• BMB Reports
• /
• 제37권1호
• /
• pp.59-74
• /
• 2004

The study of whole patterns of changes in protein expression and their modifications, or proteomics, presents both technological advances as well as formidable challenges to biological researchers. Nutrition research and the food sciences in general will be strongly influenced by the new knowledge generated by the proteomics approach. This review examines the different aspects of proteomics technologies, while emphasizing the value of consideration of "traditional" aspects of protein separation. These include the choice of the cell, the subcellular fraction, and the isolation and purification of the relevant protein fraction (if known) by protein chromatographic procedures. Qualitative and quantitative analyses of proteins and their peptides formed by proteolytic hydrolysis have been substantially enhanced by the development of mass spectrometry technologies in combination with nanoscale fluidics analysis. These are described, as are the pros and cons of each method in current use.

• Journal of Power Electronics
• /
• 제14권6호
• /
• pp.1281-1292
• /
• 2014

Photovoltaic (PV) solar systems with series-connected module integrated converters (MICs) are receiving increased attention because of their ability to create high output voltage while performing local maximum power point tracking (MPPT) control for individual solar panels, which is a solution for partial shading effects in PV systems at panel level. To eliminate the partial shading effects in PV system more effectively, sub-MICs are utilized at the cell level or grouped cell level within a PV solar panel. This study presents the results of a series-output-connection MPPT (SOC-MPPT) controller for sub-MIC architecture using a single sensor at the output and a single digital MPPT controller (sub-MIC SOC-MPPT controller and architecture). The sub-MIC SOC-MPPT controller and architecture are investigated based on boost type sub-MICs. Experimental results under steady-state and transient conditions are presented to verify the performance of the controller and the effectiveness of the architecture.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• 제8권6호
• /
• pp.1982-2004
• /
• 2014

Wireless Mesh Networks (WMNs) are emerging as promising, convenient next generation wireless network technology. There is a great need for a secure framework for routing in WMNs and several research studies have proposed secure versions of the default routing protocol of WMNs. In this paper, we propose a security framework for Hybrid Wireless Mesh Protocol (HWMP) in WMNs. Contrary to existing schemes, our proposed framework ensures both end-to-end and point-to-point authentication and integrity to both mutable and non-mutable fields of routing frames by adding message extension fields to the HWMP path selection frame elements. Security analysis and simulation results show that the proposed approach performs significantly well in spite of the cryptographic computations involved in routing.

• Structural Engineering and Mechanics
• /
• 제6권1호
• /
• pp.95-113
• /
• 1998

The extensive use of honeycomb sandwich structures has led to the need to understand and analyze their low velocity impact response. Commercially available finite element software provides a possible analysis tool for this type of problem, but the validity of their material properties models for honeycomb materials must be investigated. Three different problems that focus on the effect of differences in honeycomb material properties on static and dynamic response are presented and discussed. The first problem considered is a linear elastic static analysis of honeycomb sandwich beams. The second is a nonlinear elastic-plastic analysis of a circular honeycomb sandwich plate. The final problem is a dynamic analysis of circular honeycomb sandwich plates impacted by low velocity projectiles. Results are obtained using the ABAQUS final element code and compared against experimental results. The comparison indicates that currently available material properties models for honeycomb materials can be used to obtain a good approximation of the behavior of honeycomb sandwich structures under static and dynamic loading conditions.

• 한국정보통신학회:학술대회논문집
• /
• 한국해양정보통신학회 2011년도 추계학술대회
• /
• pp.882-885
• /
• 2011

This paper presents testing and self-calibration of RF circuits using MEMS switches to identify process-related defects and out of specification circuits. We have developed a novel multi-tone dither test technique where the test stimulus is generated by modulating the RF carrier signal with a multi-tone signal generated using an Arbitrary Waveform Generator (AWG) with additive white Gaussian noise. This test stimulus is provided as input to the RF circuit and peak-to-average ratio (PAR) is measured at the output. For a faulty circuit, a significant difference is observed in the value of PAR as compared to a fault-free circuit. Simulation is performed for various circuit conditions such as fault-free as well as fault-induced and their corresponding PARs are stored in the look-up table. This testing and self-calibration technique is exhaustive and efficient for present-day communication systems.

• ALGAE
• /
• 제33권3호
• /
• pp.215-229
• /
• 2018

In this study, the phylogenetic relationships among the genera Alsidium C. Agardh and Bryothamnion $K{\ddot{u}}tzing$ were investigated. Phylogenetic analyses using the plastid-encoded markers rbcL, psbA, and the mitochondrial barcode region (COI-5P) resolved a well-supported clade that included the species Alsidium corallinum, Bryothamnion seaforthii, and B. triquetrum. Our results indicated that taxonomic recognition of the genus Bryothamnion is not supported and two species of Bryothamnion are reallocated to Alsidium. A reexamination of the morphological definition of Alsidium is provided with an updated diagnosis of the genus and a morphology-based comparison of species that are currently circumscribed under this generic name. Furthermore, we reviewed morphological differences and similarities between Alsidium and the genus Digenea, both belonging to the tribe Alsidieae, discussing the most relevant morphological characters.

• Computers and Concrete
• /
• 제7권2호
• /
• pp.145-158
• /
• 2010

In this work the implementation of a production-level port of the Microplane constitutive model for concrete into the EPIC code is described. The port follows guidelines outlined in the Material Model Module (MMM) standard used in EPIC to insure a seamless interface with the existing code. Certain features of the model were not implemented using the MMM interface due to compatibility reasons; for example, a separate module was developed to initialize, store and update internal state variables. Objective strain and deformation measures for use in the material model were also implemented into the code. Example calculations were performed and illustrate the veracity of this new implementation.

• 대한수학회논문집
• /
• 제34권2호
• /
• pp.375-381
• /
• 2019

In this paper, we introduce an operation denoted by [$Br_e$], a bracket operation, which maps an arbitrary groupoid ($X,{\ast}$) on a set X to another groupoid $(X,{\bullet})=[Br_e](X,{\ast})$ which on groups corresponds to sending a pair of elements (x, y) of X to its commutator $xyx^{-1}y^{-1}$. When applied to classes such as d-algebras, BCK-algebras, a variety of results is obtained indicating that this construction is more generally useful than merely for groups where it is of fundamental importance.

• 국제학술발표논문집
• /
• The 3th International Conference on Construction Engineering and Project Management
• /
• pp.1000-1014
• /
• 2009

Research sponsored by the Korean Government investigated the establishment of a risk management process by Korean contractors involved with plant projects in the Middle East. This research effort builds upon the work completed by the Construction Industry Institute (CII), called the International Project Risk Assessment (IPRA) tool and method, and also explored how CII's Project Definition Rating Index (PDRI) could be incorporated to improve project planning by addressing risks and scope development issues. Specific findings and recommendations were developed including the creation of the Contractor Critical Areas of Concern (CCAC) risk screening tool for Korean contractors pursuing Middle East oil and gas projects.

• 한국미생물학회:학술대회논문집
• /
• 한국미생물학회 1997년도 제37회 춘계학술발표대회
• /
• pp.63-63
• /
• 1997