• 대한기계학회논문집
• /
• 제14권5호
• /
• pp.1211-1221
• /
• 1990

본 연구에서는 CWM을 이류체 미립화기(twin-fluid atomizer)로 미립화 시켜 미립화에 크게 영향을 미치는 인자들로 믿어지는 공기분사압력, 부하도(loading), 미 분탄의 크기 그리고 CWM 방울 채집위치의 변화가 CWM 방울크기 분포와 CWM 방울안 미 분탄 존재유무에 미치는 영향을 연구의 목적으로 하였다.

• 한국가시화정보학회지
• /
• 제19권1호
• /
• pp.36-42
• /
• 2021

This study measured the velocity of magnetic particles inside the power generation using external heat sources. Single Plane Illumination Microscopy (SPIM) was used to measure magnetic particles that are simultaneously affected by bubbly flow and magnetic field. It has the advantage of reducing errors due to particle superposition by illuminating the thin light sheet. The hydraulic diameter of the power generation is 3mm. Its surface is covered with a coil with a diameter of 0.3 mm. The average diameter of a magnetic particle is 200nm. The excitation and emission wavelengths are 530 and 650nm, respectively. In order to find out the flow characteristics, a total of four velocity fields were calculated in wide and narrow gap air bubbles, between the wall and the air bubble and just below the air bubble. Magnetic particles showed up to 8.59% velocity reduction in the wide gap between air bubbles due to external magnetic field.

• 대한기계학회:학술대회논문집
• /
• 대한기계학회 2001년도 추계학술대회논문집B
• /
• pp.71-76
• /
• 2001

An electret filter is composed of permanently charged electet fibers and is widely used in applications requiring high collection efficiency and low-pressure drop. In this work, the collection efficiency of the filter media used in manufacturing cabin air filters was investigated by using poly-disperse particles when submicron particles are loaded. Long-term experiments were conducted by applying different charging states, which are spray electrification and charge equilibrium by bipolar ionization. In order to investigate on the effect of particle loading in filter media, NaCl particles were generated from 0.1% and 1% solutions by an atomizer. In NaCl 0.1%, the collection efficiency of electret filter decreased and then did not change in equilibrium state. In the case of relative larger particles of NaCl 1%, collection efficiency for the equilibrium charged particles increases due to the particle loading on the filter fibers. Particles charged by spray electrification are small in collection efficiency after equilibrium state and increase of filter media's pressure drop was very low in comparison of the equilibrium charged particles.

• 한국환경과학회지
• /
• 제19권4호
• /
• pp.509-516
• /
• 2010

This study was investigated the characteristics of indoor air concentration of fiber particles in 30 public facilities and 245 schools by PCM (phase contrast microscopy). Also SEM/EDX (scanning electron microscope / energy dispersive using X-ray analysis) was used to obtain physicochemical information of asbestos fiber and to classify asbestos and non-asbestos of fiber particles. The airborne concentrations of fiber particles were $0.0009\pm0.0009$ counts/mL in public facilities and $0.0012\pm0.0006$ counts/mL in schools by PCM. All the samples were satisfied with the IAQ (indoor air quality) level of 0.01 counts/mL. In classification of 4 type shapes, over 80% of the fiber particles were identified as single fiber type. And this study analysed airborne fiber particles in 4 sites for identifying asbestos of by SEM/EDX. The asbestos fibers in most samples could not be found.

• 한국분무공학회지
• /
• 제11권2호
• /
• pp.98-104
• /
• 2006

A charged droplet scrubber was introduced to remove visible smokes generated in many industrial facilities. Lab-scale and field tests were conducted in this study. The system consists of a corona discharger to effectively charge the fine particles, fellowed by an electrostatic chamber to promote coagulation between charged fine particles and oppositely charged droplets and a demister to remove resultant particles. Overall collection efficiency, 98.4% was obtained from a lab-scale test, when a high voltage was applied to an ionizer and a charged droplet scrubber. Field tests also show the high collection efficiencies, 93.5% with one stage and 99.4% with two stage system. This system can be used to increase the collection efficiency of the conventional air pollution control devices to satisfy the national emission standard.

• 한국마이크로전자및패키징학회:학술대회논문집
• /
• 한국마이크로전자및패키징학회 2003년도 기술심포지움 논문집
• /
• pp.256-259
• /
• 2003

To develop cleaning process various particles should be deposited on wafer surfaces to measure particle removal efficiencies. The purpose of the article in to evaluate, removal efficient)r of silica and alumina particles from wafer surfaces when they are deposited by dry and wet method. Dry deposition in air and wet spray deposition using solutions are used. van der Waals are considered to calculate the adhesion force of particles on surfaces. Higher adhesion force is measured on alumina particles on silicon when particles are deposited in air.

• Journal of Advanced Marine Engineering and Technology
• /
• 제24권5호
• /
• pp.103-110
• /
• 2000

A two phase compound jet, which mixes pulverized solid particles with the air in the test section, is experimentally analyzed in this study. Two phase flow is jetted 10 degree upward in the primary jet, while the secondary jet utilizes the air only. The height difference between the primary and secondary central axises is 32.5mm. The velocity vector field, concentration field, and turbulent properties of solid particles are measured by using 3-Dimensional Particles Dynamics Analyzer. When the jet angle of the secondary jet goes into effect, the solid particle recirculation zone becomes larger. Also, solid particle concentration becomes more dense due to a velocity decrement of particles.

• 상하수도학회지
• /
• 제16권6호
• /
• pp.655-662
• /
• 2002

Separation characteristics of inorganic particles occurred during heavy rainwater were investigated in DAF (dissolved air flotation) process. In order to remove the inorganic particles effectively, the collision and flotation efficiencies were examined from a hydrodynamic point of view. Generally, the collision efficiency increased with floc size under the variation of fluid dynamic conditions including inertial force. However, more precise model should be required to analysis the collision efficiency expressed both the physical properties for inorganic particles and hydrodynamic conditions for a reactor.

• Journal of the Korean Wood Science and Technology
• /
• 제44권6호
• /
• pp.821-827
• /
• 2016

This study evaluates the economic feasibility of industrializing fluidized bed dryer for wood particles. The theoretically required heat energy and energy efficiency were evaluated using a pilot scale fluidized bed dryer. When Mongolian Oak wood particles with 50% initial moisture content were dried in the fluidized bed dryer with air of $70^{\circ}C$ air circulating at 1.1-1.3 m/s for 30 minutes, the total theoretically required heat energy was 2,177 kJ. Of this, 1,763 kJ (approximately 81.0%) was used to heat the air flowing in from outside the dryer and 386 kJ (approximately 17.7%) was used to heat and remove water from the wood particles. Actual energy consumed was 7,560 kJ, giving energy efficiency of 28.8%. Thus, to industrialize a drying method such as fluidized bed drying, where the dryer volume is significantly larger than the volume of wood particles, it is necessary to minimize energy loss and maximize energy efficiency by designing the dryer size considering the amount of wood particles and choosing a suitable air circulation rate.

• Environmental Analysis Health and Toxicology
• /
• 제20권2호
• /
• pp.179-186
• /
• 2005

Particulate materials (PM) less than 10 ${\mu}m$ in diameter are of special interest in air pollution because they are respirable and responsible for the increasing mortality rate of lung cancer and cardiovascular diseases. These particles are often referred to as $PM_{10}$ and they are divided into a coarse fraction and a fine fraction which is also often referred to as $PM_{25}$. In this study, we monitored the TSP, $PM_{10},\;PM_{2.5}$ concentration of ambient air collected in northern part of Seoul in early spring and measured the concentration of heavy metals; Cr, Mn, Zn, As, Cd, and Pb. All the heavy metals were found in the collected particles and the concentrations were variable in the $PM_{10},\;and\;PM_{2.5}$ respectively. The detected concentration ranges were Cr: $ND\~2,889ng/m^3,\;Mn:2.4\~257.9ng/m^3,\;Zn:ND\~353.7ng/m^3,\; As:ND\~22.3ng/m^3,\;Cd:0.1\~2.9ng/m^3,\;and\;Pb:ND\~392.2ng/m^3$ in fine particles. Heavy metal toxicity of the particles were also tested in $H_9C_2$ cell line derived from rat cardiomyocytes. As for the results of health risk assessment calculated by unit risk of IRIS, heavy metals in ambient air of Seoul metropolitan area were found to be responsible for the increase of total excess cancer risk. Among them, chromium (hexavalent) was found to be the most risky in fine particles of ambient air collected in the northern part of Seoul in early spring.