• 분석과학
• /
• 제36권4호
• /
• pp.161-169
• /
• 2023

In this study, a straightforward and precise nitrogen/sulphur-codoped carbon dots (N/S-CD) was produced using a microwave irradiation approach. The N/S-CD was formulated from succinic acid (SA), bis-(3-aminopropyl)-amine (BAPA), and sodium thiosulphate (STS) as sources of carbon, nitrogen, and sulphur, respectively. The synthesized N/S-CD established a valuable quantum yield (QY) of 70 % and was sensitive to aluminium ion (Al³⁺) with a detection limit of 0.21 µM and a linear concentration range of 0-100 µM. When detecting Al³⁺ in real water samples, the N/S-CD resulted in a satisfactory recovery in the range of 91.14 %-103.37 %. Thus, the proposed study is very promising for Al³⁺ detection in environmental water samples.

• Bulletin of the Korean Chemical Society
• /
• 제34권9호
• /
• pp.2691-2696
• /
• 2013

The electronic cigarette (E-cigarette) is a battery-powered device that aerosolizes nicotine so that it is readily delivered into the respiratory tract. The analytical data regarding the substances present in E-cigarettes are very limited. The aim of this study was to measure the concentration of aldehydes-formaldehyde (FA), acetaldehyde (AA) and, acrolein (AL)-in 225 replacement liquid brands from 17 E-cigarette shops sold in the Republic of Korea by headspace solid-phase micro extraction and gas chromatography-mass spectrometry (HS-SPME GC-MS). The concentration range of FA and AA was 0.02-10.09 mg/L (mean = 2.16 mg/L, detected in 207 of 225 samples) and 0.10-15.63 mg/L (mean = 4.98 mg/L, detected in all samples), respectively. AL was not detected in any of 225 replacement liquids. FA and AA were originally present in almost all replacement liquids of electronic cigarettes.

• 한국해양공학회지
• /
• 제11권2호
• /
• pp.57-69
• /
• 1997

The objetive of this study is to compare the mechanical proprties of 6000 series Al-Mg-Si aluminum alloy (AC120) with 5000 series Al-Mg aluminum alloy (TG25), and to investigate the influence of corrosion solution for fatigue life. Comparing of TG25 and AC120 alloy sheets, TG25 alloy sheets showing higher plastic ratio and total elongation have better formability than AC120 alloy sheets. The hardness of nugget area was a little higher than that of base metal area. Also, grain coarsening was observed in HAZ(Heat Affected Zone). In a corrosion fatigue experiment, the fatigue life decreased as concentration increased, when a dipping time was constant. The life decreased as dippling time increased, when a concentration was constant.

• 한국염색가공학회지
• /
• 제18권5호
• /
• pp.22-29
• /
• 2006

The purpose of this study was to investigate the dyeability and antibacterial activity on wool fabric dyed with cochineal at variable dyeing conditions. Al, Cr, Fe, Cu and Sn were used as mordants and adsorption was compared with different mordanting methods. The optimum dyeing conditions of wool fabrics were dyeing concentration 2.0%(o.w.s), dyeing temperature $60^{\circ}C$, pH 3 and dyeing time 30 minutes. The pre-mordanting method was preferred for Al and Cr, and the post-mordanting one was preferred for Cu, Sn and Fe to achieve better dyeing. The optimum mordanting conditions of wool fabrics dyed with cochineal were mordanting concentration of 1%(o.w.s), mordanting temperature $60^{\circ}C$, and dyeing time 30 minutes. Wool fabrics dyed with cochineal showed a little antibacterial activity, but it was increased by Cu and Sn mordanting. The light fastness and perspiration fastness of wool fabric treated with cochineal were improved by mordanting.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2002년도 하계학술대회 논문집 Vol.3 No.2
• /
• pp.908-911
• /
• 2002

Recently deep interests and attraction have been paid on the generation of ozone, which is widely used to remove bed smell and to clear water. In this paper the silent discharge and ozone generation characteristics of various typed discharge chambers were investigated experimentally. Dielectric of $Al_2O_3$ was embedded in the cylindrical type of discharge chamber to improve the ozone generation rate and to stabilize the silent discharge mode of operation. Discharge current and ozone concentration depend strongly on the applied voltage and frequency.

• Bulletin of the Korean Chemical Society
• /
• 제26권9호
• /
• pp.1415-1420
• /
• 2005

The spectral interferences of OH from aqueous solvents in ICP-AES have been studied and eliminated using a cryogenic argon trap. The prominent lines of Bi I 306.772 nm, Al I 309.271 nm, and V II 310.230 nm, which are very seriously overlapped with the OH band, were examined. With an extended torch and high tangential flow of 20 L/min, water vapor from air entrainment was prevented. The combination of a condenser and argon cryogenic trap was able to eliminated most of water vapor carried by the argon sample gas. Removal of OH spectral interference could extend the linearity of the calibration curve 5-10 times on the lower concentration for ICP-AES. Interference Equivalent Concentration (IEC) has been reduced to 5.6, 5.9, and 12.4 times for Bi, Al and V, respectively.

• The Korean Journal of Ceramics
• /
• 제3권4호
• /
• pp.235-238
• /
• 1997

Basic properties of new cement pastes based on the system $CaO-Al_2O_3-P_O_5-H_2O$were studied Phosphoric acid solutions and calcium dialuminate clinkers synthesized by the hydration-burning method were used for liquid and powder components of the paste, respectively Variation in the compositions of the paste was achieved by changing the liquid/powder ratio and the concentration of phosphoric acid solution. The hardening rate of the paste was so largely affected by the amount of phosphoric acid that hardening was inhibited with the low-concentrated solution but was explosively accelerated with the high-concentrated solution. The phosphoric acid solutions of concentration of 45~50% and the liquid/powder ratio of 0.5~1.5 were favoured for the high early-strength cement paste with the reasonable hardening rate and high strength. The binding phase of hardened paste was the dense amorphous gel of the system $CaO-Al_2O_3-P_O_5-H_2O$. in which the unreacted calcium dialuminate grains were embeded.

• 한국세라믹학회지
• /
• 제31권5호
• /
• pp.485-490
• /
• 1994

The reactive ion etching characteristics of aluminum oxide films, prepared by PECVD, were investigated in the CCl4 plasma. The atomic chlorine concentration and the DC self bias were determined at various etching conditions, and their effects on the etch rate of aluminum oxide film were studied. The bombarding energy of incident particles was found to play the more important role in determining the etch rate of aluminum oxide rather than the atomic chlorine concentration. It is considered to be because the bombardment of ions or neutral atoms breaks the strong Al-O bonds of aluminum oxide to help activate the formation reaction of AlCl3 which is the volatile etch product.

• 한국식품위생안전성학회지
• /
• 제12권1호
• /
• pp.15-19
• /
• 1997

The stability of monascin yellow pigment isolated from Monascus purpureus was determined over a period of storage for the wide range of pH, various metal ions and antioxidants. The absorption maximum of monascin pigment was 385 nm. Monascin pigment was more stable in acid solutions than in alkaline (pH 9 and pH 11) during storage period. It was also observed the reduction of absorption was occur after 3 days storage. The stability of monascin pigment was not changed by adding the various metal ions of the concentration of 10-4 M, however, it was unstable by adding the Zn2+, Al3+ and Fe3+ of 103- M concentration. The antioxidants. BHA, BHT, cysteine and L-ascorbic acid, have no effects on the stability of monascin yellow pigment. Thus, it may be concluded that the monascin pigment is stable and useful food additives as the natural colorant except for the alkaline food and food containing the Zn2+, Al3+ and Fe3+.

• 한국자동차공학회논문집
• /
• 제3권2호
• /
• pp.95-101
• /
• 1995

Experiments have been conducted to investigate the characteristics of formaldehyde and nitrous oxide formation from the catalytic reaction of methane. Catalysts used in the experiment were Pd. Pd/Pt/Rh loaded on ${\gamma}-Al_2O_3$ and ${\gamma}-Al_2O_3-La_2O_3$ monolith. In the catalytic reaction of methane. as the concentration of NO, $O_2$ and $CH_4$ increased, the formaldehyde emission was increased. The concentration of $N_2O$ increased as NO and CO increased. It was also found that the formaldehyde emission was produced by the gas reaction of methane in high temperature above 950K.