• The Journal of the Acoustical Society of Korea
• /
• v.33 no.2
• /
• pp.118-125
• /
• 2014

An approximation of speed of sound in the measurement plane is essential for the inverse estimation of temperature. To this end, an inverse problem relating the measured retarded time data in between set of sensors and actuators array located on the wall is formulated. The involved transfer matrix and its coefficient vectors approximate speed of sound of the measurement plane by using the radial basis function with finite number of interpolation points deployed inside the target field. Then, the temperature field can be reconstructed by using spatial interpolation technique, which can achieve high spatial resolution with proper number of interpolation points. A large number of retarded time data of acoustic paths in between sensors and arrays are needed to obtain accurate reconstruction result. However, the shortage of interpolation points due to practical limitations can cause the decrease of spatial resolution and deterioration of the reconstruction result. In this works, a regeneration for obtaining the additional retarded time data for an arbitrary acoustic path is suggested to overcome the shortage of interpolation points. By applying the regeneration technique, many interpolation points can be deployed inside the field by increasing the number of retarded time data. As a simulation example, two rectangular duct sections having arbitrary temperature distribution are reconstructed by two different data set: measured data only, combination of measured and regenerated data. The result shows a decrease in reconstruction error by 15 % by combining the original and regenerated retarded time data.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.7 no.2
• /
• pp.79-88
• /
• 1987

This study is intended to propose a system reliability analysis model for R.C. bridge superstructures based on the systems reliability theory. Approximately assuming that the ultimate capacity of the superstructures is reached, when two adjacent girders fail subsequently, a practical system reliability model is proposed, which is based on a point estimate for Level II parallel-series system modelling. The sensitivity analysis of system reliabilities for the variation of the coefficients of correlations between the failure modes is performed by applying the proposed model for R.C. T beam bridges. It is observed that the point estimate method for the proposed model corresponds to the average value of the Ditlevsen's bound, and the system reliability index, ${\beta}_s$, varies quite sensitively according to the variation of the cofficients of correlations. Systems reliabilities of a few existing T beam bridges are analyzed by applying the proposed practical system reliability method of this study, and, in addition, the preferable direction of the development of the reliability-based code calibration using the system target reliability index concept are suggested.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.33 no.2
• /
• pp.781-790
• /
• 2013

This research focuses on development of the conceptual cost estimation models for I.L.M box girder bridge. The current conceptual cost estimation for public construction projects is dependent on governmental average unit price references which has been regarded as inaccurate and unreliable by many experts. Therefore, there have been strong demands for developing a better way of conceptual cost estimating methods. This research has proposed three different conceptual cost estimating method for a P.S.C. girder bridge built with the I.L.M method. Model (I) attempts to seek the proper breakdown of standard works that are accountable for more than 95 percentage in total cost and calculates the amount of standard work's materials from the standard section and volume of I.L.M box girder bridge. Model (II) utilizes a correlation analysis (coefficient over 0.6 or more) between breakdown of standard works and input data that would be considered available information in preliminary design phase. Model(III) obtains conceptual estimating through multiple-regression analysis between the breakdown of standard works and all of input data related to them. In order to validate the clustering of coverage in the preliminary design phase, the variation of I.L.M cost coverage from multiple-regression analysis[model(III)] has been investigated which result in between -3.76% and 11.79%, comparing with AACE(Association for the Advancement of Cost Engineering) which informs its variation between -5% and +15% in the design phase. The model proposed from this research are envisioned to be improved to a great distinct if reliable cost date for P.S.C. girder bridges can be continually collected with reasonable accuracies.

• The Korean Journal of Malacology
• /
• v.31 no.2
• /
• pp.123-127
• /
• 2015

${\beta}$-Glucan is a polysaccharide that is widely used as an adductive in fish feed to facilitate immune stimulation. This study aimed to investigate the effect of ${\beta}$-glucan on immune responses in the Manila clam Ruditapes philippinarum. For this purpose, three groups of R. philippinarum were exposed to 0%, 0.1%, or 1% ${\beta}$-glucan in sea water for 1 hr/day for 2 weeks using an immersion method. Thereafter, two immune parameters-phagocytic rate and antibacterial activity-were measured. R. philippinarum exposed to 1% ${\beta}$-glucan showed an approximate 30% significant increase in phagocytic rate. In addition, ${\beta}$-glucan significantly limited the growth of the pathogenic bacteria Vibrio tapetis, V. parahaemolyticus, and V. ordalii. Moreover, the mortality rates of ${\beta}$-glucan-treated clams decreased during a 17-day experiment. Our study suggests that treatment with ${\beta}$-glucan significantly increases the immune responses in R. philippinarum, and that immersion is a simple and effective method for immune stimulation in this species.

• Journal of the Korean Geophysical Society
• /
• v.8 no.1
• /
• pp.45-48
• /
• 2005

In order to investigate the velocity structure of the southern part of the Korean peninsula, exploded seismic signals were recorded for 120 s along a 294-km WNW-ESE line and 150 s along a 335-km NNW-SSE line in 2002 and 2004, respectively. Velocity tomograms were derived from inverting first arrival times. One-dimensional velocity models derived by joint analyses of teleseismic receiver functions and surface wave dispersion at several stations near the profiles were uesd to build initial models. The raypaths indicate several midcrust interfaces including ones at approximate depths of 2.0 and 14.9 km with refraction velocities of approximately 6.0 and 7.1 km/s, respectively. The deepest significant interface varies in depth from 30.8 km to 36.1 km. The critically refracting velocity varies from 7.8 to 8.1 km/s along this interface which may correspond to the Moho discontinuity. The velocity tomograms show (1) existence of a low-velocity zone centered at 6-7 km depth under the Okchon fold belt, (2) extension of the Yeongdon fault down to greater than 10 km, and (3) existence of high-velocity materials under the Gyeongsan basin whose thickness is less than 4.2 km.

• Journal of the Korean Geophysical Society
• /
• v.8 no.1
• /
• pp.15-21
• /
• 2005

The apparent source spectrum of the Fukuoka earthquake is estimated at the seismic basement by removing from the observed spectra at Korean seismic stations the path and site responses that were previously revealed through inversion process applied to large spectral D/B accumulated until 2004. The approximate source spectrum is also estimated by using data recorded near the epicenter from various Japanese seismic networks and compared with the Korean source spectrum. The comparison result shows that there is good agreement among source spectra estimated based on the data from seismic networks of Korea at large distances (190 km

• Geophysics and Geophysical Exploration
• /
• v.11 no.2
• /
• pp.137-147
• /
• 2008

Fault rupture directivity of the Odaesan earthquake, which was inferred to be the main cause of the high PGAvalue (> 0.1 g) unusually observed at the near-source region, was analyzed by using the data from the nearby (R < 100 km) dense seismic stations. The Boatwright's method (2007) was adopted for this purpose in which the azimuth and takeoff angle of the unilateral rupture directivity function could be estimated based on the relative peak ground-motions of seismic stations resulting from the nature of the rupture directivity. In this study, the approximate values of the relative peak ground-motions was derived from the difference between the log residuals of the point-source spectral model (Boore, 2003) for the main and secondary events based on the Random Vibration Theory. In this derivation, the spectral difference for a frequency range between the source corner frequencies of main and secondary events was considered to reflect only the effect of the fault directivity. The inversion result of the model parameters for the fault directivity function showed that the fault-plane of NWW-SEE direction dipping steeply to the North with high rupture velocity near upward in SE direction is responsible for the observed high level of ground-motion at the near-source region.

• Journal of Sasang Constitutional Medicine
• /
• v.26 no.4
• /
• pp.365-378
• /
• 2014

Objectives This study was performed to investigate the cut-off values of abdominal circumference and Body Mass Index(BMI) according to Sasang Constitution. Methods A total of 1,773 persons, namely 440 male people and 1,333 female people, in ages from 40 to 69 years old, participated in this research. They are all included in the community based Genomic cohort in Wonju in years from 2006 to 2013. The diagnostic criteria of metabolic syndrome was used followed by the National Cholesterol Education Program in Adult Treatment Panel III (NCEP ATP III) and Asian pacific guideline for only abdominal obesity. Results The prevalence of metabolic syndrome was 34.8% for men and 37.6% for women in this research. Taeeumin was the highly significant risk type for the metabolic syndrome in both sexes. Cut-off values of abdominal circumference were 88.3 cm in men, 80.3 cm in women, and cut-off values of BMI were $24.2kg/m^2$ in men and $25.3kg/m^2$ in women. For men, cut-off values of abdominal circumference were 79.5cm in Soyangin, 88.8 cm in Taeeumin and 79.5 cm in Soeumin, and cut-off values of BMI were $23.2kg/m^2$ in Soyangin, $25.6kg/m^2$ in Taeeumin and $20.6kg/m^2$ in Soeumin. For women, cut-off values of abdominal circumference were 76.3 cm in Soyangin, 80.3 cm in Taeeumin and 76.8 cm in Soeumin, and cut-off values of BMI were $22.4kg/m^2$ in Soyangin, $24.9kg/m^2$ in Taeeumin and $21.3kg/m^2$ in Soeumin. Conclusions Although 90 cm in men, 80 cm in women as an Asian pacific guideline were regarded as quite approximate to the mean value of abdominal circumference and $25kg/m^2$ to BMI. But if the results could be allocated in terms of the Sasang constitutional method, the cut-off values for Soyangin and Soeumin should be lowered than now.

• Food Science and Preservation
• /
• v.9 no.4
• /
• pp.400-405
• /
• 2002

Herbs are widely used as a source of tea and otherwise such as botanical medicine, essential oil for perfumes, cosmetics, and food spices. This study was carried out to investigate the characteristics of herb tea prepared with lavender, rosemary, mint, thyme and sage cultivated in korea. Approximate composition were as follows : crude protein 1.4∼17.5%, crude fat 6.1∼15.8%, sugars 43.5∼61s%, crude ash 7.7∼10.7%. Minerals contents of Ca ranged 707∼1763mg%, P 234 ∼513mg%, K 2,391∼3,430mg%, and Mg 361∼573mg%. Vitamins were $\beta$ -Carotene 6.9∼27.7mg%, B$_1$, 0.34∼0.62mg%, B$_2$1.37 ∼2.52mg%, niacin 5.3∼8.8mg%, and C 102∼111mg%. The changes of chromaticity a and b, pH, and sugar content of the herb tea at the different temperatures were decreased 80$\^{C}$ and 100$\^{C}$ in comparison to 60$\^{C}$ but increased chromaticity L. In the result of sensory test of the processed herb tea was more preferred than the market goods.

• Journal of the Computational Structural Engineering Institute of Korea
• /
• v.20 no.6
• /
• pp.751-759
• /
• 2007

We have developed several methods for the optimization problem having large-scale and highly nonlinear system. First, step by step method in optimization process was employed to improve the convergence. In addition, techniques of furnishing good initial guesses for analysis using sensitivity information acquired from optimization iteration, and of manipulating analysis/optimization convergency criterion motivated from simultaneous technique were used. We applied them to flow control problem and verified their efficiency and robustness. However, they are based on quasi-Newton method that approximate the Hessian matrix using exact first derivatives. However solution of the Navier-Stokes equations are very cost, so we want to improve the efficiency of the optimization algorithm as much as possible. Thus we develop a true Newton method that uses exact Hessian matrix. And we apply that to the three-dimensional problem of flow around a sphere. This problem is certainly intractable with existing methods for optimal flow control. However, we can attack such problems with the methods that we developed previously and true Newton method.