• Bulletin of the Korean Chemical Society
• /
• v.32 no.2
• /
• pp.451-454
• /
• 2011

The traditional BCS superconductors $AOs_2O_6$ (A=K, Rb, and Cs) were investigated to find the relationship between their structures and superconducting transition temperatures. The $T_c$ decreases with increasing the unit cell parameter of $AOs_2O_6$. This is in contrast to the case of conventional BCS superconductivity in a single bond model, where $T_c$ may increase with increasing the the unit cell parameter since the DOS at Fermi level increases as the unit cell parameter increases. Instead, the $T_c$ of a $\beta$-pyrochlore oxide is proportional to the lattice softness of the compound.

• Journal of the Korean Magnetic Resonance Society
• /
• v.19 no.3
• /
• pp.119-123
• /
• 2015

The thermodynamic properties and structural geometry of $KMgCl_3{\cdot}6H_2O$ were investigated using thermogravimetric analysis, differential scanning calorimetry, and nuclear magnetic resonance. The initial mass loss occurs around 351 K ($=T_d$), which is interpreted as the onset of partial thermal decomposition. Phase transition temperatures were found at 435 K ($=T_{C1}$) and 481 K ($=T_{C2}$). The temperature dependences of the spin-lattice relaxation time $T_1$ for the $^1H$ nucleus changes abruptly near $T_{C1}$. These changes are associated with changes in the geometry of the arrangement of octahedral water molecules.

• Journal of the Korean Ceramic Society
• /
• v.54 no.2
• /
• pp.150-157
• /
• 2017

Three types of piezoelectric single crystals [PMN-PT (Generation I $[Pb(Mg_{1/3}Nb_{2/3})O_3-PbTiO_3]$), PMN-PZT (Generation II $[Pb(Mg_{1/3}Nb_{2/3})O_3-Pb(Zr,Ti)O_3]$), PMN-PZT-Mn (Generation III)] were grown by the solid-state single crystal growth (SSCG) method, and their dielectric and piezoelectric properties were measured and compared. Compared to (001) PMN-PT and PMN-PZT single crystals, the (001) PMN-PZT-Mn single crystals exhibited a higher transition temperature between the rhombohedral and tetragonal phases ($T_{RT}=144^{\circ}C$), as well as a higher coercive electric field ($E_C=6.3kV/cm$) and internal bias field ($E_I=1.6kV/cm$). The (011) PMN-PZT-Mn single crystals showed the highest coercive electric field ($E_C=7.0kV/cm$), and the highest stability of $E_C$ and $E_I$ during 60 cycles of polarization measurement. These results demonstrate that both Mn doping (for higher electromechanical quality factor ($Q_m$)) and a (011) crystallographic orientation (for higher coercive electric field and stability) are necessary for high power transducer applications of these piezoelectric single crystals. Specifically, the (011) PMN-PZT-Mn single crystal (Gen. III) had the highest potential for application in the fields of SONAR transducers, high intensity focused ultrasound (HIFU), ultrasonic motors, and others.

• Journal of the Korean Ceramic Society
• /
• v.49 no.6
• /
• pp.648-653
• /
• 2012

Hybridization of dense ceramic membranes for hydrogen separation with an electronically conductive metallic phase is normally utilized to enhance the hydrogen permeation flux and thereby to increase the production efficiency of hydrogen. In this study, we developed a nickel and proton conducting oxide ($BaCe_{0.9}Y_{0.1}O_{3-{\delta}}$: BCY) based cermet (ceramic-metal composites) membrane. Focused on the general criteria in that the hydrogen permeation properties of a cermet membrane depend on its microstructural features, such as the grain size and the homogeneity of the mix, we tried to optimize the microstructure of Ni-BCY cermets by controlling the fabrication condition. The Ni-BCY composite powder was synthesized via a solid-state reaction using $2NiCO_3{\cdot}3Ni(OH)_2{\cdot}4H_2O$, $BaCeO_3$, $CeO_2$ and $Y_2O_3$ as a starting material. To optimize the mixing scale and homogeneity of the composite powder, we employed a high-energy milling process. With this high-energy milled composite powder, we could fabricate a fine-grained dense membrane with an excellent level of mixing homogeneity. This controlled Ni-BCY cermet membrane showed higher hydrogen permeability compared to uncontrolled Ni-BCY cermets created with a conventionally ball-milled composite powder.

• Resources Recycling
• /
• v.29 no.6
• /
• pp.73-78
• /
• 2020

To use a tailing obtained from coal beneficiation as a raw material for glass material, the behaviors of phase transformation of the tailing was investigated according to sintered temperature with the addition of Na2CO3. As a result of the experiment, mullite was formed at 700~1,100 ℃, and the mullite and the cristobalite just only existed at 1,450 ℃. The glassification ratio of the coal tailing was to be 97.9 wt.% at 1,450 ℃ with the addition of Na2CO3 to tailing weight ratios of 10 wt.%. However, in the case of sample of coal tailing with 20 wt.% Na2CO3 added, nepheline(Na2O·Al2O3·2SiO2) was produced during the re-sintering(2nd sintering) at 1,100 ℃. From the results, the suitable addition amount of Na2CO3 for glassification of coal tailing was found around 10 wt.%.

• Resources Recycling
• /
• v.25 no.6
• /
• pp.92-97
• /
• 2016

Spray dried $Cr_2O_3$ powder having an agglomerated structure of particles was twice treated into a plasma flame to increase its apparent density. The powder subjected to the first densification treatment did not show the entirely melted state keeping inner particle hollows, and it was fully melted after the second processing only. The powder size as a result of the second treatment decreased, and the apparent density as well as flowability were increased due to melting and surface smoothing effects. But a part of particles after the second densified treatment showed the hollow structure, especially those which were above $30{\mu}m$ in size. This densification behavior of the powder has been qualitatively discussed in terms of the thermal conductivity and inner gas pressure within aggregates exposed to the plasma flame.

• Microbiology and Biotechnology Letters
• /
• v.47 no.4
• /
• pp.630-638
• /
• 2019

Nitrous oxide (N₂O) is a greenhouse gas with a global warming potential 310 times higher than that of carbon dioxide. In this study, an N₂O-reducing consortium was obtained by enrichment culture using advanced treatment sludge as the inoculum. The dominant bacteria in the consortium were Sulfurovum (17.95%), Geobacter (14.63%), Rectinema (11.45%), and Chlorobium (8.24%). The consortium displayed optimal N₂O reducing activity when acetate was supplied as the carbon source at a carbon/nitrogen ratio (mol·mol^-1) of 6.3. The N₂O reduction rate increased with increasing N₂O concentration at less than 3,000 ppm. Kinetic analysis revealed that the maximum N₂O reduction rate of the consortium was 163.9 ㎍-N·g-VSS^-1·h^-1. Genes present in the consortium included nosZ (reduction of nitrous oxide to N₂), narG (reduction of nitrate to nitrite), nirK (reduction of nitrite to nitric oxide), and norB (reduction of nitric oxide to nitrous oxide). These results indicate that the N₂O-reducing consortium is a promising bioresource that can be used in denitrification and N₂O mitigation.

• Journal of Magnetics
• /
• v.14 no.2
• /
• pp.86-89
• /
• 2009

Structural and magnetic properties of polycrystalline $CaFe_2O_4$ prepared by the solid state reaction method were studied using powder X-ray diffraction (XRD) and $M{\ddot{o}}ssbauer$ spectroscopy. The structure of $CaFe_2O_4$ belongs to an orthorhombic system (space group: Pnma) with the lattice parameters $a=9.2373\;{\AA}$, $b=3.0237\;{\AA}$, and $c=10.7124\;{\AA}$. Results of structural refinement indicate, however, that there are two slightly different iron sites in the sample. The $M{\ddot{o}}ssbauer$ spectrum at 4.2 K shows a hyperfine sextet with a hyperfine magnetic field and an isomer shift of 47.3 T and 0.36 mm/s, respectively. An examination of the spectrum revealed that the line widths of the spectral lines were not uniform. The degree of asymmetric line broadening decreases with increasing temperature, suggesting that the difference in the degree of crystalline distortions between two $FeO_6$ octahedra is eliminated as the temperature rises.

• Journal of the Korean Recycled Construction Resources Institute
• /
• v.11 no.1
• /
• pp.9-15
• /
• 2023

The cement is a typical CO₂ emission industry. Manufacturing process improvements and increased use of alternative materials are needed to reduce energy consumption and CO₂ emissions. This study confirmed the basic characteristics of cement hydration by sintering CAF at low temperature as a CO₂ adsorbent material. For the hydration product of the synthetic CAF, crystal phase analysis, porosity, and structural images were confirmed, and the compressive strength was measured. The replacement rate of SCAF was 10, 20, and 100 %, and the compressive strength tended to decrease as the replacement rate increased. In addition, when the SCAF substitution rate is 100 %, the hydration products of the early age are calcium aluminum oxide hydrate (Ca₃Al₂O₆ x H₂O) and calcium iron hydroxide (Ca₃Fe(OH)₁₂), and at substitution rates of 10 and 20 %, CAF compounds other than general cement hydrates brownmillerite was observed. As for the porosity, the pore size increased and the porosity increased with the increase of the replacement ratio. As a result of this study, CAF manufactured by low-temperature sintering seems to be difficult to use alone and general curing for utilization as a CO₂ adsorbing material.

• Applied Science and Convergence Technology
• /
• v.23 no.6
• /
• pp.392-397
• /
• 2014

CuO nanotubes are synthesized using $TeO_2$ nanorod templates for application to $H_2S$ gas sensors. $TeO_2$ nanorod templates were synthesized by using the VS method through thermal evaporation. Scanning electron microscopy, transmission electron microscopy and X-ray diffraction showed that the synthesized nanotubes were monoclinic-structured polycrystalline CuO with diameter and wall thickness of approximately 100~300 nm and 5~10 nm, respectively. The CuO nanotube sensor showed responses of 136~325% for the $H_2S$ concentration of 0.1~5 ppm at room temperature. These response values are approximately twice as high as that of the CuO nanowire sensor for the same concentrations of $H_2S$ gas. Along with the investigation of the performance of the sensors, the mechanisms of $H_2S$ gas sensing of the CuO nanotubes are also discussed in this study.