• Structural Engineering and Mechanics
• /
• v.31 no.4
• /
• pp.371-382
• /
• 2009

The concrete plates are most widely used structural elements in the hulls of floating concrete structures such as concrete barges and pontoons, bridge decks, basement floors and liquid storage tanks. The study on the behavior of high-strength fiber reinforced concrete (HSFRC) plates was carried out to evaluate the performance of plates under in-plane and transverse loads. The plates were tested in simply supported along all the four edges and subjected to in-plane and traverse loads. In this experimental program, twenty four 150 mm diameter cylinders and twelve plate elements of size $600{\times}600{\times}30$ mm were prepared and tested. Water-to-cementitious materials ratios of 0.3 and 0.4 with 10% and 15% silica fume replacements were used in the concrete mixes. The fiber volume fractions, $V_f$ = 0%, 1% and 1.5% with an aspect ratio of 80 were used in this study. The HSFRC mixes had the concrete compressive strengths in the range of 52.5 to 70 MPa, flexural strengths ranging from 6.21 to 11.08 MPa and static modulus of elasticity ranging from 29.68 to 36.79 GPa. In this study, the behavior of HSFRC plate elements subjected to combined uniaxial in-plane and transverse loads was investigated.

• Nuclear Engineering and Technology
• /
• v.49 no.4
• /
• pp.663-667
• /
• 2017

Delayed hydride cracking (DHC) was first observed in pressure tubes in Canadian CANDU reactors. In light water reactors, DHC was not observed until the late 1990s in high-burnup boiling water reactor (BWR) fuel cladding. In recent years, the focus on DHC has resurfaced in light of the increased interest in the cladding integrity during interim conditions. In principle, all spent fuel in the wet pools has sufficient hydrogen content for DHC to operate below $300^{\circ}C$. It is therefore of importance to establish the critical parameters for DHC to operate. This work studies the threshold stress intensity factor ($K_{IH}$) to initiate DHC as a function of temperature in Zry-4 for temperatures between $227^{\circ}C$ and $315^{\circ}C$. The experimental technique used in this study was the pin-loading testing technique. To determine the $K_{IH}$, an unloading method was used where the load was successively reduced in a stepwise manner until no cracking was observed during 24 hours. The results showed that there was moderate temperature behavior at lower temperatures. Around $300^{\circ}C$, there was a sharp increase in $K_{IH}$ indicating the upper temperature limit for DHC. The value for $K_{IH}$ at $227^{\circ}C$ was determined to be $2.6{\pm}0.3MPa$ ${\surd}$m.

• Journal of Ginseng Research
• /
• v.44 no.2
• /
• pp.179-193
• /
• 2020

Ginseng products on the market show high variability in their composition and overall quality. This becomes a challenge for both consumers and health-care professionals who are in search of high-quality, reliable ginseng products that have a proven safety and efficacy profile. The botanical extract standardization is of crucial importance in this context as it determines the reproducibility of the quality of the product that is essential for the evaluation of effectiveness and safety. This review focuses on the well-characterized and standardized ginseng extract, G115, which represents an excellent example of an herbal drug preparation with constant safety and efficacy within the herbal medicinal products. Over the many decades, extensive preclinical and clinical research has been conducted to evaluate the efficacy and safety of G115. In vitro and in vivo studies of G115 have shown pharmacological effects on physical performance, cognitive function, metabolism, and the immune system. Furthermore, a significant number of G115 clinical studies, most of them double-blind placebo-controlled, have reinforced the findings of preclinical evidence and proved the efficacy of this extract on blood glucose and lipid regulation, chronic obstructive pulmonary disease, energy, physical performance, and immune and cognitive functions. Clinical trials and 50 years of presence on the market are proof of a good safety profile of G115.

• Korean Journal of Materials Research
• /
• v.26 no.3
• /
• pp.123-129
• /
• 2016

The morphology, crystal structure and size of aerosol nanoparticles generated by erosion of electrodes made of different materials (titanium, copper and aluminum) in a multi-spark discharge generator were investigated. The aerosol nanoparticle synthesis was carried out in air atmosphere at a capacitor stored energy of 6 J, a repetition rate of discharge of 0.5 Hz and a gas flow velocity of 5.4 m/s. The aerosol nanoparticles were generated in the form of oxides and had various morphologies: agglomerates of primary particles of $TiO_2$ and $Al_2O_3$ or aggregates of primary particles of $Cu_2O$. The average size of the primary nanoparticles ranged between 6.3 and 7.4 nm for the three substances studied. The average size of the agglomerates and aggregates varied in a wide interval from 24.6 nm for $Cu_2O$ to 46.1 nm for $Al_2O_3$.

• School Mathematics
• /
• v.12 no.1
• /
• pp.1-15
• /
• 2010

The study presented in this paper, which serves as a pilot study for a future comprehensive project, was to investigate how students deal with the concepts of infinity and limit. Based on the communicational approach to cognition, according to which mathematics is a kind of discourse, we tried to identify the characteristics of students' discourse on the topics. Four American and four Korean students were interviewed in English on limits and infinity and their discourse was scrutinized with an eye to common characteristics as well as culture, age, and education-related differences.

• Journal of Electrical Engineering and Technology
• /
• v.8 no.4
• /
• pp.760-765
• /
• 2013

An Interline Power Flow Controller (IPFC) is a converter based controller which compensates and balance the power flow among multi-lines within the same corridor of the multi-line subsystem. The Interline Power Flow Controller consists of a voltage source converter based Flexible AC Transmission System (FACTS) controller for series compensation. The reactive voltage injected by individual Voltage Source Converter (VSC) can be controlled to regulate active power flow in the respective line in which one VSC regulates the DC voltage, the other one controls the reactive power flows in the lines by injecting series active voltage. In this paper, a circuit model for IPFC is developed and simulation of interline power flow controller is done using the proposed circuit model. Simulation is done using MATLAB Simulink and PSPICE. The results obtained by MATLAB are compared with the results obtained by PSPICE and compared with theoretical values.

• Journal of Electrical Engineering and Technology
• /
• v.13 no.3
• /
• pp.1337-1345
• /
• 2018

The reliability of power transmission and distribution depends up on the consistency of insulation in the high voltage power transformer. In recent times, considering the drawbacks of conventional mineral oils such as poor biodegradability and poor fire safety level, several research works are being carried out on natural ester based nanofluids. Earlier research works show that sunflower oil has similar dielectric characteristics compared with mineral oil. BIOTEMP oil which is now commercially available in the market for transformers is based on sunflower oil. Addition of nanofillers in the base oil improves the dielectric characteristics of liquid insulation. Only few results are available in the literature about the insulation characteristics of nano modified natural esters. Hence understanding the influence of addition of nanofillers in the dielectric properties of sunflower oil and collecting the database is important. Considering these facts, present work contributes to investigate the important characteristics such as partial discharge, lightning impulse, breakdown strength, tandelta, volume resistivity, viscosity and thermal characteristics of $SiO_2$ nano modified sunflower oil with different wt% concentration of nano filler material varied from 0.01wt% to 0.1wt%. From the obtained results, nano modified sunflower oil shows better performance than virgin sunflower oil and hence it may be a suitable candidate for power transformer applications.

• Journal of Electrical Engineering and Technology
• /
• v.11 no.4
• /
• pp.951-960
• /
• 2016

Tower insulators in electric power transmission network play a crucial role in preserving the reliability of the system. Electrical utilities frequently face the problem of flashover of insulators due to pollution deposition on their surface. Several research works based on leakage current (LC) measurement has been already carried out in developing diagnostic techniques for these insulators. Since the LC signal is highly intermittent in nature, estimation of pollution severity based on LC signal measurement over a short period of time will not produce accurate results. Reports on the measurement and analysis of LC signals over a long period of time is scanty. This paper attempts to use Random Forest (RF) classifier, which produces accurate results on large data bases, to analyze the pollution severity of high voltage tower insulators. Leakage current characteristics over a long period of time were measured in the laboratory on porcelain insulator. Pollution experiments were conducted at 11 kV AC voltage. Time domain analysis and wavelet transform technique were used to extract both basic features and histogram features of the LC signal. RF model was trained and tested with a variety of LC signals measured over a lengthy period of time and it is noticed that the proposed RF model based pollution severity classifier is efficient and will be helpful to electrical utilities for real time implementation.

• Safety and Health at Work
• /
• v.2 no.2
• /
• pp.194-200
• /
• 2011

Objectives: Stressors in nursing put high demands on cognitive control and, therefore, may increase the risk of cognitive failures that put patients at risk. Task-related stressors were expected to be positively associated with cognitive failure at work and job control was expected to be negatively associated with cognitive failure at work. Methods: Ninety-six registered nurses from 11 Swiss hospitals were investigated (89 women, 7 men, mean age = 36 years, standard deviation = 12 years, 80% supervisors, response rate 48%). A new German version of the Workplace Cognitive Failure Scale (WCFS) was employed to assess failure in memory function, failure in attention regulation, and failure in action exertion. In linear regression analyses, WCFS was related to work characteristics, neuroticism, and conscientiousness. Results: The German WCFS was valid and reliable. The factorial structure of the original WCF could be replicated. Multilevel regression task-related stressors and conscientiousness were significantly related to attention control and action exertion. Conclusion: The study sheds light on the association between job characteristics and work-related cognitive failure. These associations were unique, i.e. associations were shown even when individual differences in conscientiousness and neuroticism were controlled for. A job redesign in nursing should address task stressors.

• Nutrition Research and Practice
• /
• v.2 no.2
• /
• pp.93-99
• /
• 2008

A community-based longitudinal study was conducted in the Manya Krobo District of the Eastern Region of Ghana with the objective of assessing how caregiving practices influence nutritional status of young children in Ghana. The study subjects were one hundred mothers with infants between the ages of 6 and 12 months. Each child was visited at home monthly for a period of six months. On each visit, information was collected on caregiver household and personal hygiene, child's immunization status, child's dietary diversity, caregiver responsiveness during feeding, caregiver hygienic practices related to feeding and child's weight and length. At the end of the study, summary scores were generated for each variable and quality of care practice determined based on their distribution. Classification of child nutritional status was based on z-scores for both weight-for-age and length-for-age. The results revealed that caregivers who exhibited better quality of care practice had well-nourished children. Such caregivers were more likely to practice good household and personal hygiene than those of poorly nourished children (97.1% vs 31.8%, p<0.001). They were also more likely to complete their children's immunization schedules (88.2% vs 62.2%, p<0.001), provide good quality diets from highly diversified sources (79% vs 23%, p<0.001), exhibit high responsiveness during feeding (100% vs 22.7%, p<0.001) and feed under hygienic conditions (100% vs 22.7%, p<0.001). Based on the findings it was concluded that good caregiving practices are associated with improved child nutritional status.