensing resistor higher than -45dB.

• 한국통신학회논문지
• /
• 제17권10호
• /
• pp.1051-1062
• /
• 1992

본 논문에서는 차단주파수가 4MHz인 연속시간의 5차 OTA-C Elliptic filter를 설계하였다. 설계된 필터는 OTA-C구조로서 5개의 OTA, 8개의 커패시터와 1개의 완충기로 구성하였다. OTA의 기생커패시턴스 및 Loading에 의한 특성저하를 방지하기 위해 완충기와 커패시터를 설계하여 연결시켰고, 이로인해 주파수특성은 원래의 설계조건, 즉 통과대역 감쇠 0.2dB이하, 저지대역 감쇠 30dB와 차단주파수 4MHz를 모두 만족시켰으며, 차단특성은 이론적인 경우보다 약 7dB만큼 더욱 특성이 개선되었다.