• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.33 no.4A
• /
• pp.440-449
• /
• 2008

In this paper, we propose a 16-QAM carrier recovery loop which is suitable for the implementation of Inmarsat M4 system receiver. Because the frequency offset of ${\pm}924\;Hz$ on signal bandwidth 33.6 kHz is recommended in Inmarsat M4 system specification, carrier recovery loop having stable operation in the channel environment with large relative frequency offset is required. the carrier recovery loop which adopts only PLL can't be stable in relatively large frequency offset environment. Therefore, we propose a carrier recovery loop which has stable operation in large relative frequency offset environment for Inmarsat M4 system. The proposed carrier recovery loop employed differential filter-based noncoherent UW detector which is robust to frequency offset, CP-AFC for initial frequency offset acquisition using UW signal, and 16-QAM DD-PLL for phase tracking using data signal to overcome large relative frequency offset and achieve stable carrier recovery performance. Simulation results show that the proposed carrier recovery loop has stable operation and satisfactory performance in large relative frequency offset environment for Inmarsat M4 system.

• Journal of the Korean Society of Clothing and Textiles
• /
• v.18 no.5
• /
• pp.595-601
• /
• 1994

This study was accomplished to investigate drape coefficient and wrinkle recovery of brushed fabrics according to treatment processes and brushing conditions. For this study, grey fabrics of blended ratio of polyester 65% : cotton 35% were bleached and dyed. These fabrics were then brushed 1, 3, 5 and 7 times. Drape coefficient and wrinkle recovery of brushed fabrics were measured by drape tester and shirley crease recovery tester respectively. The experimental results were analysed statistically to relate mechanical properties, handle, drapability, and wrinkle recovery 1) Drape coefficients of dyed fabric showed lower values and wrinkle recovery showed higher ones than those of bleached and dyed fabrics. Especially dyed fabric brushed 3 times showed good appearance and form stability. 2) Considering the blocked properties that contribute to the drape coefficient and wrinkle recovery of brushed fabrics, bending and shearing properties had a high degree of correlation with brushed fabrics, and 2HB/W showed a high positive correlation with drape coefficient and a high negative correlation with wrinkle recovery.

• Korean Journal of Social Welfare
• /
• v.60 no.4
• /
• pp.175-203
• /
• 2008

It has been well known and empirically supported that many persons with psychiatric disabilities experience recovery in the community. The sense of recovery is experienced while they recognize and manage mental illness and cope with everyday life utilizing personal and social resources. In order to explore ways in which the sense of recovery is enhanced, this study investigated the structure of relationships among the mental health state, optimism, positive emotions, quantity and quality of the social relationships, coping, and recovery of 460 persons with psychiatric disabilities through structural equation modeling. Of findings, first, in the results of path estimates of measurement and theoretical model, especially optimism and positive emotions demonstrated significant effects on the social relationship, coping, and the recovery, while, by contraries, positive emotions showed no significant direct effects on coping, neither the social relationships did on the recovery. Second, on the recovery optimism and positive emotions had direct effects, while quantity and quality of the social relationships had only indirect effects. It is particularly noted that positive emotions showed stronger effects on the recovery than optimism, and also had direct and indirect effects on the social relationships. Finally, partial mediating effects of coping were found between optimism and the recovery, between quality of the social relationships and recovery, and between quantity and quality of the social relationships; another partial mediating effects of quality of social relationships between quantity of social relationships and coping, and between positive emotions and coping; and the last same effects of quantity of the social relationships between positive emotions and coping. According to these results, discussions and implications for social work practice and practice research were suggested regarding the differential effects of positive cognitions and emotions on the recovery and different mechanisms of the quality and quantity of the social relationships, and the relationships among the resources, coping, and the recovery of persons with psychiatric disabilities.

• Proceedings of the IEEK Conference
• /
• 1998.10a
• /
• pp.179-182
• /
• 1998

Carrier recovery, the process of recoverying the carrier in receiver, removes the phase difference between VCO and the received signal. However, the conventional structure of carrier recovery cannot be applied to multi-level QAM demodulator because of the increasing decision interval and the complexity of control as the number of symbol increases. In this paper, we suggest a new carrier recovery algorithm using $\theta-matching$ algorithm for multi-level QAM demodulation to overcome this problem and analysis the performance and implement it.

• Journal of Distribution Science
• /
• v.13 no.2
• /
• pp.63-73
• /
• 2015

Purpose - Satisfaction with service is evaluated according to customers' subjective judgment. The expected value of customer service and its evaluations depend on the customers' position. The customer recognizes two different forms of service levels. One is satisfaction and the other is dissatisfaction. Customers who are satisfied want to receive the service in future. However, those dissatisfied try to change the service. The service provider tries to improve the service. There are two different service cycles. One is the successful cycle and the other is the failure cycle. This study aimed to empirically determine the effects of the justice and authenticity of service recovery on customer behavioral intention through an integrated approach to cognitive justice and psychological authenticity. Research design, data, and methodology - Based on a literature review, justice of service recovery was categorized into three types: distributive, procedural, and interactive. Then, authenticity was added to obtain four independent variables, along with recovery satisfaction as a parameter. Behavioral intention, as an outcome variable, was divided into the repurchase intention and positive word-of-mouth. The model and hypotheses were created and measurement items were developed. A questionnaire survey of items concerning the service recovery experience at family restaurants was conducted on college students and residents in Gwangju from September 30 to October 31, 2013. A total of 400 copies of the questionnaire were sent out and 385 were returned. Respondents answered questions about the importance of, and satisfaction with service recovery on a 5-point Likert scale. Excluding 174 copies without service failure experiences and 7 inappropriate copies, 204 copies were analyzed using SPSS 21.0 for Windows and AMOS 20.0 to determine the reliability and validity of measurements. The hypotheses were tested through a goodness-of-fit analysis. Results - First, distributive justice positively affected recovery satisfaction. Second, procedural and interactive justice had no impact. Third, authenticity positively affected recovery satisfaction. Fourth, distributive justice had relatively stronger effects on recovery satisfaction than authenticity. Fifth, recovery satisfaction significantly affected repurchase intention and positive word-of-mouth and it proved effective in mediation. Finally, additional analysis was performed for descriptive statistics of the principal variables by various demographic characteristics and significant differences were found in gender, occupation, and so on. Conclusions - This study has academic significance as the fairness and authenticity of service recovery were investigated to reveal the effects on behavior. The findings could be applied to a wide range of service recovery strategies. However, there are some limitations. First, data was collected only from the residents of Gwangju and most respondents were aged 20-30. Future studies should target a wide range of areas and age groups. Second, because the questionnaire used in this study targets only convenience family restaurants, the results of this study cannot be generalized to all services companies. Future research should be done on a wide range of industries such as hotels, airlines, and hospitals, and perform a comparison between sectors.

• 한국정보통신설비학회:학술대회논문집
• /
• 2009.08a
• /
• pp.285-288
• /
• 2009

The emergency recovery scheme in time of a disaster or accident up to now has been focused on how to build a backup for the public service or communication network in national scale, also, all the mobile operators have done as recovery scheme for the equipment failure in their network was to make a backup copy of billing data or package data, and they have usually studied only on the backup and failure recovery scheme in the circuit-switched network. However, since it has become more probable recently that a disaster or accident could occur in the switching office buildings, a recovery scheme in time of the failure of these entire switching offices became necessary. The purpose of this paper is to propose various recovery schemes, and by having checkups on many issues that could arise while carrying out these schemes, it presents the best solution for each issue. Moreover, it presents the future tasks that need to be studied as well as initial study directions.

• Journal of Power Electronics
• /
• v.6 no.3
• /
• pp.205-213
• /
• 2006

A cost-effective magnetic-coupled AC-PDP sustain driver with low switching loss is proposed. The transformer reduces current stress in the energy recovery switches which affects circuit cost and reliability. The turns-ratio can be used to adjust the sustain pulse slopes which affect gas discharge uniformity. Dividing the recovery paths prevents abrupt changes in the output capacitance and thereby switching losses of the recovery switches is reduced. In addition, the proposed circuit has a more simple structure because it does not use the recovery path diodes which also afford a large recovery current. By reducing the current stress and device count in the energy recovery circuit, the proposed driver may have decreased circuit cost and improved circuit reliability.

• Journal of the Korean Society for Marine Environment & Energy
• /
• v.6 no.4
• /
• pp.52-66
• /
• 2003

Generally we have difficulty in removing oil using mechanical devices because recovery rate and recovery efficiency decrease remarkably when operating in thin oil films or in oils of very high viscosity In the Present study a series of experiments were carried out to study the effect of operating conditions on the rate of recovery for the spilled oil using a drum type skimmer. For each set of experiments depth of immersion, oil film thickness and the circumferential speeds were varied systematically to find the effects on the recovery rate. The results shows that recovery rate is dependent on the contact angle for the depth of immersion and the highest rate of oil recovery shows in the case of a contact angle of 45°(h/d=0.15). For the removal of spilled oil the optimal circumferential speed can be found as the critical value to reach the saturated recovery rate for a given oil film thickness and depth of immersion. Even in thin oil thickness we have enough recovery rate and recovery efficiency within critical circumferential speed this way.

• Journal of Astronomy and Space Sciences
• /
• v.34 no.4
• /
• pp.331-342
• /
• 2017

To ensure the successful launch of the Korea pathfinder lunar orbiter (KPLO) mission, the Korea Aerospace Research Institute (KARI) is now performing extensive trajectory design and analysis studies. From the trajectory design perspective, it is crucial to prepare contingency trajectory options for the failure of the first lunar brake or the failure of the first lunar orbit insertion (LOI) maneuver. As part of the early phase trajectory design and analysis activities, the required time of flight (TOF) and associated delta-V magnitudes for each recovery maneuver (RM) to recover the KPLO mission trajectory are analyzed. There are two typical trajectory recovery options, direct recovery and low energy recovery. The current work is focused on the direct recovery option. Results indicate that a quicker execution of the first RM after the failure of the first LOI plays a significant role in saving the magnitudes of the RMs. Under the conditions of the extremely tight delta-V budget that is currently allocated for the KPLO mission, it is found that the recovery of the KPLO without altering the originally planned mission orbit (a 100 km circular orbit) cannot be achieved via direct recovery options. However, feasible recovery options are suggested within the boundaries of the currently planned delta-V budget. By changing the shape and orientation of the recovered final mission orbit, it is expected that the KPLO mission may partially pursue its scientific mission after successful recovery, though it will be limited.

• Journal of the Korean Society of Clothing and Textiles
• /
• v.23 no.1
• /
• pp.22-29
• /
• 1999

This paper descrived the changes of peel strength wrinkle recovery and dimensional stability after fusing 4 different wool face fabrics with 3 different fusible interlinings. The fusing condition was conducted by fusing press machine under 4kg.f/cm2 at 15$0^{\circ}C$. To determine the effect of the varous physical properties of the fused fabrics face fabrics and interlinings on the peel strength wrinkle recovery and dimensional stability(hygral expansion and relaxation shrinkage) of fused fabrics correlation among the KES values of fused fabrics face fabrics and interlinings to the peel strength rinkle recovery and dimensional stability of fused fabrics were expeerimentally analyzed,. As the results the peel strength was mainly influenced by the cover factor of face fabric and interlinings. After fusing wrinkle recovery and hygral expansion were decreased. The cover factor wrinkle recovery weight thickness shear rigidity and frictional properties of face fabric and the thickness of fused fabrics were not influence to the wrinkle recovery of fused fabrics. In addition the dimensional stabilities of fused fabrics were mainly influenced by the tensile and frictional properties of the wrinkle recovery of fused fabrics. In addition the dimensional stabilities of fused fabrics were mainly influenced by the tensile and frictional properties of the face fabrics.