• Journal of the Korean institute of surface engineering
• /
• v.57 no.2
• /
• pp.86-91
• /
• 2024

In this study, we investigated the effect of Na₂SiO₃ concentration on the Plasma Electrolytic Oxidation(PEO) film formation of Al6061 alloy. The morphology of the PEO films were examined by Optical Microscope(OM) and Scanning Electron Microscope(SEM). PEO film thickness increases as the Na₂SiO₃ concentration increases. The elemental analysis of PEO films was conducted using Dispersive X-ray Spectrometer(EDS). The cross-sectional elemental analysis result shows that the Si concentration tends to increase as the concentration of Na₂SiO₃ increases. X-Ray Diffraction(XRD) analysis was performed to confirm the degree of phase change according to Na₂SiO₃ concentration. In addition, Vickers hardness was measured to confirm the mechanical strength of the PEO film. As the concentration of Na₂SiO₃ increases, the hardness value also tends to increase.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.4 no.2
• /
• pp.169-177
• /
• 1994

Dilute Al-Cu and Al-Mg alloys were solidified unidirectionally upward by Bridgman method. It is necessary that solute concentration of initial melt is uniform to be able to control the concentration of crystal. When solute concentration is not uniform, it can cause unusual macro-segregation in grown solid. A non-steady state solidification was observed where the solute concentration in the grown solid decreased with the progress of solidification, when a dilute Al-Cu melt with positive axial temeprature gradient was solidified. This was caused by leaking out of Cu-rich melt into the gap between ingot and crucible during melt-down and its sedimentation after complete melting. In the case of Al-Mg alloy, the solute concentration has a minimum in the middle of grown specimen because Mg-rich melt flowed down the gap between ingot and crucible and floated after complete melting. Uniform initial melt concentration can be achieved by the homogenization of the ingot or by the absence of the gap between ingot and crucible.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.5 no.2
• /
• pp.120-126
• /
• 2005

We have proposed a characteristic method to estimate real composition when multi component oxide films are deposited by ALD. Final atomic concentration ratio was theoretically calculated from the film densities and growth rates for $HfO_2$ and $Al_2O_3$ using ALD processed HfxAhOz mms.W e have transformed initial source feeding ratio during deposition to fins] atomic ratio in $Hf_xAl_yO_z$ films through thickness factors ($R_{HFO_2}$ ami $R_{Al_2O_3}$) ami concentration factor(C) defined in our experiments. Initial source feeding ratio could be transformed into the thickness ratio by each thickness factor. Final atomic ratio was calculated from thickness ratio by concentration factor. It has been successfully confirmed that the predicted atomic ratio was in good agreement with the actual measured value by ICP-MS analysis.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.44 no.5
• /
• pp.1-7
• /
• 2007

AZO thin films have been fabricated on quartz substrate with various Al doping concentrations and annealing temperatures by sol-gel method. The bset condition of (002) orientation and smooth surface (rms = 1.082 nm) is obtained for the AZO thin film doped with 1 mol % Al and annealed at 550 $^{\circ}C$. The optical transmittance of AZO thin films is higher than 80 % in the visible region. We observe that the energy band gap extends with increasing the Al doping concentration. This phenomenon is due to the Burstein-Moss effect. Through the measurement of Hall effect, it is observed that the AZO thin film has larger carrier concentration and smaller electrical resistivity than the pure ZnO thin film. However, the AZO thin film shows the decrease of carrier concentration and the increase of resistivity with the increase of Al concentration, that is due to the segregation of Al at grain boundaries. The maximum carrier concentration of $1.80{\times}10^{19}\;cm^{-3}$ and the minimum resistivity of 0.84 ${\Omega}cm$ are obtained for the AZO thin film doped with 1 mol % Al and annealed at 550 $^{\circ}C$.

• Journal of the Korean Electrochemical Society
• /
• v.3 no.4
• /
• pp.204-210
• /
• 2000

The control of dissolved aluminum concentration in the hot dip zinc galvanizing bath is greatly important in producing galvannealed steel sheets. The purpose of present study is to provide basic data for measurement of the aluminum concentration in site in hot dip zinc bath at the temperature of $460^{\circ}C\~500^{\circ}C$ using $CaF_2$ solid electrolyte sensor with three kinds of reference electrode. Good workability and stability of the sensor were confirmed with the $Bi+BiF_3$ reference electrode from the emf measurement. In order to measure the aluminum concentration in Zn-Al bath, the galvanic cell of fluorine ion was constructed with $CaF_2$ solid electrolyte as follows; $$(-)W|Zn-Al,\;AlF_3|CaF_2|Bi,BiF_3|W(+)$$. The emf measurement was made at the temperature of $460\pm10^{\circ}C$ in the Zn-Al bath. The following correlationship between aluminum concentration and emf was obtained by the least square regression analysis; $$E/mV=56.795log[\%Al]+1881.7\;R=0.9704$$,$$0.026wt\%{\leq}[\%Al]{\leq}0.984wt\%$$

• Journal of the Korean Institute of Gas
• /
• v.16 no.6
• /
• pp.1-6
• /
• 2012

Using the Siwek 20 L spherical explosion vessel, the explosion properties have been examined to understand the influence of magnesium content in Mg-Al alloy dusts with different concentration. For this purpose, the Mg-Al alloy dusts (volume mean diameter : $151{\sim}160{\mu}m$) with magnesium content ratio were used. As the results, the increase of Mg content in Mg-Al alloy causes an decreased minimum explosion concentration and an increased maximum explosion pressure. Also the maximum explosion pressure and maximum rate of pressure rise in Mg-Al alloy dusts mainly depended on the dust concentrations. However, for the explosion index (Kst) of Mg-Al (40:60 wt%), Mg-Al (50:50 wt%) and Mg-Al (60:40 wt%), it was founded to increase the Kst with increasing of magnesium content ratio.

• Proceedings of the KSME Conference
• /
• 2007.05b
• /
• pp.2177-2181
• /
• 2007

In this paper, effective thermal conductivities of water-based $Al_2O_3$-nanofluids with low concentration from 0.01 vol. % to 0.3 vol. % are experimentally obtained by transient hot wire method (THWM). The water-based $Al_2O_3$-nanofluids are manufactured by two-step method which is widely used. To examine suspension and dispersion characteristics of the water-based $Al_2O_3$-nanofluids, Zeta potential as well as transmission electron micrograph (TEM) is observed. We confirm the manufactured $Al_2O_3$-nanofluids have good suspension and dispersion. The effective thermal conductivities of the water-based $Al_2O_3$-nanofluids with low concentration are enhanced up to 1.64% compared with that of DI water at $21^{\circ}C$. In addition, experimental results are compared with theoretical results from Jang and Choi model.

• Journal of Pharmacopuncture
• /
• v.15 no.2
• /
• pp.11-14
• /
• 2012

Objectives: The purpose of this study was to compare the antioxidant and anti-inflammatory effects of Alum (AL) and Burnt Alum (BAL), which are commonly used as external ointments. Methods: Extracts of AL and BAL were classified into three groups: 20, 50, and $100mg/{\mu}{\ell}$. The cytotoxicity was measured by using MTT assays in human keratinocyte cell line (HaCaT). The anti-oxidant effect was measured by using the DPPH (1, 1-diphenyl-2-picryl-hydrazyl-hydrate) radical scavenger. The anti-inflammatory effect was measured by using the inhibitory efficacy for the amount of nitric-oxide (NO) produced in mouse macrophage cell line (RAW 264.7). Results: BAL showed a higher level of cytotoxicity than AL. The AL groups showed a concentration-dependent scavenging effect on DPPH radicals, but no significant relevance was found. The BAL groups showed a concentration-dependent scavenging effect on DPPH radicals. The scavenging effects of the BAL groups were almost insignificant, but the values for the 20, 50, and $100{\mu}g/m{\ell}$ trials were different. The BAL groups showed significant concentration-dependent inhibitory effects on NO production, but the AL groups did not. Conclusions: AL showed an anti-oxidant effect more efficiently than BAL did, which demonstrated a superior anti-inflammatory effect. Therefore, for external usage, AL must be distinguished from BAL.

• Journal of Microbiology and Biotechnology
• /
• v.13 no.2
• /
• pp.217-224
• /
• 2003

Previously, we developed a CHO cell line (CHO-OTC1-Al9) that expresses the first two enzymes in the urea cycle and exhibits a higher ammonia-removing ability and faster growth rate than a vector-controlled CHO cell line (CHO-neo-5). The current study was undertaken to develop a cell line with an ammonia-removing ability higher than the cell line developed previously. To accomplish this, CHO cell lines expressing the first three, first four, or all five enzymes of the urea cycle were constructed using a stable transfection method. Finally, the CHO-AS-16, CHO-AL-19, and CHO-Arg-11 cell lines expressing the first three, first four, and all five enzymes of the urea cycle, respectively, were selected and found to exhibit higher ammonia-removing ability than the CHO-OTC1-Al9 cell line. Among the three selected cell lines, CHO-AL-19 showed the highest ammonia-removing ability and highest cell viability at a higher cell density, with 40% and 15% lower ammonia concentration in the, culture media than that of CHO-neo-5 and CHO-OTC1-A19 cell lines, respectively. CHO-AL-19 also showed 44% and 10% higher cell viability than the CHO-neo-5 and CHO-OTC-Al9 cell lines, at a higher cell density, respectively. The ammonia concentrations in the culture media were expressed as the ammonia concentration/cell, and the CHO-AL-19 cells revealed 45-60% and 20% lower ammonia concentration/cell than the CHO-neo-5 and CHO-OTC1-Al9 cells, respectively.

• Journal of Korean Society of Forest Science
• /
• v.88 no.2
• /
• pp.249-254
• /
• 1999

The effects of various levels of Al concentration on growth, nutrient status and net photosynthetic rate of 2-year-old Pinus densiflora Sieb. et Zucc. seedlings grown in a nutrient culture solution were investigated. Al concentrations were added as aluminum chloride($AlCl_3$) at 0(control), 10, 30 and 60ppm to the nutrient culture solution. The nutrient culture solution was maintained at pH 4.0 by adding HCl or NaOH solution. The seedlings were transplanted into the nutrient culture solution and grown in a greenhouse for 90 days from May 8 to August 6, 1996. The treatment above 10ppm of Al concentrations induced a significant reduction on the dry weight growth of the seedlings. The relative growth rate(RGR), net assimilation rate(NAR) and net photosynthetic rate of the seedlings were reduced with increasing of Al concentrations in the nutrient culture solutions. This result suggests that reductions in the RGR and NAR of the seedlings were mainly due to the inhibition of net photosynthesis. In addition, the increase of Al concentrations in a nutrient culture solution decreased the concentration of essential mineral elements such as Ca and Mg in the needle of the seedlings. However, the concentrations of Al of each plant organ increased in the treatment above 10ppm of Al concentrations in the nutrient culture solutions. This result suggests that the increased Al concentration in the belowground part resulted from the decreased concentration of essential mineral elements in the aboveground part of the seedlings.